Ford Transmission :: C4 Shifting Out Too Early When Takeoff
I am having a transmission problem. I have a 76 F100 with a 300 and a c4 tranny. When I take off it seems to be shifting out way to early. It goes in to 2nd gear at about 10mph and 3rd between 20-25mph. I do have a kickdown linkage hooked up but I have not messed with any adjustments. The is a vacuum line that runs to the rear of the transmission. Also sometimes when shifting in to 3rd it seems to go in to neutral before going in to gear.
View 1 RepliesFord - Explorer :: 2002 - Transmission Shifts After 3 Seconds - Won't Run Immediately After Shifting?
I've just bought a used 2002 Explorer Sport Trac (Automatic) 120k+ odo and what I've noticed whenever I shift from Park to Reverse or to Drive it takes about 3 seconds before I feel a slight jerk moving forward before I can step on the accelerator for the vehicle to move backwards or forwards but if I step on the accelerator right after shifting to any gear except Neutral it won't run immediately as if the clutch is disengaged and after about 3 seconds it will suddenly engage. Is this normal or is there something wrong with the transmission?
View 3 RepliesFord Transmission :: C6 Downshifting Early When Coasting To A Stop
I have a 77 F250 4X4, 400, C6. Upshifts and downshifts are working normally, except under light load and minimal throttle the tranny downshifts to 2nd at any speed under 40 mph. I've never had an automatic do this before. I checked the kickdown linkage is pulled up so it's doesn't seem to be in kickdown position always, no vacuum leaks to the modulator. I confess to be more of a manual trans guy so my knowledge is autos is limited.
View 2 RepliesCivic - Honda :: Brand New Clutch Makes Engine Sputter When Shifting Slightly Early
I had a new clutch put in my '94 civic a few months back during the engine rebuild. I'm anal about saving gas so I tend to shift a bit early, not enough to make the engine chug, but I might shift into 3rd gear at 17 mph. Never had a problem with it. Since the rebuild, when I do shift earlier, the car has hiccups where there is little or no power for a half to full second. The engine will sputter for a bit until I get up into normal operating range. But it's not like before, I'm shifting no earlier than I have been for the last 6 years and have never dealt with this before. The rpm's don't shoot up so I don't think it's actually slippage.
View 11 RepliesCamry 2012+ :: 2014 SE Transmission Seems To Shift Into High Gears Way Too Early
Drove a new 1.8T VW Passat last night. 170hp/184ftpd torque. Huge difference! My Camry feels totally underpowered now. Also the transmission seems to shift into high gears way too early. Had reprogram recall done and shifting was better for a little while but now is back to being the same as before.
View 14 RepliesSonata I45 (LF 2015+) :: Torque Converter Locking Up So Early - Shuddering And Rattling Transmission
The problem is that it appears the torque converter is locking up so early even right after getting into second gear at speeds between 20km/h and 40km/h. This causes shuddering/rattling coming from under the hood. If I am not mistaken a torque converter should lock up at speeds 80km/h+. I've never seen this behavior on any car before. I'm not sure what kind of damage is being done either by all this shuddering and rattling going on with the transmission. I feel that this should be something that needs to be addressed via some software update. Is there any software update in regards to this issue?
View 5 RepliesFord - Explorer :: 1992 - Self Acceleration Between 15 And 25 Mph
Why is my 1992 ford explorer self accelerating between 15- and 25 mph?
View 1 RepliesFord - Explorer :: 1992 4.0 - No Spark And No Fuel
VEHICLE: 1992 Ford Explorer, 4.0, 4wd Automatic, CALIFORNIA EMISSIONS w/ 59,000 Miles...
PROBLEM: Engine rolls over great, BUT No Spark, No Fuel
Here are the tests I've done:
- Each and every relay √
- Each and every fuse √
- Ensure inertia switch hadn't popped √
- Directly connect 12 volts to pump & pump came on √
- By-pass inertia switch √
- Replace PCM √
I'm thinking it's time to start checking grounds and chasing wires....
Ford - Explorer :: 1992 Died When Tried To Start And Then Restarted
I purchased a 1992 Ford Explorer Eddie Bauer edition two weeks ago from a private dealer. Last week I went to start the car, and it started, but then turned off almost immediately. I dismissed it at the time saying I did not turn the key long enough or far enough because when I tried it again, it started.
However, this morning (05/06/14) it turned itself off again. It was on for about a second or two before it died. I started it again and pumped the gas. It started for me but it sounded rough like it might die again.
I am not sure how to fix this. The previous owner did not mention that there was any problem. I am thinking that I'll either need to replace the battery or the spark plugs.
Ford - Explorer - Transmissions :: 1992 - Engine Won't Turn Over?
1992 Fod Explorer XLT: When I attempt to turn over the engine, the flywheel spins, but the engine doesn't. This is a very gently driven vehicle. I drove home hone day, backed into the driveway and unloaded the groceries. The next morning, when I tried to start it, the engine will not turn over. I dropped the starter and tested it--all good. While I had the starter off, I found I could spin the flywheel freely--appears to not be attached to the engine. It's tight with no play whatsoever. Last year I had a new flywheel installed--something I would do myself, but decided I'm at the age, I'm just not up for it. It's been running great for 18 months with no problems. There was never a noise. This just happened one morning. I thought the crank may be broken, but that seems unlikely since it was driving great until the next morning.
View 13 RepliesFord - Explorer :: 1992 - Emergency Brake Stuck
I have an '92 Explorer 4X4 with a stuck emergency brake. I have tried tugging on the lines from the back of the truck (where the line splits into two beside the frame). The brake is stuck in the on position, and when I pull the release nothing happens. It has been cold here lately, so i thought they were frozen, but after pulling the release lever, it seems like a mechanical issue.
Any temporary solution that get my truck drive-able and to my mechanic for a closer look. I am not very mechanically inclined but it seems to me that the release lever is pulling at nothing and not moving the cog to release the actual emergency brake.
Ford - Explorer :: 2004 Explorer - Transmission Seal Blowing When Under A Heavy Load
I'm in a situation where I may be having to tow my 3500# boat/trailer with my '04 Explorer 4WD (this is well within the max tow limit, per the manual). I have the 4.0L with the 5 spd auto tranny and 3.73ls gears. I've towed the boat a handful of times with this vehicle and had a good experience every time. Now I'm looking at this being my primary towing vehicle, towing once or twice a month in the summer. The car only has 48000 miles on the ticker and is in pristine condition, so mechanically it's sound.
I asked my mechanic what he thought of this arrangement and he hates the Explorers, so he's giving a biased response. Have any of you towed something on a somewhat regular basis with this, or a similar, vehicle? Any issues? My mechanic keeps going on about the transmission seal blowing when under a heavy load.
Ford Ranger / B-Series :: 1992 - No AC And Power Steering / Poor Clutch Disengagement Resulting Hard Shifting
1992 Ford Ranger 4x2 with 2.3L engine and 5 speed manual transmission. 135,000 miles, no AC and no power steering. I am having poor clutch disengagement and resulting hard shifting. The shop added a little fluid to the reservoir last oil change and it is still looking full. I always park on concrete and never see any leaking. I don't know what may have been done before as I haven't had the pickup all that long. Where should I start? Is there probably internal bypass leaking in the hydraulic clutch as there seems to be no external leaking?
View 4 RepliesFord - Explorer :: 1992 - Starter Started Grinding / Flywheel Shim
I have a 1992 for explorer XLT 2-wheel drive Automatic 4.0 engine. The starter started grinding against the fly-wheel. Changed the starter and the same thing happened. There is no shim for this starter. I took it down and checked the flywheel--as much as I can see through the starter mount hole and the teeth on the flywheel are great. There is only the slightest point of impact where the starter is just grazing the flywheel.
I also grabbed the flywheel to look for looseness, thinking it might have broken and/or warped and I just can't see where it broken because of the small hole. It's solid! It's as if the whole thing just moved back about an inch and a half... I texted both the old and new starters with jumper cables, and the make certain, I took them to the local parts store and they also texted them. While both of the starter were fine, I'm not!
Ford - Explorer :: 1992 XLT Starts Chugging And CEL Comes On After Running Good For 15 Minutes
1992 Ford Explorer XLT 4wd 4.0L (California vehicle) runs good for about 15 minutes, then suddenly starts 'chugging,' loses power, and check engine light comes on. After sitting overnight, it will again run good for about 15 minutes, then repeats the problem.
This problem began AFTER smog check test failed (it ran smoothly all the time before) and after, as was recommended to me, I replaced the 02 sensor. (Failure of smog check, it turns out, was more likely because, unknown, a 10" piece of exhaust pipe was missing, so Catalytic Converter was not connected to the tailpipe).
I had a mechanic scope the Explorer but he could not determine a specific failure from the codes, although he suggested possibly it's the missing 'Octane Adjust Shorting Bar,' or maybe the 'crank position sensor' is bad, but he could not give a diagnosis.
Ford Transmission :: 2000 F150 - Transmission Holding 2nd Gear Too Long Before Shifting Into 3rd
I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.
View 6 RepliesFord - Explorer :: 1992 - Coolant Leak At Front Of Engine Above Water Pump
My 92 Explorer 4WD has a coolant leak somewhere at the front of the engine above the water pump. I assume it's the lower intake manifold gasket leaking. The engine has 170k miles. I'm also seeing a small amount of white smoke, possibly steam when the engine is running. It's somewhat heavy when I start it up but mostly goes away once warm, so I suppose it could be steam, but could be coolant from either a head gasket leak or lower intake leak.
I also get a lot of water from the exhaust dripping on to the floor and the smell of the exhaust could be that of coolant, it's hard to tell. There is no coolant in the oil. I was wondering if I should go ahead and change the head gaskets while I have the intake out. Is there anyway to be certain the head gaskets are fine? I'd hate to change the intake gasket to find out there's a small leak in one of the head gaskets.
One other thing: I failed emissions because my CO was too high, but my HC and NOx were very low. Could this be an indication of coolant entering the combustion chamber? Just wondering why my CO was so high yet everything else passed (Massachusetts emissions).
Ford - Explorer :: 1992 - Clunk In 4 Wheel On Left Side Like The Transfer Case Bind Up
Something is snapping/clunk in 4 wheel about every 20-100' driven on the left side. Slightly notice it in 2 wheel but 4 it's loud and you can feel the clunk. It's almost like when you feel the transfer case bind up, yet feels like it's right in the left side, up front. Yes I have to put new tires and rotors up front, upper and lower ball joints and inner tie rod on the right side. U joint in front drive lines feel solid.
View 4 RepliesSilverado :: 1992 - Rough Gear Shifting With Clunking Sound?
I Own A 92 Chevy Silverado, 154 K Miles. Runs Great! My Problem? I Experience Rough Shifting At First Take Off, After She Warms Up The Shifting Is Smooth. After Parking And Starting Again, Rough Shifting With A clunking Sound.
View 9 Replies