Ford - Explorer :: 2005 - Water Gets In And Soaks Front Passenger Side Floor When It Rains
Have a 05 Explorer and every time it rains, water gets in and soaks the front passenger side floor. It only happens after it rains and happens even if it is not driven. I am pretty sure there is a drain line plugged up someplace from the cowl, just not sure where it is. The toe kick seems to stay dry but the floor gets soaked.
View 4 RepliesFord - Taurus :: 1999 - Trunk Full Of Water
I got a 99 Ford Taurus and recently I wanted to remove the wheel to see if I can change the front breaks myself. When I opened the trunk to get the jack, to my surprise, the recess where the spare wheel is stored (below the ‘carpet’ in the trunk) was full of water, I am talking a couple of inches deep! The spare wheel itself, which is relatively new and rarely used, was completely ruptured.I don’t know where the water could have come from.
I suppose it could have been rain, but the cardboard boxes that were stored in the trunk (above the ‘carpet’) were not wet. To drain the water out, I found a big (2” x 3”) hole in the bottom of the trunk that is plugged with a rubber plug. I removed the plug and let the water drain. But now I am just puzzled. Where did the water come from? And how come there are no drain holes in the bottom of the trunk? And why did the spare wheel rupture? And how can I prevent all this from happening again?
Ford - Explorer :: 1998 - Fuel Gauge Stuck At Full
I have noticed when I turn the key on the needle moves down just a touch but goes back to full. I have disconnected the wiring harness for the fuel tank and reconnected it. I have tried tracing the harness back towards the front but no luck yet. I'm guessing it's a bad ground or something. And if so what was the solution.
View 5 RepliesFord - Explorer :: 2007 V8 - Check Engine Light On - Can Only Fill The Gas Tank About 3/4 Full
I have 2007 explorer 4.6 v8. The check engine light is on, and i can only fill the gas tank about 3/4 full, after moving the gas nozzle all around and taking about 15 minutes. I read a few different things while searching. Like vapor canister need to be replaced. or the vent hose needs to be replaced.
View 1 RepliesFord - Explorer :: 2002 XLT - Grinding Noise Only Noticeable When Starting Out From A Full Stop And Turning
Grinding feeling, and noise from rear of 02 explorer xlt. only noticed when starting out from a full stop and turning. It feels like something is grabbing like the rear brakes. I purchased this suv of a local dealer lot, because it was so clean and on a short test run seamed fine.
The day after I picked it up I took it for a shakedown cruise to see if I noticed any problems. After going up a few forward grades I noticed a disturbing rattling noise coming from mid under carriage, and got very worried. I immediately took it to a local well revered mechanic. They eventually had it for 4 days in order to diagnose it. After the dealer had done the inspection on the car and passed it, that all rotors and pads needed to be replaced, left front wheel was locked up, inspection sticker month was never punched, both front tires were bad and either the flex plate or tork converter or both needed to be replaced. I took it back to the dealer with the report and he agreed to fix it with me paying for parts. He did and the rattle was gone !
Yet now I have noticed the problem mentioned at the beginning of this piece, plus the rear wiper does not work. I think I got taken for a ride, which may become a longer ride than I thought. All I want is a reliable car. what could that rear noise be ???
Ford - Explorer :: 2004 - Misfiring On Cylinder 3 And 6
Changed the spark plugs now I have misfire in cylinders 3 and 6. Do I change the spark plug wires or the coil pack?
View 5 RepliesFord - Explorer :: 2006 - Misfire On Cylinder 3 And 4 Consistently
My wife's explorer has developed a misfire on cylinder 3&4 consistently. I did have cylinder 2 misfire once. But have not had it come back. The explorer is a 2006 4.6 limited with 130000 miles. Originally it was misfiring on cylinder 3. So I swapped the coil packs between 2&3. Cleared the codes. Still got a cylinder 3 misfire. So I went and bought new plugs for it. Cleared the codes. Still misfire on cylinder 3. Swapped injectors 3&1.
I took it out and romped on it and now I get cylinder 3&4 consistently misfiring. Now I got me to thinking that the only side that is misfiring is the pass side. I was going to swap o2 sensors but couldn't get the driver side out so I went and bought a new o2 upstream for the passenger side. Still get 3&4 misfire. Thought it might be fuel related so I pulled the filter. It was kinda tough to blow through so I put a new fuel filter in it. How the hell can I check the fuel pressure without a fuel fitting? I am now thinking it might be fuel pump, plugged cat, or low compression
Ford - Explorer :: 2002 - Water Flows Out Of Oil Drain
Have an 02 explorer 4.0. Been having to add about a quart of coolant a month. Took it to the shop and they replaced the thermostat. Now water flows through the motor and comes out of the oil drain plug as fast as I put it in the radiator, the radiator never fills to the top. What could of possibly happened to cause this?
View 11 RepliesFord - Explorer :: Coil Pack Isn't Putting Out Spark To Cylinder 1
1998 Ford Explorer. Coil pack isn't putting out spark to that cylinder. Would the next step be to replace the pack, or might I check something else 1st?
View 5 RepliesFord - Explorer :: Ignition Cylinder Replaced Now 2002 4WD Will Not Start
My son has a 2002 Explorer 4WD EB that needed new valve and intake manifold gaskets. I pulled it apart this weekend (battery disconnected) and replaced (don't get me started on the passenger valve cover with that *@&$^ EGR valve in the way). He's also had issues with the key being removable from the ignition when the vehicle is still running (worn key and/or cylinder most likely). So when I put his key in to test my gasket job, it won't go in all the way. After much trial and effort, I call a mobile locksmith who has to drill out the old cylinder and rekey/replace it (keyed to use the same, single old key we have).
Now, the cylinder turns happily with the old key. In the "Run" position, all the dash lights come on as they should, but turning then to "Start", caused a loud single click, then the dash goes out, and the engine never even tries to start. Then, nothing electrical in the car works unless I disconnect the battery for about 10 mins, then reconnect. Upon trying to start, the same thing happens (good dash lights at "Run", then single loud click from the engine compartment, then nothing. It seems maybe the PAT has lost its memory of the old key?
I watched and assisted the locksmith put the cylinder and PATS antenna back together, so I know connections/placement of that is good. At this point, I'm about to lose all the money I saved on the gasket job to the freakin' ignition issue.
Explorer :: 2003 - Fuel Gauge Does Not Show Full After Fill Up?
2003 Ford Explorer fuel gauge does not show full after fill up. The Ford service stated that it can take up to 17 minutes (of running time) for the fuel gauge to show full after fill up.
View 7 RepliesFord - Explorer :: 2001 - Overheating But No Steam / Water Running Out
my 2001 Ford Explorer has started overheating but there is no steam or water running out and when I turn the heater on I get slightly warm water what can I do? the temp gauge will go to hot and after a while will drop down then go back up to hot what kind of damage am I doing to my car?
View 3 RepliesFord - Explorer :: 2003 - Water Leaking From Dome Light?
My 03 explorer leaks water from the dome light and from the mounting bracket for the sunvisor on drivers side when we have a heavy rain. I have had back to the dealer 4 times. They have resealed luggage racks twice and cleaned drain holes for sunroof twice. The body shop manager has told me he has fixed hundreds of these and he has also told me that all sunroofs leak. The most recent visit I was told not to park on an incline. If I knew that this vehicle could only be driven when the sun was out , I would have never bought it.
View 11 RepliesFord - Explorer :: 2004 - Torque Value For Water Outlet Bolts?
What is the torque value for the 2 bolts on the upper radiator hose water outlet on an '04 4.6L?
View 1 RepliesFord - Explorer :: Vehicle Starts And Idles A Bit Rough - Cylinder 8 Misfire
I just got a 4.6 4WD Explorer in for rough running. It had timing chain noise and some odd codes for primary coil H codes along with cylinder 8 misfire.
I replaced the coil to get rid of the "H" code and it was fine. Still misfires on 8, and I really don't care because it's coincidence that the timing could be affecting it or perhaps.... bent valves!
The vehicle starts and idles a bit rough. Can't go very fast, and of course I know I should run it as little as possible!
Here is the deal, how should I present this to the customer? Should I let him know that some valves could be bent after replacing the chain (and all associated parts) and that it could still be effed? Or will I be fine after replacing? Pretty much, where they had a tensioner failure/guide breakage and valves bent too?
Ford - Explorer :: 1999 - P0303 / Cylinder 3 Misfire - Resetting Code
On my wife's '99 Explorer, she just acquired, we had a P0303, #3 cylinder misfire. I found the plug cracked and replaced it. Do the codes reset themselves or do I have to do it? I'd rather not disconnect the battery and reprogram the radio.
View 7 RepliesFord - Explorer :: Puddle Of Water On Driver Floor - Remove Headliner?
Have a tarp over the roof of our Explorer, getting a puddle of water on the driver floor.
It's getting the headliner wet near top driver side of door/windshield.
Is there a drain tube, or is it a blocked channel in the roof that I can clean with a stiff wire from above?? or does this require removal of the headliner?
Ford - Explorer :: 2003 - Misfire On Cylinder 8 / Running Rough At Idle And Under Load
126000kms on 03 explorer 4.6 truck started. Running rough at idle and under load.... Code came up for cyl 8 injector. Replaced injector... problem still there. Switched cop and plug with another cyl and plug.... same code and cycl 8 is definitely not working. Would a generic problem always affect i cylinder. I even checked wire clip on for injector... it appears ok. There is power to injector wire clip.
View 5 RepliesFord - Explorer :: 2003 - Overheating / Water Dripping Out By The Back Side Of Engine
I have a 2003 sport trac that is leaking water like a hose but don't know if its a hose or water pump. How can you tell?? I have the water pump housing to change but when I fill the radiator and look under truck I see the water dripping out by the back side of the engine. Since I don't know where the water pump would be I don't know how to fix. I don't get taken to the cleaners when I get it fixed.
View 4 Replies