Ford 7.3L Power Stroke (1999-2003) :: F250 Will Crank / Hesitate / Start And Die - Code P0231
Okay, I am having issues with a 1999 F250 XLT 7.3 with diablo programmer. I have searched and searched and have tried everything we could think of and it is a no go. The truck will crank, hesitate to start, start and die, other times it will only crank and not run at all. We can make it stay running by hitting the accelerator. The only code we were getting was the cps code, but that is suspected to be because of the excessive cranking and no start times. Previous to this issue getting this serious it would stall randomly, at idle, going down the road at constant speed, slowing down, or accelerating. We now have code P0231.
Through this we have tried:
IDM
(loaner) ECM
removing Diablo
3 CPS
shaving down CPS
Shimming CPS
IPR
Fuel pump
relay
fuel pump fuse
Ford 6.0L Power Stroke Diesel :: 2006 F250 Won't Start - ICP Is Low - Code P0231
I got a 2006 F250 6.0 that won't start. It turns over perfectly. What I've done so far was change oil and filter, along with fuel filters. All fuses and relays are fine. I payed for the scan gauge 2 and monitored FICM SYNC, FICM voltage, ICP, AND IPR. Every thing checks out besides ICP. The ICP is reading under 400. So I unplugged the ICP. Still no start.
I decided to spray some starter fluid in the intake and turn her over. Boom starts right up and runs fine. I even drove her around for about 20 min. I get home and shut off the truck. wait a few minutes and nothing dead again. So ICP is low but the truck runs fine after some initial support from starter fluid. What I need to do next? I don't want to have to take it into the shop for something stupid I could do myself.
Also the code its throwing at me is P0231 Fuel Pump Secondary Circuit
Prius (2001-03) :: Replaced HV Battery - Error Codes With Triangle Came On
I successfully replaced the HV battery on my own and it was so easy even this girl to do it! I drove the car about 300 miles when I got the triangle of death warning light again yesterday. I took my 2002 Prius to the dealer to read the codes but how to borrow a scanner (or whatever) from Autozone and do it myself.
View 19 RepliesPrius (2004-09) :: Replaced Battery And Car Wasn't Coming On - Error P
So from the beginning the car wasn't coming on. It gave me error "p" said my parking break was not working properly and needed to be on a flat surface in order to work. We jumped it and replaced the battery shortly after that. The car will turn on but the actual engine is not turning on. The display screen has a little car with a red exclamation going through it. The dashboard also has all the lights on. We have tried to jump it from the relay at this point but it wont start now to where before it would.
View 6 RepliesFord Excursion :: Replaced Battery And Fuel Pump Relay / Only Crank / Won't Start?
Black Beauty finally gave up. Replaced battery, replaced fuel pump relay. Would only run with starter fluid sprayed into the air intake. She'll crank but not start. Here she sits at the dealership.
View 14 RepliesFord Excursion :: Error Code P1201 - EGE Valve?
I am getting an error code of 1201. Is this the ERG valve? How do I change out? Looking for Pictures or diagram?
View 5 RepliesPrius (2004-09) :: Error Code 1121 After Hybrid Water Pump Replaced
I had my hybrid water pump replaced (free, under recall) about a month ago. Now the check engine light comes on intermittently, and it's with error code 1121 (Coolant flow control valve sensor stuck). I've seen other people on this forum hypothesize that the work could cause this error (if not bled properly, leaving air in the system). But my dealer said the work had nothing to do with this error and I need to replace the control valve. How to suggest to my dealer that it could, in fact, be due to their work and that I think they should fix it for free?
View 15 RepliesFord Excursion :: 2003 - Replaced Radiator Still Leaking?
I successfully replaced the radiator on my 2003 Ford excursion (LMD, V10, gas). I filled her up with coolant and started her and turned on the air full blast.
Noticed though that she is now leaking somewhere between the engine and the transmission pan.Where and what to check?
Prius (Gen 1) :: Error Code P3001 - 12V Battery Not Charging
My 01 Prius is not charging the 12V battery and I have error code P3001. Everyone on here said P3001 is the HV battery ECU. (which I replaced with one from the Junk Yard and still get the error code)
I charged the 12V battery over night and Autozone says that its ok. They tested it with a little machine. The only other thing I can think of is that the Inverter DC-DC converter part is bad. How I can test that? (is there a way other than replace the inverter?)
Prius (2004-09) :: Replaced Dead Cells On HV Battery - Code P0A80
Have replaced dead cells on wife's HV battery over a month ago. Threw this P0a80 code today and will barely move. She idles into dealership and they say it's the battery, really!
View 2 RepliesPrius (2004-09) :: Replaced 2 Modules In Hybrid Battery - Code P0A80
I have 2005 Prius with 300k miles. I started throwing P0A80 code. I removed the battery and checked all the modules and found 2 of low voltage, ordered them from Ebay and replaced them. I placed the battery back in the car and started the car but got P0A80 code again. I purchased the grid charger from Hybrid Automotive and connected it according to their instructions for 24 hours. I drove a car but got the red triangle again and P0A80 code again. I removed the battery again and tested the voltage of all the modules and these are the readings:
View 4 RepliesPrius (Gen 2) :: Fan Not Working / Battery Overheating - Error Code POA85
VSC, ABS triangle warning! Error code POA85 ... We took the car apart and basically found the error with the fan it's not working. When you connect the battery to the fan it's working perfectly. The fan motor resistor is overheating is this the problem? Or should it be very hot.
View 4 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Ford F-150 - 1997-2003 :: CEL On With Error Code P0155?
Have this code Po155 oxy sensor heated bank 2 sen 1. I have replaced all sensor in the tail pips and check engine light code still comes on.
View 7 RepliesFord F-150 - 1997-2003 :: IAC Over Speed Error Code P1506
About 3 days ago I noticed my engine RPM was around 250 higher than usual. Usually my truck idles around 550-600 rpm (I know this is low). Anyway, yesterday it threw the P1506 "IAC over Speed Error" Code. It is idling very rough, shifting weird, but does crank up fine.
My truck is now at 93,000 miles and I just cleaned the IAC at 87,000 miles due to the common no start condition. I guess I am going to get a new IAC now since another code came up.
Well, my question is it came up with two other codes also:
P0171 - System too Lean, Bank No. 1
P0174 - System too Lean, Bank No. 2
Do you think the P1506 (IAC Code) made the O2 Sensor codes show up or is it really the O2 Sensors? I just changed my two upstream O2 Sensors around 90,000 miles. Should I get a new IAC or try to clean it again?
Ford F-150 - 1997-2003 :: 2002 - Got Error Code PO174
Looking for some experience/recommendations for the "what to do" and "in what order" for an error code. Recently the "SERVICE ENGINE SOON" light came on and has stayed on for the last 2 weeks. It has don this before after a heavy rain but went off after a few days but not this time. I took it to Advance Auto who hooked it up to a Trouble Code Reader and got back "PO174- Bank 2 system to lean". From what I've read from the Haynes book and other forum postings this is either a O2 sensor issue or a intake manifold gasket issue? Does this sound right? Next is how to go about addressing this issue in a systematic manner so as not "fix" 10 things that don't need fixing and not running to mechanic and paying a buttload for something I can do myself for less.
View 1 RepliesFord F-150 - 1997-2003 :: Transmission Range Sensor Replaced - Got Code P0705?
I have replaced the transmission Range sensor (with OEM) and it is adjusted correctly, however This did not clear the. Code P0705... I am stuck ....
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Error Code P0475 - Fix?
I went and got my truck smog and it failed because of this code. I then changed the sensor cleaned out the tube and I still can't figure out how to get rid of the error code?
View 3 RepliesFord F-150 - 1997-2003 :: Got Error Code P1000 - Idle Rough - CEL On?
What that means? The check engine light is NOT on but I looked for a code because my truck is idling rough, and when driving, when the overdrive kicks in, it vibrates really bad. As if a bad U-joint on your drive shaft. The truck has been in a field for about 5 months broke down so any clue? Haynes manual says nothing about P1000.
View 13 Replies