Ford F-150 (2004-2008) :: Check Engine Error Code C3203
I have two codes off my "digi moto lite" obd2 scanner....
P0201 - internet search suggests it's a fuel injection code....
However I can't find anything on code C3203....
Ford F-150 (2004-2008) :: Getting P0605 Code Every Now And Then / PCM ROM Error
I just bought a F150 with 103,000 on it. The engine is a 4.6. I get a P0605 code every now and then which doesnt effect performance. I erase the code and it doesnt appear again for maybe another 100 miles.
I suspect a loose connector but not sure. Looked up the code and it reads PCM READ ONLY MEMORY (ROM) ERROR. My question is what does the PCM operate? And wheres a good place to start troubleshooting?
Ford F-150 (2004-2008) :: Error Code P0605 After SCT Tuner Install
I recently changed from a problem-ridden SCT Livewire to a SCT Xcalibarator3, and now when running my custom tune I get a check engine light and a error code P0605. I never got this on the same tune with the Livewire. What causes this and how to fix it?
View 4 RepliesFord F-150 (2004-2008) :: OBDII Not Reading Code - Communication Error?
What would make the OBD II not read the code that is set on my truck. It says "Communication Error..." Fuse 41 grants power to the Diagnostics port and the cigarette lighter. The cigarette lighter is working. Any other reasons I can look at?
View 3 RepliesFord F-150 (2004-2008) :: 2007 - Stumbling And Hesitating A Bit Between 25 - 35 MPH / P0307 Error Code
My 2007 Ford F150 Lariat (5.4L) with 82k miles popped a P0307 (#7 misfire) code one chilly morning. It began stumbing and hesitating a bit between 25-35mph, and each time it occurred, the engine light would flash on and off. Hesitation clears and light goes steady. Cleared the code and didn't see problems again for a month...until the next cold day (freezing temps). Popped again and hesitation returned. Ford dealer wants to change plugs. I've read coils can also cause the issue. Not sure if I can do either myself.
View 4 RepliesFord F-150 - 1997-2003 :: 2002 - Code P0340 - Service Engine Light On?
I have a 2002 f150 4.2 code p0340, ran rough, replaced cam sensor. drove after replacing and it runs fine now, code and service engine light comes on after restarting. from what i have read could this be a wiring problem?
View 4 RepliesFord F-150 (2004-2008) :: 5.4L - Getting Codes P0340 And P0344 Randomly?
At around 100K miles started to get the dreaded P0340 and P0344 that occurs randomly - engine cold, engine hot, rainy, hot, cold, you get the picture. Only occurs at startup. Shutdown/Clear Code/Restart and all is well for days... otherwise the engine runs fine. Have replaced the CMP sensors, thoroughly cleaned CMP and crankshaft sensor connectors, even replaced the alternator. I would like to tone out the wiring back to the PCM connector pins. I am trying to find a pinout diagram. PCM is 7L3A-12A650-GKF.
View 2 RepliesFord - Explorer :: 1996 - Check Engine Light Code P0340 - Camshaft Position Sensor
1996 Ford Explorer on a small island with no mechanics. Vehicle does less than 100 miles per year, never over 20 mph. The check engine light came on and the code reader says it's a problem with the Camshaft Position Sensor. The vehicle runs fine, just as it did before the check engine light came on. I'm tempted to put some electrical tape over the check engine light and keep driving.
View 2 RepliesFord F-150 (2004-2008) :: Knocking Noise / Running Rough And Stalling - P0340 And P0345
I have a 2006 f150 it was making a knocking noise after the engine oil temp reached 160* and made the noise to 1700rpms. I thought it was the cam phasers so I replaced them. The truck is still making the noise and running rough and stalling but not as bad and not as often. Before it did it all of the time. The truck is timed properly. I had a new cam sensor and tried it but that did not work. I watched vct on the scan tool and both cams are in sycn.
View 2 RepliesFord F-150 (2004-2008) :: Misfiring - Rough Idle - Got Codes P0340 / P0344 / P0345 And P0349?
I recently purchased a Ford pickup. I bought a 2004 F-150 with the 5.4L 3V engine. I have only driven it for about 300 miles so far and am having problems. The engine has 200,000 miles on it. I have read several posts on here about the cam phasers which I believe that I may have some issues with. The engine will run good when cold, on the road, etc. The engine does have a slight ticking after it warms up (cam phasers?). When I come to a stop after the engine is operating temperature, the engine will start to miss and shudder and all 4 above codes come active and are also pending (8 codes in total).
All 4 codes are logged at the same time. I have replaced both cam position sensors, both sensor ends and terminals for cam position sensors, checked wiring around rear of engine (does not appear to be rubbed through), all plugs were replaced, and all COP boots are good. Is there anything that can cause these codes that may not be the actual cam position sensors, ie. VTC, COPs, cam phasers? What pins the cam position sensors come to on the ECU (so I can ohm the entire wire harness)?
Also, if the engine is missing with the codes active and I rev the engine up it will come back to idle and run great. The engine never dies out, just runs horribly. I have also unplugged each sensor with the engine running which has no effect on the way it runs.
Toyota - Celica :: 1996 - Check Engine Light Is On / Code P0340
My 96 toyota celica check engine light is on and I get the code P0340. Also I can't seem to get my reverse light to work what could be the problem.
View 7 RepliesFord F-150 (2004-2008) :: 2006 - Missing And Rough Idle - Codes P0340 / P0344 / P0345 And P0349?
I recently purchased my first Ford pickup. I bought a 2006 F-150 with the 5.4L 3V engine. I have only driven it for about 300 miles so far and am having problems. The engine has 146,000 miles on it. I have read several posts on here about the cam phasers which I believe that I may have some issues with. The engine will run well when cold, on the road, etc. The engine does have a slight ticking after it warms up (cam phasers?). When I come to a stop after the engine is operating temperature, the engine will start to miss and shudder and all 4 above codes come active and are also pending (8 codes in total).
All 4 codes are logged at the same time. I have replaced both cam position sensors, both sensor ends and terminals for cam position sensors, checked wiring around the rear of engine (does not appear to be rubbed through), all plugs were replaced, and all COP boots are good. Is there anything that can cause these codes that may not be the actual cam position sensors, ie. VTC, COPs, cam phasers? What pins the cam position sensors come on the ECU (so I can ohm the entire wire harness)?
Also, if the engine is missing with the codes active and I rev the engine up it will come back to idle and run great. The engine never dies out, just runs horribly. I have also unplugged each sensor with the engine running which has no effect on the way it runs.
Ford F-150 (2004-2008) :: 2007 - Engine Flutter And Stalls In Reverse?
I have a problem. My 2007 ford f150 4x4 5.4 triton engine starts to flutter and stalls when its in reverse, engine is warm, and I am backing up a trailer with about 5,000 lbs on it. It drives fine with or without towing. I did notice it does it with nothing behind it on occasion. Whats causing this?
View 2 RepliesLexus LS 2007+ :: Engine Light On / Rough Idle At Start Up / Code P0340
1997 lexus ls400 204500 miles, engine light is on code P0340 (cam shaft position sensor bank 1), rough idle at start, once the car warms up it runs ok but loss of power, hesitates, if press more on gas pedal the car jerks. I have replaced both cam shaft position sensors and engine coolant temp sensor but no improvement. What could be the problem?
View 15 RepliesFord F-150 (2004-2008) :: Keep Getting Error Code P0446 - Evaporative Emission Control System Vent Control
I got a Ford f150 and getting the error code P0446 Evaporative Emission Control System Vent Control. My truck has burnt up 3 of these things already in the last 8 months. Why my truck keeps killing them?
View 2 RepliesCamry :: 96 Camshaft Error P0340
I have a 96 camry 4Cyl 2.2L with 360k miles. The CEL came on and I checked the code and it came up with P0340. This points to Camshaft Position Sensor A Circuit. Well the manual indicates that this sensor is built into the distributor and it's a whole assembly.
When I do a search for the part (camshaft position sensor) on a auto parts website, it comes up with a totally different part. The part that comes up looks like a crank shaft position sensor. Where to start first? The crank shaft sensor or the camshaft sensor on the distributor? I did ohm the cam shaft sensor on the distributor and it's within cold specs. Where would I find the crankshaft sensor?
Also, I did clear the code and started the car up and within 5 minutes the code came back up. The car seems to be running fine, smooth idling, no hesitation on the road either. II don't hear any noises coming from the Timing belt either, I just don't want to get stranded!
Honda - Fit :: 2008 - Stalls When Cold / Operator Error
I own a 2008 Honda Fit 5sp manual with 95,000 miles and have had noticed that the car will stall in cold weather. When stopping, I push the clutch in and take my foot off the gas to apply the brake. When the car stops the rpms go to zero and the car stalls. It has no problem starting again but will do this consistently until the engine is hot. It has also stalled on particularly cold/rainy days while the car is moving (over 30mph).
I can prevent the car from stalling by revving the engine, but I would need a third foot to do this while stopping. The check engine light is off. I took it to the dealer who has not been able to reproduce the problem and says it's operator error that is causing the engine to stall.
Prius (2004-09) :: Engine Light, Error Code P0301 Came On
So I changed my spark plugs, due to an error code saying p0301 which means cylinder one misfiring. I reset the engine light disconnecting the negative battery terminal. Once it reset it ran rough for a few miles. I put about 50 miles on it and it seems better.
View 2 RepliesLexus RX 2004-09 :: Service Engine Light Is On - P0446 Error Code
My service engine light is on and the tech at Quick Lube said this is the error code that is reporting. "P0446 EVAP Control System Vent Control Circuit Malfunction". Is the car safe to drive?
View 10 Replies