Ford Excursion :: 2005 - V/B Spring Swap?
I work at a ford dealership in detroit, im looking into doing a v/b code swap, and just had some questions. my current stock excursion springs are completely shot. so i need new ones so might as well do the swap. do i need to order or get anything other than the v code springs, and the b code springs, new u-bolts, and modify the b code springs? i do not need shackles or anything to have the ex sit level when im done..? just making sure before i get involved. have viewed many topics on here about it and just want a definitive answer. 2005 excursion, v10. i actually wanted to go with the X's in front, but i dont know how to make those level in back.
View 14 RepliesAvalon 2005-12 :: HVAC Defaults To Recirc
I noticed that no matter whether it's on recirc or vent when I shut down the car, our '06 Touring's HVAC will always default to recirc when I turn it on. Is there a way to keep it from doing this? It drives me nuts, because I hate having recirc on.
View 7 RepliesFord Excursion :: Trans Swap 7.3 To 6.0?
I am in the middle of the 7.3 to 6.0 swap and wanted to confirm the in and out lines of each cooler. All the links to the websites that were writeups seem to be dead.
View 3 RepliesFord Excursion :: Steering Wheel Swap
I am looking to swap the worn steering wheel in my Excursion. I would like a wood and leather like the Navigators have. Any tips on doing the swap?
View 14 RepliesFord Excursion :: 2004 - Seat Swap In 2nd Row
I'm thinking about swapping from captains chairs to bench seats in the 2nd row of my 04 Limited Ex with tan leather. I'd like to mount an amp or 2 under it.
View 10 RepliesFord Excursion :: A/C Blows From Defrost?
Every time I turn my Ex off and start is again I have to turn my A/C completely off then hit the A/C and Recycle button to get air to blow out of the panel vents or it will automatically blow out of defrost vents no matter what setting it was on when I turned ignition off. Is there a blend door actuator/some sort of air diverter on these like my old Yukon XL had? On the Yukon the driver and passenger vents would blow hot and cold.
View 4 RepliesFord Excursion :: V10 - A/C Going To Defrost Under Load?
Well mine was. Checked all vac lines, 4wd was fine, tested with vac pump tested ok. So first I replaced the canister. Nope, actually happened more often. Pulled the 4wd solenoid that's mounted on the inner fender, rusted and split just above where the vac lines connect. I capped them and now my a/c is perfect, 4wd is out but for now I can live without 4wd.
View 3 RepliesFord Excursion :: 2001 - Gear Selector Swap
I have a 2001 Ford Excursion with the 5.4 and auto trans. I don't know for sure what specific tranny is in it but I do know what I want to do. I really like the pistol grip style shifters that a 2004 ish F-150 has and I wanted to make that conversion in my Excursion. Is it possible? Are the trannys the same to where I can switch out the gear selectors? And also how would I even do it?
View 7 RepliesFord Excursion :: Spring Swap Height Differences
I thought I had come across a chart here that showed you the different spring ratings and the expected height change difference from stock, for each engine option.
View 7 RepliesFord Excursion :: 2001 - Front End Swap Easy?
What all is needed to swap to the newer style and how easy is it?
View 14 RepliesFord Excursion :: 2002 - Just After Ride Spring Swap?
I want some honest opinions on whether a spring swap is worth the money and time to make the ride better and less harsh of ride. I currently have a completely stock 02' 7.3 4x4 Excursion with 204,000 miles. I have been reading a lot on the spring swap and really want to know if it's worth it for the sole purpose of ride and keeping the front off the bumpstops. I don't tow enough to justify it for that reason , and could live without the lift portion because I use it for a daily and family hauler. I experience some sway but not terrible ,but I do believe my shocks are shot as well and I have hit the front bumpstops a few times over railroad tracks.
View 14 RepliesFord Excursion :: 2003 V10 - Blows Out Defrost Only
Mile marker hubs on my rig. V10. Plugged 2 ports on what I thought was the vacuum pump pass side middle of the fender. The lines coming out of what I thought was the vacuum pump were molded together going into two separate ports. I plugged both ports. What did I do wrong and what should I plug?
View 3 RepliesFord Excursion :: Engine Produces 2k RPM And Goes Defrost?
Diagnostic routine. Anytime the vents are on and the engine produces 2k rpm or more it goes to defrost. ....Why and how to remedy?
View 6 RepliesFord Excursion :: AC Not Blowing Out Of Defrost Or Floor Sometimes
The front a/c on my ex on the highest blower motor speed blows out the vents like its on low, but I can hear the motor blowing at full speed. It's not blowing out of defrost or floor unless I switch it. On lower settings I can barely feel any air at all. Only does this rarely. Could it be my vacuum pump?
View 4 RepliesFord A/C :: 2002 Excursion - Air Blowing Through Defrost Only
I'm not sure if on my 2002 Excursion limited the air vents are controlled thru vacuum or electronically. Where to start. Where to even begin looking to correct this problem. I'd rather not have to pay the dealer prices unless it is something out of my league of fixing.
View 4 RepliesFord Excursion :: Vibration After Gear Swap Coming From The Front
Brought the truck home the other night after having the 4:88's and locker installed. At about 65mph plus I have a severe vibration that sounds like it's coming from the front. It's bad enough I can feel it in the floorboards.
After some research I'm thinking the drive shafts need to be balanced due to the increased speed they are now running at. The u joints are good and I trust the installer did a good job putting the gears in.
Factory gears were 3:73's. 7" of lift on 37's. Any other parts other than the drive shafts?
Ford Excursion :: Stuck On Defrost Vacuum Leak
Ok, I have capped off the vacuum lines to the front hubs and replaced the vacuum solenoid on the passenger inner fender. Still stuck on defrost. I know there are several options from this point what would be the next step after what I have just recently done. Going away on a ski trip and would like to have it working properly before I go.
View 14 RepliesFord Excursion :: 2002 - A/C Blowing Air From Vents To Defrost?
My 02 V-10 Ex seems to be blowing Air from the front vents up to the Defrost unless it go through a series of events-- Hit Auto then forward Air then the fan has to be a 4 only. It will blow forward vents then go back and forth from theirr to the defrost. Also the Temp seems to be much hotter then it should.
Took a interstate trip this weekend though and it seems to blow much colder and do a little bit better staying in the front vents however still goes back and forth. Im in FL and its HOT!!!! The only thing I know is that its a vacuum system.. and that again its HOT in the truck as a daily driver.
Ford Excursion :: AC And Defrost / Vent Switching Back And Forth
I have to once and for all try to figure out what the heck is up with the AC and the defrost/vent switching back and forth. I have searched and searched and posted a few months back as well. But now that it's summer and 100 degrees out I've had a chance to test some more.
1 - I replaced both hoses going to the hubs up front.
2 - I am not sure how to test vacuum, but I did cap the hoses that lead to the hubs and still had the fluctuating back and forth
Looking for detail how to test for vacuum leak with a gauge directions ? What number is supposed to hold on the gauge and for how long etc...?
3 - It used to be that when I got to a high speed or RPM it would shift to defrost, but now I've noticed that once on the freeway going to work for instance and doing a constant 55-65 ( sub 2k rpm ) for about 20-25 minutes the vents hold fine. When I start to stop and go with higher RPM's it starts to 'break down' again. Could it be that there is a vacuum canister or pump ? I don't know ?? The diesels have a vac pump - do the V10's ? What can I check if there is no vacuum leak - what's next ?