Ford 7.3L Power Stroke (1999-2003) :: 2000 Truck Taking Three Cranks To Start - Code Is P1280
2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 1 RepliesFord Excursion :: Started Spattering And P1280 Code Popped Up?
I did a CCV MOD and washed the engine with simple green and a garden hose yesterday, started the truck and it was running fine for about 10 min. After that it started spattering and a P1280 code poped up. Is it related to a wash or ccv? It does not stoll but idles bad, drives fine once i get it over about 5mph.
View 1 RepliesFord Excursion :: Truck Cranks Just Fine But Won't Start / Acts Like There Is No Gas
Been having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
Ford Super Duty (1999-2016) :: 7.3L Suddenly Start Taking More Cranks To Finally Fire Up On First Start
I don't drive the truck much anymore but over time my MPG has gone to total crap...about 10mpg around town...and that's baby-ing it.
Now it suddenly takes many cranks to finally start on a first start. (cold or warm days)....
Golf V R32 :: How To Check Fuel Pump - Car Taking 8 Cranks To Start
Lately my car takes 2-3 cranks before it starts and I'm thinking it could be my fuel pump. There were a few times recently it took like 8 cranks to start. How to test fuel flow to see if it has issue? Also, could a old battery cause this issue?
View 18 RepliesElectrical-wiring - Honda :: Delay In Start / Taking 3 To 6 Cranks Before Firing Up
So heres the deal 1989 civic dx hatchback 106k on the odometer automatic 1.5l d15b2 engine . It's been having delayed starts taking 3 to 6 cranks before firing up then running fine, suddenly it dawned on me maybe it was the distributor , so I swapped it with a spare I had because sure enough the old one had red death red dust in the cap. Cleaned the contacts set the timing reassembled, some wires broke on the back of the wiring harness to the distro. Rewired them, the car kept getting worse I jumped it and took it to my friend a vw mechanic it drove 49 miles there fine after the jump, new plugs new wires new fuel filter we did the wire job set the timing checked the timing belt got the battery tested and the alternators new and did a oil change also did a coolant flush a few weeks ago.
It started right up drove it back to Chicago , in the morning I was getting off the highway it stopped running no noises I pulled over 8 cranks later it started parked it 3 blocks away, went to test drive it when I stopped at a light it shut off cramming it and hitting the gas pedal got it to start drove it a block down it shut off at a stop sign and I parked it. What it is I'm throwing code 8 which is a top dead sensor which I think is in the distro which I replaced a month ago. Fuel pump sounds like its priming but you have to gas it and crank it to start it which is odd for a automatic , it is girk injected is this tds sensor going to do that by itself? Or could it be a ignition module? ( what I read online) starter? Main relay , fuel pump switch?
Ford Excursion :: New ICP / CPS But Still Hiccups - Codes P1000 And P1280
I have not yet managed to fix the Ex, i have replaced the CPS with a Delphi 101 cps, and the ICP sensor. The truck ran great for almost 3 hours, but then started acting up again. Codes I pull are P1000 and P1280.
The p1280 code is probably from a loose connector, i got injection pressure of 728psi constant at idle and during low rpms, will fix that tomorrow, but that is probably not what causes the hiccup, but if my new one is function correctly, then i might be something else? The old was from stock and had an oily connector, i have replaced the pigtail though.
The funny thing is, that when i open the hood, the rpms will climb up around 200rpms at idle, to right under 1000rpms, it will do this slowly, takes about 10 seconds. Close the hood and it goes back to normal, so maybe a vacuum leak? When i slam the hood shut, it will sometimes do the hiccup. I have managed to loose 2 of the bolts to the valve cover, but it sits tightly.
Really lost on this truck, what can cause this hiccup, when it does it, the water-fuel light comes on (got a new filter in it). I also have a check engine light, but if i delete the codes when its running, it goes away until startup again.
Another thing i have noticed is that the truck is slower to start then normal, before i got this problem, the truck would start right up when turning the key, now i have to crank it for about a second more.
Ford 7.3L Power Stroke (1999-2003) :: Intermittent Starting / Code P1280
My 02 f250 w/ 7.3 won't start. Cranks and nothing. No smoke or anything. For the last year It has had a intermittent starting problem, where I would drive it for 15-20 mins. If I shut it off like I would if I was at the fuel pump and then restart it, it wouldn't. I'd have to wait 30 minutes with a hood open and then it may start. Other times I would have to wait hours.
I tried replacing the crank position sensor, the fuel pump and filter.I did all this in the Last 300 mile . There's No change. After a week or two of sitting it won't start. What can I check and what can I try.
To add more info. Since I am not the original owner I pulled the computer that is located behind the ebrake to see if someone else had installed a chip, as I've heard that if that chip goes bad then the truck won't start. I disconnected that battery and pulled it. Negative on any chip. Put it all back together and tried again. No start. I borrowed a code reader tonight and pulled a P1280 code. I'm back to square one.
Ford Excursion :: SES Never Go Out / Cranks Over But No Start
My 6.8L is experiencing an issue. Truck hasn't been ran in a few months...it ran fine when it was parked and has sat longer than this with no issue before. Battery voltage fine...
I get in, insert the key, turn it over and it cranks but doesn't fire.., why is that, I wonder? I notice the SES never goes out before I crank the truck over.
I unplug the battery, tried to clear any fault codes with my handheld tuner (which there was nothing showing up) and turned the ignition on. I left the key in the on position but didn't try to start it. The SES lights never turns off.
I am assuming that if the SES light stays on, the ecu will not allow the truck to start...is that true? What components have an effect on the SES light when you first turn on the key?
Ford F-150 - 1997-2003 :: 1999 - Truck Cranks Over But Won't Start
Last night my boyfriend took a friend to the check cashing store, truck ran fine. shut it off, and when he came out the truck would not start. it cranks over but won't start. Took ignition coil off and had it tested but its fine. What else could be wrong or what can i do to try to get it to start again.
View 5 RepliesFord F-150 (2004-2008) :: 2006 Truck Cranks But Does Not Start
I just went out to move my truck to take out garbage and it cranks but doesn't start. It is 4.6L 4WD. I sprayed ether in intake no change. Checked all fuses all good. It has been raining pretty hard the last 3 days and it has been sitting in rain all 3 days. I checked for codes with a simple code scanner no codes. But the code scanner I used is not able to do KOEO or KOER tests. I know it needs new plugs but it has never sputtered or died on me. Has slight misfire but not engine stopping. I havnt had any check engine lights or problems before.
View 3 RepliesFord Excursion :: Cranks Fine But Does Not Start
Had the Excursion out today. Made a stop coming back and used the remote start. I entered the truck and by mistake pressed the brake pedal which shuts off the engine. When I tried to start the truck with the key...it cranks fine but does not start. It'll try to run, sputter...but will not run.
I cannot hear the pump running when the key is turned. It was towed home and it in the driveway. I assume it's the fuel pump....but wondered if the remote start/alarm could be killing the power to the pump? The cut-off switch in the passenger footwell is pressed in. Where do I start:?
Ford - Ranger :: Random Inability To Start Truck / Cranks But Won't Turn Over
99 Ford Ranger disguised as Mazda B2500. (Same vehicle I think) 5 speed manual, 4 cyl., no a/c. Bought new and maintained according to schedule. Randomly fails to start. Cranks but won't turn over. I try several hours later and am able to start it. Mechanic has not been able to duplicate the failure to start. Checked thoroughly and finds no problem. I am very hesitant to drive it like this.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Cranks But Will Not Start
This past weekend I noticed I was loosing boost pressure on my 2003 7.3l F250 so I pulled my turbo out found the problem fixed it then put the turbo back in. After it was all said and done I went to start the truck up and it just cranked and cranked a cranked but no start. Worried I didn't hook something up right I checked and rechecked everything to do with the turbo, all good nothing out of the ordinary.
I tried to start again, nothing. Spent all day yesterday trying to figure this out. Replaced the cps still nothing. No movement in tach but I don't remember any on startup anyway. Drained the fuel filter had adequate pressure and such but replaced the filter anyway. Still nothing. Checker all my fuses, one by on and non were blown but I still tried disconnecting my fuel bowl heater and still got nothing. I tried disconnecting the Icp still nothing. There was no oil around the icp either.
I'm getting frustrated that the truck wont start, the truck ran perfectly fine before the turbo removal but now wont even give a sign of kicking up. Just cranks and cranks. Also checked Hpop to see if that's the cause and it's filled like to the brim. But when I'm cranking the truck about 10 sec into the oil pressure gauge kicks up and reads good but only when cranking.
Ford Ranger / B-Series :: Truck At Times Cranks But Does Not Start - Hot Or Cold
Removing fuel injectors-coolant contamination.. How is this done? I need to see if they are any good-or clean/replace them-after I accidentally left the clip off the hose running out of the thermostat housing when I drained my coolant last week and the first time I drove, coolant leaked onto the top of the engine/manifold depressions, getting onto and into the fuel injectors.
I tried to clean it up as much as possible the first time(finally got it going) but still a few days later the truck at times cranks but does not start-hot or cold. I assume my idiocy is the cause or maybe it is just coincidence of something else? From what I read from my symptoms it could also be the fuel pump relay, pressure regulator, coolant temp sensor, crank sensor.. among other things. My fuel pump is 1.5 years old, so hopefully that isnt it. Have the injectors possibly been contaminated to where I should just replace them?
Ford 7.3L Power Stroke (1999-2003) :: Truck Cranks But Won't Start
Truck cranks wont start. Fuses and relays good, New motorcraft; IPR, ICP with pigtails, New T500 hpop, New 180/80 Injectors, Push rods, 910 valve springs, Mellings lpop. Motorcraft oil cooler.
Reservoir full, oil new 15-40w Amsoil, Rails full, Fuel bowl full and clean, HPOP drive gear rechecked and torqued.
RPM 180
Temp oil 88*
ICP duty cycle koeo 14.8, crank 64.85
ICP pressure 250 -450psi
ICP voltage .27-.50
Manual gauge on oil rail 250 -450psi when cranking
Inj pulse width .0005,
Buzz test was good
Vref 5v all sensors. 12v at IPR w/koeo
Fuel pressure 58psi
Air test hpop hear no leaks with stethoscope.
DTC codes: P1280, P0380
Also put straight edge across injectors to double check they were seated.
Ford F-150 - 1997-2003 :: 2000 Truck Cranks But Won't Start - No Fire
2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 RepliesFord Excursion :: 2004 6.0 Just Cranks Over But Won't Start After Warming Up
I have researched a little and believe i have a leak in the high pressure oil system. My 2004 Excursion 6.0 will start when it is cold but after warming up will not start it just cranks over. So here is my question; the two wires leading from the Turbo had melted and shorted and in fixing that i loosened what i believe to be an oil line feeding the Turbo. Could this be the problem? Also is there an O-Ring that seats the line into the block that may need replaced?
View 2 RepliesFord Excursion :: 2004 6.0 Cranks Fine But Will Not Start
My 2004 6.0 will not start. It cranks fine. History This happened once before about a year ago towed it into the shop and it stated fine.
The batteries were low yesterday and the truck would not start because the voltage was too low to run the starter. I charged them. Went to try again and I cranked it for close to 30 seconds with no results.
Only cods so far are #6 glow plug and EGR valve open. Whats next, check the FICA?