Ford - Explorer :: 2003 Truck Started And Running Rough - High Temp Low Oil Light Came On
2003 ford explorer 4.6L. This truck will start and run rough high temp low oil light come on and temp gauge is pegged hot. Oil gauge is fine though, checked oil its fine.
I checked coolant reservoir its ok.
If I shut truck off and restart it will run ok and rev like normal and then all of a sudden go into limp mode and will misfire etc...
What sensor seems to be the main culprit?cht sensor???
Ford - Explorer :: 1997 4x4 - Rumble Up Front Above 90 Km/h - Wheel Bearing?
My wife's Explorer 4x4 has a noise in the front at around 100km/h. It is not detectable below 90km/h. Its not noticeable from a standstill until around 100, then you hear it a little. I find I can make it more noticeable if I vary my speed from 110 to 105 up and down, then its easier to hear. Once you get below 90 km/h you cant hear it at all.
I have a broken leg right now, and I normally do ALL my own work so I'm a little-limited mobility wise at the moment.
I'm suspecting a wheel bearing. I put the Explorer in the garage and my son jack up both wheels on the drivers side. I started the engine and SLOWLY accelerated up through the gears to 100. I know the hazards with this as I've done it with other vehicles, but this was the first 4x4. Then we jacked up the passenger side (after lowering the drivers side) and did the same thing. I could slightly hear/feel the rumble when the passenger side was jacked up.
I did drive the vehicle on my outdoor ramp/pit so I could use my crutches and get underneath to have a look. I grabbed the cv axles and they feel solid. The propeller shaft was replaced last year, and the cv axles look brand new. (bought the vehicle off a friend two years ago.).
So, are my suspicions correct, is it the pass. side wheel bearing? The Explorer has 294000kms. Never did test it on corners as I didn't want to swerve back and forth on the highway with the amount of traffic.
Ford - Explorer :: 2003 - Rumble Strip While Coasting?
Care finally runs well and passed inspection. So I can legally drive it at speeds. Noticed what feels like widely space rumble strips when coasting 2003 explorer. I am now trying to check all my fluids ... trans seemed a bit low (PITA), rear and front differentials seemed full... but should they be checked with the engine running or off??
View 14 RepliesFord F-150 - 1997-2003 :: 1999 Truck Rumble And Died When Trying To Start
I came home from work truck was running decent got up in the morning to start it up. Tried to start up was real rumbly and died got the same twice then went to just cranking over not getting anything else tried spraying some starter fluid in air and it would try so assuming its firing abd possibly gas related ...
View 4 RepliesDakota :: 2003 - Bad Rumble In Right Front / Clicking Noise When Turning
I have a 03 Dakota 4x4 that is rumbling badly from the right front. The rumbling increases and gets louder steadily with speed, transfers slightly through the steering column, and goes away when turning right and taking the weight off the right front tire. It is also doing this when in 2WD. I have replaced the bearing hub assembly but that didnt fix it. I have also pulled out the CV axle, but am unable to tell if this is the problem. I'm also not finding any worn bushings or ball joints, or at least not enough wear to justify this horrid sound.
It is my understanding that a worn CV will produce a clicking noise when turning. I haven't noticed this at all, yet I can't imagine what other moving parts could be causing this rumbling. I have also taken a look at the spline on the differential, and other than the normal tiny bit of movement, it looks fine.
Ford - Explorer :: 1997 AWD - Brief Rumble Every Now And Then
My 'new to me' '97 Explorer has this odd 'rumble' every now and then, as if I just ran over some rumble strips. Very brief, maybe a second or less, as if I hit 5 or 6 of those bumps. It is a V8, XLT all wheel drive and I'm not familiar with it. Is this something I need to get looked at soon or is it just one of those things with the AWD. I only driven it a few times so I don't see a pattern and all else is great. Its a tight truck with less than 100K miles and I really enjoy it.
View 7 RepliesFord - Explorer :: 2003 - Suddenly Started Running Really Rough
I have been puzzled to why my truck isn't running right. We were driving down the highway one day and*then all of the sudden it starts running really rough. I changed MAF sensor, plugs and plug wires, oil change, fuel filter and air filter. Still doing the same thing. What this could be? 2003 ford sport trac..
View 11 RepliesFord F-150 - 1997-2003 :: Truck Started Rattling From The Exhaust
1997 F150... Truck has slowly started getting worse and worse performance. About 3 weeks ago the truck started rattling from the exhaust, Towing my trailer the other day, the truck had NO power, I thought it was the plugs, so I replaced them.
Now the rattle is worse (no lose heat shields). I am blowing the little tubes off the drivers side exhaust manifold, the ones that go to the DPFE sensor.
Did I mention, that the truck has no power, sluggish, now I am dumping hot exhaust fumes into the engine compartment. Still got the rattle underneath.
I think the cat is plugged up on the drivers side. (which probably explains all my symptoms)
Any other reason for the rattle literally coming from the drivers side cat and the little tubes being blown off?
Ford - Explorer :: 2003 - Pinion Bearing Has Started To Go / Whine From Rear End
I have a 2003 explorer where the pinion bearing has started to go, now the rear is starting to whine. the truck is a 2003, its a limited, with the 4.6 v8 in it. I would like to swap the rear with another used one, rather than rebuild the diff. the car is AWD, has a hitch receiver so I would imagine it has the tow package, my question is could I grab a rear out of a non AWD explorer, or one that had the 4.0 in front of it? something with the same gear ratio but out of a similar, non exact car, it has the advancetrac in it with the push button on the center console.
View 3 RepliesFord - Explorer :: 2003 - Truck Wouldn't Shift To 2nd Without Letting Off The Gas
I'm under the understanding that my 03 explorer AWD tranny level can't be checked. Is this true. Well anyway , went on a 1000 mile round trip. Left for work following morning and truck wouldn't shift to 2nd without letting off the gas. OD lite was flashing. Got to work. Left work and goes into 2nd fine but now it wont hit 3rd till I let off the gas. No OD lite flashing but now check engine lite is on. Watzz up. I would like to check the fluid....but see above.
View 2 RepliesFord - Explorer :: 2003 - Loud Clunk When Put The Truck In Reverse And Once Hit The Gas
I am trying to track down where exactly a clunk is coming from on a 2003 Explorer 4x4(auto, hi, low). My buddy brought it by my house yesterday and i cannot pin point it. If you put the truck in reverse, once you hit the gas, it clunks pretty loud. If you just put it in reverse, let off the brake, it will not do it until you hit the gas.
I got the explorer up in the air and crawled under it. I had my buddy switch from forward to reverse, and back again. Every time he let off the brake in forward or reverse, it would clunk. The reverse clunk was definitely louder.
It does the clunks in all settings, -auto,hi,low. No flashing dash lights. The dash lights do come on accordingly. One thing he pointed out was the Auto,HI,Low Buttons themselves are not backlit anymore. Not sure if that has anything to do with it?
I cannot narrow it down as the whole transfer case, front driveshaft and front diff, shake with the clunk. U joints don't seem to have play (prying with small prybar). I then went ahead and unplugged the big wire connector at the transfer case and the clunk went away.
Ford Excursion :: 2003 V10 Truck Started Stalling At Irregular Intervals
I have a 2003 Excursion 4X4 V10 (6.8l) gas with 130K.
About six months ago, the truck started stalling at irregular intervals. The truck runs fine for weeks at a time, but will suddenly die. This happens at idle, and under power. After stalling, the truck usually starts back up, but there has been a few instances where I thought it sounded fuel starved. It has stalled as many as four times in a row (within 15 minutes), but shortly after it runs fine again.
I researched this board, and tried the following: cleaned the MAF, and replaced the IAC Valve.
But, it stalled again, so in late February I took it to the dealer; a AAA approved repair facility which means they guarantee the fix for two years.
The dealer claimed to have pulled a P0231 code. As a result, they replaced the fuel pump and assembly, along with the fuel filter.
The truck ran fine until two weeks ago, then it went thru a series of stalls again. In each instance, the truck started right up, and I drove it to the dealer.
The dealer took it in again and had it for six business days, but they could not replicate the issue. I suggested they test the PCM/fuel relay and the signal going to the fuel pump - they said everything checked out okay. No charge, the ticket remains open.
What could be causing this? I am not too good with electrical stuff; in fact, I know very little. Another member explained a way to test the signal at the time the truck stalls, but I am not sure if I could competently do it. I am thinking I need to start replacing part after part until it stops? I don't mind doing that, but would need to know which parts to focus on. Should I start with the MAF? I cleaned it, but do not know how to test it.
Ford F-150 - 1997-2003 :: 2002 - Truck Is Hard To Get Started And To Keep Running
Sometimes the truck is hard to get started and to keep running, Once it warms up it will run fine. The next time it is started it will start fine but when you are going down the road if I try to accelerate it will start backfiring and not pick up any speed. I am getting a lean code on both banks. I have changed the IAC, the throttle position sensor and mass air flow sensor. 2002 F150 with 6 cyl
View 1 RepliesFord F-150 - 1997-2003 :: Truck Would Not Crank After Sitting For Few Days Without Being Started
I am having problems with my 97 F150 6cyl. A couple of months ago, I noticed the truck after sitting for a few days without being started would not crank. After some trial and error, I found that turning the ignition switch on and off several times did the trick and the truck would crank right up. I was thinking this might be a fuel pump or fuel filter issue but, I'm not sure.
A couple of days ago I was going to drive the truck and did the ignition switch deal as usual and the truck cranked up but, there shortly after while just idling the motor died. I have tried and tried to crank it and it want start back. After thinking on it, I don't know if this is a fuel problem or not, or maybe even the ignition box.
Ford - Explorer :: 2004 - Rumble From Rear Of Vehicle When Letting Off Accelerator
04 explorer, When traveling under throttle the thing runs smooth, when letting off accelerator, there's a rumble from, what seems like, the rear of the vehicle, when I press the accelerator, it almost "clunks" and acts fine once it's under acceleration again. Should I suspect my rear end gears going out, or something simple like a universal joint.
View 1 RepliesFord F-150 (2004-2008) :: Rumble / Shudder In Truck On Initial Acceleration
Just rejoined this Ford gang after years absence. Used to own "The Muny Pit", a '79 F-150 4WD monster with a '69 429... constantly breaking something. Anyway, where to look on my '08 F-150 XLT 4WD with a 5.4, 83,000 miles. Searched the search bar for my title and found a post on an '00 Expedition describing similar issue than mine... for about 6 months now when I accelerate either from stop or a crawl; forward or reverse; more so when turning, but does do it wheels straight.
Upon initial acceleration I have this horrendous rumble / shudder in the truck, like the grinding metal bearing sound/feeling felt when the pinion bearing went out on my '79 (only felt it seconds before the 9" rear pumpkin exploded). Once rolling it stops. I have checked all wheel bearings.. I have check all the suspension joints... everything looks fine, no obvious issues. The only suspension mod I've done is a 1.5" leveling kit when brand new. On the Expedition two replys suggested changing the transmission/transfer case fluids claiming it cured their vehicles.
Ford F-150 - 1997-2003 :: Truck Suddenly Started Running Rough / Too Many DTCs All At Once
I have a 2001 F150 4.6L auto. This truck suddenly started running rough. Cleared all codes and re-scanned after starting truck. The codes are as follows; P0135, P0155, P0443, P0740, P0743, P0758, P1451, P1460, P1747, and P1760.
My question is; is it normal to have this many DTCs come up at once? Could my PCM be faulty causing this problem? Can you swap a pcm from the same year truck with the same options without reprogramming?
Ford F-150 - 1997-2003 :: Truck Randomly Started Missing - Misfire On Both Cylinder 1 And 8
I've got a 97 f150 4.6 that has randomly started missing over the last month. It has started to get more frequent and codes are showing a misfire on both cylinder 1 and 8. Both of these cylinders run off the same coil pack. I'm thinking its the coil? The plugs and wires, motocraft, have about 3k on them and the truck runs great otherwise. I just don't know how common a coil would cause this or if they would act intermittent like this.
View 5 RepliesFord F-150 - 1997-2003 :: Constant Airbag Light When The Truck Started And Shut Off
I bought a 01 F150 with the 5.4 motor in it not much over a year ago. The truck needed quite a few things but the price was right. I have been dreading fixing one issue I knew about when I bought the truck. I figured I would ask here before contemplating taking my 12 year old truck to ford.
I have done quite a bit of reading about the airbag codes and in some cases people suggested the passenger switch led can burn out causing the light to occur. Here's what I know,
The truck has not been in a accident. I bought it from the owners son who only knew where to put gas in the truck. The father took care of the truck and he assured me it was not accident related for what it's worth.
Upon start up there are no flashes of the airbag light. From the time the key is turned ign. on to the time I shut the truck off it is a solid light. Early this spring I soldered a new led in the passenger on/ off switch with no change. I wonder if the switch is bad but I did not see a proper way to test it.
A airbag light code reader would seem to possibility but I have not seen any auto-part stores that borrow that type and my obd2 scanner cannot pull those codes. Where to start with troubleshooting?