Ford F-150 (2004-2008) :: 2007 - Hard To Shift From Park Even On A Flat Surface
2007 F150 supercrew, sometimes it doesn't want to shift out of park even on a flat surface where its not torque locked.. is there an adjustment i can do myself?
View 2 RepliesFord F-150 (2004-2008) :: 2006 XLT Hard To Get Out Of 4WD Sometimes
I have a 2006 Ford 150 FWD XLT. So here is the problem. I sustained right front damage in an accident and 4WD worked prior to and after the accident (before going to the shop). Before the accident it would easily lock into 4WD but would sometimes have trouble getting out of it. When I received the truck back from the shop and went to use 4WD a week later nothing happened No lights no nothing. I tried it in neutral, drive and reverse. I took it back and they said it was the shift motor and not related to the accident so they couldn't fix it. So I just bolted a new one on and still nothing. I checked the solenoid and it appears to be working. I also checked the fuses and still nothing. The shop did replace the right front hub assembly.
View 1 RepliesFord F-150 (2004-2008) :: 2006 4.6L - Hard To Start When Its Below 50F Outside
I have a 2006 4.6L that's hard to start when it's relatively cold outside.
Normally, when it's warm outside, I can barely bump the starter, and it starts right up. But when it's cold outside, it usually takes 3 or 4 2-3 seconds of cranking before it starts. Even then, it has a really rough "about to die" idle, until about 10-15 seconds, and then it idles without a problem. Once it's running, it runs great.
It has 79k miles on it, and all I've done to it is put in a throttle body spacer, and a K&N filter. I've read a few posts from people that have had similar issues, that had K&N filters, but their problems have been more consistent. Mine only seems to happen when it's first started.
As far as I know, the plugs have never been changed, as with the COPs. I've heard about a vacuum line running to the throttle body may be the culprit, but haven't been able to find any more details on that, like where the line runs to, possible replacement part number for it, etc.
Ford F-150 (2004-2008) :: 2006 V8 Cutting Out / Hard To Start?
I have an 06 F-150 4x4 with the 5.4L Flex Fuel V-8. The truck has 133,000 miles on it. This morning, the truck was very hard to start. It took me 4-5 times of cranking the engine for 30 seconds or more before it started. Once it starts, it idles fine. Out on the road, the engine cuts out and the truck bucks pretty hard. The truck doesn't die, and the issue is intermittent. I changed the fuel filter less that 10,000 miles ago. The Check Engine Light has NOT come on. What could my problem be?
View 7 RepliesFord F-150 (2004-2008) :: 2006 - Hard Steering / Heavy Feel
I've got an '06 F150 and the steering isn't right with it. It has had a heavy feel and is almost like the power assist is only working half as good as it should. It's been like this for a couple months. I 've had all four ball joints and the steering rack replaced in the last month. It had the heavy steering feel before and after everything was replaced. It also doesn't recover itself on sharp turns, I have to turn the wheel back as I complete the turn. Could it be the power steering pump? I thought it was a mechanical device and it either worked or it didn't, maybe they get weak?
View 14 RepliesFord F-150 (2004-2008) :: 2006 - Auto Hubs Making Noise / Cannot Shift From 2wd To 4H While Moving
I recently purchased as used 2006 F-150 Lariat 4x4 with 77K miles. I am having an issue with the shift on the fly, I had a vacuum leak that was causing the auto hubs to make noise on occasion but it has never allowed me to shift from 2wd to 4H while moving. I have replaced the IWE solenoid and repaired the vacuum leak but it still will not engage while moving. The light for 4H comes on but the hubs will not engage. The dealer where I purchased the vehicle is not a ford dealership and whey have been trying to solve the problem but to no avail.
View 3 RepliesFord F-150 (2004-2008) :: 2006 - Truck Downshifted And Falls On Face Under Hard Acceleration
I have an 06 F150 2wd with the 5.4. Today on my way home I had to cross traffic while getting on the highway and had to get on it a bit. When I gave it the gas the truck down shifted then just fell on it's face until I let off the gas a little then it sped up like normal. It normally runs great but I don't get on it much. I just don't see why It runs great until I try to get a move on.
View 3 RepliesFord Ranger / B-Series :: 2004 - Hard To Shift Into Low Gear
It's a 4 cylinder 5 speed, and once or twice a day when the light turns green and I go to put it in low gear, it just doesn't want to go into gear easy. It's like the syncro isn't happy or something. The clutch is depressed all the way and not dragging.
View 14 RepliesSonata NF (2006-10) :: Hard Shift From 3rd To 2nd Or 1st During Deceleration
Recently my wifes 2009 Sonata limited has started having a hard "clunk" when braking. It feels like a hard shift from 3rd to 2nd (or 1st?) during deceleration. Only really occurs when moderately cold and only during the first 10 miles or so of travel. What I should check?
View 4 RepliesAccent MC (2006-11) :: Hard Shift From 1st Into 2nd Gear
I have brand new ( 800KM ) Accent with Automatic transmission and I noticed that it shifts from 1st gear into 2nd kinda rough. By this I mean that I can feel shift pretty good, and I don't feel shifts from 2 to 3 to 4. I don't rev engine high, typically shifts occur when engine revs around 2000 rpm.
I am not sure if it is a transmission defect or this is the way it shifts? May be I need to breaking my car first and it will go away?
Subaru - Forester :: 2006 - Hard To Shift At Speeds Of Between 15 - 25 MPH
I have a regular mechanic that I use, except for a recent plug change. The car now feels like it is shifting awkwardly, and at speeds of between 15-25 MPH, it's as if it has a hard time choosing a gear. Can improperly installed plugs have an impact on this sort of thing?
View 1 RepliesElantra HD (2006-10) :: 2007 - Hard To Shift Into 1st / 2nd Gear
I got a new clutch & shift cables & fluid professionally done one year ago. I have only put 5k miles on it since. In the last two months the... gate/slot for 1st & 2nd have been getting worse n worse. All gears show sporadic rough shifting (read rough as a clunk or one tooth grind), but 1st/2nd are consistently rough & the gate seems to be getting narrower...
Environmental & operating temp, do not noticeably affect these symptoms.
Ford Transmission :: E4OD - Hard 2 To 3 Shift Caused By Slow 1 To 2 Shift?
This is on my 7.3PSD. I've observed that the 1-2 gear shift drops about 1,000 RPMs and takes a good half second or longer to do so when given a lot of accelerator pedal input. And then the 2-3 shift is a very quick and harsh shift.
If I am accelerating gently the 2-3 shift is as unnoticeable as the 1-2 shift is quick. Is the slow 1-2 shift causing the trans to protect itself and affecting the 2-3 shift? And if so, what do I do to resolve all of this? I changed the trans fluid a week ago and there is no change.
Lexus GS 2006-11 :: Hesitation Developed In GS460 / Hard To Shift
A major throttle hesitation has developed in this car,that is so bad, sometimes when you put the pedal to the floor it doesnt want to accelerate at all. Feels like the car has a bout 25% power, it seems to shift very weird also, its like the car is trying to keep the rpms very low. I am not positive but it seems to occur mostly when the car is first started and still cold,or on very wet or humid days?it feels like the car is activating the traction control and the throttle plate is not opening all the way at wot?
Notice: already change spark plugs + A/T oil + filter
Accent MC (2006-11) :: Manual Transmission - Hard To Shift From First Gear Sometimes
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
Ford 6.0L Power Stroke Diesel :: Torque Shift Trans / 4 - 5 Gear Shift Under Hard Acceleration
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 RepliesAzera TG (2006-11) :: Occasional Hard Shift While Accelerating From A Signal Light
On my 2006 Azera Limited with about 27,000 miles on it. Occasional hard shift issue. Normally the car is only driven 10 miles a day to and from work no problem. But on longer trips have hard a few instances of hard shift.
The first time this hard shift bump occurred was when I was driving on city streets 2 minutes after getting off the freeway after a 2 hour drive. On a scale of 1-10 this was a #5 bump like feel followed by a #3 bump in the next few minutes while accelerating from a signal light. There were no further bumps that day, even after another 2 freeway drive.
The second time the #3 bump happened was on an on ramp after a 3 hour freeway drive and a short rest stop. No further bumps that day even after another 3 hour freeway drive.
The last time this #3 bump happened was on a city street after a 45 minute freeway drive. No further bumps on the return trip. I am not sure which gears this bump happens between.
I have no MIL set. So I took it too a transmission shop and they could not find anything wrong but said there was a code C1616 CAN Bus Off Failure. His opinion was that this problem maybe an electrical issue.
Accent MC (2006-11) :: Hard / Jerky Shift - CEL Showing Code P0717
My 2009 Accent started doing the Hard/Jerky shift problem that I seen discussed in the forums. Had check engine light, scanning showed a code P0717. My question is, which sensor should install?
View 4 RepliesAccent MC (2006-11) :: Hard To Shift Into Proper Gear At Different Speed Ranges
My 2008 seems to be having some intermittent trouble shifting into the proper gear at a couple of speed ranges.
Occasionally I'll start it up and pull out of a parking space (or leave a stoplight) and it feels like it's stuck in 1st well after it should have switched to a higher gear (I sometimes feel the upshift at about 10* mph). If I continue accelerating and hit about 40-50 mph, once again it appears to stay in the current gear instead of shifting.
When this issue is happening, the car feels even more underpowered than usual and takes way more throttle than it should to accelerate. This results in a cruising RPM of 3.3-3.5k at 60 mph. At that speed the engine would normally be doing about 2.2k RPM. Similar power and RPM conditions exist in the lower-speed range, too.
This whole thing is usually preceded by a rough shift into gear (D or R) when I first start the car. It's always had a slight lurch in the appropriate direction as I take it out of park, but this is really noticeable.
If I stop the car and come back in an hour, it (usually) appears to have reset itself. I can drive around and the transmission control is as good as always.
This has been going on for about a month, with an episode maybe every week or two. I took it to a shop and they didn't find any problems (I told them about the weird shifting and lack of power).
Does it sound like this is what's happening (it's not getting into the right gear)? Thoughts on what I should do? I can't really remember the speeds.