Ford Transmission :: 1979 F150 - 4 To 5 Speed Trans Swap?
I am looking to change out my manual transmission in my 79 f150. I want to put a 5 speed in it but still keep my manual clutch. I have a 300 engine that I also want to keep, can I just put a late 80's early 90's 5 speed transmission in it and keep my original bell housing?
View 5 RepliesFord Aerostar :: Auto To Manual Trans Swap - Code P1744
My friend has a 97 Aerostar swb panel van. It's a 3.o with an automatic, with the code of death P1744. For the price of a rebuild, he would rather put a manual trans in it. What trans will fit, and what needs to be done as far as electronics goes?
View 8 RepliesFord 6.0L Power Stroke Diesel :: Stuck In 3rd Gear After Trans Swap With 10 Codes
Bought truck for cheaper price with no 3rd gear. Went to a reputable yard and picked up a cheaper trans... It was carfaxed with 185K miles and in a rollover. (This is the last time I try to save a couple bucks by getting a cheaper transmission.)
I believe trans is stuck in 3rd gear...Takes off slow. RPMs do not drop..Doesn't shift...Feels like I'm in 3rd from takeoff. Here are the codes:
P2262: Turbo / Super Charger Boost Pressure Not Detected Mechanical
P2614: Camshaft position signal output circuit / open
P2262 again
P1000 On board diagnostics II Monitor / drive cycle test not complete
P0678 Cylinder 8 glow plug circuit
P0672 cylinder 2 glow plug circuit
P0603 Internal control module keep alive memory malfunction
P0720 output shaft speed sensor circuit
B1676 Battery pack voltage out of range
B1318 Battery voltage low
Ford Ranger / B-Series :: 1986 - Diesel Swap - Engine And Trans Combos?
I have A 1986 ranger with a 2.9 v6. I am thinking of doing a diesel swap and I am wondering what engine and trans combos would work best for this. I was thinking 4bt but there are may other options that could work.
View 14 RepliesFord F-150 - 1997-2003 :: Trans Swap Form 2000 To 2002 - Repin The Harness?
Ok so I've done a lot of searching but can't find any info on how to repin the harness to use the 2000 4r70w in my 2002. Both are 4x4 and came behind a 5.4.
View 4 RepliesFord Super Duty (1999-2016) :: Engine Swap 2006 F250 5.4 To 1000 7.3 Trans?
My dad has a 2006 F-250 5.4 3v that spun a rod bearing at 107,383 miles. He's never been thrilled with the performance of it (told him he should have gotten the 6.0 when he bought the truck new, but why listen to a 15 yr old ). We've been throwing around a couple different ideas for engine swaps since the 5.4 is dead. We scored a 5.4 2V Lightning engine, but after trying to figure out transmission controllers or if we'd be able to tune the stock PCM for the 2v, we've put the project on hold.
Recently, I've been trying to convince him to do a diesel swap over the L-motor. I have a friend selling a cheap 99 7.3 with trans, PCM, harness, intercooler, piping and other misc stuff. Would that harness generally be plug and play with the body of the 06? Would it be more worthwhile to try to find a 6.0 from 05-07 and swap everything over?
I've also been considering a Cummins swap, although I haven't gone much past looking at complete engines on eBay and Craigslist. Would this be the better route, and just get a standalone controller for the 5R110?
So I'm looking for other's opinions. Should we go 7.3, 6.0 or Cummins? Should we stick with gas over diesel? Try to make the Lightning motor work? Or just go back with a stock 5.4 3V? I should say, he won't sell the truck for whatever reason, so he's not worried about resale or anything. We're in Michigan, so we don't have to worry about emissions. And we're fairly mechanically inclined, so I'm not too worried about doing the swaps, however my knowledge on diesels is limited.
Prius (2004-09) :: Immobilizer Not Letting The Car To Start After Trans Swap
I have an 06 Prius. I bought it with a broken/leaking transmission about 3 months ago. I drove the car home and it sat for a few months, then I drove it into my garage to start working on it a few weeks ago. I just finished up with the trans swap this evening and I went to "start" the car to get the coolant circulating/blead, and the car would not start. I get nothing, I just get a blinking red light in the shape of a car with a key in the center.
I am pretty sure this is the immobilizer symbol. What can I do to reset/fix this? This is my first prius and I have not driven this one more than 50 miles so it could be something silly that I am just not familiar with. This is what I am doing...I get in the car, put the key in the key slot, and I push the brake, then I hit the power button...I get nothing, other than the blinking light on the dash.
I went back out to the car and messed around a little bit. When I put the key in the slot I get what I described above...nothing. But if I don't put the key in the slot, and just push the power button the display comes on but I am not able to shift into any thing other than park or neutral. When I am able to power up with out the key in the slot I get a red car with an explanation point going through it at the top left of the screen.
Then at the display just below the windshield most of the lights stay lit up. What does this point towards? Why would the car not try to go into Drive or Reverse? And what's going on with my key? The only two times I have driven this car i just put the key in the slot and it turned right on and I drove away, now with the key in it will not do anything.
Ford Excursion :: Steering Wheel Swap
I am looking to swap the worn steering wheel in my Excursion. I would like a wood and leather like the Navigators have. Any tips on doing the swap?
View 14 RepliesFord Excursion :: 2004 - Seat Swap In 2nd Row
I'm thinking about swapping from captains chairs to bench seats in the 2nd row of my 04 Limited Ex with tan leather. I'd like to mount an amp or 2 under it.
View 10 RepliesFord Excursion :: 2005 - V/B Spring Swap?
I work at a ford dealership in detroit, im looking into doing a v/b code swap, and just had some questions. my current stock excursion springs are completely shot. so i need new ones so might as well do the swap. do i need to order or get anything other than the v code springs, and the b code springs, new u-bolts, and modify the b code springs? i do not need shackles or anything to have the ex sit level when im done..? just making sure before i get involved. have viewed many topics on here about it and just want a definitive answer. 2005 excursion, v10. i actually wanted to go with the X's in front, but i dont know how to make those level in back.
View 14 RepliesFord Excursion :: 2001 - Gear Selector Swap
I have a 2001 Ford Excursion with the 5.4 and auto trans. I don't know for sure what specific tranny is in it but I do know what I want to do. I really like the pistol grip style shifters that a 2004 ish F-150 has and I wanted to make that conversion in my Excursion. Is it possible? Are the trannys the same to where I can switch out the gear selectors? And also how would I even do it?
View 7 RepliesFord Excursion :: 2005 - AC Defaults To Defrost When Swap To 4 Hi
I noticed when i swap to 4 hi. The AC defaults to defrost. I have read this is a possible vacuum leak. Well after driving for about a mile the AC goes back to vents " while still in 4 hi" does this mean my hubs are sticking and finally engaging? Or still probably have a vacuum leak?
View 3 RepliesFord Excursion :: Spring Swap Height Differences
I thought I had come across a chart here that showed you the different spring ratings and the expected height change difference from stock, for each engine option.
View 7 RepliesFord Excursion :: 2001 - Front End Swap Easy?
What all is needed to swap to the newer style and how easy is it?
View 14 RepliesFord Excursion :: 2002 - Just After Ride Spring Swap?
I want some honest opinions on whether a spring swap is worth the money and time to make the ride better and less harsh of ride. I currently have a completely stock 02' 7.3 4x4 Excursion with 204,000 miles. I have been reading a lot on the spring swap and really want to know if it's worth it for the sole purpose of ride and keeping the front off the bumpstops. I don't tow enough to justify it for that reason , and could live without the lift portion because I use it for a daily and family hauler. I experience some sway but not terrible ,but I do believe my shocks are shot as well and I have hit the front bumpstops a few times over railroad tracks.
View 14 RepliesFord Excursion :: Vibration After Gear Swap Coming From The Front
Brought the truck home the other night after having the 4:88's and locker installed. At about 65mph plus I have a severe vibration that sounds like it's coming from the front. It's bad enough I can feel it in the floorboards.
After some research I'm thinking the drive shafts need to be balanced due to the increased speed they are now running at. The u joints are good and I trust the installer did a good job putting the gears in.
Factory gears were 3:73's. 7" of lift on 37's. Any other parts other than the drive shafts?
Ford Excursion :: Leaf Spring Swap - Wheel / Tire Size
My leaf spring swap is almost complete... its been almost 3 weeks with all the conflicts of life but its getting near completion. Just have to do front passenger side now.. Tomorrow and it should all be done.. hopefully... Any ways... my preliminary numbers are 40" front (ground to fender) and 41.5" rear.. Might be 1/2" to 1" off since I haven't finished the job AND the truck is sitting on dirt. Any ways, What size wheel/tires can I fit on there now? And will I need a spacer with that size?
View 1 RepliesFord Excursion :: 2002 - Swap 2nd Row Bench Seat For One With Full LATCH System
What model year(s) 2nd row bench seats that have a factory LATCH system will fit in a 2002 Ford Excursion to replace the seat that is missing the anchors that are between seat bottom and seat back?
View 14 RepliesFord Excursion :: Back End Lower Than Front And Drops Dramatically While Towing - Spring Swap On A Lift
So this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 Replies