Ford F-150 - 1997-2003 :: Truck Is Misfiring / Blown Head Gasket Cylinder 6 On Driver Side
Ok I got this truck from my mother-in-law for free with a blown head gasket cylinder 6 driver side. I did the replacement had the heads machined put it all back together by the book. Now I can't get it to fire on all 6 cylinders only 5 I think. Thought maybe bad gas (it sat since late November) put 5 gallons (over double the gas) fresh gas and half a bottle of b-12 chem tool. Dubble checked all plugs wires connections (coils plugs wires all new). I drove for about 10 miles oil pressure and temperature stayed perfect but no change in running truck shakes a lot and no real power. Don't sputter or backfire no engine codes other than imcr bank 2 open. Engine is 4.2l v-6 170k miles.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Ticking Noise Coming From Driver Side Of The Engine
So I have a ticking sound that has me puzzled. I thought it could be coming from the drivers side of the engine. This weekend, actually on Monday I decided to do the hot re-torque on the diver side. I warm up the engine for about 15min and have at it. I had put this off for weeks because it has been way too hot. Dam it was still too hot, I was sweating buckets. I had to stop several times to clear the sweat off my head my eyes my shades .I torqued everything to spec and nothing moved.
I went to 125 inch lbs and I got movement on the rear two injectors. I gave them about 1/2 a turn and stopped. I put everything back together, I used hair spray form the 99 ct store. It seemed OK. Fast forward to Tue. I needed to be sure so I went for the boost leak test. Here is my concern. I was going to test to about 30 PSIG, but I ended up at about 40 psig and I forgot to disconnect the MAP sensor! How likely is it that I damaged the sensor, and how can I tell? She is pretty stock and does not have a boost fooler to protect the sensor. Nothing popped and I did not leave the the HP on very long.
Ford Super Duty (1999-2016) :: Oil Leaks On Driver Side Cylinder Head
I have a '97 f350/460 efi with 210,000 miles on everything. the only oil it leaks is driver side cylinder head (very little). And that is my fault, a little impatient when changing head gaskets. Its gonna outlast me I am pretty sure. Anyway, fords rock...
View 4 RepliesSanta Fe (DM - 2013+) :: Rattling / Ticking Noise Coming From Driver Side Door
I purchased a brand new 2014 SFS 2.4L Luxury just a week ago. I have noticed rattling/ticking noise coming from the driver side door. If I press againt the door with my elbow, the noise stops.
And here is the weird thing, I can hear the noise in the morning when the car is cooled overnight (parked in underground garage). But it does not happen when the car has been parked under the sun for a long period of time (in 25C/77F). So basically, I hear it on my way to work and it disappears on my way home.
Ford F-150 - 1997-2003 :: Best Way To Clean Cylinder Head?
whats the best way to clean a 97 f150 5.4 cyl head
View 2 RepliesRam / SRT10 :: Ticking Noise Coming From Front Driver Side Wheel When Touch The Brake Pedal
I have a 2001 ram 1500 4x4. For the past 2 weeks, when I touch the brake pedal I can hearing a ticking noise coming from the front driverside wheel. The ticking frequency is speed dependent. I had the brakes replaced, and the shop could not find the ticking noise. The truck performs get and there are no braking problems other than the ticking sound, but now for the strange part...
My abs and brake light are now coming on. However, as soon as my abs and brake light come on, usually on the freeway around 65mph, the ticking noise from braking is gone. So with no abs and brake light, brand new brakes tick at the slightest touch of the brake pedal, with the ticking freq. equal to wheel revs.
With abs and brake light on, no ticking. Plus the shop said that I only have abs in the rear.
Ford F-150 - 1997-2003 :: Sensor Broke In Cylinder Head?
I have a 1999 Ford E150 4.2l. My cylinder head temp sensor was dangling but still connected to the sensor... the connector was loosed from the filament but was still connected by exposed metal pins.
I figured I would replace it like i did to my ECT by the Water Pump. So I pulled the connector out and it started to leak...a little. and when I put the socket on it I instantly broke the sensor flush with the Cylinder Head.
I researched on here and found many people believe the CHT gives info to the Dashboard Gauge and the ECT is used by the ECU. I thought that was correct because I had ECT readings from my scantool...and my Dash Gauge never worked. When I found the dangling CHT I figured it was never working.
So I JB welded CHT hole. figuring i would fix it properly later. I replaced the ECT and expected everything to go back to normal.. No gauge reading on dash and a scan reading with no codes.
I want to replace the CHT sensor properly. Do I HAVE to remove the manifolds. Or do you think its safe to drain the coolant and drill it out. Its easy access. Im worried about all the tiny pieces getting into narrow passage ways.
I am almost 100% going to drill out. Manifold sounds like hell and its getting cold. What sensor controls what? Can I drill it out safely?
Ford 6.0L Power Stroke Diesel :: 2005 - Leak At Fuel Line Fittings Near Driver Side Cylinder Head
2005 PSD 6.0L Excursion ... I suspect that have a fuel leak at the fuel line fittings near the driver side cylinder head. (I believe that it is fuel, since it is so clear, I guess I should collect a few drops and see if it burns vs. coolant.)
It appears to be at the junction of the fuel lines. This is the point where the fluid drops off the tubing and falls down. The clip that holds the two tubes together at the joint is very dirty, the one below them is clean. The tag on the line that is at the joint leaking is part number 3c34-9j338-ag. Is there a o-ring in side the joint? Do I need to replace both hoses of the joint? I can't find any posting of a history of this fuel line leaking.
Or... is it that the joint never fail, and the leak is up tube? I can't see any where it is coming out when viewing it from the top.
Jetta - Volkswagen :: Ticking Noise Coming From The Top, More Towards The Back Of Head
I have this noise on my cars head, its like a ticking noise that is coming from the top, more towards the back of the head.
It sounds like a bad lifter sound and gets louder with acceleration.
I have did a complete head overhaul-changed valves-lifters-seals-guides- also did oil pressure test and everything seems fine.
but he noise is still there? vw jetta 3 1.8i
Ford F-150 - 1997-2003 :: Check Engine Light Is On - Cylinder Head Over Temperature / Overheating
I have a problem nobody can figure out. My check engine light is on. Took it to Advance to have it scanned; came backwith Code 1226, Brake warning light ground short ( not concerned that at this time); Code P1285, cylinder head over temperature; and P1299, engine overheating (this repeated 4 times).
Now for the symptoms: Truck start and runs good, except with engine light on, runs about 4 miles, then the temperature gauge goes all way up, oil light come on (But oil pressure gauge is OK), Have loss power, and heater has no heat. I shut key off, restart, runs perfect, gauges OK, heater OK.
Ford F-150 - 1997-2003 :: Vibration Felt In Steering Wheel / Humming Sound Coming From Driver Side Front
I have a 2003 F150 manual 4WD with 4.6L engine and 165000 miles. When i am driving i feel a vibration in the steering wheel and on floor board that intensifies when i press the accelerator. I do hear an irregular humming that sounds like it is coming from the driver side front. I checked the wheel for any play but it was very tight. i check tie rod ends, ball joints no play. i recently changed both u-joints on the rear shaft and the bearing hub on the passenger side front. Also, the steering feels a little 'wobbly' when i make sharp turns. it almost feels like it is giving. What else should i check?
View 1 RepliesFord 6.0L Power Stroke Diesel :: Fuel Leak Coming From Banjo Bolt Going Into Front Of Driver Side Head
I've experienced a fuel leak, I've checked all over, and the only thing I've came up with so far, was maybe its coming from the banjo bolt going into the front of the driver side head.. I cant really get to it good enough to tell though..
View 6 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Engine Noise / Right Side Cylinder Head Began Running Very Loud
To make a long story short, after replacing the timing chains, guides, and tensioners, the right side cylinder head began running very loud. Think of the usual chatter associated with these engines and multiply it. It was constant, from start up to shut down, and it increased with rpm. Thought at first it may be caused by debris in the oil clogging the lifter(s). After changing the oil multiple times along with different additives and driving roughly 600 miles, the noise persisted. Taking a look down the oil filler tube with a flashlight and with the engine running, the head looked dry. Safe to say at this point I was starving the head of oil.
Removed the valve cover. Removed the rearmost camshaft cap. Sure enough, the oil passage was completely blocked. Inspected everything and there was signs of running dry (minor discoloration, dried oil spots... but no real damage and no play anywhere. Put it all back together and the truck runs quieter than the day a bought it.
Here's the camshaft cap:
This is exactly what it looked like after removal. The material blocking the passage is hard and bridle like plastic.
Sonata I45 (LF 2015+) :: Ticking Coming From Driver Side Speaker
This happens every single day. I'll be sitting in the car, keys in, or keys out of the ignition and all of a sudden you will hear ticking coming from the drivers side speaker. Then silence. Then randomly you hear the damned thing ticking again, sometimes 3 ticks, sometimes 4, sometimes 2, sometimes more.
It's happens sporadically. A different amount of ticks each time. It happens with car power on and off.
I'm assuming this is a build up of static? I have a subwoofer and amp installed and the power cable is running along the drivers side, could the speaker be picking up the electrical interference?
Ford F-150 - 1997-2003 :: Strange Noise Coming From Front Passenger Side Of Truck
Have a 1998 F-150....heard a strange noise coming from the front passenger side of the truck. Parked and turned the wheel and heard something fall off. It appears to be a shield of some sort.
View 2 RepliesFord F-150 - 1997-2003 :: Head Gasket On Passenger Side Number 3 Is Leaking
I have a 97 with a 4.6 Triton motor I need to replace the head gasket on the passenger side number 3 is leaking nothing else is wrong with motor so I have it torn down to timing chain cover and ready to remove. do i have to take the drivers side valve cover completely off to take timing chain cover off or can I take to first 2 studs out of the drivers side front valve cover and side the timing cover off. I just want to replace the passenger side head gasket and get rid of truck.
View 6 RepliesLexus GX 2004-09 :: Engine Ticking Pretty Loudly - Sound Coming From Driver Side
I'm not sure if I've just gotten used to the sound of the car or what but lately, it seems like the engine is ticking pretty loudly. It runs perfectly and I didn't think much of it until my friend commented on it. Sounds like it is coming from the drivers side (mainly).
View 14 RepliesCamry :: 2003 - Oil Leak From Driver Side Head Gasket
I own a 2003 Toyota Camry with 195,000 miles. We have owned the car for about 6 years. It is now leaking oil from the drivers side of the head gasket. The oil has been leaking down onto the exhaust and smoking, and it has been getting worse and worse. This is a second car and is not used much, only once a month for short trips. Is there any temporary fix for this that can maybe get me through a year? Also, I have heard mixed opinions on how hard replacing the head gasket is, does the engine really need to be removed?
View 9 RepliesFord F-150 - 1997-2003 :: Leaking Antifreeze Externally At The Front Of Passenger Side Head Gasket?
Working on a 2000 F150 with the 5.4 and as near as I can determine its leaking antifreeze externally at the front of the passenger side head gasket. Seems a little odd. The coolant is a nasty dirty orange color. With the truck running on the hoist it was dripping very steady off of the very front exhaust manifold bolt.
View 3 Replies