Ford Excursion :: Rear Driveshaft To Avoid Vibration?
So I have 3 rear u joints and a vibration. I swear I read some where that there was a change to the rear shaft to aid in vibrations. So if that's the case could someone point me in the right thread or tell me what one to use. I have access to both....
View 14 RepliesFord Super Duty (1999-2016) :: Rear Driveshaft Woes / Vibration At About 45 Mph
When I bought my 05 350 dually it had been wrecked, the rear diff was under the bumper and most of the rear suspension, including the back part of the rear drive shaft was in the bed of the truck. I have gotten everything back in place, and have driven the truck for a few weeks, but I knew I was going to have to replace the ujoints because there was visible damage to one of the caps. I have also had a vibration at about 45 mph. I had no way of knowing how the original driveshaft was oriented at the slip yoke so I went with best guess. Now in my research I read that if the driveshaft is not put back exactly in the same position vis a vis the slip yoke it will be out of balance.
Also if the drive shaft is dropped it is scrap, and if I have any lift on the truck {it had 4 inches when I got it} the whole thing will shake itself to pieces. Most of the answers to other drive shaft questions talk about taking things to a good driveshaft shop. No such thing here in the vast stretches of My state. I am pretty much on my own as far as building or repairing this thing. Is there any way to determine how the shaft was originally oriented? I also have some damage on the end of the yoke and will have some trouble getting the ujoint apart. Is the shaft now junk? And if I get an ebay replacement, how do I tell if that shaft is in the right orientation?
Ford - Explorer :: 1998 - Clicking Noise Coming From Front Driveshaft?
I have 98 ford explorer sport 4x4 does has a clicking noise coming from the front driveshaft that connects the transfer case to the front differential. At first we thought it was the front drivers side cv joint which we replaced. nothing changed. there is still a noise apparently coming from the front driveshaft. we can not tell if it is the front differential or the transfer case itself. The noise is being transfer through the front driveshaft. It sounds a bearing is going bad.
View 1 RepliesFord Aerostar :: 1997 - Rear Differential / Driveshaft Making Clicking Noise When Put Into Gear
My 1997 4.0 Rear Wheel Drive is making a clicking noise when it is put into gear or when it switches from drive to reverse and vice versa. Sound is coming from the back of van. Does not make noise all the time. Drove 50 miles last night with no problems and minimal clicking. Could it be U-Joints going bad? Or is this a different problem?
View 6 RepliesFord 6.0L Power Stroke Diesel :: 2007 - Magnaflow Exhaust - Down Pipe Causing Vibration And Noise?
I just got a 5 inch turbo back Magnaflow stainless exhaust system installed on my 2007 F 450. The downpipe rests directly on the firewall and causes a horrible vibration and noise at times. I have been on the phone talking directly with Magnaflow trying to resolve this issue
View 6 RepliesFord 6.7L Power Stroke Diesel :: 2011 F250 - Vibration / Change Driveshaft?
Truck has just over 5000 miles on it. Had the tires road forced, no luck! Took it to the dealer ford said replace the tires 2 at a time (r then f), picked it up yesterday no better and said that ford wants to put a new driveshaft in it!
View 14 RepliesFord Super Duty (1999-2016) :: Vibration - Fluid Coming From Front Driveshaft At The Tcase?
On my way to see my folks and I started feeling a vibration like driveshaft or wheel bearing between 45-55 mph then at about 75 then BOOM! Pulled over and found a pool of ATF thought my stock 4R100 just bit the dust but looking at it the fluid is coming from the front driveshaft at the Tcase. My hubs are unlocked and my ESOF is in 2HI but I assume my tcase was locked. Also since the tcase is probably screwed I'm goin to do the 271 with manual hub swap, how hard that is?
View 10 RepliesFord Super Duty (1999-2016) :: Vibration On Takeoff And Other High Torque Situations - Unbalanced Driveshaft
We've gone through pretty much every other option as to the vibration on take off and other high torque situations and have pretty much settled on the the driveshaft as the issue. I added traction bars recently thinking that the old leaf springs just aren't up to the job anymore. That seems to have worked some but it's still there. We've gone through the rear diff also and that's good. I'm looking at options for replacement of the shaft. What are the current thoughts on one piece shafts? Is aluminum the better option?
View 14 RepliesFord - Explorer :: 1996 - Rear Differential Was Leaky / Loud Whine Noise In Rear
Well i picked up a 96 4x4 with the 4.0 a few weeks ago and been fixing stuff weekly that i find wrong. One thing i noticed was the rear diff was leaky but couldn't get the fill plug out so left if for now. Last night my wife was on interstate and it just started making a loud noise so she pulls over calls me. I get there and drive it and it makes a woowoowoo noise and it got louder as speed increased. She was 3 miles from the exit so i drove it about 15-20 to get it off interstate than another 2 miles to her sisters. We let it sit for a few hours and found a flatbed to haul it home, and when we finally got home i drove it off the flat bed and now it was making a loud clunky noise. Parked it in drive till today. Cracked open the rear and no fluid came out.
Inspecting all the gears looked good no metal in bottom so i went and got a new rear cover and 3 qt. of fluid. Put it back together and the woowoowoo was still there but seemed to slowly go away as i drove it around the block. So what else could be going on here or do i need to drive it and warm up the fluid so it circulates? I also noticed a sheeee sound like metal on metal when braking but i changed all 4 rotors and both pads last week but i noticed the brakes in the rear that look like drum brakes was bare but i assume that is only for the ebrake so didn't bother changing them yet. Could those be hitting the inside of the rotor and making the metal to metal noise?
Ford - Explorer :: 2006 - Drive Train Vibration Noise?
Whats making the vibration & noise, my 2006 Explorer V8 LTD 4X4 is making a weird noise (vibration) & I think its the front drive shaft CV between the transfer case & the front differential........ this happens when I`m moving & at any speed, I have brand new tires.
View 8 RepliesFord - Explorer :: 2010 - Groaning Noise And Slight Vibration Starting At 34 MPH Under Load
I have a 2010 Explorer XLT that I bought in 8/2012 with 7,000 miles on it. I had had a problem with a groaning noise and slight vibration starting at 34 mph, under load. I don't hear the noise if I let off the gas at 34. I hear it a little past 35 or so and it doesn't seem to groan again until about 60 mph or so. I also have a feeling of the all wheel drive engaging when I back out of the driveway, put it in drive and turn the wheel slightly.
I took it to the dealer this week under warranty and he calls me today and says the tires are worn differently all around and that is causing the problem. He says the tires could be out as much as, or as little as 1/16 of an inch and that is what is causing the all wheel drive to catch and also the groaning noise. I understand what he is saying, but I can't believe that is the problem or more would have been written about it.
I asked the guys about rotating the tires and he said it would not matter, it would just take the problem from one end of the vehicle to the other. These tires are not worn like the truck is out of alignment, it is just normal wear. It now has about 21k on the odometer. What do you all think of this diagnoses? The guy says the PTU thinks it needs the all wheel drive and therefore engages it. This truck can also be manually put in 4 wheel drive by flipping the switch.
Ford - Explorer :: 2009 4x4 - Low Growl Hum Noise And Vibration Felt On Gas Pedal When Accelerating At About 40 MPH
I'm the original owner at 50k miles with Ford ESP warranty. Drive-train still under original warranty. I started noticing a low growl hum noise and vibration felt on gas pedal when accelerating at about 40 MPH. At first I thought it was the road or tires.
Then a few weeks later on a slight hill the growl-low hum was accompanied with a much more noticeable/louder growl/grinding noise in a heartbeat like rhythm. Took it to dealer and they first said it was the transmission. It was replaced.
Then they said the noise was from the rear differential/axle. It was rebuilt, oiled and sealed. Taking it back today for another drive with the mechanic to show them again the problem persist. What it may be? Also, my MPG has dropped significantly from an average of 18 to 13. This is while driving on 4x4 Auto.
Ford Super Duty (1999-2016) :: 2012 - Drive With Rear Driveshaft Removed?
I want to and went to buy a new 2012 F350 leftover - everything is good except that Ford.com says the truck was initially put into service In September of 2012 and therefore my warranty will expire in September of 2015 instead 2016.
Dealer says it's an error and will be corrected AFTER I buy the truck, so far I have been unable to get a straight answer from Ford.
Any information about being able ot change the original date a vehicle is put into service ?
Ford - Explorer :: 2007 Warm Startup Causing RPM Spike And Subsequent Stall
A warm startup on my 2007 Explorer causes an RPM spike and subsequent stall (half of the time) on the way back down. I've tried a fuel additive, Ford ran codes with no problems...
View 6 RepliesFord Super Duty (1999-2016) :: 2015 - Alignment Of Front Spline On Rear Driveshaft?
Proper alignment and re-installation of the front spline on the rear driveshaft of my 2015 F350.
I removed my rear driveshaft recently (it slipped right out upon removal without any force or resistance), and I'm getting ready to re-install it again this weekend, but I've noticed that one of the grooves between the array of male splines on the shaft itself appears to be slightly different than the rest - it seems to be slightly wider. It even has a white-colored stripe of paint down the full length of the groove as if it were denoting it as being somehow different from the rest?
Problem is, when visually inspecting the splines on the inside of the receiving yoke (the part that the spline fits into), I do NOT see any such differences. In other words, it doesn't appear that there is only ONE way to properly insert the front splined-end of the driveshaft. What am I missing here?
Is the front splined-end of the rear driveshaft intended to be inserted into the yoke in ANY position around the dial? Or is there only ONE specific position or orientation that it is intended to be inserted or installed? NOTE: I've seen references elsewhere on-line that seem to indicate the need for proper alignment when there are multiple U-Joints, and maybe this is a part of it (?), but I'm not quite sure which U-Joints to consider or how to interpret such an "alignment".
Touareg :: 2005 - Squeal In Rear Driveshaft
I have a 05 T with 85,000miles. Recently, it has developed a piercing squeal which varies according to rpm level. VW dealer thinks it is a bearing in driveshaft.
View 3 RepliesFord - Explorer :: Howling Noise Between 50 And 65 MPH From Rear End
2002 EB V8 4WD 3.73 make a howling noise between 50 and 65 MPH? Sounds like it is coming from the rear end.
View 14 RepliesFord F-150 - 1997-2003 :: Chirping Noise From Driveshaft Area
I have a 99 F150 4x4 4.6L automatic trans. The truck has 260,000 miles on it. Saturday, while going down the interstate, this chirping noise started up from the rear. When I got home I jacked the rear up and spun the wheels while listening. There is a chirping noise that, as best as I can tell is coming from around the front of the driveshaft around the u-joint area. I've never known of a u-joint to make this type of noise before. There is no vibration or anything, just the noise. The frequency of the noise increases and decreases as I speed up and slow down. I don't think it's coming from the transmission, but it's hard to tell, as everything echoes. I couldn't imaging the driveshaft itself making this noise, but I guess it's possible.
View 12 RepliesFord - Explorer :: 1994 - Horrible Noise From Rear
The last couple of times hauling wood with a trailer, the 1994 Explorer seemed to seriously lack power. Then I noticed there was an awful grinding noise coming from the rear. My guess is that the wheel bearings are shot creating an enormous amount of extra drag, especially with the added load of the trailer. Or what else could it be? How much should I expect to pay to have bearings replaced?
View 9 Replies