Ford Excursion :: 2000 V10 - Fuse 19 Keep Blowing - All Gauges And Speedometer Die?
I have a 2000 Excursion V10, I keep blowing the #19 10A miniature fuse while I am going down the road. All gauges and speedometer all of sudden die but the vehicle keeps running until I turn it off. When I try to restart she won't fire until I put a new fuse in.
View 14 RepliesFord F-150 - 1997-2003 :: 2000 - No Cruise Or Speedometer
2000 f150 4x4 auto 5.4 .. I have replaced vss and rear axle sensors. Checked all fuses. Did instrument panel test. Gauge sweeps. Still nothing.
View 10 RepliesFord F-150 - 1997-2003 :: 2000 - Starts Intermittently / Dash Gauges Spike To Max Levels For A Second Then Normal
Dad's 2000 F150 5.4 ltr will start intermittently, when it does fire it runs fine, but right after start up all the dash gauges "spike" to the max levels for a sec and then go back down to normal....
Put the Cen-Tec 98614 code reader on and it continues to say "Link error" and I can't communicate to the interface. P.S., I confirmed the Code reader is good by pulling a 420 O2 sensor code from my Toyota in just a few seconds....
I can hear the fuel pump kick in so I doubt that is the culprit. Because of the gauge spike at start up (every time) this problem screams grounding problem, but I don't know where to start. Could it be a faulty relay?
Ford - Focus :: 2003 - Speedometer And RPM Gauges Dropping Down To 0 - No Reading?
I have a 2003 Ford Focus ZX5 automatic with 143k miles on it. Recently I've run into a problem with the speedometer and RPM gauges dropping down to 0, no reading. It is an intermittent problem and has no logical connection to any of the other functions of the vehicle (it can happen while the car is idling, in motion, upon startup, etc etc.) Everything else on the instrument cluster works perfectly fine, (odometer still reads correctly and works, gas gauge is fine, etc). I'm thinking maybe it is an electrical issue since the car seems to be in fine working condition other than that, even when it drops out. The gauges won't start reading again until I start the car up...and sometimes that is not a guarantee. I use this vehicle to commute locally 4 days a week and I've already put a lot of money into new components for the vehicle.
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Gauges / Speedometer And Tach Stopped Working
I have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
Ford F-150 - 1997-2003 :: 1998 - Gauges Not Working?
I have a 98 F150 with a 5.4 auto 4X4. All four of the guages are on the left side of the instrument cluster. Neither one of the 4 work. The gas gauge, the amp meter, the oil pressure, and temp gauge work. the all four just stay all the way down. I've checked all the fuses and the sending units. ONly fuse position number 6 and 30 pertain to the cluster. I took the cluster out too make sure it was plugged in and it was. I know there is gas in it and I know the oil pump is working.
View 4 RepliesFord F-150 - 1997-2003 :: Truck Only Starts After Being Jumped - No Gauges
Ran for a month just fine. Now it will only start after being jumped. Everything worked just fine.... What should I test first?
View 8 RepliesFord F-150 - 1997-2003 :: 2002 V8 - Dashboard Gauges Always Stay In The Same Position
I have an F 150 2002 Trition V-8. I always thought I knew how to read an instrument panel on a vehicle but after being put down by my Ford, I have to rethink this knowledge.
I have noticed over the past 4 years that my volt meter guage on the instrument panel always stayed in the same place whether the motor was running or just the key in the on position. I noticed that a little battery icon kept coming on and going out yesterday. I read the owner's manual and it said something like this indicates your battery is not taking a charge correctly. Well why has the guage not told me anything. Well the alternator has quit but yet and still the guage is still showing me all is well.
I ask a Ford dealer service dept. about this and they do not have a clue. All they tell me is people do not pay attention to the guage but when the light comes on they need. They also said the gauge would work when everything shuts down, but man! I don't need it to work then. I know it's broken when that happens. It quits running.
What is the purpose of the gauge sitting there all shiny and pretty if it is not going to say anything other than "HEY MAN! I am just here looking pretty and taking up space".
I have looked at other trucks and they do the same thing. Nothing .. What is going on with this gauge which undoubtedly does nothing?
Ford F-150 - 1997-2003 :: No Lights To Gauges / Heater Controls Quit Working
I have a 2000 F-150 and my lights to my gauges and heater controls quit working. I checked all the fuses inside and under the hood. All good. I swapped a few relays around and no luck. I tried replacing the headlight switch and that did not work. I checked power to the gauges from the headlight switch and there is no power, I then ran a hot wire to the wire that powers the gauge lamps and they do light up, so it is not a bulb issue. I assume I am not getting power, but do not know where else to look?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F350 - No Gauges Or Throttle
2000 F-350 7.3L no gauges or throttle, I checked the fuses and no luck....
View 4 RepliesFord F-150 - 1997-2003 :: Speedometer Will Only Go To 40?
I have an 03 f150 5.4, it runs fine, shifts fine and will get up to speed. I can go over 40 but the speedo will only work until i get to 40 and then it just stays there. My rpm guage seems to be working fine. I thought it might be the speed sensor/output sensor on the trans but it shifts fine so I dunno anymore?
View 8 RepliesFord F-150 - 1997-2003 :: 2003 - Got Code U1262 - Random Misfire?
I have a 03 F150 with a bi-fuel 5.4 engine an it has 195000 miles. I have had trouble for some time now with misfires. I bought the truck in october of 2011 with 125000 miles and replaced all the coils and spark plugs because it was misfiring badly will running on CNG. It was fine on gasoline and never had any codes. After I replaced the plugs and coils it ran fine on CNG and gasoline.
This summer 2013 it began missing badly at highway speeds only when running on CNG. If I accelerated the miss would go away until I was light on the throttle again.I checked the misfire count and found the bad cylinder and replaced a coil. Then a day later same thing on another cylinder. I swapped a coil from another cylinder and problem went away for a day. Eventually I chased the misfire around all the cylinders on the engine until I had ended up either replacing a spark plug or swapping a coil on all the cylinders. And I still had a misfire. It seemed to be worse on days with temperatures above 90 degrees. Eventually I got it to stop misfiring.
So now 5 months later I am back again with a misfire. This time it is misfiring on both gasoline and CNG and under any throttle conditions, except coasting. I have no codes. And the misfire monitor is sending me around the engine again. I have replaced a spark plug in two cylinders and swapped 4 coils.
I'm ready to buy all new coils, but I want to be sure that it is not a waste of money since the old ones only have 70000 miles on them.
Two days ago I had the misfire monitor saying #4 in the evening and the next day without me having done any work on it it was saying #6. Later that same day it said #7 and I still hadn't done anything other than drive the truck.
I checked the connections at the firewall on the drivers side with the three large plugs that are held in with a 10mm bolt, they looked fine, no corrosion or burnt pins. I checked the connection at the ACFM which also looks good. I will check the connection at the PCM in the next day or so.
Some other problems that may be contributing:
1. I occasionally get a U1262 code (scp fault)
2. Sometimes when I check the misfire monitor it only shows 7 cylinders, sometime 9 cylinders. I am using an Innova 3160 scanner.
3. I have either a leaking valve cover gasket or leaking head gasket, because I have oil dripping from the rear bottom corner of the passenger side cylinder head right above the exhaust pipe.
Ford F-150 - 1997-2003 :: Gauges And Tach Stopped Working While Driving - Wiring Diagram?
I am working on my son's 1997 F-150, 2 wheel drive, 4/6L truck. He was driving it when the gauges and the tach stopped working. I replaced the cluster and it still blows the fuses. The five amp fuse that is specifically for the cluster doesn't blow. It is a twenty five amp fuse that also power the overdrive circuit, etc.
After replacing the gauge cluster I installed a new fuse and the overdrive button on the shifter started smoking. Where I could get a wiring diagram of this circuit so I can see how it is wired.
Ford F-150 - 1997-2003 :: Speedometer Goes Up To 36 Mph And Stays There
My 1997 f150 when I put her in drive the speedometer goes up to aproxx 36 mph and stays there no matter what I do or how fast I drive and then slowly falls back to zero when I shut the truck down. Where can I start, I had someone look at it years ago and the said the cluster was bad. I use my GPS to tell me the speed I am going, everything else works in the cluster.
View 2 RepliesFord F-150 - 1997-2003 :: Speedometer Does Not Move When Accelerate
My speedometer has not been working for months now and it really hasn't bothered me as I go by RPMs, but I am going to make a long trip in a few weeks and I wanted to try to get this fixed.
The speedometer flips over to 100 mph and rest on the opposite side as it should. When I accelerate it does not move until I get over about 35 mph where it will then flip to 86 mph. It will slowly move to 82 mph as I accelerate up until 75, where it will then no longer change. Every once in a while it will start working when I start the truck up, or when I am driving down the road. It has before, within a 30 minute time frame, started working and stopped working 6 times. Currently my ABS light is on, but it has been on long before this started occurring. Every other gauge on my dash works.
I drive a 5 speed manual V6 2003 Ford F150.
Ford F-150 - 1997-2003 :: 1998 - Speedometer Not Working
'98 F150. the speedometer isn't working, all other gauges are. Where do I start ?
View 13 RepliesFord F-150 - 1997-2003 :: Random Misfire Now Won't Start
I have a 1997 F-150 2WD 4.6L V-8 that began having random misfires as I would drive. I was planning on going out today to get the new plugs and coils however when I got off work and pulled into my drive something happened when I went to leave the truck wouldn't even crank it just made a clicking noise. The battery has full power (the radio ect. still works). I am hoping that the problem is with the coils and plugs but if not ...
View 5 RepliesFord F-150 - 1997-2003 :: Speedometer Is Not Completely Dead But Bounces Around
1997 F-150 XLT Extended cab. 4.6L VIN 6, 5 speed manual, 4x4. Replaced speed sensor on transfer case, speedometer is not completely dead but bounces around. Seems to be about 10 mph below actual speed. When I come to a stop say at a red light speedometer drops to zero at about 20 mph or so. Cruise also inop. It seems like whenever I let off the gas to stop or shift gears the speedometer drops down but then goes back up but not to the right speed. It has the mechanical odometer by the way. Everything else seems to be working fine. New speed sensor did not come with the plastic gear so I had to reuse the old one. Not sure if that gear was bad or not, but it was the pink one if that matters.
View 6 RepliesFord F-150 - 1997-2003 :: 2001 / 4x4 - Speedometer Started Cutting In And Out?
I just got a 2001 f150 supercrew 4x4. Speedometer started cutting in and out. Just the speedo needle cuts in and is accurate for a long while then jumps up 10mph then goes back to accurate speed then cuts out and needle goes to zero for a bit then comes back on to accurate speed.
Just the speedo needle is the problem the trip meter and odometer and all other gauges on the cluster works just fine. Do I need a new cluster? Wouldn't be a speed sensor? Speed sensor would just cut off and would affect the odometer too wouldn't it?