Ford Super Duty (1999-2016) :: Tow / Haul Fails To Engage
2008 F-250XL, 5.4L V8, 5 speed auto, 3.73 rear.
Two/haul fails to engage and does not light up dash indicator light from time to time. After 4 or 5 tries it usually will engage normally. No codes.
Ford - Explorer :: Transmission Fails To Engage When Attempting To Accelerate While Turning
I have a 2000 Ford Explorer XLT. V6, 4x4
At very low speeds (5-10 mph), attempting to accelerate while turning (like coming out of a parking lot OR out of a curve) the transmission fails to engage. I hit the gas, the RPMs go up, but it doesn't get into gear. I will let off the gas, give it a couple seconds, hit the gas again and usually it engages. Sometimes I will have to repeat this step a second time. This problem started very slowly and has gradually gotten worse. It happens about once a day.
Concerned, I took it to the local Ford dealership and they have thus far changed/flushed the transmission fluid and replaced the filter. The mechanic said he found no metal shavings in the fluid, which might indicate grinding gears. They also said there were no codes coming up pointing to a transmission problem. It is still having the same exact issue however. The trouble now is they cannot "verify" the problem. The mechanics have put 40+ miles on it in similar driving scenarios and it will not act up for them.
After a couple weeks of back-and-forth, I'm really frustrated. My understanding is that they're "not sure" it is a transmission problem. They don't really want to open up the transmission case until they have a place to start. It should either be something mechanical with the transmission or a problem with the computer that controls the transmission, right? After getting off the phone with the mechanic today he said it might be a sticky throttle body?
Golf V R32 :: Intermittent Cruise Control / Fails To Engage
My cruise fails to engage, sometimes first thing in the mornings, sometimes in the afternoon, cold engine or warm, fresh start or on resume. After the car is turned off for a few, something is resetting it and it then works fine. Wondering if this has something to do with a faulty switch, fuse, or whatever. I've tried the cruise switch on the stalk in turning it off for a while, keeping it pressed in, turning it back on, everything.
View 6 RepliesPassat (B5) :: 1999 - Transmission Slip / Fails To Engage For About Half A Second After Hitting Throttle
Every once in a while (maybe once a week) I notice that my transmission will slip (fails to engage for about half a second after hitting the throttle). Usually this happens after I have slowed down to almost a stop and then accelerate. The last time this happened I was on a slight incline (maybe 4%).
Is this something to worry about? Any easy way to test if this is an indicator of a big problem coming up down the road? The car has about 130k miles on it now and the transmission fluid and filter was changed at about 90k, the fluid level was checked by a VW tech so I assume it is correct.
Ford Excursion :: 2000 - 4WD Won't Engage?
I have a 2000 excursion v10 with 66k miles on it. This past weekend i went to engage my 4wd and it would not work. the light on the dash is on and i think i heard a click but no luck. A buddy told me to tap the transfer case motor with a hammer but am a little skeptical. another friend told me to check the vacuum switch with the vent/ defroster but i am not sure that holds true with my yr/model (i did a test where i left the vent setting on face/feet then turned on the 4wd. the airflow seemed to remain as set). About a year ago i removed, regreased and repacked my front hubs.
View 10 RepliesFord Excursion :: How To Engage Hub Forward
I am a new manual 4wd system. i have a 02 excursion. i have tried to turn my hubs but they don't seem to move. i am unsure how to engage the system.
Should I put the hubs in the lock then put it in 4 wheels hi or low or the other way ....
Now from reading some of the forums it may sound like my locking hubs may be frozen and need replacing ....
Any good set of locking hubs and can i rebuild my sock ones for spares. its there a step by step on how to replace the locking hubs ....
Ford Excursion :: 2001 EX 4x4 Works In 4Hi / Won't Engage To 4Lo
The Transfer case motor works fine changing from 2H to 4H and back to 2H. Verified the drive shaft is locked in 4wd. Drive shaft is free when switching back to 2H. Hubs work fine and no problems on the vacuum side. Garage is 50+ degrees.
Very occasionally I can get into 4 Lo. (Neutral - complete stop - brake pedal depressed). My main question is could the Transfer case motor be bad if it works in and out of 4H with no problem? I have not seen any answer to this question from my searching. Also, could the dash switch be going? Last summer this started and now seems to be getting worse. This weekend I could only get into 4L one time. Where to start checking (motor on transfer case or dash switch or other)?
I have tried rolling slowly, backing up etc... Problem is I can easily hear the motor work when going to 4H and going to 4Lo (when it is working) most times when it is switched to 4Lo, there is complete silence like there is no power to the motor at all. Tapping the motor does not work. I pulled the electrical connectors off the motor and all pins on both plugs look clean and new.
Thought to first check the dash switch but not sure how to check it. The motor could be also a problem? Is there a way to remove the motor and check it?
I want to get this fixed by the spring since I use 4Lo every weekend when launching the boat. (Never has been deep enough in the water to get close to the Transfer case)..
Ford Excursion :: 4x4 - Transfer Case Does Not Engage
Looking at another Ex but the owner says the transfer case does not engage. Says it can be locked into 4X4 by crawling under it and engaging it manually by removing a motor [Servo motor ?] Does this mean I would need a new transfer case or just the servo motor ? I know mine did the same thing last winter. It would go into 4X4 and then pop out.
View 10 RepliesFord Excursion :: 4WD - Could Not Get 4Hi Or 4Lo To Engage With Rocking Back And Forth
I had to make a few trips up and down the snow covered driveway. I moved the dash switch to 4wd high for each trip and then back to 2wd when I was turning around at each end. On my final trip back, I got stuck while turning around in 2wd. I tried switching to 4wd high and low but could not get either to engage with rocking back and forth.
The dash light did not come on and only the rear right wheel was spinning. Shifting to park or neutral and turning the switch to 4wd did not change the results. When I finally got myself unstuck, the 4wd still wouldn't engage when driving in a straight line.
What could have broke or stopped working? Bad vacuum line? Bad fuse? Could I have still initiated 4wd by manually locking the hubs? If so, is the process with the dash switch still the same even when manually locking the hubs?
Ford Excursion :: Auto Locking Hubs Won't Engage?
And the vacuum pump was replaced.
View 7 RepliesFord Excursion :: 2001 4x4 - Warn Hubs Will Not Engage?
I bought a 2001 Excursion Ltd 4 years ago. A previous owner put Warn Premium hubs on it, which I would have eventually done myself.
I got stuck a couple of weeks ago and tried to use my 4wd. Nothing.
A friend suggested I replace the Transfer Case Motor as it can go out if you don't use it. I got that done today but I still don't have 4wd.
I can hear the transfer case shift and see the drive shaft spinning, but the front tires don't spin.
I thought it was the PVH solenoid, but discovered the Warn locking hubs don't use the vacuum and it has been disconnected/plugged.
Ford - Fiesta :: 2011 - Automatic Transmission Won't Engage
I have a 2011 Ford Fiesta and yesterday morning I went to start it and the check engine light came on. When I tried to shift into reverse, the gear lever moved but the gear wouldn't engage. None of the other gears worked either. I turned the car off and back on again, and it was fine (the check engine stayed on, though). I have to repeat this process every time I start the car, and this afternoon it took three tries. This a low-mileage car: I bought it brand new a little over 4 years ago, and it's barely over 20,000 miles. I have an appointment scheduled with the dealership, but is this something that's going to cost me a lot of money or is it just a computer issue? One other detail: it was very very cold the night before the issue started (about -10 degrees).
View 19 RepliesFord Excursion :: Transmission Will Occasionally Hesitate To Engage Drive From Park
Just a little background, my Ex is a 2000 V10 4x4 with 217,000 miles. I've owned it for a little under a year. Very clean truck, and well maintained by previous owner. Now the issue. Starting about a month after I bought it, it would occasionally hesitate to engage drive from park. I checked fluid and it was full and clean. I had a buddy recommended that I check for chafed wires in the steering column which I did and found nothing. It seemed to get better for a while but now it's back. It's doing it more than half the time I put it in drive and sometimes takes 10-15 seconds to engage. So am I probably looking at a new trans? Or, is there anything that can be done to save the old trans?
View 1 RepliesFord Excursion :: 2001 - Reverse Slow To Engage After Sitting For 8 Days
Monday I started my truck after leaving it in the garage while on a 8 day vacation. Shifting into reverse led to almost no movement at all. After a few seconds, I shifted back into park and then reverse again and got a solid reverse right away. I may have noticed sluggish shifting into reverse previously, but not this noticeable. What could be the culprit?
2001 Excursion 7.3 4x4 .....
Ford Excursion :: 2000 Will Not Roll Backwards - Some Hesitation To Engage Each Gear?
I have a 2000 Excursion 7.3 4x4 with 237k miles on the original 4R100. Yesterday afternoon I went to back out of a parking space and the truck wouldn't move. When I put it in R, the transmission will engage and upon pressing the gas pedal it acts like it wants to move but will not budge. It rolls forward with no issue or noise. It will not roll backwards at all - not in neutral and not in reverse. The transmission shifts fine but with some hesitation to engage each gear. I have noticed some slippage but nothing crazy.
I 1st thought something might be wrong with the rear end but after some research I think it might be the transmission.
Ford Excursion :: Alarm Won't Engage When Leave A Window Rolled Down And Open Any Door
Everything I've seen in the forum refers to alarms activating and how to turn them off, my problem is the opposite. Last year I performed a simple injector cup procedure on my 2000 7.3 Excursion which took about 3 months, during which time I had my batteries removed. When I finally buttoned everything back up I noticed that my alarm does the "chirp", but that I can leave a window rolled down and open any door without it going off. How to get this to reset? I can hit the panic button and get the alarm, but as a security feature it's not working.
View 6 RepliesFord Super Duty (1999-2016) :: 2011- While Not Moving Forward - 4WD Won't Engage?
2011 F250 6.7L Powerstroke, automatic tranny, Electric Locking Diff
When I engage the On the Fly 4WD switch the indicator panel says "shift to 4x4H in Progress" and everything seems fine but if I am not moving forward when I shift the 4WD doesn't engage. The engine revs up but nothing happens. When I release the accelerator the transfer case bangs like it is going to rip out of the truck. In reverse it is even worse. I am lucky that I didn't gun it or I could have done allot of potential damage. All my other Ford 4WD vehicles engage immediately from a full stopped position. This is quite of troublesome because if you have to shift when your stuck in the mud, your still stuck. If I shift while moving forward it works just fine.
My question is: Does this particular model (2011 F250 6.7L Powerstroke with an automatic tranny) have to be moving forward in order for the 4WD to engage?
Ford Excursion :: Reverse Lights And Back Up Alarm Will Not Engage - Gear Shifter Adjustment?
My reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....
View 14 RepliesFord Excursion :: 4x4 Selector Switch On Dash Lights Up Properly But Auto Hubs Don't Actually Engage
My Excursion is having an issue with the 4x4 system. The. 4x4 selector switch on dash lights up properly for 4x4, but the auto hubs don't actually engage. The hubs will lock only if I manually lock the hubs. I can hear relay click, so I don't think its electrical. The hubs had new o rings installed when I did front ball joints a few thousand miles ago, and the 4x4 worked fine up until today.
View 5 Replies