Ford Excursion :: Parking Brake Light On Intermittently?
I've been having a problem lately where I'm driving down the road and the brake light comes on and starts binging. I stop push the parking brake and release it a few times, then the light goes out and I'm on my way. Sometimes when I first release it the light doesn't extinguish and sometimes it is never on. I'm guessing there is a switch somewhere for the parking brake that isn't working so great. Is it around the pedal or somewhere in the brakes themselves? Is this a typical problem?
View 14 RepliesFord Excursion :: 2000 4x4 - Brake Light On And Did Not Go Out
I noticed this morning that the brake light on the dash did not go out. I cycled the e-brake, checked the fluids. The fluid level is fine and I reached up and pushed in the contact switch for the e-brake and the light still didnt go out.
Driving it - no issues with braking. I know on some older vehicles, there's a proportional valve that gets stuck and can be cleaned. I'm not very familiar with this and Im not sure if it even applies to this model.
I did have the flex brake lines changed on the front because the right front was leaking and thought might as well do both.
2000 Ford Excursion Limited 4x4 ....
Ford Excursion :: 2000 V10 - Dashboard Brake Light Staying On
2000 Excursion 2WD 6.8L V-10. Dashboard brake light has come on and is staying on. Fluid is up in reservoir visual on lines and calipers appear in standard nick. Bad brake light switch?
View 2 RepliesFord Excursion :: Parking Brake Cable Snapped?
When I set the parking brake last night, there was a loud pop and the pedal suddenly went soft to the floor and would not spring back when I pulled the release. The pedal doesn't spring back up when I pull the release lever, but I was able to pull it back up by hand to get the dash light to go out. That works, but without the tension from the brake cable the pedal works back down and the dash light comes on.
When I got out of the driver's seat, there was a cable laying on the ground right under the front door. The cable snapped right in front of a metal cable joiner. What is involved in fixing this?
Ford Excursion :: 2001 - Parking Brake Pedal Will Not Depress
2001 Ex limited 4x2 w/50k miles-- The parking brake pedal will not depress...at all....not even a millimeter. Feels like it is "locked".
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Parking Brake Light Doesn't On - Replace Brake Sensor?
I just had a remote start installed with a turbo timer that works off of the parking brake being engaged. No matter how hard I press it the light does not go on, however when the installer probed the sensor to ground it, it worked fine.What part this is that needs to be replaced. The stealership quoted me at 200 something for a whole parking brake assembly.
View 14 RepliesFord - Crownvictoria :: 2000 - Parking Brake Is Non-functional?
2000 Crown Victoria, 186K miles
I have to park on the street at my house, and it's a decent enough hill. I always park facing down the hill and I'm in the habit of turning the wheels towards the curb. Just recently I was parking and in neutral, easing the car's weight onto the parking brake and I heard a pop of some sort, and now my parking brake is basically non-functional. I don't think I lost any cables as none of them are hanging loose under the car, but I won't know until I get the rear rotors off and can inspect things. I know at least one other CV owner who went to check his parking brakes and the shoe linings had separated from the backing plates, but all of that's not really my question.
As of now I have to park on the street with one of the wheels firmly against the curb to hold the car in place (in this case, driver's front wheel). Am I going to mess up the tire on that wheel by doing this? There are no ill effects to this point, and maybe it's okay if only for some hours at a time and not days/weeks. What do you think?
Ford Ranger / B-Series :: 2000 - Parking Brake Cable Route?
I bought 2000 Ranger with rear half of the frame cut and welded.
The mechanics who did this did terrible job of putting things where they belong. I rerouted wiring harness and rebuilt EVAP lines, but cannot figure out what is the correct route for parking brake cable.
Currently some part of the parking brake cable is sitting on the leaf spring. It may also be missing some mounting brackets or clips. Looking for a picture or diagram showing parking brake cable routing?
Ford F-150 - 1997-2003 :: 2000 XLT - Parking Brake Cable Removal
I'm having a hard time trying to figure out to detach the cable from the pedal assembly. The place where the cable attaches is so hidden by various plates, pawls and springs that there is no access. Also the whole assembly is put together with rivets so there's no easy way of taking it apart. Is there some trick to getting the cable out?
Also, I need to find out exactly where the cable goes through the floor pan. I'm in the process of fixing the rust on this. My 2000 XLT 4x4 and the floor pan and rockers were so rusted that there was no evidence of where the cable went through the floor pan! I assume it's supposed to go through the channel right next to the inner rocker but where exactly? A simple measurement from the back edge of the A-pillar is all I need.
Ford Brakes/Suspension :: 2000 - Parking Brake Shoes Won't Hold The Truck At All?
I have a 2000 F350 4X4 with a V10 under the hood and a 5 speed manual transmission. It has a heavy western hauler bed, and a dual tired rearend. The truck has disc brakes all the way around that work great. I bought the truck used and immediately replaced all the disc brake pads as well as the seperate parking brake shoes and I had the parking brake drums turned. My problem is the parking brake shoes won't hold the truck at all and never have even when they were new. The parking brake shoes seem very small to me for a truck this size and weight. I have adjusted them as tight as I can with out causing them to drag when they are released. Is this a common problem for this type of parking brake on this type of truck? Is there something I am over looking or need to do to perhaps improve the parking brake? Would it be possible to splice some sort of "locking" valve into the brake lines going to the disc brakes to perhaps hold them engaged when I park the truck? I have a good idea how air brakes work, so I suppose this "locking" valve would work like that except basically opposite of a locking air brake valve, if that makes any sense.
View 14 RepliesHonda - Accord :: 1998 - Parking Brake Light Comes On Until Jiggling The Brake Handle
The red dash light for my parking brake stays on until I jiggle the brake handle, then it stays off until I re-start the car the next time and then it goes on again. Brake fluid is fine.
Appears to be a faulty switch attached to the handle. How do I fix this? Is it a major job? [it's a 1998 Honda Accord]
Touareg :: When Parking Brake Released In MFI Got Warning Parking Brake Fail To Release
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 RepliesFord F-150 (2004-2008) :: Parking Brake Light Stays On?
So here is my issue, my parking brake light stays on. Ive checked my parking brake pads, the cables and the switch. They are all servicable and operational yet the light stays on...
View 7 RepliesFord F-150 (2004-2008) :: ABS And Parking Brake Light Came Onto The Dash
I recently purchased an 07 f150 lariat leveled 4x4. I noticed the other day that all at once, the abs light and parking brake light came onto the dash, 4x4 low doesn't work and just stays in high and the ac doesn't blow cold. I'm assuming this is somewhat connected considering this all happened at once but really just not sure.
View 1 RepliesAccent LC (2000-05) :: 2002 Parking Brake Dash Indicator Won't Go Off
I recently had my '02 Accent serviced. When I picked it up, the mechanic had set the parking brake with about 15,000 lbs of force. Once I got it released, I noticed that the red parking brake dash indicator light won't go off while the car is running.
I have verified the brakes are free, and have tried wiggling the brake handle.
Is there a switch somewhere that could be bad? For the record, I do most minor maintenance myself, and have 214,000 trouble-free miles on my 1.5L SOHC Accent.
Ford Wiring/Electrical :: 2004 F150 - Parking Brake Light Stays On
Why the parking brake light in my dash stays on, 2004 F150. Fluid in master cylinder is full, has no signs of leaks anywhere.
View 2 RepliesFord F-150 (2004-2008) :: Parking Brake / ABS Light Comes On Intermittently - C1342 Code
Intermittently, the parking brake/ABS light comes on with no pattern I can put my finger on. Some times its on when I start it and stays on the entire time I drive it. Some times its off when I start it and then comes on while I'm driving it. This morning I took it by Advance auto and had them check for codes while the light was on: C1342 - ABS control module. I can't find a lot of information about this code or what can be done to fix it other than taking it to a dealer. Any alternative solution, perhaps re-seating the connectors to the module - and where the heck is the module and what does it look like?
View 1 RepliesFord Super Duty (1999-2016) :: F250 - Parking Brake Light Stays On
I have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 RepliesPassat (B5) :: Rear Parking Light Went Out, But Brake Light Works
Recently purchased a 2001.5 Passat, and of course got the mod itch... started with an Neuspeed ECU flash & DV, along with K&N... and now I'm in the process of suspension & exhaust... Unfortunately the past week, I was told that I had a tail light out.... Upper Rear Passenger Side Parking/Brake Light.... So I figure, hit up the parts store, grab a new bulb, and I'll be set...
Well, come to find out that it's not the bulb....
The light works when I brake, so 1/2 of the bulb is good... but the parking lights won't come on that side, but on the driver side everything is good..... even with the new bulbs..(replaced both on that side[passenger] just to be sure.)
So, just out of curiosity, I took one of the old bulbs that I thought was shot, and put it in the drivers side, and what do you know... it worked flawlessly on that side...
So, I'm led to believe I have a short... or a wiring problem somewhere... but I can't see how this could have just happened without really messing with anything... I mean, I disabled the DRL's.... but I even undid that(small piece of tape covering the B prong)... just to make sure..