Ford - Explorer :: 2003 V8 AWD Binding On Turns
I recently purchased a 2003 Eddie with V8 and AWD. On turns everything was binding making the turn almost impossible to take. The front hubs have been replaced and it now has four new tires. This is a great deal as the Anti-lock sensors in the hubs were throwing a code and the bearings were shot. This made a difference but there is still some binding taking place. This truck is a daily driver so need to know where to go from here. I pulled two fuses that were listed as "4wd v-batt" but this made no difference so I put the fuses back. My mechanics Snap-on modis computer doesn't find any codes at present, so we are confused. Nice vehicle, but this is driving me crazy.
View 13 RepliesFord - Explorer :: 2002 - Turns Over But Just Won't Start
It turns over but just wont kick in. Battery good, fuel pump good, no check engine light. It did this a couple time this month, and finally started, not it wont start at all. Runs great otherwise without any issues. Just don't know where to look or what to look for. All fuses are good. Fuel pump safety is okay.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2003 F250 Turns Over / Starts And Immediately Shuts Off
I have an 03 f250 that i think is getting air in the fuel line when it sits. It turns over starts and immediately shuts off. Then i have to crank it for a minute or so before it will start. After that it is good all day. Next day it might sputter on start but stays on. More than a day it shuts off immediately and needs cranking for a minute...
View 13 RepliesFord Excursion :: Turns Over But Starts To Shudder And Buck - Fuel Pressure Gauge Reads 0
Just had the tires rotated , then shop tech backs the X out of the shop, parks it and then hands me the keys. I hop in and turn the key , the truck turns over , but starts to shudder and buck, and fuel pressure gauge reads 0.
View 3 RepliesFord - Explorer :: Starts Only When Cold
I have a 'mysterious' problem, that has stumped Ford mechanics and everyone else that I've taken it to; my 1991 Explorer will 'start' COLD,drive great as far as you want, but don't cut the key off!!! It will not start 'hot'!! You have to let it 'cool' all of the way back to cold!!! I have driven it all day long, making stops of up to three hours, and it never quit ONCE!! Used a lot of gas !!! We've changed all types of parts BUT nothing has worked... I put it in a 'Garage' to be looked at and all they did was 'blow' the engine up. They didn't fix my mysterious problem and now won't release the car, unless I pay them.. I got the tires off at night!!!
View 3 RepliesFord - Explorer :: 2001 - Turns Over Just Fine But Makes No Attempt To Actually Start
2001 explorer, SOHC. Sometimes just lately (5 times in the past three weeks) the engine just does not start. It turns over just fine but makes no attempt to actually start. When it does this it will after a few attempts start right up like nothing was ever wrong. It doesn't seem to matter whether it is cold or warm. Intermittent problems are very hard to diagnose .....
View 10 RepliesFord - Explorer :: 2003 - Bind In Sharp Turns - Occasional Knock?
Picked up an '03 Eddie Bauer v8 with the full time AWD knowing that the transfer case needed to be replaced, I got a good deal so it was worth it. It's still driveable but it binds in sharps turns and I get the occasional knock. I have two questions really, what is the correct PN for the single speed transfer case for this year model?
All the online ford parts store will give me is 7A195... well yeah, there's like a hundred different variations on that part number. And what year Mountaineers and Aviators will cross over to the Explorer? I've been searching ebay but their info is all over the place, no consistency. As an after thought, how difficult would it be to convert this to a 2 speed part time 4x4?
Ford - Explorer :: 1998 - Steering Is Binding / Shaking During Stopped Or Low Speed Turns
Just replaced a badly worn Hub on my 98 AWD Explorer. The grinding noise is gone but now the steering is binding/shaking during stopped or low speed turns. What is going on or what I might have done wrong?
View 3 RepliesFord - Explorer :: 1995 - OD Off Light Starts Flashing By Itself?
The OD OFF light starts flashing by itself and I can't get it to go out. Everytime it does this, the car is sluggish, won't pull very good at stop signs and kicks hard when down shifts. Thought it was weather related but it doesn't matter what the temp. is. Eventually it will go out by itself and everything is fine.
View 4 RepliesGTI 337/20th Anniversary :: Car Starts But It Turns Right Back Off
So my Gti 337 it starts but it turns right back off starts and turns right back off people are telling me it's the fuel pump checked it it's not that people are saying its my ECM.
View 5 RepliesToyota - Camry :: Turns Over Slow But Starts
2004 camry 4 cyl. turns over slow but starts. I checked battery voltage (car not running) it is 12.6 volts. when cranking in dropped to 6.??. The post terminals and cables looked ok but I did not disconnect or remove them to check. How can I verify if it is a bad battery or a bad starter.
View 3 RepliesFord - Explorer :: 2001 - Starts Then Sputters / Dies And Won't Restart Again?
I have been having issues with my 2001 sports trac 4x4 v6 sohc fuel in. 132k mileage. The problem is I can jump in and it will start first try, fuel pump is heard activating, idle is rough, feels like truck is about to die, pumping on the gas usually causes it to catch and smooth out......after 10 mins. or sometimes less than that truck starts to sputter, step on throttle it dies faster, sometimes when stepping on the throttle before it dies and a truck is able to rev up and then back to idle and not die.
But most times stepping on the gas when it begins to sputter after running for 10 mins or so causes it to die once it dies it doesn't start back up and when key is turned on and off, no fuel pump activation noise. I have scantool data take off an autel 619 saved to notebook text format. Those are my numbers for the scan tool, suggestions I have gotten so far are vacuum leak, failing fuel pump, bad o2 sensors, bad MAF.......so far replaced fuel filter and cleaned MAF....no difference.
Ford - Windstar :: 2003 - Grinding Front Brakes On Occasion When Coming To A Stop
My 2003 windstar SEL needed new brakes and to have the rotors turned... instead I opted to buy new discs and pads online ... To my surprise the new discs were about a 16th of an inch thinner than the old.... I changed discs and pads and was happy for a few days, but now on occasion when coming to a stop the front brakes grind terribly....the next time i stop everything is fine...visa versa...dscs feel true (no pulsing) I DID APPLY BRAKE QUIET TO THE BACKS OF PADS....
View 2 RepliesPrius (Gen 2) :: Passenger Headlight Starts On But Then Turns Off After About 10 Minutes
I have a 2008 Prius touring edition. The passenger headlight starts on but then turns off after about 10 minutes. How to fix this issue?
View 5 RepliesElantra XD (2001-06) :: 2002 - Starter Turns And The Car Almost Starts
The car has been sitting since last March (11 months). I have 3/4 tank of gas. The starter turns and the car almost starts. I suspect old gas is the problem because it sounds as if it wants to start and the gas is old. Could it be the injectors are clogged? If so, is there a way I can clean these myself? Or maybe another diagnosis?
View 2 RepliesFord - Explorer :: 2007 XLT - Clunk Noise While Making Left Hand Turns At Slow Speed
My wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
Ford - Explorer :: Vehicle Starts And Idles A Bit Rough - Cylinder 8 Misfire
I just got a 4.6 4WD Explorer in for rough running. It had timing chain noise and some odd codes for primary coil H codes along with cylinder 8 misfire.
I replaced the coil to get rid of the "H" code and it was fine. Still misfires on 8, and I really don't care because it's coincidence that the timing could be affecting it or perhaps.... bent valves!
The vehicle starts and idles a bit rough. Can't go very fast, and of course I know I should run it as little as possible!
Here is the deal, how should I present this to the customer? Should I let him know that some valves could be bent after replacing the chain (and all associated parts) and that it could still be effed? Or will I be fine after replacing? Pretty much, where they had a tensioner failure/guide breakage and valves bent too?
Ford - Explorer :: 2003 Starts Will Only Run For A Couple Of Seconds At A Time Then Stalls
I have a 2003 ford explorer sohc 4.0l , that starts only with the gas peddle pushed to the floor and will only run for a couple of seconds at a time. Just replaced all the timing chains and tensioners. It has 145 lbs compression, and 60 psi fuel pressure. No codes on the computer.
View 8 RepliesFord - Explorer :: 1992 XLT Starts Chugging And CEL Comes On After Running Good For 15 Minutes
1992 Ford Explorer XLT 4wd 4.0L (California vehicle) runs good for about 15 minutes, then suddenly starts 'chugging,' loses power, and check engine light comes on. After sitting overnight, it will again run good for about 15 minutes, then repeats the problem.
This problem began AFTER smog check test failed (it ran smoothly all the time before) and after, as was recommended to me, I replaced the 02 sensor. (Failure of smog check, it turns out, was more likely because, unknown, a 10" piece of exhaust pipe was missing, so Catalytic Converter was not connected to the tailpipe).
I had a mechanic scope the Explorer but he could not determine a specific failure from the codes, although he suggested possibly it's the missing 'Octane Adjust Shorting Bar,' or maybe the 'crank position sensor' is bad, but he could not give a diagnosis.