Ford F-150 (2004-2008) :: Broken Coil-on-plug Wire Clip?
2007 F-150 Screw 5.4... Successful spark plug change. Well, sort of. I disconnected some of the coil clips/wires from the coils during the operation. Upon installation of the wires/clips, one of the clips did not 'click' into place.
Thinking the clip needed to be pushed/pulled, I bent the clip a bit and it snapped off! Being the slow learner that I am, a second clip also did not 'click' in place, and you know where this is going: I have two broken clips out of 8. After those two, I was much more gentle.
So, can these clips be replaced and/or spliced in? I'm thinking about just using nylon ties to hold them in place. So far, they are staying put just by being pushed in place, but these two do not seem very secure.
In the future, what is the correct way to make sure these things 'snap' back into place if they seem to not want to cooperate?
Here's a picture of the two 'press clips' that broke off....
Camry :: 2004 - Spark Coil Connector Holding Crack Off?
Scheduled maintenance for changing spark plugs for my Camry 2004 2.4L is either 120k miles, or 144 months (12 years). My Camry reached 12 years first. In removing the coil connectors, 3 of 4 holdowns cracked off. I guess not so surprising after 12 years subject to engine heat. I'm NOT going to replace the connectors. Looking for a patch for this problem? Duct tape will just result in adhesive getting everywhere it shouldn't. Maybe there's a high temperature "crazy glue" I could apply at the connector interface that will last another 12 years, or 120k miles?
Otherwise, I'll use the "hope adhesive". That means I'll just hope the connectors don't work loose at a bad time.
Camry :: 2004 - Ignition Coil Connector Broke - Connect Directly?
I replaced my valve cover gasket yesterday on my 2004 Camry. While putting back together, three of the tabs on the connectors for the ignition coil harness snapped off and would not stay together because of tension on the harness. I tried to zip tie them because I read that in another forum post but the clips (alligator clips?) inside the connector did not seem to be making contact with connector on top of ignition coil. The car was mis-firing and running very rough.
After much frustration, I finally removed the wires with the alligator clips from inside the connector and plugged them directly into the top of the ignition coil. Well, the car started and seems to be running/idling fine although now the Check Engine Light is on. Also, I have not driven car yet.
My question: Can I drive the car like this or will the vibration from the engine eventually loosen the connections. I am planning on ordering the connectors but they will not be in for a few days and I need to drive the car.
Ford Escape / Hybrid :: 2005 XLT - Ignition Coil Connector Wires
I had squirrels eat wires to the front 3 Ignition coil connector on my a 2005 ford escape XLT,my question is the new connectors have a white and black wire and the old ones had a red and a colored wire, but comparing both old and new connectors I notice the new connector has the black wire where the old connector has a red, so do I use the black wire to replace the old Red? , it's rather confusing to me when you plug in the new connector you can see the black wire is where the red wire was on the old one, or does it matter which wire goes where?
View 2 RepliesFord F-150 (2004-2008) :: Broken Locking Tab On COP Connector
In removing the COPs on my 2004 F150 Lariat 5.4L for a spark plug change, I noticed that the locking tab on one of the electrical connectors that plugs into the COP is broken. The previous owner had a zip tie on it to keep it on. Can I purchase a new connector and splice it on so that I don't have to use a zip tie? If so, what is the part number?
View 11 RepliesPassat (B5) :: 2004 - Spark Plug Coil Pack Removal?
2004 passat 1.8t. How do I remove the coil packs on the top of the spark plugs, so I can repalce the plugs.
I unclipped the wire and unsure how to pull the coil pack off.
No bolts. can turn it and maybe pull, but doesn't budge and don't want to break.
Ford F-150 (2004-2008) :: 2006 - Adding Reverse Lights To 7 Pin Connector
For our new pontoon with surge brakes I need to add reverse lights to the wiring harness to deactivate the surge brakes while backing up. What is the proper way of doing this? BTW this is on an 06 F150 XLT with factory 7 pin harness.
View 4 RepliesCamry :: 2007 V6 - Wire Unseated From Connector During Ignition Coil Removal
Any easy solution to reseating this wire in the connector? It got yanked out by accident when i was removing an ignition coil under the wiring harness. 2007 camry v6
View 3 RepliesFord F-150 (2004-2008) :: Trailer Lights Inoperative - No Power Back To 7 Pin Connector
My trailers lights aren't working at all- so frustrated right now!! I've checked all the fuses and those are good, I've got no power back to the 7 pin connector...
View 9 RepliesCamry :: 2006 - Little Keeper Clips Broken On Connector Plugs That Connect To Coil Packs
Changed the spark plugs on my 2006 Camry today. Everything went smoothly and quickly except for the fact that I broke all the little keeper clips on the connector plugs that connect to the coil packs. I called my Toyota dealers and one said I had to replace the entire wire harness. The other found the connector plugs for around $8 each. Will the broken clips be a problem with the connectors eventually coming off from vibration if I don't replace them? I'm not sure how to replace the connectors if I go that route. How to go about replacing the connector plugs?
View 7 RepliesFord F-150 (2004-2008) :: Coil Going Bad / Breaking Down?
I hate it when this happens, but I have a coil breaking down, and I've been advised multiple times to not replace all 8 coils. So how do I figure out which one it is? I am almost sure its a coil, as the plugs do not have enough miles on them to be bad already, and the truck has plenty of power it just has a slight shudder under a load, and the engine light will occasionally flash. Seems to go away after a bit. However, I can't get it to throw a code for whatever is causing the issue. 2004 Ford F150 146k miles on it
View 10 RepliesFord 6.7L Power Stroke Diesel :: Clearance Lights Plug In Connector Location?
Do all New trucks come with the factory clearance light plug-in-connector and if so, where would it be located? The reason I ask, is I'm considering adding the cab clearance lights to my 15 F350. Really would like the factory lights but I hear Recon makes some similar.
View 14 RepliesFord F-150 (2004-2008) :: Front Coil Spring Was Broken?
So I have had my FX4 for almost 10 years now. I have an xtra cab, bought new summer 2004 in Connecticut. Bought it had 5 miles on odometer, as of today has almost 117k miles. We just relocated this past weekend from CT to Manatee County, Florida, my wife followed me down in her 2010 Escape. Both trucks ran perfect..easy driving cruise control on 70 most of the way except for VA where there seemed to be a state trooper every 5 miles
anyway so overall I am satisfied with my truck since I've owned it. Changed oil every 4000-4500 miles without fail, 5-20 Motorcraft semi synthetic and FL-820 S filter is all it has ever seen. Engine doesnt burn/leak a drop of oil. As far as maintenace items and repairs, I looked through my records, here's what I've done:
1) rear axle rebuilt under warranty, clutch packs were shot at 60k.
2) brakes/rotors all around at about 50k, they still as of now have plenty of meat left
3) pinion seal went at about 90k
4) fly wheel had to be replaced at about 95k that was an expensive repair
5) replaced both front window regulators
6) replaced sliding rear window, under warranty, was leaking badly.
7) idler pulley replacement
8) exhaust rotted from just in front of muffler to tailpipe, replaced.
Also was told before we left CT that front coil spring was broken? I don't know about that truck suspension seems fine but will have it looked at.
Also normal maintenance did tranny flush 4x so far, fuel filter 4x so far, on 3rd set of tires, came with BFG rugged terrain, replaced at 62k with TOYO open country, they lasted 40k, now have Goodyear Wrangler LT's, so far excellent. Air filters, a light bulb here and there, and replaced battery after 6 years just to do it.
I have NOT changed the plugs yet truck does run great but I know what can and probably will happen, I feel comfortable with a dealer doing it, I'm not mechanically inclined enough to do it. I will have a little bit of a commute to work here, so I will probably get a ford Fiesta or a focus for the drive, but no way am I getting rid of this truck!
Ford F-150 (2004-2008) :: 2006 - Rough Idle After Replacing Ignition Coil
completely stock 2006 4.6, 230,000 miles, I purchased and can vouch for everything after 106,000.
Two separate issues...have had a slight ticking noise growing for about the last two years. Seems to get slightly worse near an oil change but that could be my imagination. It has finally gotten loud enough that my wife (who drives with the delicacy and observational skills of a Sherman tank driver) actually mentioned it to me the other day. It is directly related to engine speed whether the truck is in gear or not. I kind of think it might be a manifold gasket going out but am not sure. Am not very worried about it but...felt like I needed to mention it because of my bigger problem....
Truck has gotten very "cranky" on startup in the last week. Has a rough time finding an idle speed but typically sorts itself out after about 5-10 seconds. This afternoon it started idling rough at a stoplight. It got steadily worse and noticeable even at speed. Four stoplights and nine miles later it threw a code and coincidentally, I was in front of an Advance Auto. They read it and said the #3 cylinder was not firing. I bought an ignition coil, drove 15 miles home and changed it. From everywhere I looked online, this is the second cylinder from the firewall on the passenger side.
Had a little trouble getting it in and am not entirely sure it is fully seated in the slot, but I can't get it to go any further. Seems as tight as a couple of the others. I disconnected the battery to clear the codes, cranked it up and it seems to run "better", but still has a rough idle. Just test drove it about 12 miles and no check engine light but the idle has not cleared up. I think coil must be working fine because I have no issues at highway speed. Earlier, when I backed off the gas you would feel the miss very badly, but not as much when under a load.
Ford F-150 (2004-2008) :: Codes For Misfire On Cylinders 4 And 5 And Coil D Circuit Malfunction
I do not know the 5.4l 3v as well as my last 360ci dodge. It's a 2005 F-150 SuperCrew 4x4, got it cheap, and it's got issues. Got codes for misfire on cylinders 4 and 5 and Coil 'D' circuit malfunction. Obviously it has codes for limited power as well. was wondering how cylinder numbering goes and what coil is 'D'.
View 6 RepliesFord F-150 (2004-2008) :: Loss Of Fuel Mileage - Stutter Intermittently - Coil?
Changed my spark plugs and fuel filter but my fuel mileage seems to go down, used to get a average of almost 16mpg on a tank, now I'm down to 13.5mpg and also have the occasional stutter at different speeds/rpms. Is it time for new coils?
View 2 RepliesCamry :: 2004 SEV6 Hesitates / Hangs And Then Snaps Into Gear Mostly At Lower Speeds
Purchased a loaded SEV6 with 60k a couple months ago. It's a pretty car, but I'm a little concerned about the transmission's behavior. I previously owned a 2000 Camry LE 4 banger and even at 140k it shifted effortlessly. So it comes as a surprise that my new car hesitates, hangs, and then snaps into gear. This happens mostly at lower speeds, between 20 and 40 I'd say. It's actually given me a noticeable jolt a couple of times. This seems out of character for a Camry, no? I couldn't find any info on TSB's for this. What could be going wrong?
View 9 RepliesFord F-150 (2004-2008) :: AC No Longer Blows Cold Air And Temp Gauge Dead
2006 F150 King Ranch. My Air Conditioning no longer blows cold air. Additionally, the Temp Guage is pegged dead left. No movement at all even at normal operating temp. I've had the dealer replace 2 sensors and a wiring asy (XL3Z-14A411-AA). I still have the same problem. No cold air and the gauge is still pegged dead left.
View 3 RepliesFord Excursion :: Spark Plug Came Out And Broke The Coil Pack Mount
I'm looking around for coil packs and came across these: Granatelli Pro Series Extreme Coil Packs.....
View 12 Replies