Ford Exhaust System :: Copper Exhaust Coming Off The Headers
Why it won't work. copper exhaust coming off the headers. I have the ability to get it and bend it and how cool would that be copper duals. Why won't it work. If I bolt it right to the headers.
View 7 RepliesFord Exhaust :: New Exhaust - Pipes Coming Out Of The Headers Alone
I got this hankering to re-do my exhaust while my truck is all dissembled. My true dual has been a mistake since day one. It never gave me that deep growl that I wanted, and I miss my old cat back. Anyway I thought of an idea that would give me my one muffler back with plenty of air going into it. Check out the pics, and let me hear it. I will be leaving the pipes coming out of the headers alone, that way I don't have to buy doug thorleys expensive y-pipe.
View 2 RepliesLexus GS 2006-11 :: AWD Exhaust System Has Rust / Leakage
I have come across reading about all the issues 2006 AWD models have, and one in particular is the exhaust system. It lacks a proper replacement. After reading about people's exhaust system leaking having rust through out, I decided to take a look at mine. It is full of rust.
View 9 RepliesToyota - Rav4 :: 2007 - Ceramic Brake Grinding Due To Slight Rust Build-up?
In September 2012, I had all of my brake pads and my front rotors replaced. On at least two occasions since then, I have noticed grinding. I took the car back to be looked at in October and today and in both instances the mechanics couldn't find a thing wrong with the brakes. On Saturday, I was driving more than usual and they were grinding the majority of the time. I'm not sure why this problem comes and goes and whether it increases with use over the day. I find it easier to replicate when coming to a stop in the street rather than in the driveway at a low speed. Is there something I ought to have the mechanics test out? In each of these cases, they have test driven my car, but at the same time, I don't want to tell them "Try driving it for an hour".
I drive a 2007 Toyota RAV4 (about 56000 miles on it) and while I am aware of grinding due to slight rust build-up, that issue usually clears itself up after the first few brakes of the day (I believe that this is a common problem).
Ford F-150 (2004-2008) :: Headers And Exhaust Replaced - Codes P0010 And P0020
I replaced my headers and added slp loud mouth 2 side exit now my truck is throwing every evap code o2 codes and p0010 & p0020, There is 17 codes total. The headers are obx without cats. Also added 80mm bbk throttle body and some brisk racing plugs with hot street coil packs. Truck run with all of that stuff fine but when i did the headers and cat back everything went wrong.
View 9 RepliesFord Exhaust :: Rust Build Up Inside The Exhaust
How to get rid of the rust build up inside the exhaust right at the exit point. The dual exhaust is in front of the right rear tire. 2005 f-150 5.4.
View 4 RepliesFord Super Duty (1999-2016) :: 2011 - Shorty Headers Match Up With The Stock Exhaust?
Looking for aftermarket headers for a 2011 f250 6.2l gas job. I have the famous leak and I want to put something in that isn't going to warp. I was told shorty headers typically match up with the stock exhaust. Eventually going to put in a cat back also so true shorty headers would be sick.
View 14 RepliesIS F (2008-2014) :: Headers With Stock Exhaust?
i cant find the dyno post but didnt the isf make more power with headers and stock exhaust?
View 6 RepliesFord Exhaust System :: 2006 - Exhaust System Installation?
Want to install exhaust system on my 06 F350.Tell me,what is the best brand for my truck,I know, very good intake system is from K&N,what about exhaust?
View 10 RepliesFord Exhaust System :: Exhaust Leak - No Gasket Or Donut Ring In The Flange?
I tore it apart and there was no gasket or donut ring in the flange. Is there supposed to be a gasket or donut ring? I can feel the leak with my hand. I have retightened & it still "tick-ticks" real bad.
View 7 RepliesFord Exhaust System :: 351w Exhaust Collector Stud Nut Size
I have a 90 bronco with a efi 351w and im missing one nut for the manifold to exhaust pipe flange. I have looked all over the net and can't find the size I know its a 1/2in socket but I need the thread pitch and size, had the parts guy try to sell me the stud and nut kit seem really expensive for just a nut and to install the full kit I have to pull skid plates and the trany supports just to start to get room to do the job, seems like a lot of work to replace 1 nut...
View 1 RepliesFord Exhaust System :: 2003 V10 - Running Little Bit Rough / Exhaust Leak?
I just purchased a 2003 V10 with 270 000kms. The truck had had regular maintenance. It has an exhaust leak and runs a little bit rough. Could the exhaust leak cause the truck to run a little rough or am I dealing with another issue?
View 2 RepliesFord Exhaust System :: Exhaust Quieter When Cold / Much Louder When Warmed Up
My F150 exhaust seems rather quiet when I first start it up, but after it gets warmed up good, the exhaust is much louder (which I like). I started wondering if I had a crack up front that widened out when it got hot, so looked under it when I got home today with it hot and still idling, but didn't see any cracks. Also I did not hear any noise like a leak. All sound was coming from the side exit pipe. So... what is the phenomenon that would cause this?
View 5 RepliesFord Exhaust :: 2000 - Can Remove Catalytic Converter From The Exhaust System?
Long story, I'll try to make this short, 2000 E250 5.4L What would or could happen if the catalytic converter was removed from the exhaust system?
View 5 RepliesFord Exhaust System :: 1996 F150 - Exhaust Making Strange Howling Noise
Ok, probably about 1/3 times i start my 96 f150 4.9 with true duals, the left pipe has a higher pitched howling noise, its a steady tone whether I rev the truck up or not it just gets louder. It will do it for about 6 seconds and then stop. The truck doesn't run badly because of it, but i took her to autozone to get her scanned and they said that the oxygen sensor on the first manifold bank has a slow response on startup. Is that what causes this strange noise, I don't even know how it would make it, it sounds much different from the engine. The right pipe doesn't do anything.
View 9 RepliesFord Exhaust System :: Exhaust Manifold Leaking / Louder Than Normal Knock When Accelerating
Leaking exhaust manifold? The truck has a much louder than normal "knock" when accelerating. At first I thought and had some bad fuel in the tank. I eliminated that with a full take of good fuel and some STP but the "knocking" continued. Then I thought that perhaps it wasn't firing on all cylinders but it felt like it had full power. I took it to my mechanic and he said it as a exhaust manifold leak. He said that he has never replaced the exhaust manifold but that it was a "nightmare" and expensive. He also said that it's not a safety issue but on the long run the leak would cause the truck not to pass its emission test. He said the problem was with rusted bolts that would be difficult to remove.
View 12 RepliesFord Exhaust System :: 1994 Ranger - Loud Exhaust Sound In / Outside The Truck And At Idle
I have a 94 ranger 4L. I am looking for a more loud exhaust sound in/outside the truck and at idle. I have had a cherry bomb turbo on it and it was ok but not loud enough for my liking. I just picked up a flowmaster 40 2 days ago and it sounds good but again just not loud enough for my taste and kinda a lot more. I was looking for a louder muffler that is not a glasspack and would like to stay under like 80 or so.
I also thought about getting a high flow cat which i think might make some more sound but was not sure. Im running the stock pipe which is 2" and end in back of the wheel on the right. I look at the Hooker Headers Maximum Flow Muffler which i thought would be louder b/c it's more straight through the muffler so it would put off more sound better. What would u recommend for something more loud ?
Ford Exhaust System :: Exhaust Leak At Manifold Where Donut Gasket Meets The Catalytic Converters
My truck just started running really loud when it's cold and the leak goes away when it warms up to operating temperature.I did a little bit of investigating and I have found where the leak is coming from at the end of the exhaust manifold where the donut gasket meets the catalytic converters. It appears that the bolts rotted that hold the system together at the gasket. What should I do to repair this? I don't really want to replace the whole manifold because I know I'll break a stud off in the engine because everything is pretty rusty down there. I even took some pictures of the problem....
View 3 RepliesFord Exhaust System :: 1994 F250 - Replacing Exhaust?
I have been thinking about toying with my exhaust. I don't have a crazy amount of money. I got a 94 F250 with the 5.8 liter 351. Heres what I was thinking. Get rid of everything after the cat, and then run a single 3 inch pipe from the cat to a flowmaster 40 series, and then exit either right before the back tire or right after it.
View 7 Replies