Explorer :: 96 Ford XLT Truck Will Shift Into Reverse Only
I Have a 1996 Ford Explorer XLT my problem is my truck will shift into reverse but nothing else. Whats wrong with my truck and how do I fix it...
View 3 RepliesFord Ranger / B-Series :: 2003 - Truck Wouldn't Start Again After Parked
My 03 Ranger 4.0L has become a mystery that has baffled every one I know. Everything was fine and I ran home to something from my house was in there maybe 10 minutes came out and the truck wouldn't start. it doesn't even crank over. out of the clear blue. I had a friend who works for a garage check it and he thinks timing chain. Since then I have been told it wouldn't just fall off sitting there with no indication at all there was a problem.
Thought maybe PATS system. Its in order. Put in on a computer from auto-zone and it shows a check engine light but the reading is there is no codes in the computer on file. I am at a loss. Its been months and I really cant afford to take it to a garage right now. Its the strangest thing ever no crank, no stalling just nothing I hit the switch it lights up like its ready to start and nada.
Ford 7.3L Power Stroke (1999-2003) :: Truck Wouldn't Go Fast / Plenty Of Power In Low End
2002 f250 7.3l diesel...
I got a new radiator and the tranny fluid was the worst the mechanic had ever seen. He serviced it and warned me that it might not be long for this world. I broke my flexplate and so I had to pull the tranny, and I decided to throw a new torque converter in because it was giving g me symptoms like a broken sprag( it wouldn't rev up or do a brake stand in gear, therefore slow takeoffs).
I was recommended to replace the tranny, I decided I could do the job again down the road if I needed to. About two thousand miles down the road I had a hard shift going from overdrive down to get up a hill and about 10 miles later the truck started slowing down....I couldn't give it enough pedal to keep it going and the engine sounded rough.
I pulled over and checked fluids and everything was fine, truck idled fine, bright red tranny fluid not burnt at all. Pulled on to the road again and it pulled fine until about 40 mph and it wouldn't go any faster. I got it towed home and ordered up a tranny from Ford figuring it must be toast, but I thought I'd throw it out to the forum to see if there is any other troubleshooting I can do before I install the new one in case it is some other problem or some electrical harness or something, or if that is a pretty standard reaction to a fried tranny.
Engine runs good at idle, shifts perfectly to drive and reverse, drives forward and back(I'm very hesitant to drive it out of the driveway in case I can't get it back in). Only happened two times before I decided to tow it. Temps looked fine on the gauges, fluid was a little overfilled in the tranny, but again, not hot or burnt.
Ford - Explorer :: 2004 - Rumble From Rear Of Vehicle When Letting Off Accelerator
04 explorer, When traveling under throttle the thing runs smooth, when letting off accelerator, there's a rumble from, what seems like, the rear of the vehicle, when I press the accelerator, it almost "clunks" and acts fine once it's under acceleration again. Should I suspect my rear end gears going out, or something simple like a universal joint.
View 1 RepliesFord Transmission :: 2001 F150 Truck Shudders When Letting Out The Clutch
I have a 2001 F-150 4.2L 2WD LS with 102k miles. At 95k miles, the clutch slave cylinder started leaking fluid. So, I had my local garage replace it. And while they were at it, put in a new clutch. That is when the trouble started.
I cannot let the clutch out like I used too. When letting out the clutch from a dead stop,the rear end now shakes, shutters, and if it is really bad, the rear end starts bouncing. To minimize the shakes, I have to keep the engine below 1000rpm until the clutch/1<sup>st</sup> gear is fully engage. It is worst when there is a load on the truck like going uphill, or a sharp turn for a dead stop. After the truck gets rolling, I don’t notice the problem when shifting gears.
I have been babying it for 7k miles and it has not improved. What is wrong? Did I get a bad clutch job?
Ford Ranger / B-Series :: Starting From A Stop In 1st - Truck Bogs Down When Letting Out The Clutch
Started up my truck today, accel pedal didn't want to move, after giving it some more force it eventually became "unstuck". Now, the real issue I'm having is from a dead stop, in 1st gear, as I'm letting out the clutch the truck boggs down as if I'm not trying to accelerate. I'm giving it as much as I normally would as I'm letting out the clutch but the motor will either die or take a couple seconds before it starts to go. Once I'm moving I don't notice any problems clutching through gears. The check engine light IS on now, however I don't have any diagnostic gear or really any tools for that matter. 1998 2.4L 5-speed...
View 2 RepliesFord - Explorer :: 2005 Started Making Slightly Jumping Motion And Thumping Sound When Letting Off Gas
My 05 Explorer has started making a like slightly jumping motion and thumping sound when I let off the gas. It seems to maybe happen when it wants to gear down but it I give it the slightest gas it quits. Do you check the ans fluid when it's hot or cold? I checked it hot and it ran out.
View 1 RepliesFord - Explorer :: 2003 - No Response When Shift From Reverse To Park
It is a 2003 xlt 4.6 auto. sometimes, but not too often, when you shift from park to reverse nothing happens, no go backward.... even if you mash the go pedal. if you shift to drive then back to reverse it works fine. Not predictable enough to show it in failed mode to the mechanic. Is this a common simple fix? would this issue throw a code? (No blinking or idiot lights on dash when it does this) is there something I can tell the tranny guys to look at since it is on my dime? Somthing like a shift solenoid or something...
View 2 RepliesFord - Explorer :: 2003 - 5R55W Trans Does Not Shift Into 2nd Or 5th Gear
2003 Ford Exploreer 4x4 5R55W Auto Tranny. From driving the car it does not shift into 2nd or 5th gear. The O/D light flashes, and the check engine light comes on. Gives Code P0775, which indicates a problem with Solenoid 2.
This weekend I changed the Shift Solenoid Pack with a brand new one from Ford, and the exact same problems still exist. It's as if I hadn't done anything to the car. I have read somewhere that 2nd and 5th gears share a band in the tranny, could the the problem.?
Ford - Explorer :: 2003 - Shudder And Slow Shift - No RPM Rise
2003 Explorer tranny. 4.0 V6, 213km (133 miles)... Biggest concern is 4-5 upshift shudder, no rpm rise, just a shudder and slow shift. Slight shudder on 3-4 too, I think. Some online reading points to torque converter failure.
Other symptoms: sometimes slams into gear when shifting out of park, other times it feels like there is no fluid in converter when first put into gear, especially after sitting a day or 2. (my truck does the same thing, but that's after sitting 2-3 weeks at a time)...
Ford F-150 - 1997-2003 :: 2002 Truck Won't Shift Into 2nd Or Drive
Today at a light my truck wouldn't upshift. I can manually shift from low to second but not to drive. Reververse works fine. I was noticing a slight slip between 45 & 55mph and would sometimes go away if I disingaged the overdrive.
View 2 RepliesFord - Explorer :: 2003 4WD - Truck Started To Rumble In The Front
I have a 2003 Explorer.... 4wd..... and here's my story.. I had a tire blow out (front driver side) and I took it to a tire chain to get it replaced (it was the closest thing to where it happened and I had to get to work)
After the tire was replaced, the truck started to rumble in the front and seemed like the brake was being pressed while I was driving. I called the chain tire store and told them my truck was not doing this prior to them replacing the tire. They said it was fine because I was riding on a better tread tire and the remaining tires were worn.... (okay..maybe so?)
I drive 80 miles one way to work....the whole way there...rumbling and this 'brake applied' feeling. Worked my shift...drove the 80 miles back home...same thing.
Took truck back to store....they said that it was the Front Drive Shaft had cracked at the Transfer case.... I've asked a few people and they think it's just the ABS still locked because I was traveling a high rate of speed when my tire went out. I think the tire store chain screwed up when they replaced the tire....
Ford - Explorer :: 2003 - Loud Clunk When Put The Truck In Reverse And Once Hit The Gas
I am trying to track down where exactly a clunk is coming from on a 2003 Explorer 4x4(auto, hi, low). My buddy brought it by my house yesterday and i cannot pin point it. If you put the truck in reverse, once you hit the gas, it clunks pretty loud. If you just put it in reverse, let off the brake, it will not do it until you hit the gas.
I got the explorer up in the air and crawled under it. I had my buddy switch from forward to reverse, and back again. Every time he let off the brake in forward or reverse, it would clunk. The reverse clunk was definitely louder.
It does the clunks in all settings, -auto,hi,low. No flashing dash lights. The dash lights do come on accordingly. One thing he pointed out was the Auto,HI,Low Buttons themselves are not backlit anymore. Not sure if that has anything to do with it?
I cannot narrow it down as the whole transfer case, front driveshaft and front diff, shake with the clunk. U joints don't seem to have play (prying with small prybar). I then went ahead and unplugged the big wire connector at the transfer case and the clunk went away.
Ford - Explorer :: 2002 - Died And Wouldn't Start
Yesterday I drove my mom's 02 explorer to the gas station to fill it for her. After filling, I started it. It ran for several seconds and then died. It wouldn't start right away, so I let sit for a half hour, and then it started and I drove it 10 miles home. What is going on?
View 6 RepliesFord - Explorer :: 2006 Just Died And Wouldn't Start Back Up
Was driving the other day and it just died and wouldn't start back up. It has fire and is getting gas. It's a 4.0 Sohc...
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - Brake Shift Interlock - Truck Stuck In Park
having problem w/ 98 f-150. first truck stuck in park. figured out how to get around that (turn key 1 position, shift to neutral, start vehicle, then engage transmission). but no brake lights! I have turn signals, driving lights, hazards, etc in rear. I disconnected harness from brake light switch. there are 2 leads, 1 hot, 1 not. i jumped them and no brake lights. i tested the switch and it functions properly (it's reconnected now). i changed my bulbs in tail lights. I unplugged the solenoid (which is impossibly located behind/beside steering column). this allowed me to shift like an old truck (without having to brake first), but doesn't solve my lack of brake lights (i've reattached the solenoid harness to remind me of my problems).
i am putting my money on a broken wire somewhere between the brake light switch (b/c that was good) and the solenoid (i am not hearing that faint click when i step on brake). but a broken wire should work by accident some of the time (unless cut cleanly and completely). there is a green wire with red stripe leaving the brake light switch and 3 wires at the solenoid harness (1 green and maybe a smaller gauge than those at the switch and 2 others which i don't recall their colors). Ford service manager doesn't think it's the solenoid but wasn't otherwise useful except to say, "hey, why don't you bring it in to me." What to look for before i plunk down for someone to perform what I already have before completing the job!
can i splice a wire from something (? brake light switch?) to something (?wire in solenoid harness?) or does that "electronic signal" get processed somewhere else first?
Ford - Explorer :: 2005 Wouldn't Start / Just Clicked And Lights Flashed
I have a 2005 Ford Explorer and a few days ago it wouldn't start, it just clicked and the lights flashed. I put it on a charger overnight and it started right up. I took it to Autozone and he tested the starter, alternator and battery and said everything was green. It was fine until yesterday when I started it up and it ran a self test and gave me:
Ignition Key B
Serial # 00075194
Part # 4L2T-10849-CK
Diagnostic Trouble Code : 9318,9352 and D900
I looked through my manuals and can't find anything with codes. My friend says batteries don't last long in Florida, I have only been here a year from Michigan. I bought the truck in 2008 and have never replaced the battery. The guy at Autozone was reluctant to sell me a battery because he didn't think I needed one. I have never had any problems with this vehicle.
Ford - Explorer :: 2003 Truck Started And Running Rough - High Temp Low Oil Light Came On
2003 ford explorer 4.6L. This truck will start and run rough high temp low oil light come on and temp gauge is pegged hot. Oil gauge is fine though, checked oil its fine.
I checked coolant reservoir its ok.
If I shut truck off and restart it will run ok and rev like normal and then all of a sudden go into limp mode and will misfire etc...
What sensor seems to be the main culprit?cht sensor???
Ford Excursion :: Blower Motor Wouldn't Turn Off By Itself When Truck Was Turned Off
It started with the blower motor that wouldn't turn off by itself when the truck was turned off. I forgot to turn the fan off one night and woke up to a dead battery. Got my dad to come give me a boost and it would turn but not start and the anti theft light in the dash was blinking fast.
Later in the day I got another boost and it started right up.
This was yesterday... after the last boost and startup I went and got a few things, stopped to get gas... started back up fine each time.
Last night I was greasing zerks and making sure everything in the front end was nice and tight when the abs module started clicking... and the anti theft started blinking and truck wouldn't start. Left it alone and went to bed.
This morning I boosted it and it started fine. Later in the day it wouldn't start again because of the anti theft. Gave it 5 minutes and it started. Stopped to get gas... wouldn't start (anti theft)... started after about 5 minutes.
On the way back home... it's been making this 5 beep, pause, 5 beeps, pause sequence so I pulled it into the garage and turned it off now the locks are locking/unlocking by themselves randomly, the beeping is on and off, anti theft light blinks for a few minutes then goes away only to come back...
I've been told to remove the fuse box under the hood and check to make sure all connections are clean... I've searched and seen possible solutions ranging from a dirty connection to needing a new GEM module and apparently sometimes just a low voltage situation will cause our trucks to act nuts...