Ford 6.0L Power Stroke Diesel :: Body Mounts Completely Went Out?
So since I bought this truck a few weeks back I noticed it rode alittle "rougher" than some of the other trucks I test drove. But for the life of me I could not find anything suspension wise so I crawled under and looked else where to find this......
I'm ordering new mounts from AutoNation Ford White Bear Lake | Parts & Accessories I've read good and bad things about using after market poly bushings, and I'm just not wanting to take the risk. I want it to ride like factory. There are a total of 8 mounts, just the rears are going to run $150.
Also on a side note, I'm thinking of swapping out the exhaust. The downpipe is a full 4' and its hitting in alot of places. Do most of you run the 3.5" DP like MBRP makes?
Passenger far rear Top of same one, basically gone Here you can actually see where the shell has been hitting the frame bracket The middle ones look ok but are pretty dry rotted Drivers far rear is completely gone top and bottom The exhaust pipe is whacking the cross member because the hanger isn't even being used
Ford Excursion :: U-bolt Torque For Shock Mounts?
Couldn't get the bolts out of the bushings so just bought new mounts. Was wondering to have the torque value for the u-bolts...
View 2 RepliesFord Excursion :: Replaced Motor Mounts Now Vibration At Speed
I replaced the motor mounts, and now there is a vibration at speed (70 or so). I've taken it to Michigan and back, so it is probably broken in. Can these things be put in improperly?
View 13 RepliesFord F-150 (2004-2008) :: Electronic Throttle Body Replacement
While driving home my yellow wrench light came on and I had no power at the pedal, even though the engine was idling smoothly. This happened with no warning and went away when I turned the truck off and restarted it. About 4 miles later it did it again. I immediately went to a nearby dealership only to find out my electronic throttle body needs replaced. Needless to say at this time of year 500+ dollars is not readily available, although I need my vehicle for work.
I do not know a thing about ETB's but did a little research online and found many aftermarket ones at a much better price than Ford's(surprise). My question I guess is what are my alternatives to factory replacement? Can I remove and clean this component or replace it with something of better quality? I'm not into high performance with my truck but if I could get a little better throttle response or gas mileage I'm all ears. My truck is a 2004 Supercrew 4x4 XLT w/ 5.4 Triton. Around 74,000 miles and well taken care of. Miles are nearly all highway.
Ford - Explorer :: 2001 - Rear Body Mount Bushing Replacement
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
Ford F-150 (2004-2008) :: Code P2135 - Electronic Throttle Body Replacement
Throttle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not diagnosing. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. If you find yourself in this situation I show you how to change the throttle body and reset the pcm to learn the new idle trims.
Ford F150 F250 5.4L 3v Electronic Throttle Body Replacement P2135 - YouTube ....
Ford Super Duty (1999-2016) :: 2014 - Front Body Mount Bushing Replacement
The driver side front body mount bushing on my 2014 is gone which has the grill sitting on the bumper. I started to replace it, but the bolt is sized to the nut. ran off about 1/2 inch and that is it, it will not tighten or loosen anymore.
I cut the head off the bolt, but can not get the body high enough to remove the old bushing so i can cut the nut off flush with the rad support. Now I am trying to get the air filter box out so i can cut the top of the "nut cage" off to remove the bolt and nut out the top. but i can not figure out how it is held in.
I have the intake disconnected and the filter hat off, overflow tank hose disconnected, and two bolts holding the whole thing to the fender out, but it will still not budge. What am I missing here?
Ford Excursion :: Clunky Sound While Narrowing Down To Driver Side Body Mount?
I've got this clunky sound I am narrowing down to the drivers side body mount. The stock one has lasted 11 years. But I'm reading thread after thread about stock replacements lasting a year or so before crapping out again. I've found a few people mention the energy suspension lot, or another one that has Kevlar (daystar iirc). I googled them and found a handful of super duty owners who used the poly mounts complaining about harshness and vibration transmitted to the cab.
My truck is my dd and with my new highway tires and stock exhaust it's as quiet as it ever has been and that makes me and the family happy on long trips. I don't want to do anything to ruin that.
F Series :: Code P2135 - Electronic Throttle Body Replacement
Throttle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not working with diagnosis. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. How to change the throttle body and reset the pcm to learn the new idle trims. [URL] .....
View 2 RepliesPrius C :: 2012 - A/C And Fan Won't Turn On After Replacement Of Body Control Module?
I have a 2012 prius c and just replaced the body control module - no problem there, but now the ac and fan will not turn on. Fuses visually look ok (I don't have a tester) and they had been working previously. I live on Molokai - no prius mechanic on the island so I do my own repair when I can - how to diagnose the problem?
View 4 RepliesFord Excursion :: Groaning Noise In Back Storage Area As Body Flexes When Starting To Move
I am getting a groaning noise in the back storage area as the body flexes when starting to move. At first I thought it might be the spare tire mounting or the third seat but I still get the noise with the tire out and the seat out.
Does this sound like a body mount issue? Have not had any body mount noises in the front. Can I access the rear body mount without dropping the gas tank?
Prius (Gen 1) :: Mass Air Flow Sensor Replacement And Cleaning Throttle Body
Got told by the dealer I need to replace my Mass Air Flow Sensor...to the tune of $657 dollars. And get a throttle body cleaning.
View 14 RepliesFord Excursion :: Transmission Shifter Arm Replacement?
Overdrive off button hasn't worked in a couple years and there is no power to the switch so I figure the wires across the column are damaged. Even after replacing the button a couple times the ends were always falling off so I'm ready to replace the entire shifter arm assembly. I also need to replace the bushings since the arm is loose.
I will also be installing yet another turn signal since the one from Rock Auto didn't last long. The new one will be from Auto Zone, which said the shifter arm is a dealer only item.
Ford Excursion :: Radius Arm Bushings Replacement
I am in need of new radius arm bushings (both sides). How to be able to just unbolt the sway bar, unbolt the shocks, dismount the coil springs so they fall out to the sides and then drop the rear of the radius arms so they could press out the old bushings and insert the new? This is a 2WD and I think the process would be same for an F250 of the same year (2000 - 2004). The reason I ask is because I really, really don't want to have to get down to the king pin level and completely remove the radius arms if I don't have to.
View 2 RepliesFord Excursion :: Spark Plug Replacement?
OK, this technically isn't for the Ex (since it's a diesel), but I do need to replace the spark plugs in a Ford V8 soon. Problem is I've been running diesels for a long time and haven't really kept up with spark plugs.
Seems like there's lots to choose from now. Regular old fashioned, double tip, triple tip, platinum, kryptonite, thermo-nuclear tip, etc. Is one spark plug really any better than another, or is it all just marketing gimmicks? Is it worth spending extra for some fancy sounding spark plug?
Ford Excursion :: Drag Link Replacement - Need Tie Rod Too?
I have a new-to-me 2001 Ex V10 4x4 w/ 132k. I'd say it's 85% and I'm slowly working to get it to 100%. Right now, I'm tackling the low hanging fruit. I'm trying to track down the front end clunks and creaks.
I cinched down on the driver side sway bar end link and it took out some of the clunk. I traced the remainder of the clunk to the drag link which I can rotate about 20-30 degrees by hand. Both grease boots are shot.
New rotors and pads get here Monday. While I change them, I'll be working the front end issues as well. I went ahead and bought the Energy Suspension sway bar bushing kit and will swap them all out. I also plan on replacing the drag link ends too.
My question is: do I need to replace my tie rod ends? The grease boots have definitely leaked but I can't detect any slop like the drag link. If the grease is leaking all over is that a sign that they need replacing?
I've never done steering work before but it looks straight forward. Any tips for a novice? Anything I should be aware of before I start? While I'm down there, is there anything else I should change while the steering is apart?
Ford Excursion :: 2003 - Track Bar Replacement?
I'm attempting to install new x codes on the front of my 03 x and I was wondering if the track bar should be replaced? Bought one just in case, oh and any tricks in getting that bad boy off?
View 10 RepliesFord Excursion :: Front Stabilizer Shock Replacement
Is there any particular front stabilizer shock I should purchase for a replacement for my 2003 X 6.0L diesel? Anything I should stay away from?
View 7 RepliesFord Excursion :: Replacement Of Rubber Bump Stops?
While driving the other day I heard a loud bang under the ex. went back and found the rubber bump stop on the drivers side had rotted and fell off. After inspecting the passenger side it looks like it is about to fall off . I dont mind spending money to keep my equip in proper running order but I dont want to be taken advantage of doing it!
View 14 Replies