Ford Super Duty (1999-2016) :: 2005 F250 - Transmission Slipping Going Uphill
I bought my F-250 Super Duty 6.0 last October, and I am extremely happy with it comparing to my former '03 Dodge 2500 TD. The Ford drives so much better!
There is only one problem I have with it. Without pulling it shifts nice and has lots of power. A Month ago I bought a fifth wheel trailer and I hardly notice it behind the truck, also it doesn't use more diesel pulling. However going uphill the transmission seems to slip, and I can hear (sounds like) a fan running loud? I loose speed.
All the temperature gauges stay normal, no difference. It starts to pull worse. I replaced de tranny filters, inside and the outside one. Also I did put the correct transmission fluid in there, no difference. Almost no grindings in the oilpan/magnet.
I looked on many sites, but cannot find anything on this. Personally I think it's the torque converter? My final step would be to have the transmission rebuild, with the best parts available, (close to WA, ID, MO)...
Ford Super Duty (1999-2016) :: Transmission Shifted Into Drive Takes 5 Seconds Or More For It To Engage Hard
I have a 2006 F250 Lariat super Duty / 6.0 L engine / 143000+ miles / once started and transmission shifted into drive it takes 5 seconds or more for it to engage hard or if I build up the RMS then it jumps into gear hard, after it gets going it feels like I am driving on a washboard until it get warmed up good 10 mile or so. Is it the transmission filter and if so which one, I understand there is a small one on the outside of the transmission if so where? I can't find it.
View 14 RepliesPrius (Gen 3) :: 2010 Shifted From Park To Drive?
I have had my 2010 Prius since August 2009, and have never experienced this til now.
I had pulled into my driveway and was talking on the phone using my factory-installed bluetooth speakerphone. When I power the Prius off while doing this, the call is in limbo for like 30 seconds before my phone's internal speaker picks it back up, so I put the car in Park and sat there talking.
I talked for about 10 minutes. Suddenly, the car started creeping forward and I hit the brake pedal. The car had shifted from Park to Drive.
No harm was done, but from now on I'm going to engage the emergency brake too.
Ford 7.3L Power Stroke (1999-2003) :: Transmission Slipping When Put It In Drive
My tranny is acting odd. I put in drive and seems to slip a lot in 1st, barely even move at some times. If I put it in 1st with the shifter it goes in and grabs then I can shift up to 2nd or drive and there aren't problems. It drives normally when not from dead stop.
Transmission has 50k miles on it since replacement. Fluid level is normal. I don't tow and drive it particularly hard. I will have to go back and look at miles since last fluid change. I should be right around 30k miles since last change.
Ford Transmission :: C6 Slips In Drive But Works Fine If Manually Shifted
I have a 78 f100 2wd, 300 inline 6 and I've put 2 c6 transmissions in it. The transmission shakes real bad in reverse. When you put it in drive and try to take off it wants to quit pulling but when you put it in first gear and shift up to 2nd it works perfect. My plan was to just junk the C6 and switch to a manual trans but I don't know what trans I would swap it with.
View 8 RepliesFord - Explorer :: 1999 XLT Transmission Taking A Couple Of Seconds To Catch In Drive
I've had a 1999 explorer for a few months. The transmission has always taken a couple of seconds to "catch" in drive and was then fine. Today, I had to tow another car a short distance and now going into drive directly is useless.
I must shift into 2nd and then back into drive. Then, for the most part, the car drives fine unless I have to put it in Park or in Reverse. Then I must repeat the procedure.
The fluid is fresh and the dipstick shows a slight overfill. Is there anything I can do about this or is this the death of the transmission. If I can run it another couple of years, I'd be satisfied.
Ford F-150 (2004-2008) :: Transmission Won't Go Into Drive Until Gas Is Given / Slipping?
Transmission won't go into drive until I give it gas and then hard shift between 1&2 then a little slipping when I get on it in higher speeds , fluid and filter brand new, threw a speed sensor so code I replaced with new but no change, don't know what to do and can't find out why speed sensor code went off changed but didn't fix? Can't drive truck!!!
View 3 RepliesFord Super Duty (1999-2016) :: 2006 - Tranny Slipping While Towing Uphill
'06 Power Stroke/136k miles.
This last weekend I was towing my rzr up hill and the tranny slipped, lost power, and the "Wrench" check eng came on. I pulled over, checked my fluids, checked for leaks, checked for smells, couldn't see anything visibly wrong.
Turned it back on and no other issues on the way to the camp site. On the way home, days later, same thing happened twice. Is the tranny going bye bye? Would it be worth it to get a flush for the possibility it just may be the fluid and maybe some sediments or something of the sort?
AND the bigger question is, if it is the tranny, should I trade this POS in, or replace the tranny? It has had a few problems lately with the turbo. Needs a new AC compressor. I didn't do much homework or know about the 6.0's before I bought this truck. After I bought this truck last year I heard about all the problems the 6.0's have and wished I would have went another route.
I can turn a wrench pretty decent (Aircraft Mechanic) but I have very little knowledge on vehicles, let alone this POS. I am apprehensive about doing a transmission or any big components without assistance. This is why I am trying to decide what the best option would be for the long run.
Ford Transmission :: Over Drive Light Started Flashing And Truck Got Jerky Going Uphill - 4r70w Went Out
One day I was driving my truck 96 f150 4x4 Eddie Bauer edition and the over drive light started flashing and the truck got jerky going up hills. I got home and hooked my code reader up and (p0708) it said transmission range sensor. I replaced that the next day and drove it around town for about 30 minutes and parked it all seemed to good. But the very next day I started down the road and the transmission was slipping very bad after I turned around after a few hundred feet I barley made it back to my house. I checked my transmission fluid it's full and doesn't smell burnt or anything, I double checked the alignment on the neutral safety switch I just installed and it still in line. So I'm thinking my transmission is going out...
View 4 RepliesFord Super Duty (1999-2016) :: 2004 F350 - Tow Haul Mode Pop On And Off When Shifted From Drive To Reverse
One of our trucks, 2004 F350 Powerstroke, my company truck, recently the last snow even we had, my tow haul mode would pop on and off almost evertime I shifted from drive to reverse while plowing. I didn't want it on, it just kept poping on and off. Thought maybe the button was stuck, but it moved like normal. My other thought was there is a loose connection in the shifter or column causing it to go on and off.
View 6 RepliesFord Super Duty (1999-2016) :: 1997 - Uphill 4th Gear Very Hard - Clutch Slipping?
I have a 1997 F250 heavy duty 4x4 7.5 efi. I just bought a 2003 weekend worrior weighing 5800lbs dry. When I go up slight hills in 4th gear it seems to work real hard especially on freeways, could my clutch be slipping or am I just at max tow
View 11 RepliesFord - Explorer :: 2003 - Transmission Forward Gears Are Slipping
2003 Explorer with a slipping transmission...codes are P0731, P0732, P0733... Just had a new solenoid pack installed last week when O/D light came on and truck was clunking into reverse. Now, after new pack was installed the forward gears are slipping all over the place!
View 5 RepliesFord - Explorer :: Transmission Is Slipping / SES Light On - Multiple Codes
Any way, they come to me and tell me the tranny is slipping. I immediately notice the SES light on. I decided to check codes to see if I have any errors coming from the tranny. So far I have these codes: P0455 P1151 P0304 P0174
I dont know this vehicle at all and wanted to see if some of these items are common and/or possibly related to each other.
Heres what I have found:
P0455 - EVAP leak somewhere. Seems a lot of people have discovered a crack in the filler neck.
P1151 - Passenger O2 LEAN
P0304 - Cyl 4 misfire
P0174 - Passenger lean condition "A Heated Exhaust Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time."
Looks like I need to clean the MAF, check vacuum leaks, possibly replace passenger O2. Ive also read some of these codes come from a common issue with the intake gasket. May need to replace it? How should I clean the MAF? Can I use some normal solvents?
I need to mention a tick/tap on pass side under cold idle (consistent, but not constant). Still need to test to see if it happens at other times. Right now has Seafoam in the oil and about to run it and then change the oil. Also, have ran it though the brake booster. Currently in the sit and wait process, about to go out and make the neighborhood smoke like Hiroshima.
Ford - Explorer :: 2003 - Cutting Off While Driving When Shifting From Drive To Park
I have an '03 sport trac with 146k miles on it. Truck is in good shape for the most part, it has been very well kept before i got it. In the last few months i have had the flow master exhaust put in and the k&n intake. I had the vacuum leak problem with the hole in the elbow, which was fixed and discovered after replacing the IAC.
I have had a problem with the vehicle almost but not quite stalling when shifting from drive to park. The first thing i did was check for vac leaks, found none. I did not replace the IAC again only because it is only a few months old. I also replaced the MAF, which did not work either, I was still almost stalling going from D to P. The vehicle shut off while in the drive through at McDonald yesterday. It restarted roughly and i managed to get it to a safe spot. I lifted the hood and felt the radiator main hose was solid feeling, so i drove home and replaced the thermostat. In the process i got coolant all over everything.
The problem I am having now is the truck is just cutting off, both at idle and while driving down the road. It starts right back up and away i go. It is random, the truck is running a ok with no signs of any trouble then the next second it shuts off.
Ford Transmission :: 1994 F250 4x4 - Slipping In Drive And OD / Started Dumping Fluid
I was towing my 20' boat and had a 4000 lb camper on back going up a grade in 85-90 degree heat when the tranny started dumping fluid. Got to the top and let it rest for 2-3 hours and refilled and was fine for the rest of the trip. This happened last summer. Truck is only driven about 1000 miles a year. I believe this is the E40D.
This year it will run smooth until after about 20 miles and then begins slipping in Drive and OD. Seems to work fine in 1 and 2. It shifts very hard and runs higher rpms before doing so. Slipping then seems to be sporadic and may not slip for quite awhile but it still shifts very hard.
Ford - Explorer - Fuel-economy :: 2004 - Stalling At Times When Going From Park To Drive
2004 Explorer 4WD XLT 4.0 6cyl - Mileage is 117,000 - Check Engine Light came on - Pulled the code of PO193. Had the Fuel Pressure Sensor changed, Plugs and wires and check engine light is still on after being re-set several times? Car is stalling at times when going from park to drive - It seems to idle ok in park but, when in drive at a red light, the tac will bounce a little and it seems like it's not getting enough fuel and will stall out at anytime. Is there a fuel filer that can be changed? Should I have the fuel injection checked and cleaned along with a fuel filter. Seems to be getting poor gas mileage.
View 1 RepliesFord - Explorer :: 2004 - Transmission Slipping Out Of Gear At Stop Lights After Oil Change
Like the title says. 04 Explorer.
No transmission issues ever. Immediately after doing an oil change myself for first time, get some transmission dropouts, slipping out of gear at stop lights, waiting way too long to go into 2nd, etc.
Then, started getting OD off light, and service engine. Error codes show something about wrong setting for 2nd, 5th, solenoid error... a bunch of 'em.
Anyway, guy at parts store says I must have knocked a wire loose causing misreads between cpu and transmission. It's a real pain getting under there since I'm using jack stands, so exactly what I should be looking for or at least the exact name of a connector or something so I can look it up.
Ford Transmission :: 2005 Expedition - When Select Drive Will Not Shift Into High Without Slipping And Rapid RPM Increase
Just made it back from out of state hunting trip,driving to get new tires. And heard a bump sound , Driving about 40 mph and tack jumped from around 1800 rpm to 4500. Engine' smooth and parameters good . However will drive in low and 2 nd gear approximate 25 mph. When select drive will not shift into high without slipping an rapid rpm increase. Currently 135k service record's and general appearance were well maintained....
View 2 RepliesFord Excursion :: Transmission Will Occasionally Hesitate To Engage Drive From Park
Just a little background, my Ex is a 2000 V10 4x4 with 217,000 miles. I've owned it for a little under a year. Very clean truck, and well maintained by previous owner. Now the issue. Starting about a month after I bought it, it would occasionally hesitate to engage drive from park. I checked fluid and it was full and clean. I had a buddy recommended that I check for chafed wires in the steering column which I did and found nothing. It seemed to get better for a while but now it's back. It's doing it more than half the time I put it in drive and sometimes takes 10-15 seconds to engage. So am I probably looking at a new trans? Or, is there anything that can be done to save the old trans?
View 1 Replies