Ford F-150 (2009-2014) :: Message Center Started To Read - Check Fuel / Fill Inlet?
I just got my new 2009 F150 XL yesterday and after 100 miles today the message center has started to read Check Fuel, Fill Inlet.
View 13 RepliesFord - Escape :: 2004 V6 Misses / Bucks And Jumps - Multiple Check Engine Codes
This is a Ford Escape XLT with the 3.0L V6. I get the following codes - P0316 P0300 P0136 P0305 P0306. Sometimes it runs just fine and sometimes it misses and bucks and jumps. It has been taken to a local shop and they said they found a loose ground at the computer. They said they corrected this and it should run fine. It still shows the same codes and runs like it did before they worked on it.
View 10 RepliesFord Escape / Hybrid :: 2001 - No Start When Turned Key / Dash Lit Up But Starter And Fuel Pump Did Not Fire
I have a 2001 ford escape V6 3.0l. Dropped a new motor in it, got everything running fine. Surprisingly the most frustrating part was when we mixed up the order of the front 3 coils but we got it!
It drove "ok" for a week and a half. Then it started to shudder at 45-55 mph. Got it home that afternoon and started to diagnose why it would shudder. Suspect its not shifting right.We started to diagnose what was wrong, made some adjustments to IAC, MAF and checked a few other things. We then went to test drive, started up fine, drove up the driveway 50' and it died. It didnt sputter and die, it just lost all power and died.
Got it back in the garage and tried to get it started again. Turned Key... nothing. Dash lit up but starter and fuel pump didnt fire. Odometer reads ------. I can jump the starter by pulling the starter relay. Same for the fuel pump. I use a jumper wire between two pins and I can get the starter to crank and the fuel pump runs when I jumper wire the relay too. So I know its not a bad starter nor a bad fuel pump.
Odd part of everything is that It drove just fine that day (other than shuddering). Then started just fine, then died. When it died we were making a sharp left turn in the driveway. We've messed with the steering wheel because it was "accidentally" put upside down when we dropped in the new engine. Could something have grounded out in the steering wheel? Air Bag? Maybe a problem in the clock spring? What would stop it from The fuel, starter and spark all at the same time? Bad PCM? Grounding issues?
Ford Escape / Hybrid :: Check Engine Light Only Comes On After Motor Is At Higher Rev - Codes P0304 And P0316
A couple of weeks ago I got a check engine light. Pulling the codes I saw that it was a p0304 and sometimes a p0316. The first time this happened I check the spark plug cables and one was loose (cycylinder 4). Then last week my fuel pump died. since then I have gotten the two codes on a somewhat continous basis. I replaced the plugs (needed to anyway) and the problem did not go away.
The odd thing is that the check engine light does not come on at idle. IT only comes on after the motor is at a higher rev. The replaced plugs looked pretty normal, but the cylinder 4 plug had some carbon deposits. I am currently running injector cleaner in the gas. I may go ahead and replace the plug wires since the current ones are high mileage and it is not an expensive fix.
Ford - Fusion :: Check Fuel Inlet Light Went On
The check fuel inlet light went on. Should we be concerned? What does this mean?
View 9 RepliesFord Escape / Hybrid :: 2004 XLT V6 - Power Loss / Vehicle Won't Go Over 30 MPH
I have a 2004 Ford Escape XLT V6 and I am experiencing a major loss of power in the vehicle. It idles smooth at about 1000rpm's but when you drive it , the vehicle won't go over 30mph and has a significant miss to it. I replaced the fuel filter, put in some Seafoam and took it for a drive and it still did not have any power and I blew out the EGR valve on the test drive. I replaced the EGR valve and the problem still remains. I hooked up a handheld computer to it and I got a P0300, P0304, P0305, P0306, P0316 and a P0355 error codes.
View 1 RepliesFord Escape / Hybrid :: 2005 - Electrical Shocks When Touch The Vehicle
Why do I get an electrical shock when I touch my 2005 Escape? It's not like I drag my feet on a carpet prior to touching it. I had same issue on an other vehicle. It is very annoying - what should I do?
View 7 RepliesFord Escape / Hybrid :: Service Emissions Message On Dash - Car Shudders A Little When Driving
Started up my 6 cylinder 2005 Ford Escape with 187,000 miles on the engine this morning and after 5 minutes a check engine light came on and the car shut off on its own. I restarted the car and then I got a dash message "Service Emissions" and the car shudders a little when driving. I am going to the autoparts store later for a OBD scanner code check.
View 1 RepliesFord Escape / Hybrid :: Theft Light Coming On Randomly / Vehicle Shut Off While Going Down The Road
I have an 05 escape xls 4cyl that has started acting up in the past 2 weeks. The vehicle has 52k on the clock and has no other issues but what im posting about.
Heres the problem: Vehicle starts fine every time you turn the key. It does not stall or idle rough when engaging the trans mission so I've concluded it has nothing to do with the torque converter. Once the car is running the vehicle will shut off randomly with the THEFT light coming on. I played with it for about 2 hours and have found that it will do this idling in Park, while in Reverse, and while in drive. The vehicle also will shut off while I am going down the road and every time it does the THEFT light is coming on as the problem starts. It does appear that it only happens when the accelerator is not depressed and will sometimes stay running if you hit the Gas Pedal as soon as it starts to happen.
I have tried using another key figuring maybe a transponder is bad...No dice does the exact same thing. I have also noted that i do hear single quiet (tock) when the vehicle shuts off coming from the drivers side lower engine compartment.
Ford Escape / Hybrid :: 2004 2WD Stalls Out - No Codes
2004 Ford Escape 2WD 3.0L with about 81,000 miles.
Problem: 2 possibly related
1) If warm up (get to about 190+ degrees) and then cut off engine. Does not start. If I wait about 30 secs and play the gas pedal, then I can get it to start with high revs and after about 15 secs runs normally. Or, I can disconnect the air intake and it'll start fine. But if you stop and try to start again, no joy unless playing with gas pedal.
2) After driving about 20-25 mins, it seems to randomly stall-out while going about 40 mph. When it stalls out, it will restart again after about 30 secs.
Note: Neither of the above throw any codes.
Here's my problem chart after mining the other posts:
Thing to replace/do //// No Code /// Stall while driving /// Won't restart when hot
Fuel Pump //// Yes /// Yes /// Doubt it
Fuel Filter //// Yes /// Yes /// Don't think so
CKP Sensor //// Yes /// Yes /// Yes
CMP Sensor //// Unlikely /// ? /// Possibly
ECT //// Maybe? /// Yes (if too hot) /// Yes
IAC Valve //// Unlikely /// Yes /// No
Thermostat //// Yes /// Yes (if too hot) /// Yes
MAF sensor //// Unlikely /// No /// Yes
What I've done:
- Well, I started looking at the vacuum lines and they were crumbling so I replaced all those (to EGR and all that).
- There is a mystery line that appears to come up from the canister and go to nothing--is this some kind of atmospheric vent?
- My cheap scan tool also shows engine temps getting up to 216 degrees if I make it work (idle high at 2000+ rpm), so I'm suspicious of the cooling system and thinking maybe the ECU is shutting down to avoid overheating.
I'm going to start with flushing the coolant and replacing the ECT and thermostat while doing so. This is relatively inexpensive and ECT can do weird things. The restart problem is consistent, so I'll know if I fixed that right away.
Ford Escape / Hybrid :: 2004 Vehicle Starts Right Up Dies / Stalls - Smoke From Rear Of Engine
I just picked up a 2004 ford escape and information is difficult for me to obtain. Person I purchased from had all new suspension installed. Says it needs new transmission.
My indications: Vehicle starts right up dies/stalls with anything above throttle. Major lack of power. Was able to put in Reverse and it moved a bit and same as drive. Smoke from rear of engine. Seems like coolant dumping into exhaust. shake on exhaust you can hear slosh slosh in exhaust.
No engine trouble codes no lights on dash.
Am I looking at a headgasket? This has the 3.0 duratec v6 with the water pump belt driven by the cam on the driver side. Open up the oil cap there is the timing chain. serpentine belt is on passenger side of engine. There is no coolant/water in the engine oil but the coolant is disappearing FAST. no coolant on spark plugs that indicate its in the cylendars.
Was going to check compression but the compression tester I have only threads up to 14mm. to small for the hole. I can probably rent a tester with proper sizes if needed. Fuel pressure at the rail primes to 60 psi and stays there. Stays at 60 psi while running as well.
Ford Escape / Hybrid :: 2012 - Cooling Fan Runs On High As Soon As AC Turned On
The cooling fan runs on high as soon as the a/c is turned on, regardless of the engine temp. I have the sensor(6F9Z-19D594-AA) that mounts on top of the accumulator. If i replace the existing sensor, will the refrigerant leak out?
View 10 RepliesFord Escape / Hybrid :: 2002 - Random Misfire Codes
I am having some ( Bad Luck ) with my 02 escape I been getting random misfire codes started checking over o2 sensors first, replaced one on bank 1 downstream, I have screenshots to look over along with codes....
View 3 RepliesFord Escape / Hybrid :: 2001 3.0L Engine Has A Miss - No Codes?
What to look for. 2001 escape 3.0 starts and runs but it has a miss and no codes came up yet . the engine will rev up but it really takes time to idle down . don't matter if its cold or hot it just don't want to drop to idle as fast as it should.
View 4 RepliesFord Escape / Hybrid :: 2001 - Stall After Fueling - No Codes?
I have a 2001 Escape 3.0 l 6 cyl. She stalls or almost stalls every time I fuel up. I found if I turn key but not to start, it only severely sputters and usually doesn't stall. Replaced EVAP canister (and all but dust separator inside), fuel pump, EGR valve, pcv tube, iac, upper gaskets, valve cover gaskets, seals, spark plugs, fuel/air filter, evap purge valve, fuel filler cap, ftp sensor, all ignition coils, checked for clogged fuel filler neck, fuel/vent hoses from/to evap canister...nothing worked.
There is a hose I cant get to that ends unattached just past fuel tank and near fuel vapor(?) "tee" under car. Seems to come from fuel tank. What is it? Just an overflow vapor hose? Should it be attached to something? Anyway, I suspect fuel vent hose or valve on top of fuel tank since my options are limited now. Have it running great (except this issue) with 260,000 miles so really don't want to spend mucho $$. No codes thrown.
Ford Escape / Hybrid :: 2007 - Passenger Side Low Beam Won't Urn On When Headlights Turned On
I have a 2007 Ford Escape with a passenger side low beam that won't turn on when the headlights are turned on. I have replaced both low beam lights and checked all the fuses. Fuses are ok,none are burned out. My high beams work perfectly as well as my fog lamps. I need any and all advice and information , including any simple wiring diagrams that could be of use . Is it possible that the multi function switch for the turn lights and headlights is the problem?.
View 10 RepliesFord - Explorer :: Check Engine Light And Wrench Symbol On With Multiple Codes
I have 2007 explorer 4.0 4x4. Check engine light and wrench symbol on with codes po743 po750 po755 po po765 po966 po966 po970. Feels like it is now stuck in 3rd gear.
View 2 RepliesFord Escape / Hybrid :: 2006 - Fuse 26 Keeps Blowing / HVAC Blower Motor Turned Off
I have a 06 Mercury Mariner and this past week fuse #26 keeps blowing turning the HVAC blower motor off. I replaced the blower motor since i had one already in the garage and same thing is happening. The AC will run for awhile and in about 10/15 mins the fuse will blow. Fuse #26 is the Climate control system mode switch, are these known to go bad? Is this the part I should replace or look for other problems IE compressor?
View 2 RepliesFord Escape / Hybrid :: 2006 - At Idle Engine Run Around 1000 Rpm - Error Codes P0113 And P2196?
Have a 2006 ford escape, at idle the engine will run around 1000 rpm's and then regularly dip down 500 rpm's. Through the intake i can here a distinct "thwap" when the RPM's dip.
Only codes are
P0113 and P2196
Problems accelerating sometimes, Took it too a shop they said bad exhaust valve on the backside of the engine either 1-2-3. They said needed engine work, but said they didn't know where the bad valve was so i don't even know how the made the determination. Vac gauge at idle also indicates bad valve.
However, when i give it even the smallest amount of gas possible the engine smooths out and vac gauge reads totally normal and steady.