Ford F-150 (2004-2008) :: Truck Started To Miss Then Quit
My sons 04 f150 started to miss then quit on him then wouldn't start so he had a buddy pull it to a neighbors I went to check it out an hr later the first time i tried to start it it started ran for 2 sec then quit tried again and it would just crank no start went back 3 hrs later with my code reader no codes but he did say check eng was on when it quit first time so i try starting started up so i headed for home, it started running rough twice on way home but seem to come out of it both times.
View 1 RepliesFord F-150 (2004-2008) :: Truck Quit When Going Down The Road And Won't Turn Over
My Dad has a 2004 F150 with the 5.4L. Going down the road it just up and quit, when would not even turn over (no starter click or anything), all lights seem to be working and nothing out of the ordinary on the gauges. Mechanic found fuel pump fuse blown then fuel pressure still low, so changed fuel pump. Still not running....
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Radio Quit Working Then Lights And Truck - Alternator?
Driving home my radio quit working. I looked at the gauges and they all dropped to the left. The it looked like my lights quit working and then the truck just quit. All of this happened within 5 miles and 10 minutes. I jumped it and quit before I could even get going, it did start momentarily. Could not even get the gear shift into neutral; had to jump it to get that to happen.
It is 2006 F150 4x4, 5.4L engine and about 95,000 miles.
Ford F-150 (2004-2008) :: Turn Signals And Hazard Lights Quit Working / Blown Fuse Now Truck Won't Start
My 2007 F150's turn signals and hazard lights quit working. I checked the fuse and it was blown. Once I pulled the old fuse out the truck wouldn't start at all. What happened?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Just Quit While Running 70 MPH
Traveling right now. Limited access to FTE.
On the way to the airport this morning at 4:30 am, the engine simply did while running down the interstate. Absolutely no symptoms leading up to it. Turns over fast but will not start. White smoke from tall pipe while trying to start.
I unplugged the fuel bowl heater and checked the IPR tin nut and the ICP sensor connections... Nothing obvious.
Problem was CPS and the engine is now running fine again.
Ford F-150 (2004-2008) :: Brake Lights On Whilst Truck Not Running?
At 2:30am this morning I looked out my window and saw my brake lights and third brake light come on for about 5 seconds and then go off. This scenario kept repeating itself. I went to drive my truck 2007, and the brake lights remained on even when the lights were turned off when I was driving. I also need to seal the third light. Brake regulator has been replaced.
View 2 RepliesFord F-150 - 1997-2003 :: Truck Quit Running / Engine Turn Over But Will Not Start
I have a 1997 ford f150 V-6 4.2. My son was driving the truck on the expressway and it quit running. The toe truck has delivered the truck back to my house. The engine turns over but will not start. I shot gas into the engine with a spray bottle and the engine still would not start. Was going to check the coil for spark next. What to check first. Was thinking the problem could be the modulator or coil.
View 10 RepliesFord F-150 (2004-2008) :: Running Very Rough / Shaking At Low RPMs - Truck Died
On my way into work this morning, my 06 with the 5.4 started running very rough/shaking at low rpms. I could kick it out of overdrive and it would smooth out and seemingly be fine at higher rpms.
This worked out for a couple of miles until the truck just died on me completely. The Edge is showing po351, 352, 353......358 codes. Ignition coil Primary/Secondary circuit fault on every cylinder.
I'm thinking its unlikely that every coil failed simultaneously....computer? When I try to start the truck, it will try to hit on a cylinder or two, but will not run.
Ford F-150 (2004-2008) :: Truck Running Rough / Clunky Like Not Getting Gas - Fuel Pump Module?
First it was the whole spark plug debacle. Now it's the "fuel pump module". Story starts a several months back. On a moist day I was headed out and the truck ran very rough, "clunky", like it wasn't getting gas. After 15 miles and a stop truck ran fine. Didn't think much of it and truck ran fine for month or so. I was then away for a couple days and came home to find my truck wouldn't run (started briefly then died). Local mechanic thought it might be a fuel pump issue but then got truck running thinking it might have been a delayed inertia switch in front panel (I had hit a deer a week or 2 prior). Again, not thinking much of it continued to drive truck with no issues for awhile. Then one rainy morning on my way to work the truck was running very rough and "clunky" again. It died several times and finally for good.
After getting it towed to the mechanics, he figured the fuel pump was finally shot. The end to my long story is it was the fuel pump module (luckily a lot cheaper fix than the fuel pump) - half of the housing was gone (corroded away) adn moisture was shorting the pump electronics. Why, if this module is half encased in plastic do the engineers feel the need to encase the other half in metal (appeared to be cast aluminum)??!!????!! Of course it makes sense to have an electrical unit that is mounted underneath the truck where it can collect all the moisture, snow, salt from the road encased in a corrodable metal housing. No no, don't put it all in plastic, just half of the unit. MAKES PERFECT SENSE!! I thought to be and engineer took some sort of brains and common sense. Must be not at Ford. I can't be the only one with this issue and wondering WHY!!! - it must be widespread??
Ford F-150 (2004-2008) :: 2007 Truck Won't Stay Running After Undercoating With Fluid Film
Began doing this on sunday and just finished up last night. Truck starts and runs for a bit then stalls. Here is what I did in this order:
1.) Washed truck sundday with purple power and a garden hose. I washed the wheel wells frame and underside, but DID NOT wash the engine at all.
2.) Painted the frame and wheel wells with black paint.
3.) Applied 1/2 gallon or so of fluid film all over the bottom of the truck everywhere I can. Again NOT the engine bay.
Where to start. When it stalled, I can restart every time by waiting 3-5 minutes. It was 13 degrees F last night, so i suspect fuel lines may be freezing but not sure.
Ford F-150 (2004-2008) :: Battery Drains When Truck Idle
I have a 2008 F150 that the battery drains after sitting 4 days or longer. This has happened about a dozen times since I bought the truck and the dealer could never figure out why. Warranty is up now and it is STILL happening! I had corporate office insult me by telling me everything "checks out" and it is just like a cell phone. If you don't periodically charge it up, the battery dies. I asked her where I was supposed to plug my truck in at night and there was silence on the other end. I am 62 and have never had a car or truck do this from just sitting. The dealer insists everything checks out.
View 14 RepliesFord F-150 (2004-2008) :: Rough Idle / Truck Wants To Stall
Let me describe this perplexing issue. I have a speratic rough idle problem. When it happens it's almost like the truck wants to stall. Once going the truck is fine. There has never been any acceleration issues, but for a short time the truck would kind of lunge off idle. It hasn't done that for quite some time. I've replaced the fuel filter. There are no vacuum leaks that I know of. I've tried higher octane fuel. I've tried injector cleaner for a month. What should the fuel pressure be and what is the test port located? Is the fuel pump in the tank? If so, whats that big log looking thing behind the gas tank that the fuel lines run to? Also, there are no MIL codes...
View 14 RepliesFord F-150 (2004-2008) :: Truck Lost All Power / Barely Staying Running - Code P0012
2008 F150 5.4L .. The truck lost all power the other day driving and barely made it to work. On the ride home it was still running horribly, like it just fell on its face. the check engine light came on. Went to autozone and put HEAT in the gas tank cuz the night before it was at quarter tank and temp went from warm to freezing(thought maybe condensation in tank).. Truck ran a lot better( not perfect). Drove around that day and it was fine. Pulled down the driveway and CE light shut off. Ran the code anyways and it was P0012..
Talked to a few mechanics and they said try replacing the Camshaft position sensors..did so and it ran worse. the truck hardly would idle or rev and shook violently..i shut it down right away. Then it threw 9 codes..Cam shaft position- over retarded timing bank 1(P0012), misfire cyl2, misfire cyl3, misfire cyl 4, random misfire, cam sensor bank 1, three of them were repeated codes..
I replaced the sensors back to stock and cleared the codes. the truck is running like it was in the beginning of the problem..No vilant shaking but falling right on its face at idle and any rpm..not drivable. Would rather do the work myself. very capable except for replacing camshaft phasers which i have heard could be the issue..Could it by the VCT seliniod, EGR valve, plugs, wires...Did just change the oil a week ago and cleaned and reoiled air filter.
Ford Super Duty (1999-2016) :: 2004 - Running Rough Both At Idle And Driving - Truck Shakes A Lot At Lower RPMs
I have a 2004 SD with 5.4 that is running pretty rough both at idle and driving. Truck shakes a lot at lower rpms. I have a scan tool and had a misfire on cylinder 4 so I replaced the coil and the plug. Also replaced the idle air control valve. Plan on replacing O2 B1 S2. (One of my codes) even after replacing the coil and plug I'm still getting misfire detected from cylinder 4??? Other codes I had were misfire detected on he first 1000 revolutions. That hasn't come back though.
View 2 RepliesFord F-150 (2004-2008) :: 2005 FX4 Truck Extremely Rough Idle
A week and a half ago I went out to my truck to go somewhere and I got about 2 blocks away and the truck started running really rough and had a big lack of power, so I turned around and scanned it with my code reader and the codes I got were p2271, p2196, p0303, p0012, p2197, and p2272. since then I've changed all the spark plugs, boots, swapped all the coils and injectors from a great running truck, fuel filter, and the bank 1 upstream O2 sensor.
the other thing that came to mind that could of caused the problem is that a few days before the problem started. I jump started a co-workers car and he hooked the cables up backwards on his car. Could this be the cause of the problems I'm having.
The truck is an 05 F150 FX4 5.4 with 180,000 miles on it.
Ford F-150 (2004-2008) :: Idle Will Drop Down When Stopped And Truck Sounds Like It Is Going To Die
My friend just bought a 2008 F150 5.4 110k, it ran great all day during all of the test drives, after he gets it home it has started acting up. Most of the time it runs great, but sometimes when you stop the truck the idle will drop down and the truck sounds like it is going to die but so far it hasn't actually died, it starts knocking really badly and runs very rough. If you let it keep running like that it sets P0340. If you rev the truck up it cleans up and sounds fine again and it will even drop back down to a clean idle most of the time. I swapped the cam sensors because it was easy and just to see and it didn't make a difference, I was hoping after switching the sensors the code would switch to the other head but it didn't.
View 14 RepliesFord F-150 (2004-2008) :: Truck Is A Bit Rough At Idle - B1360 Code - No CEL
So I bought a 2006 F150 stx reg cab with the 4.6l motor with 90k miles on it a few weeks ago. It was in really good condition and I couldn't pass the deal up. All in all, I love this truck. However at idle the truck is a bit rough. No check engine light, but a bit rough non the less. So I hooked up my obd2 torque app and I see I have anywhere between 6 and 60 total counted misfires, but none detected by individual cylinder. So I ran a scan and have a B1360 code without the CEL on. So I changed the plugs and coil packs and cleaned the k&n filer (non cold air filter, just a replacement k&n) and I still have all the symptoms and the b136p code. So I Google the b1360 code and there's very little on it. Basically says open circuit ignition.
View 1 RepliesFord F-150 (2004-2008) :: 2006 XLT Started Running Rough Out Of Nowhere Near Idle
I have a Ford F150 XLT. I have 67000 miles on it and the other night it just started running rough out of no where near idle. Once you got over 20mph the rough running would go away. I took it to get an engine change and engine flushed but it came back. It doesnt always run rough near idle or below 20mph. The Ford dealer says my engine has only 22 psi oil pressure near hot idle and cant engage the VCT phazers and they want to replace the whole engine.
View 1 RepliesFord F-150 (2004-2008) :: Truck Is Misfiring / Low Idle - Check Engines Codes
My 2004 f150 has always been great to me. all the way till now at 255k miles. My truck is misfiring really bad. Here are the codes I have :
P0506 low idle (because of the misfire)
P0356 ignition coil F (6) primary/ secondary circuit
P0308 Cylinder 8 misfire
P0174 system too lean (Bank 2, right side of engine)
p0316 misfire detected on startup
This problem happened 2 days ago. I reset the codes and they all come back together in 10 minutes. the misfire is very bad. I wonder why coil 6 has a fault code but number 8 has the misfire code.