Dodge - Neon :: 1997 - Replaceable Seal On The Front Engine Causing Leak?
My dad has a 97 Dodge Neon 4 cylinder. The car has been leaking oil, and on Sat the leak grew and was real bad. He took it to the only shop he could find open who put it up on the lift and said the leak was coming from the front of the engine. On monday they did the work ($286) and told my dad it was a seal on the front of the engine behind the flywheel. My dad is old and doesn't hear well and the mechanics english was not real strong and his writing on the recepit is not real clear. As I am worried my dad might have gotten taken, is there a replaceable seal on the front of the engine that could go and cause a leak? They showed my dad the leak as the car was on the lift and running as that was only when the leak occured. I am concerned my dad was taken. He says he drove it around and such and didn't see any leaking when he picked it up and left it running in his drivway for a while upon getting home and no leak. Just wondering?
View 11 RepliesDodge - Neon :: CEL Stays On - Vacuum Seal On Gas Tank?
My check engine lite stays on. I was told it MIGHT be the vacuum seal on the gas tank. How much should I expect to pay to get this fixed? and how long should this repair take?
View 6 RepliesFord Transmission :: Small Leak Around Tail Shaft Seal
I got a fmx mated to 351w, trans was on back of a 302 and no problems other than small leak around tail shaft seal but shifted great. Now I decided to install mildly built 351w so figured it'd be a good time to build tranny. Installed after build and immediately it was slipping. Pulled trans out took it back to shop and he said the forward seal was blown. Installed again, after about 15 miles same result! What could be causing this. It is fine in reverse, but slips bad in forward gears.
View 2 RepliesDodge - Neon :: 2005 - Transmission Leak Coming From The Drive Shafts
I would seem that my Neon has started a very small leak seems to be coming from the drive shafts. You may call the differentials. You may also call it a transaxle. I prefer to call them driveshafts and transmissions. I took it to a service place to take a free look at it. I do not have the equipment that they have. They put it on the hoist and when you walk under there it does look like it is coming from one of the driveshafts. They were not Tranny experts and said they could not fix it, but said it would need to be rebuilt or changed. My question is, since they are not tranny experts. Does something like this really need to be rebuilt? Is there not just a seal leaking that can be changed without a rebuild? Why would they make something like that? Just to make you pay more money to get it fixed? I did try some Lucas and then Trans X hoping that would seal it up. Lucas seemed to do nothing. Just put in the Trans X today.
View 9 RepliesDodge - Neon :: 2003 - Cooling System Leak / Burning Rubber Smell Coming Through Vents
I have a 2003 Dodge Neon and recently had transmission work done on the car. When I got the car back the radiator cap was left loose, I didn't know this until I took the car for a drive and it overheated. I let the car cool down, replaced the coolant, and made sure the cap was sealed down. The car now has a slow coolant leak, when I turn the car off I can see it drip underneath for about 2 minutes and then it stops. Also, after the car heats up to running temperature I get a burning rubber smell coming through the vents. What could this be? The car only has 70,000 miles on it and I would like to keep it going if I can.
View 6 RepliesPassat (B5) :: Cam Shaft Adjuster Seal Leaking
Passat, 2003, 5 speed, turbo, 1.8T engine, 4 door, 66K miles.
No oil on garage floor and tiny amount of oil at rear of engine, Is this urgent?
(I have had many cars with no seal or gasket issues- especially at 66K).
Ford Excursion :: A/C Shaft Seal Leaking?
Well, the ac in my truck has been less than exciting since I've owned it and its time to address it before another trip.
I crawled under last night to explore the Ac clutch air gap and found that the shaft seal is leaking and clutch is grooved pretty bad and covered in oil.
I'm thinking it's time for a compressor, clutch, orifice tube, expansion valve and reciever/dryer. Does that about sum it up? I haven't messed with AC systems much outside of my simple jeep system that was as easy as two seals and recharge in my garage to fix it.
Do I need to flush the lines out? Should I do that at all? Motor craft worth the cost over something like four seasons? Its almost twice the cost but in the end if something goes I'm further downstream after freon etc to charge it and the possible shop charge if I pay to have to done.
Celica :: 2000 GT - New Output Shaft Seal Leaks
I installed a JDM 2ZZ-GE engine and 6 speed manual trans-axle into my 2000 Celica GT.
I have ran into a interesting problem. I replaced the output shaft seals and now whenever the car is in the air and the suspension is unloaded (the drive axle is pulled slightly from the trans) the drivers side seal leaks a bit of gear oil. The drive axle is snapped into place. Nothing leaks when the car is on the ground.
I did reuse the old drive axles, which had a lot of miles on them but still appeared good and useable. I have been told to replace the new seal because it may be damaged, but I am wondering if it may be that the drive axle end is worn.
I have seen this with harmonic balancers for engines. They even sell a replacement sleeve for harmonic balancers so you can re-use the old worn one.
Santa FE SM (2001-06) :: Balance Shaft Oil Seal Replacement?
I have a 2001 4 cylinder Santa Fe. And atm I'm trying to replace the balance shaft oil seal but am having major problems getting it out.
View 2 RepliesSanta FE SM (2001-06) :: AC Compressor Replacement - Shaft Seal Is Leaking
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6
Golf IV / Jetta IV :: 2001 - How To Access The Transmission Input Shaft Seal
I'm trying to get to the manual transmission input shaft seal on my 01 GTI w/12V VR6. I've removed the 3 bolts surrounding the input shaft but the metal shroud underneath the 3 bolts seems to be adhered tightly in place. You can see the 3 bolt holes and metal shroud in this photo: [URL]
Am I on the right track in trying to remove that shroud? If so, how do I loosen it?
Ford Excursion :: Front End Noise - Inner Seal Dangling On Stub Shaft
For what it's worth I have been feeling a bit of a tug for 3 weeks. That's about 150 miles or 5 times driving. Installed new sway bar damper.
Pulling into the driveway the heard a ting, and look to find the inner seal of the hub spinning on the stub shaft!
An exploded view of this front end hub/bearing/brake assembly?
Ford Ranger / B-Series :: 1999 - Output Shaft Seal Won't Stay?
I replaced the seal the other day on my ranger because I noticed my fluid disappearing. Went ahead and changed the filter and fluid as well. Flushed the system, and I go back to my truck tonight and there's a huge puddle of trans fluid. And the output shaft seal is once again, up against the drive shaft. I've spent like $150 on trans fluid since Friday, and $1000+ to get the truck running again last month, so pardon me if I get edgy about her.
99 2.5 auto. I changed the trans pan gasket too. No leaks from it.
Ford Excursion :: Drips Coming From Rear Axle Input Shaft Seal
I have noticed a few drips coming from the rear axle input shaft where the drive shaft connects. It has only done it once and there is no residue on the trailer hitch so I know it didn't dump everything on the road. If change this seal, how difficult is it and do you have any information which might make it easier.
View 14 RepliesFord Ranger / B-Series :: 1989 - Tranny Input Shaft Seal Replacement?
I'm replacing my clutch components in my 89 Ranger with an M5OD transmission. While I'm doing it I'm going to replace the input shaft seal on the transmission. I'm looking for the torque specs for the housing that holds the seal.
Also, should there be any play on the input shaft? My transmission has never made any noise but I noticed some slight play in the shaft.
Ford 6.0L Power Stroke Diesel :: Front Axle Shaft Seal Leaking?
I took the front axle shafts out a couple months back and remember NOT seeing any differential fluid in the axle shaft housing. But then when I took the tire off tonight.. I noticed diff fluid leaking from from the axle shaft dust seal ?
1. I didn't think diff fluid flowed up near those front dust seals ?
2. That's a brand new dust seal so I'm guessing some debri must be in the connection causing the leak ?
Ford 7.3L Power Stroke (1999-2003) :: Transmission Output Shaft Seal Removal
I'm trying to replace my transmission output shaft seal on my 2wd and I can't seem to get the seal removed. I couldn't find anything to rent from O'rielly's or Advance Autoparts that would work. It's in there really tight ....
View 10 RepliesDodge - Neon :: 2005 - Won't Go Over 60 Mph?
Intermittently (although lately it's pretty common, perhaps due to the Texas heat?) my car will take several seconds to start. It sounds like the battery is dead, i.e., it sounds as if it's about to start but it straining, and then it eventually engages.
When this happens, I know that a) I won't be able to turn on cruise control and b) I won't be able to accelerate easily. at best I can get it to 60 mph
Similarly, even if I start up without a problem, and I'm cruising down the HWY at 80 MPH, the car will suddenly loose momentum and won't go above 60 mph. And I can't turn on cruise control (cc shuts down, in fact, if it was on).
This is a 2005 Neon, by the way.
I have replaced the battery and cabling to the battery to no avail.
Ford 6.0L Power Stroke Diesel :: 2003 F350 - Drive Shaft Noise / Rear Pinion Seal Is Leaking
I was getting ready to replace the carrier bearing and noticed the rear pinion seal is leaking. Before attempting the replacement myself, I would like some opinions on the noise in the video below. Is this normal? I am confidant I can replace the carrier bearing and pinion seal, but not sure I have the tools for anything else.
YouTube ...