Ford 6.0L Power Stroke Diesel :: 2006 F250 - Code P0677 / #7 Glow Plug Circuit Module
06 6.0 F250 throwing code P0677 #7 glow plug circuit module. I don't think one bad plug would cause a no start, however coupled with too much oil possibly? Swapped my oil about 500 miles ago, I put in 20qts accidentally, drained off about 3-4 qts eyeballed, truck fired up and ran fine no smoke nothing. Yesterday morning I was leaving work and moved my truck from parking space to behind the bay at my fire station, I turned the engine off.
Loaded up my gear and turned the engine to the aux position and someone was talking to me so inlet it sit for a while in the auxiliary position. Went to crank no start, turned the key off then back on and it fired. Fast forward after 7 different starts throughout the day, I'm at dinner with my son we go to leave engine will not start at all, rolls and rolls and rolls nothing. Towed her home and scratching my head. Over filled oil with a bad plug cause no start??
Egr delete, new oil cooler, cat and muffler delete, upgraded Y turbo pipe. Also have an SCII throwing codes p0677 and p0401 egr code....
Ford 7.3L Power Stroke (1999-2003) :: Code P0670 - GPCM Glow Plug Control Module Control Line Failure
How to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
Ford Excursion :: 2002 7.3L With P0671 Code - Glow Plug Circuit Fault
I have have been getting a p0671 fault code every time I start my truck now that its cold. If I clear it and its warm it doesn't retrigger at least until it sits overnight again. Is this likely to be that the Glow Plug needs replacing on the #1 cylinder? Autolite Glow Plug is only $20 or so. Mechanic is recommending changing the bank and the harness but I'd rather just do the one GP myself if possible. I see on here that the valve cover has to come off. Which side is #1 on and do I need any gaskets etc? How big a job is it to remove the valve cover? I'd go and look myself but its cold out ...
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Glow Plug Control Module Function?
OK, what does a glow plug control module do? The short bus I got has one on it. It looks like it fits right into the circuit without much, if any, modification. I got one with my short bus and am curious if it would be something worth adding to my pickup. So...what does it do and could I/should I install it?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2007 F350 - Check Engine Light For Glow Plug Control Module
So; I bought my 07 f350 6.0 the other day. I have a light on that sends a code for glow plug control module, but the truck starts fine, the same in cold temperatures as warm, so far nothing below 32 degrees though. I dont have the code # at the moment, but will update when i get the scanner back. Why this module is throwing a red flag?
View 6 RepliesFord Excursion :: Service Engine Soon Light Came On - Cylinder 1 Glow Plug Code
2001 Excursion Service Engine soon light came on, took it to Auto Zone, said #1 cylinder glow plug. I have a Superchips tuner, can I diagnose it with it? Which is the #1 cylinder?
View 1 RepliesFord 6.0L Power Stroke Diesel :: CEL On For Multiple Codes - Cylinder 1 / 2 / 7 And 8 Have Glow Plug Circuit Open
Just got back from the beach yesterday. On the way back I noticed the check engine light on and read the codes. It listed 4 codes, P0671,P0672, P0677 and P0678. From what I can find, Cylinder 1, 2, 7 and 8 have the glow plug circuit open. Truck ran fine and didn't miss a beat. Ambient temp was around 80 when we started up the truck so I guess diesel plugs are not to crucial for that temp. I did notice when driving back the Vbatt would jump from 12.2v at1854 RPM (34 MPH) and 13.8v at 1652 (57 MPH).
Would bad batteries or low batteries cause this type of problem? This may be wishful thinking on my part. I have tested the batts with a DMM and they are at 12.3v. I took them out and charged them but they always go down to 12.3v. FMP is 47.5v to 48.5v. It seems suspect that all four glow plugs would be bad so I assume it could be the harness. What are some ways I can test to verify where the problems come from.First thing I would do is get two new batteries as these are still under warranty.
Ford 6.0L Power Stroke Diesel :: 2005 - Fuel System Codes / Glow Plug Circuit Failure
So i just finished putting in new high pressure oil rail cup seals in and a new #2 injector. Truck was running great for about 5 miles and then just shut off. When I had it towed home I plugged in the super chips tuner "no tunes installed" and I have a p0460, p0463, p2290, p2291. I also have a #7 glow plug circuit failure Ive been a little neglectful in getting done.
View 6 RepliesFord Excursion :: Check Engine Light Comes On Randomly - P0683 Code
I randomly started throwing a couple codes that have been causing my "check engine" light to come on ... came on on my way into work this morning) . I know that the P0683 code is the Glow Plug Ctrl Module to PCM Comm Circuit (from my code reader), but I am not sure what to do next ... I have the dealer service DVD from 2002 that I will look at this weekend....
View 7 RepliesFord 6.0L Power Stroke Diesel :: Glow Plug Code And CEL Code P0675
Truck has been running very well while in the warmer North Carolina climate pulling trailers with no limp mode or wrench light. However, when daughter started the truck this morning, SGII showed one DTC and when she pulled it up it was P0675. OK, glow plug num 5 maybe or the module. No issues starting or rough cold idle. I told her to clear the code and we'll see if comes back.
She did ask if it is something she should have it repaired before the trip back to Vermont. So I thought I'd ping the group here since reading posts, they seem to be fairly easy to replace (and assuming it isn't a chafed wire) and I could probably save her some $. Just want to make sure there isn't any chance of real engine damage.
Ford 6.0L Power Stroke Diesel :: Every Glow Plug Code At The Same Time?
Just happened to check codes today for fun and found something interesting. I've known about 2 or 3 glow plug codes since last winter but I looked today and I have a code for every single circuit. Thought that was kind of odd.... I already have 8 brand new plugs and both harnesses from Autonation sitting in the back seat, was just waiting till the fall to change them out. At 176k on the originals I decided to change them all. But now I'm thinking the GPCM may be faulty as well.
P0671 Cylinder 1 Glow Plug Circuit
P0672 Cylinder 2 Glow Plug Circuit
P0673 Cylinder 3 Glow Plug Circuit
P0674 Cylinder 4 Glow Plug Circuit
P0675 Cylinder 5 Glow Plug Circuit
P0676 Cylinder 6 Glow Plug Circuit
P0677 Cylinder 7 Glow Plug Circuit
P0678 Cylinder 8 Glow Plug Circuit
Ford 6.0L Power Stroke Diesel :: Glow Plug Cylinder 8 - Code P0678
Pulled p0678, glow plug 8. I've changed out the glow plug on cylinder 1 a few years ago.
Cylinder 8, being on the driver side rear, is it difficult to change out? Should I just pay Ford or another shop to fix this?
Ford 6.7L Power Stroke Diesel :: CEL Code P263C For Glow Plug Driver Performance
CEL came on in my 2013 6.7L with 74K miles a couple days ago. Pulled the code today and it was a P263C - Glow Plug Driver Performance code. Any remedy for this.
View 8 RepliesFord 6.0L Power Stroke Diesel :: Running Rough - #2 Contribution / Glow Plug / Injector Code
#2 contribution/glow plug/injector code ????? Harness looks good. What's the malfunction?? Runs rough. Never seen those 3 codes together.
View 2 RepliesFord Excursion :: Cruise Control Module Location On 6.0
My cruise control is out. I have checked the clock spring wiring and it is OK. Going to replace the brake switch today. Looked for the CC module but cannot locate. Where it is on the diesel X.
View 1 RepliesFord Excursion :: 2000 - Location Of AC Control Module In Dash?
I was told that their is an AC control module in the dash. As I have a 2000 that we are still getting parts, where in the dash this control module is?
View 5 RepliesFord Excursion :: 2005 - Blower Motor Control Module
I have a 2005 Eddie Bauer 4X4 with the 6.0 and Automatic Temperature Control. I need a new blower motor control module, and have been confused by what I have been able to find online. What is the full Motorcraft part number, or other information so I can get one.
View 2 RepliesFord Excursion :: 2005 - Cruise Control Module Location
Discovering where my cruise control module is located on my 05 Excursion. . . I've looked at all of the pictures showing that it should be right in front of the a/c unit, underneath the vacuum pump, but on both my 04 and my 05 Excursions, there is nothing to be found on that location. Where the bugger can be located.
View 2 RepliesFord Excursion :: Cruise Control Will Not Work / Deactivator Switch Is Open Or Circuit Defective
I bought a 2002 Excursion 2wd V10 at an auction with 105,000 miles. I've been working through the little problems and I'm down to one last small item.
The cruise control will not work. I found a thread to diagnose the problem. My diagnosis is:
After doing the self test I received: 3 flashes - deactivator switch is open or circuit defective.
What does this represent and what shall I do to correct it?