Ford F-150 (2004-2008) :: Transfer Case Noise When Tries To Engage Once In A While As Driving
I have a problem transfer case 2006 f-150 , it tries to engage once in a while as I am driving and makes a terrible noise . I pulled the vacuum lines off at the hubs on each front hub and it stopped trying to engage. What the problem could be ?
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F350 Sounds Like Shifter Motor On Transfer Case Is Trying To Engage
Truck is an 03 F350 with the 6.0. It sometimes sounds like the shift motor on the transfer case is trying to engage. It has the vacuum system which is blocked off. Warn aftermarket hubs. Switch on the dash with 2wd, 4wd and 4 low.
It's kind of an off and on thing. Try to engage for a few or more seconds then nothing for awhile then repeat. It sounds like it's at the transfer case. It could very well be coming from firewall/engine bay area as well. Is there anything between the dash switch and the motor?
Ford Excursion :: 2003 - Transfer Case Not Engaging
2003 ex 6.0 limited....300000 miles ...Automatic.Merry Christmas to all.My Transfer case will not shift into 4wd . Dash light for 4wd high and low works .I get no power to transfer case 2pin connector when key turned on.Also fuses 19,27,31,33,34,45,111 are all good when checked with meter.I also swapped 2 relays in engine compartment and no change.4 WD Switch on dash has power on Green/red wire I think it is for dash light and not for operation.
View 13 RepliesFord Excursion :: New Transfer Case Now Tranny Runs Hot?
Swapped out my transfer case since mine was detonated and now my tranny is running hotter? Drove in town for about 10-15 minutes and noticed my temps climbing and once it got to 180 it felt like it was slipping when moving from a full stop. i went home and parked it. Checked my fluid level and it looked a little low so topped it off while running and went through gears to make sure it was good. Drove again and it still went up to 180 in 10-15 minutes in town driving. Before we swapped the transfer case it was driving fine and went on a road trip 6 hour drive and felt fine. I bought the excursion and it supposedly had a new tranny in it.
View 14 RepliesFord Excursion :: 2000 - Transfer Case Leak?
The dang thing leaks from the fill plug, I been reading about using liquid teflon on it.
View 4 RepliesFord Excursion :: 2000 V10 - Engaging 4x4 At Transfer Case
I had sold my Explorers but just picked up a 2000 Excursion V10 plow truck. It has been hacked and slashed I find cut wires under the dash and hood. I have tried everything to get the 4x4 to engage and no luck. It is used just for my driveway no road driving...
So question is: Can I engage the 4x4 at the transfer case so it will go, and stay in 4 wheel drive. If so do I take the shift motor off or does that big bolt by the motor do anything.
Ford Excursion :: 2000 V10 - Transfer Case Broke In Half
Having problems. Transfer case broke in half, I think it is because of the auto free wheeling hubs. Is it possible to manual hubs on it?
View 11 RepliesFord Excursion :: Transfer Case Shift Motor Change
My TC motor picked today of course with the snow to go bad. Luckily I hobbled to advance right as they were about to close and got one. I laid in the snow and changed it. Needless to say I got soaked beyond belief. Anyways now it changes in and out well but still seems way to loose in the rear. Not sure if something else is malfunctioning or if these things are like that. Right now I don't feel nearly as safe as I did in my expedition and that was without even using 4hi or low just the A4WD. The excursion is sliding everywhere. My tires have great tread but are highway tires so maybe that's the issue. They are Dura Grapplers. I'm going to try throwing some weight in the rear to maybe gain some traction.
View 2 RepliesFord Excursion :: 2000 V10 - Transfer Case Broke In Half After Vibration
Driving on my way home, my Excursion began vibrating and bang the transfer case broke in half. question will a 2000 f250 tcase swap with mine?
View 6 RepliesFord Excursion :: Transfer Case Input / Front Seal Replacement
Noticed some fluid on the bottom of the Ex a few months ago and have been watching it since. Drained and refilled with the XL-12 fluid at the time and based on what I can see the likely culprit is the input seal on the transfer case. I have searched high and low both here and via the almighty google with little info to be found. Is it simply remove transfer case, replace input seal, reseal case connection, and refill?
View 2 RepliesFord Excursion :: 4x4 Not Working - Transfer Case Not Engaging When Switch Is Turned On
My excursion has not been engaging the transfer case when the switch is turned on. I have ohmed the switch and also tried a known good switch from another superduty. I can get everything to work properly with a snap on MODIS by performing function tests.
View 4 RepliesFord - Explorer :: Transfer Case Sensors Name?
I just replaced the transfer case BW 4405. And I noticed that the 2 sensors (front drive shaft and rear drive shaft) are bad. What is the name of these two sensors? I'm looking for a brand new ones...
View 13 RepliesFord Aerostar :: 1991 - How To Check ATF In Transfer Case
Where/how to check the ATF in the transfer case? I found the lower drain bolt,but I don't see anything up higher that looks like a fill hole.
'91 Aerostar 4.0L AWD
Ford Aerostar :: 1992 - Model Of Transfer Case?
So long story short I have a 92 Aerostar AWD which I'm pretty sure had the transfer case recall done (97V204000 1992 FORD AEROSTAR Recalls) it has the aluminum driveshaft but a couple of years ago the transfer case cracked and I replaced it with a "New OEM" transfer case off eBay. Fast forward to the present and my van has a strong vibration at 60+ my transmission guy says it all looks good so the vibration has to be from one of the driveshafts. My thought is that I may have got a transfer case without the recall done on it and its warped my driveshaft. I don't really know thats possible or what I could do about it if that was the case.
View 8 RepliesFord - Explorer :: 2003 - Transfer Case Diagram
I bought a new to me 03 explorer 4.6 tow package XLT 136000mi. Rebuilt aamco trans with 10k on it. Been checking it over before i put it on the road.. No 4x4 but the button lites work and i got into low range once. (Had a hell of a time getting back to high but eventually it did). Question is if there is 12v at the brown wire on the TC the case should be fully locked? I figure when i check it if there is not 12v at the brown wire in 4x4 high i could apply 12v directly with a jumper wire to see if the case locks to 4x4. Am I correct?
View 2 RepliesFord Transmission :: Transfer Case Noises When Shifted Into 4WD
About 9 months ago heard a strange noise when shifted into 4 wd , sounded like driving over those grooves on the side of the highway to keep people awake.
Had to pull over to stop , as it would not go back into 2wd with the noise still going.
Then it stopped , after shutting truck off and restarting.
Then earlier this year after trying to do it again in 4wd had bad clunking noise and was hard to get back in 2wd , I can here the shift motor engaging and the dash reads in 4wd, seems its not engaging fully in 4wd and not going back to 2wd, its a very bad clunking noise, shakes the whole truck.
Ford - Explorer :: 2007 - Getting CEL On - Transfer Case Code?
I keep getting a check engine wrench on the readout, put a scanner on it and got the following code:
P183b transfer case code ...
What this means?
Ford - Explorer :: Low On Fluid - Tranny Or Transfer Case?
My 4WD sport trac was running fine. I took it off road and put it in 4WD. After I was done in the woods. I put it back into 2WD and backed up to unlock. I then drove 2 hours home. The next day the transmission started shifting funny, especially overdrive almost like I was low on fluid. (which I check and I'm not) And the truck sounds like its running ruff. Is my transfer case still ingaged? Do I need to take it in for tranny work?
View 9 RepliesFord Transmission :: BW 1345 - Shift On Fly Transfer Case?
I have a BW 1345 transfer case. Does it have the shift in the fly capability? And, if so, what precautions should be taken if shifting on the fly?
Second, where can I get a "plate" or label that shows the shift pattern? I know the shift pattern, I just want to post it in my vehicle in case anyone else ever drives it and needs to use the 4 wheel drive.