Ford 7.3L Power Stroke (1999-2003) :: 2001 F350 - Swapping Overhead Console With Longer One?
I was wondering about swapping out the short OH console on a 2001 F350 Lariat with the longer one that has two doors for a garage opener etc? Are the clips on the base plate the same? I see the longer console shells on e bay for a little over 100 bucks which seems like a no brainer if it snaps in place of the shorty. Looks like the temp and compass slots are identical.
View 4 RepliesFord Super Duty (1999-2016) :: 2012 - Overhead Console Removal?
How to remove the overhead console on a 2012 F-250 ? I would like to tap into the wiring to power my radar detector.
View 7 RepliesFord 6.0L Power Stroke Diesel :: 2003 F350 - No Headlights / Overhead Console Is Dead
Just bought a 03 F-350 dually today. 6L 4x4.
Headlights don't work , everything else does? Dash lights , taillights , cab marker lights all work. Headlights and front park lights don't?
I also see the overhead console is dead and shows nothing? Plus the ignition turns without a key being in it?
Ford Excursion :: Overhead Console Removal?
How to remove the overhead console in my Excursion? I just want to make sure I dont break it.
View 6 RepliesFord - Mountaineer :: Overhead Console Removal To Replace Burned Out Map Lights
I am working with a 2006 Mountaineer Premium with rear heat/ac, sunroof, and Homelink. I need to remove the overhead console to replace burned out map lights. I cannot determine how to remove the console.
The shop manual has instructions for 2 styles of overhead consoles but not the one in this vehicle. Those 2 styles have a sun glass or garage door opener compartment that you open to access some screws.
This console has the map lights at the front, the controls for the rear ac/heat in the middle, and a panel for the sunroof switch and Homelink buttons at the rear. There is no room for a compartment that opens.
I can get the front portion loose by pulling it down off the clips. The back seems to held in by screws. I do not want to apply much force to avoid damaging anything.
Ford 6.0L Power Stroke Diesel :: Compass On Overhead Console Gone Dead
2004 6.0 lariat ... The compass on my overhead console has gone dead or at least doesn't show anything other than sometimes calibrating ... All other functions miles to empty etc work fine just the compass feature ...
View 2 RepliesTouareg :: Overhead Center Console Removal?
How to remove the overhead center console? I have two false buttons - one on each side of the homelink buttons. Someone pushed on one of them and it popped up inside the console. I've pulled pretty strongly on the console and it comes down about a half inch, and I can see some clips inside holding it, but can't seem to pull it far enough down to get access. I don't want to break the console in half...
View 1 RepliesFord 6.0L Power Stroke Diesel :: No Power To Overhead Console
Just did an interior conversion to my truck from xlt to lariat. I installed a new headliner with the overhead console, took the kick plate off where if it existed would be. Found the harness to plug into but noticed it only had a thicker black wire coming out of it, the harness for the overhead console had around 12 or 13 wires. I don't have a volt meter to test the wire on the truck side. But beings this is my first time installing an overhead console I'm not sure what hardware I need or what I'm doing wrong. Did research on the Internet and there's not much on installing overhead consoles. All I've seen were repairing the circuit board which visually checked and didn't see any cracked solders.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2004 F350 - Overhead Console Missing
Bought a 2004 f350 lariat last fall. Overhead console was missing. Finally got around to replacing the display. Temp, compass works fine, but mileage and distance to empty are way off. Display typically shows 13.5mpg but when manually calculating am usually closer to 17. Distance to empty is way off as well. I did some research but didn't find much on how to recalibrate it. No difference with or without tunes.
View 8 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Power On Overhead Console With Sunroof
2004 F250 - My problem is that it started with no power on LCD (the one that shows the MPG,compass and outside temperature) but if I give toc, toc, toc with my knuckles the LCD works but it went off about 2 weeks ago and stop function,the other things like the sunroof switch and the 2 lights are ok...
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Outside Temp Sensor For Overhead Display
For some reason my OH display decided to show 140 deg F when its 40 deg F outside. Continues to show 140 all the time now regardless of out side temp. In case its the related outside temp sensor sending unit, where it is exactly on an 02. Unless someone has solution may try changing that out to see if that is the problem?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Removal Entire Dash?
I want to remove my whole dash to paint it but i cant figure out what is holding it in,i removed all the black screws from one side to the other the screws under the tabs by the windshield and it still feels like its being held in somewhere underneath?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Rear Fuel Line Removal?
Having trouble figuring out how to remove the rear fuel line from the fuel pump. Doesn't seem to be the type that uses the quick disconnect tool like the front line does.
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Water Pump Removal As A Unit
I have a 99 SD 7.3 with 210K miles. It has the OE water pump, clutch and fan. I am replacing every thing from pump to fan including pulley, thermostat and sensor. The question is can every thing be removed as a unit? I don't see why not but never did one that way.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Ignition Lock Cylinder Removal With No Key
So I have a replacement steering column for my truck and need to swap out lock cylinders. My question is; since there is NO key, is there any way to avoid drilling out retaining pin. If I did drill it out am I entirely screwed'?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Airbag / Steering Wheel Removal
Having searched I believe that I need to remove two torx screws from the back of the wheel to remove the air bag. These have that damned protrusion in the middle so I'll have to find and buy a torx driver just for that job. What size is it?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Doing Clutch - Slave Cylinder Removal
I'm getting ready to swap my clutch and got to looking at the slave cylinder. I read somewhere that you have to rotate and twist it to get it out? Or something else? Also after reinstalling how do you get the slave plastic piece cut that holds the rod in? Or do you just push the clutch?
View 4 RepliesFord Audio/Video System :: Tapping Into Power At Overhead Console
I'd like to stick my Garmin up next to the rear view mirror and not have a wire hanging down. Tapping into power above the overhead console? I should be able to clip the plug off the Garmin power cord and tie into 12vdc directly and tuck the short wire where the rear view wire comes out.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Manifold Removal - 1 Bolt Stuck?
I managed to get the drivers side exhaust manifold and all of its bolts off no problem. On the passenger side I had 1 bolt head that was already broken and I have only 1 other that is still holding on for dear life. I've been soaking it in aerokroil for awhile now and no luck. I tried some PB blaster today because I am willing to try anything. I also tried heating up the bolt with a torch and some map gas but not sure if I am heating it up enough or not. Anyways, everything else has been going great, got the uppipes off and the valley, turbo and pedestal all cleaned up good. Just need to get the last whole bolt and broken bolt out so I can install the new manifolds. What I should try to remove the last 2 bolts. How hot should I get the bolt when trying to remove it? Or should I be heating the engine block?
View 12 Replies