Explorer :: 1999 Ford XLT V6 - Automatic Transmission Removal
I have a 99 Ford Explorer XLT, V6, 4X4 with the 5R55E automatic transmission. I'm getting ready to remove / replace the transmission. Do you have to lower the back of the engine any for the transmission to clear the torque converter? Any tricks to getting torque converter off the flywheel?
View 14 RepliesFord Super Duty (1999-2016) :: Transmission Line Removal?
OK, so I ordered in the new lines and have them. BUT my problem is snaking the factory transmission line out from under the truck. I have pictures to show my struggles.
How do I pull this:
Out of here???
Towards the front of the motor
Front passenger side cab corner
Replacing these lines? I don't care about breaking the old one, but I still need to find a way to install the new one.
Ford Super Duty (1999-2016) :: Transmission Line Removal?
I have replaced both the transmission lines except the one that connects the two. It is the one near the top of the transmission that is about a foot long and goes from the fitting of the one transmission line to the other fitting for the other line. My questions is how do I remove it? It seems to be permanently affixed to the fittings, so those it come attached to new fittings?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Transmission Output Shaft Seal Removal
I'm trying to replace my transmission output shaft seal on my 2wd and I can't seem to get the seal removed. I couldn't find anything to rent from O'rielly's or Advance Autoparts that would work. It's in there really tight ....
View 10 RepliesFord F-150 - 1997-2003 :: 1999 - Automatic Transmission Removal / Mounting Bolts To Engine?
How does one get to the top mounting bolts to engine? Are special tools required? Is there an access plate?
View 6 RepliesFord - Explorer :: 1999 - Transmission Hunting Between 45 And 55 MPH
My wife got an Explorer, '99, 5.0, all wheel drive, automatic 4R70W with a lot of miles. It looks and runs great except for the transmission hunting between 45 and 55. I told her to lock out the OD except for freeway driving. Is there anything we should look out for in the vehicle?
View 12 RepliesFord - Explorer :: 2008 - Stock Subwoofer Removal?
Are there any guides out there on how to remove the stock subwoofer? I have been searching numerous places and coming up fairly blank on how to remove it. So far I have found that I need to remove the seatbelt bolt, but looking in the trunk it appears I need to remove the piece of trim that runs along the trunk lid floor and both the B and C pillar in order to remove the trim that goes over the subwoofer.
Does the trim clip into place on the trunk lip, pillars and over the sub? Looking for any more information on getting to the stock sub? I have found a half dozen threads of people swapping them out, but no one posted how they got to the subwoofer in the first place.
Ford - Explorer :: 1996 - Center Console Removal?
I am trying to remove the center console in my 1996 explorer limited 4x4 4.0 liter v-6 . Is there some type of trick or hidden fasteners? I am trying to replace the heater core.
View 2 RepliesFord - Explorer :: Driver Side Steering Arm Removal?
Working on power steering upgrade and removing old components. 51 f1 mostly stock with safety updates. I have the drivers side steering arm loose, but cant seem to remove it. Is there a cam or pin I am not seeing? Couldn't find any reference in shop manual. Removed cotter n nut. Used air hammer gently. Pushed forward 1/2" n then stopped. Swivels vertically.
View 1 RepliesFord - Explorer :: 1999 - Transmission Slipping When Shifted From Park Into Drive And Going Uphill
I have a problem with my transmission slipping. It seems to happen most often when I have shifted from park into drive and am going uphill. I don't really notice a problem with it when I am on flats or even at red lights. It can drift backwards for 10-15 feet before "catching."
I don't feel any problem when I am going faster or in higher gears. 1999 Ford Explorer SOHC 6 Cyl 4.0...
Ford - Explorer :: 1999 XLT Transmission Taking A Couple Of Seconds To Catch In Drive
I've had a 1999 explorer for a few months. The transmission has always taken a couple of seconds to "catch" in drive and was then fine. Today, I had to tow another car a short distance and now going into drive directly is useless.
I must shift into 2nd and then back into drive. Then, for the most part, the car drives fine unless I have to put it in Park or in Reverse. Then I must repeat the procedure.
The fluid is fresh and the dipstick shows a slight overfill. Is there anything I can do about this or is this the death of the transmission. If I can run it another couple of years, I'd be satisfied.
Ford - Explorer :: 2007 - Front Differential Cover Removal?
I just acquired a 2007 Ford explorer. I'm in the process of changing all the fluids and am wondering if there is room to pull the front differential cover off to clean the gunk out of the bottom of the front differential. It looks tight and I'm wondering if the differential or the steering rack and pinion need to be removed to remove the cover or if there is just enough room?
View 1 RepliesFord - Explorer :: 2004 - Front Door Panels Removal
I thought this might be a little difficult but it wasn't at all. Simplest door panel that I've ever pulled off.
first remove the panel that goes around the door handle, gently pry it up in the front where the speaker grill meets the panel, use a couple of flat head screw drivers for this. It will pop up once the tabs are released, then you can remove it.
Then remove the window/lock control panel, the front of this will need to be gently pulled up and then you can remove it by sliding it forward. Don't pry up on the rear or you can break the tab off. Unplug the three wire connectors/plugs. A small flat head will work with this.
Remove one 7mm screw behind the panel that you just removed, then remove the two 7mm screws on the very bottom of the door panel.
Now simply lift the door panel straight up and then outward, remove the last wire connector for the power mirrors & it's off.
I also replaced the outside door handle & lock assembly. It was very easy as well. just a 12mm socket, 1/4" drive ratchet & small flat head screw driver.
Ford - Explorer :: 2004 Explorer - Transmission Seal Blowing When Under A Heavy Load
I'm in a situation where I may be having to tow my 3500# boat/trailer with my '04 Explorer 4WD (this is well within the max tow limit, per the manual). I have the 4.0L with the 5 spd auto tranny and 3.73ls gears. I've towed the boat a handful of times with this vehicle and had a good experience every time. Now I'm looking at this being my primary towing vehicle, towing once or twice a month in the summer. The car only has 48000 miles on the ticker and is in pristine condition, so mechanically it's sound.
I asked my mechanic what he thought of this arrangement and he hates the Explorers, so he's giving a biased response. Have any of you towed something on a somewhat regular basis with this, or a similar, vehicle? Any issues? My mechanic keeps going on about the transmission seal blowing when under a heavy load.
Ford - Explorer :: 2003 - Power Steering Pump Removal / Replacement
I have a 2003 Ford Explorer with Power Steering problems. I have read and tried all the solutions I found here, except replacing the pump. Seems like it is the pump. Oil was burnt, I flushed twice. I checked the rack and lubed as identified in another post, same jumpy hard to steer issue. Anyway, now I am trying to remove the Pump. I have removed the reservoir and am trying to remove the pump. I have the top two bolts out, but cannot get to the bottom tow bolts. How do you access them? Do I need to remove the lower radiator hose, and / or the oil filter?
View 10 RepliesFord - Explorer :: 2004 - Rear Passenger Side Wheel Studs Removal
How do you remove the rear pass side wheel studs? I have knocked them loose but there isn't enough clearance to remove them. I have removed the parking brake shoes already. Does the hub have to be pulled to do this?
View 2 RepliesFord - Explorer :: 1996 4X4 - Starter Removal / Stuck By Oil Pan And Front Diff Housing
I have a friend with a 96 4.6 4x4. He tried to put a new starter. He couldn't figure out how to get it out! So I got called out. I can barely get under this dam thing. I'm lost on how it comes out. It stuck by oil pan and front diff housing. It not much that I'm stuck by 1/4" at most.
View 3 RepliesFord Transmission :: 1995 - Left Axle Removal?
I have to pull the left front axle shaft on my 95 250 4X4 to replace one of the axle ujoints. Before I get into this project, I'm going to replace all wheel bearings and related seals while I'm at it. Are there any seals that go into the differential that would be accessible after the axle is removed? Any quirks about getting it apart?
View 7 RepliesFord Ranger / B-Series :: Top 2 Bolts Removal Of Transmission?
How in the heck do you get the top 2 bolts off of the transmission housing? They seem to be positioned in such a way that they are impossible to remove.
View 14 Replies