Ford F-150 (2004-2008) :: Codes P0053 / P0132 / P2195 And P2196 After Manifold Swap
Had my friends shop replace my passenger side exhaust manifold on my 2004 FX4. Two studs at the front broke flush and one other broke but was sticking out of the head. To get room they did the trick of unbolting the trans mount and the passenger side engine mount and moved the engine over. All is back together but started throwing the 53,132, 2195 and 2196 codes, engine seamed to run fine though. Before bringing it back in I decided to check for any simple things, vacuum leaks or connectors that might have been knocked loose. At first I thought this was a good candidate for a vacuum leak but it turned out to be a vent for the front hubs.
My next thought was that maybe the pass side upstream oxygen sensor got knocked during the work and was now shorting out. It is very tight on that passenger side! Truck has 102,000 miles so they were at the end of their lives. I decided to just replace all 4 with OEM units. I used one of the oxygen/mapp gas torches from the hardware store and a 7/8 in wrench. The drivers side was easy and I did not have to remove the drive-shaft like some write-ups discussed.
Although doing that would give plenty of room. Pass side downstream is fairly easy, upstream was a bit tougher. I took out the inner fender skirt and loosened the trans dipstick tube. That gave just enough room for my large hands to reach in and turn the connector so the sensor side of the plug faced out. I used a pick and fashioned a hook out of a coat hanger to pull the connector apart. That ended up being the hardest part. Putting a good amount of heat into the sensor bung quickly made all the difference in getting them out.
Here is what the upstream pass side sensor looked like. Could not see it from below or from the wheel well.
The codes are all gone now (were coming back after one drive before) so I think the sensor was the issue.
Ford F-150 (2004-2008) :: 2006 - Airbag Code 42 Flashing
2006 F150, FX4, 5.4, super crew. Had the infamous airbag code 42 flashing at me the other day, replaced the sensor in the front of the radiator support, and am still getting the same code. The old senser had some corrosion inside the sensor itself, but the connections were clean on both the sensor and the pigtail. Is there something I may have missed?
View 3 RepliesFord F-150 (2004-2008) :: 2006 - Keyless Entry Code
I just bought a 2006 Texas Edition F150 with key less entry but the instructions and assigned codes did not come with it. How do I find what the code is to operate the system?
View 8 RepliesFord F-150 (2004-2008) :: 2006 - Axle Code H9 Means?
I have a 2006 F-150 Lariat with a 3.55 Ratio axle. What does the Axle Code H9 mean?
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Code P0345 - Low Oil Pressure
I have been having quite a rough time fixing a P0345 code on my 06 F-150 w/5.4 w/85,000. This truck has gone to a Ford dealer every 5K for the oil change/checkup etc.
Long and short - P0345 Code @ approx 83,500 miles, rough idle once the engine was up to temp and it would clear if you bumped the skinny pedal.
I have replaced the following:
--Both Cam Phasers
--Both VCT Solenoids (they both had holes in the screens - see this post [URL] ....
--Passenger side Cam Position sensor (I broke it pulling it out to do phaser swap)
--Spark plugs - SP515's
Issue was still present so then I replaced:
--Complete Timing chain set (Chains,Gear, Guides and Tensioners) - Drivers (left) side tensioner collapsed.
Once all back together and running the code is still there so I finally installed a REAL electric oil pressure gauge. Turns out I only have about 15psi at hot idle and 50psi when driving etc.
I am at wits end, because at this point I would have to guess that the engine is junk... Either a bearing is shot or whatever... Do I take the 3-4 hours to drop the pan to potentially see what is going on? Or just drop some 15W40 in the engine and trade it in?
Ford F-150 (2004-2008) :: 2006 - Code P2207 - O2 Sensor Replacement
I have a 06 F150 and I am getting the P2207 code on it. Sounds like a O2 sensor has gone bad. From reading a little about it online, it sounds like there are (3) different ones on the truck. Is there any way of knowing which one has gone bad or do you just have to replace all of them? How hard of a job is it, do you need a special tool to remove the old sensor?
View 1 RepliesFord F-150 (2004-2008) :: 2006 - Misfire On Cylinder 1 / Code P0301
I have a 2006 F150 with a cylinder #1 misfire only code p0301. I have done new spark plugs, new coil packs, and new fuel injector on cylinder #1 with no luck. What to do next?
View 5 RepliesFord F-150 (2004-2008) :: 2006 - Random Misfire Code P0316
Friend has a 2006 with the 4.6 motor. From time to time he gets a random misfire code ( I think its 0316).. He claims it will only do it when the gas tank is less that half full. I don't see any correlation between fuel level and the code. I am going to check fuel trim values, etc, when the code is set, this weekend.... all I can assume is low fuel pressure which sets the code... Any problem with the pressure module or fuel pump / discharge hose that is related to low level in the tank ?
View 3 RepliesFord Super Duty (1999-2016) :: 2008 - No Power / Throwing Codes P2196 And P2198
2008, 5.4 liter, F250, with 6-speed manual transmission
My truck was running fine until I decided to clean my engine. I just wanted to remove the extra dust covering it, so I used a low pressure garden hose to wash away the dirt that had accumulated last winter and spring.
It started throwing codes like Fuel Rail pressure sensors, P0191, P0192. I had no power, and I could hardly drive the truck.
I figured I had some water in some connectors, so I checked around, but could not detect any moisture.
I kept driving it, and the problem got less severe. One warm summer day, I drove my truck for about an hour trip, and everything looked fine after this. Problem never came back.
I was even noticing that it was better on gas that ever before, I was doing 11liters/100km, in city driving.
Until one day (2 months later), I had to disconnect the battery to do some servicing on my truck (more that 30 minutes), and it started to run crappy again, having some piston misfire, throwing codes P2198 and P2196, (O2 sensors). No power, if I am very gentle on the gas pedal, I can manage it, but as soon as i try to accelerate, runs like crap, black smoke coming out of the exhaust.
The problem comes and goes, sometimes, the problem stops, and I can get going, no issues. Air filter is clean, even tried with no air filter, no differences., but it really sounds like bad air/fuel mixture.
Accent RB (2012+) :: Check Engine Light Turned On / Code P2196 Always Comes Up
I love my car 2012 Hyundai Accent GLS but once it hit 60K miles, the engine light came on and it has been eating gas. I get up to 160 miles per tank now. My MP fluctuates from 12-25 MPG. I literally watch it jump when I fill up the car, then a few miles later, it drops again. Code P2196 always comes up. (stuck rich)
Dealer advised me to do fuel system flush.
Dealer replaced upstream o2 Sensor
Dealer replaced Check Valve
New Spark Plugs last Fall due to hearing really loud spark knocking... and also re-gapped last week. Now I can hear them slightly again.
Engine light just came back on after almost 200 miles.
Reading some other threads- apparently this seems to be a known issue for my car.
I am wondering if I should try replacing the downstream o2 sensor.... OR consider trading my car.
Ford F-150 (2004-2008) :: 2006 - No Power / Rough Idle / Random Misfire Code
Have an 06 F150 5.4 3v with no power. spark knock. rough idle. wants to die while driving, and random misfire code. Have replaced fuel pump, filter, coils and plugs. What to check next? Already thought of EGR - it doesn't have one.
View 4 RepliesFord Escape / Hybrid :: 2006 - At Idle Engine Run Around 1000 Rpm - Error Codes P0113 And P2196?
Have a 2006 ford escape, at idle the engine will run around 1000 rpm's and then regularly dip down 500 rpm's. Through the intake i can here a distinct "thwap" when the RPM's dip.
Only codes are
P0113 and P2196
Problems accelerating sometimes, Took it too a shop they said bad exhaust valve on the backside of the engine either 1-2-3. They said needed engine work, but said they didn't know where the bad valve was so i don't even know how the made the determination. Vac gauge at idle also indicates bad valve.
However, when i give it even the smallest amount of gas possible the engine smooths out and vac gauge reads totally normal and steady.
Ford F-150 (2004-2008) :: 2006 - Got Code P0743 - Overdrive Dash / Engine Lights Blinking?
On my 2006 Ford F150 2WD, v6 automatic, the overdrive dash lamp is blinking, I get a engine light and the code I get is a P0743. That indicates the solenoid or wiring is bad, but everything works just fine. The transmission is running fine, clear fluid - no odor. The overdrive works and the truck shifts like new. When I start, the "OD-OFF" light immediately starts blinking and never changes. I can activate the OD normally and it doesn't effect the blinking light.
Where to start? I suspect that since all is functioning well, the issue is with the signal to the ecm? By the way, I can clear the code so that the engine light goes off, but the "OD-OFF" light remains blinking.
Ford F-150 (2004-2008) :: CEL On With B1484 Code - Fix?
Check engine light came on this week. Said B1484 code Brake pedal open circuit..
I tried disconnecting the battery for a few minutes to reset but light came right back.
Ford F-150 (2004-2008) :: MIL Code P0171
What a p0171 is?
View 2 RepliesFord - Explorer :: SES Light On / Codes P2196 And P0405
I have an 03 Explorer 4.6L that is running bad. The code was P2196, I changed B1S1 O2 sensor and cleared code. A few minutes later the SES light was on, I checked codes and now I have P2196 (again) and P0405. Why I was only getting the O2 code and now I have it again after replacing it and a new code (0405 EGR)..
View 14 RepliesFord F-150 (2004-2008) :: Getting P0605 Code Every Now And Then / PCM ROM Error
I just bought a F150 with 103,000 on it. The engine is a 4.6. I get a P0605 code every now and then which doesnt effect performance. I erase the code and it doesnt appear again for maybe another 100 miles.
I suspect a loose connector but not sure. Looked up the code and it reads PCM READ ONLY MEMORY (ROM) ERROR. My question is what does the PCM operate? And wheres a good place to start troubleshooting?
Ford F-150 (2004-2008) :: Airbag Flashing Code 42 Now 16
Ok I have a 2004 F150. The airbag was flashing 42, I have since replaced that sensor and now its flashing code 16. I have searched everywhere and cannot find the answer to my question. Any clue as to what this code is trying to tell me. Lost 1, this is lost 3, are you lost 2?
View 4 RepliesFord F-150 (2004-2008) :: 2005 FX4 5.4L - B6 Axle Code
Unable to decode the B6 axle code on my f150,5.4 L,FX4 2005. Clearly located on the drives side door is the label 'axle' directly below that is B6 ! Unable to locate a listing for this code any where?
View 3 Replies