Ford F-150 - 1997-2003 :: Idles Fine But Sputters Out As Soon Put It In Gear After Hitting Large Water Puddle
I have a 2002 F150 super cab with the 5.4 liter v8. I hit a large water puddle on my way to work Tuesday. I was going faster than I probably should have been. After hitting the puddle the truck lost power. It idles fine but as soon as I put it in gear it sputters and has no power. Also, the O/D drive light is now flashing. What might be going on with it.
View 4 RepliesPassat (B6) :: Stuck In 3rd Gear After Hitting Puddle / Parking Brake Fault Light Lit Up
Hit a puddle-now car is stuck in 3rd gear... with parking brake fault light lit up. How to fix it? it happened on the highway on the way to work at 70mph . so now i either have to drive home with it the rpms at 4k or get it towed. Car is a 2006 passat with 35000 miles.
View 5 RepliesFord F-150 - 1997-2003 :: 4R70W Trans Fluid Leaking - Puddle Of Fluid Under The Truck
I have a 1997 Ford F-150 XLT 4x4 with the 4.6W and a 4R70W trans. For the past year is has been leaking trans fluid and has slowly got worse and worse. At first the truck would only leak at high speeds (when driving on the interstate for extended periods of time) and now It has gotten to the point where I am adding close to a quart of fluid a week. ( roughly about a quart every 300 miles!). I thought that it was the pan gasket leaking at first, so I flushed the trans fluid (dropped the pan and drained the TC and put on a new filter) put a new gasket on and torqued it all down and added some new Valvoline max life fluid. The first trip in the truck I noticed a puddle of fluid under the truck again.
The pan looked like it could have been a little warped, so I ordered a new pan and a new FoMoCo gasket (the one the came with the new filter was the cheap felt type). I thought I for sure had fixed the truck this time, but I drove it and once again it was still leaking. I checked all that I could before replacing the pan and gasket. I checked the trans cooler lines and fittings (no leaks) I pulled the inspection plug and it was dry (so I ruled out the front pump or TC leaking). The whole underside of the truck is covered with fluid so it is hard to pin point the leak, but most of the fluid drips down on the transmission cross member.
Ford F-150 - 1997-2003 :: 1999 - Cabin Water Leak - Small Puddle In Driver Side Rear Floor Corner
My 1999 F150 Supercab has developed a water leak which I would like to ask your opinions on. Parked on a 20 degree incline during a pouring rain yesterday, I came out to find a small puddle in the driver's side rear floor corner and about an ounce of water pooled in a little lip at the bottom of the rear window in the right corner of the window! Haven't started tearing anything apart yet (and might not be able to myself), but it seems that it is possibly the rear window seal as the window and the outside body area appear to be in good shape otherwise (no visible rust, no seal obviously dislocated, etc).
Also, don't know if it's related, the other day I jacked up the truck with a floor jack under the front crossmember but a bit off center which caused the truck to twist a bit before both wheels came off the ground. While doing this, I heard and felt a loud bang like something broke in the frame! Couldn't see anything out of place and something similar has happened before where a lug of the jack cup had shifted slightly while jacking the vehicle and it caused a loud bang to be heard, but this time it didn't quite feel like it was at the jack but further back.
Could something have "broken" in the truck that I can't quite see and thus this leak has occurred which wasn't there previously or could it just be coincidence that the bang and leak occurred so close in time to each other. I know it's hard to diagnose something like this without seeing the vehicle or really know what happened but I just had to put it out there as part of the events that occurred within the timeline for this leak.
Ford F-150 - 1997-2003 :: Truck Stalls Out In Gear But Not In Park
I had what I was told was the breather (on the drivers side valve cover) snap off. I was able to place a piece of tubing In it and reconnect it. I had to change the #7 cylinder spark plug wire. Got a misfire code and found the wire was loose and corroded. Replaced wire and PVC valve.
My problem is, it seems not to be idling as fast as it was before this happened. The truck stalls out now in gear but not in park. 1997 F150 4.6 ....
Ford F-150 - 1997-2003 :: Truck Stumbles - RPMs Drop When In Gear
I have a 1997 forkd F150 with a 4.6L Romeo engine. I have recently rebuilt the engine and now since it is put back together I am having a issues that i cannot pin point. When the truck is running and in gear my RPM drop to around 500 or below and my oil pressure drops and comes back up when the rpm's come back up this an intermittent problem and I have replaced the IAC valve and every once in a while i get a P0401 code for the exhaust recirculation. I think I am loosing some kind of vacuum. It was not doing this when I tore into the truck. It seems to be running okay not hesitation.
View 2 RepliesFord F-150 - 1997-2003 :: Can't Get The Truck Into Gear With Clutch Pushed And It Doesn't Even Grind
Well here it is I just put a new slave cylinder in my 02' F-150 and once we figured out all the little issues we were having we finally got the truck to fire up!!! Now my problem is that when the truck is running I can't get the truck into gear with the clutch pushed and it doesn't even grind. But when the truck is off it goes through the gears no problem what so ever. When we did the slave cylinder while we were in there we just replaced everything clutch, pressure plate, flywheel, rear seal, and pilot bearing. We figured that since all the shops were quoting me 800 and up for just doing the slave that since were in there we might as well do everything since nothing has ever been replaced yet. My question is why will the truck not let me shift into gears when running but no problem when off. Oh and yes the system was bled after doing the slave actually twice so far.
View 5 RepliesFord F-150 - 1997-2003 :: Truck Dies At Stop While In Gear - Code P0443
I have a 1997 Ford F-150 with the 4.6L auto trans 189,000 miles
Ok.. there was no problems until the other day when I unplugged the positive side of the battery to replace it's clamp. I Put the new one on and drove to the store but when I came to a stop, the rpm's dropped to 0 and the truck died. I restarted it and every time I would come to a stop it would die unless I give it a little gas also if I start the truck and leave it in park it idles fine until I give it some gas then let off.. the idle drops and dies! If I give it a little steady gas the idle will return to normal.
The check engine light works fine but never once lit up because of this problem! I used a code scanner and if the truck was off and the key forward, it would have no codes. With it running it had the code P0443. I found and replaced a blown fuse and still have the same problem but it reads no codes at anytime. I checked all the vacuum hoses and there seems to be no leaks and the mass airflow sensor looks clean. I have allot of miles but it has been taken care of well and has had a ton of parts replaced over the last few years.
I am wondering why this happened out of the blue and If there is something I am missing that I should be looking at. I don't want to replace the purge control valve if thats not the problem.
Ford Super Duty (1999-2016) :: 1997 Truck Won't Shift Past 2nd Gear Top Speed 35 Mph
Ok so I went mudding this past week, and I put my 997 7.3 truck in 4x4 had fun then took it out of 4 wheel now it won't shift past 2nd gear top speed 35 mph.... It still has all the power revs up Rpms fine but it won't go faster then that.
View 8 RepliesRodeo :: 2000 Isuzu 3.2L Stalled After Hitting Puddle?
My Rodeo stalled after hitting a nice sized rain puddle on Friday. It was mainly on the passenger side. This happened to me about 10 months ago and I had it towed to a repair center and was told it was the timing belt. Few days and $600 later i got vehicle back. Ran fine till this puddle. Is it possible this could be the timing belt again? All the research I have done has not said this was an option. I need diagnosing this problem. The vehicle has been sitting for a few days and will crank but not turn over.
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Truck Cranks Over But Won't Start
Last night my boyfriend took a friend to the check cashing store, truck ran fine. shut it off, and when he came out the truck would not start. it cranks over but won't start. Took ignition coil off and had it tested but its fine. What else could be wrong or what can i do to try to get it to start again.
View 5 RepliesFord Super Duty (1999-2016) :: Truck Pulling To Right When Hitting Brakes And Occasionally Brake Would Get Hot
My 02 F250 has me baffled. For a while the truck would pull to the right when hitting the brakes and occasionally the brake would get hot. To try and remedy this I put a new caliper and hose on the right front corner a new hose on the left front side. The truck still pulled right and the pedal got spongy even after bleeding the brakes 3 times. I got to checking the rest of the brakes and found a seized slide pin on the left rear. Got that fixed and still pulling right with a soft pedal. I've checked all of the sliders and none are seized. I am lost and I cant stand the soft pedal!
View 4 RepliesFord F-150 - 1997-2003 :: 1999 - Truck Dying Immediately Upon Startup
I've recently begun experiencing a problem with my truck dying immediately upon start up. It's a 99 5.4 and it will act like it's starting normally but then will idle down and die. If I gas it to 4000-5000 rpm it will eventually return to normal idle and run fine. At first it was once a week and then every day, usually upon the second start of the day but today it happened twice and I suspect it will become more frequent. What to check that doesn't involve a Ford Dealer?
View 3 RepliesFord F-150 - 1997-2003 :: 1999 Truck Rumble And Died When Trying To Start
I came home from work truck was running decent got up in the morning to start it up. Tried to start up was real rumbly and died got the same twice then went to just cranking over not getting anything else tried spraying some starter fluid in air and it would try so assuming its firing abd possibly gas related ...
View 4 RepliesFord F-150 - 1997-2003 :: Shake Through Steering When Hitting Road Cracks
My 02 F150 4x4 at times gets a shake through the steering when hitting road cracks, pothole fills, etc. Would installing a steering damper system work or am I missing something to check in the front end. Ball joints are good, all steering linkage good, new shocks all around, control arm bushings look good and don't seem to shift when prying with a bar. Also changed all sway bar bushings and links. Maybe the control arms just have to be changed with 103,000 miles on it even if they appear OK? What about using an aftermarket steering damper on a stock F150? My long gone 82 GMC 4x4 had one from factory but it was also a solid axle setup.
View 4 RepliesFord F-150 - 1997-2003 :: 1999 Truck Randomly Stutters When Driving On The Highway
I just bought a 99 f150 it has 257000 miles on the truck, and a motor and transfer case from an '01 with 215000 miles. I'm not sure about the maintenance on the truck but when I'm on the highway the truck randomly stutters. I was thinking it was coming from the tranny because the tranny was overfilled by almost a quart but really not sure.
View 7 RepliesFord F-150 - 1997-2003 :: 1999 - Anti Theft Kicked In And Truck Won't Turn Over
1999 f150 4.2l v6.. The anti theft system has kicked in and my truck won't turn over, the stereo won't turn on, the lights don't work. How can I fix this?
View 6 RepliesFord F-150 - 1997-2003 :: 1999 - Truck Throwing P0174 Code Intermittently?
I have a 1999 F-150 with the 4.2L engine. I recently did a motor swap as the original motor was bad. I bought this truck as a project truck and have enjoyed working on it.
When I did the engine swap back in May of this year, it took a while to work out all the little bugs and quirps. However, after a while of running the truck it threw a few codes. I replaced a lot of the emission components and no more codes for several months until last month the truck started throwing the infamous P0174 "too lean bank two"... I have replaced the pcv valve and all the hoses to include the little rubber boot under the front of the intake, all 4 O2 sensors, MAF sensor, EGR, DPFE, IAC valve, new wires and plugs to include coil pack, fuel pressure regulator, and all the vacuum lines that are under the hood.
The truck runs fine, has power, but about every couple weeks or so it throws this P0174 code. I know there are alot of threads on here about this problem and I have read many of them. It only throws the P0174 and not the P0171. I am wondering if there could be a problem specific to "bank 2" that I am over looking.
Ford F-150 - 1997-2003 :: 1999 - After New Alternator When Headlights Turn On Truck Shuts Off?
I bought a 99 f350, that already had HID's in it, i found out i was running the wrong batters (weren't 800 cold crank) I just had to replace the alternator. Ever since the new alternator when i turn on my headlights my truck shuts off. IT fried my IDM and i just put a new IDM and 2 new batteries in it today. Thinking i had fixed the problem i drove around no issues, finally i was leaving someones house and turned on my lights, and truck shuts off!!! It restarts but now im trowing a code!!!! im guessing the HIDs are wired wrong and that's why its shutting down the truck but OEM IDM from ford is 1300$!!!!! brand new one installed today,
View 5 Replies