Ford Excursion :: 2wd To 4wd Conversion Possible?
Friends Is it possible to convert 2wd X to 4wd? How hard it's going to be?
My X is 2000 v10 4wd limited with 160k hard miles. And the new X is 2004 v10 2wd limited with 30k miles...
My plan is swap all the goodies from the 2000 to the almost new 2004.. How big is the fabrication work ???
Ford Excursion :: Front End Conversion?
I am thinking of switching my front end of my plain ole 01 to an 05 and up. I'm torn on getting rid of the chrome and going all painted up grille and bumper or getting a chrome set up. I found a paintable 05 take off with the oval for 60 bucks. Who out here has a all painted front end on your ex with pics. I know there are plenty with the chrome set up. I have 2 people emailing me about buying their grille now.
View 7 RepliesFord Ranger / B-Series :: 2wd To 4wd Conversion
I fit explorer rear axle to my 2wd ranger. But now I have fromt x-member with front suspension and front drive axle from explorer. Can I fit all this stuff to my ranger?
View 2 RepliesFord Ranger / B-Series :: 1997 - Possible 4.0 To 5.0 Conversion?
I recently purchased a 1997 Ford Ranger with a blown 4.0 with a 5 speed , I have a 5.0 with a Carb and 5 speed out of a 80s mustang . Is it possible to use this in the 97 Ranger , I understand I need a different fuel pump but motor mount wise I was hoping it would fit.
View 2 RepliesFord Ranger / B-Series :: 1998 - MPH To KMH Conversion
My sons 1998 ranger is in mph. Converting on to a kmh dash. There's one at the wreckers and I was wondering is it a direct replacement or is it a computer swap also? What years would work?
View 5 RepliesFord Wiring/Electrical :: Conversion Of Auto To Manual?
I am planning a swap in an Excursion from the automatic to the manual transmission.
How will I need to modify the wiring harness to make sure everything still works?
Things I can think of that will need addressed:
Harness for the brakes (Neutral Safety Switch?)
Harness for the clutch pedal
Cruise control harness differences?
Back up switch wiring?
Ford Excursion :: 2015 - Front Clip Conversion?
I've been thinking about doing a 2015 conversion on my Ex for some time. Well today I rear ended a little old lady and it seems like this is as good a time as any to get it done. I have only seen 04 and earlier models getting it done. My first question is can an 05 be converted? Second, is there a comprehensive parts list of everything i'm gonna need.
View 9 RepliesFord Excursion :: 2011 - Signal / Heated Mirrors - Conversion?
I have the small single heated mirrors on my '00 Ex. This is what I would like. To do the mirror conversion with the newer square signal/heated mirrors as easily as possible as I am NOT a mechanical genius by any means. They do NOT have to power fold OR power telescopic as my garage is large enough for my '11 F350 King Ranch to fit without folding them in. But I would like to find a direct easy plug n play type conversion for the signal and the power and heat to work. The EX just looks so dumb with those small mirrors and I want to see what's going on behind me.
View 3 RepliesFord Wiring/Electrical :: 1995 - Conversion Of Buzzer To Bell?
I have a 95 powerstroke and every powerstroke I've seen stock on youtube has a bell instead of a buzzer when key is in ignition or lights are on. The buzz is VERY annoying but I'm bad for leaving lights on so I need something. any way to change buzz to a bell?
View 1 RepliesFord F-150 - 1997-2003 :: Rear Brakes Drum To Disc Conversion
Changing rear drum brakes to discs? I've done it with my 94 explorer, and i was wondering if the axles are the same, just swap the hardware like the explorers are.
View 14 RepliesFord Super Duty (1999-2016) :: 2002 To 2015 - Front End Conversion
Question on my 2002 f350 front end conversion to 2015 front end ? I need to know, how the wiring goes to the wiper motor to get it wired up...
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Electric Fuel Pump Conversion
I was wondering if it is possible, due to budget, to perform the electric fuel pump conversion in steps. By that I mean could I remove the mechanical pump and install the electric pump on the frame, but retain the stock filter housing and regulator? I would use high pressure hose and run from the stock pump supply line on top of the engine to the fuel bowl inlet and then use high pressure to run to a three way fitting, and a bit more hose to join the fitting to the stock lines running to the head. later as budget allow I will replace the filter assembly and regulator and then the lines to the heads.
View 2 RepliesFord Wiring/Electrical :: 1993 F150 - Power Up Window And Locks Conversion
I have a 1993 F150 that I have been working on. I have a set of complete doors off of a 1989 with Power Windows and locks hung on the truck and need to figure out how to power them up. Looking for access to a wiring diagram that will identify the colors of the wires in the doors. I don't care about the auto down and all of that ... not going to try and convert the whole truck with comp and all ... just want to make these function.
View 14 RepliesFord Brakes/Suspension :: 1987 F150 - Power To Manual Steering Conversion
I'd like to convert my power steering to manual. I've done this to my Mustang, but never a vehicle this long and heavy. Looking for impressions of the results. Also, any special tools that may be required for the swap.
My truck is a 1987 F-150 4x2 extended-cab long-bed with a 351w and C6.
Ford Brakes/Suspension :: 1974 F100 - Manual To Power Steering Conversion
I have a 74 f100 4x4 with manual steering I would like to convert it over to power steering but every power gear box I have found the holes are in a different spot than the manual box is there anything out there that will match up or will I have to weld a plate on and drill new holes...
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 - New Rear Bumper Conversion?
Ok I have a 2001 f250 SD with 7.3 and my rear bumper is dented and badly and warped. The steel frame mounting part of it is straight and fine. I found a "kit" on eBay that has just the end caps and plastic top cap for a 2008+ style trucks. Would those caps and plastic fit on my frame mounted section (what the actual name for the part that the chrome bumper actually screws into that mounts it to frame) ?
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Wheel Bearing Conversion?
I have a 2000 F-250 SUperduty with a dana 50 front end , and as most of you know the front hub bearing's are junk, and expensive to replace. I know dynatrac has a kit to convert it to the tapered, cheaper, servicable bearing's. But 2g is a lil out of my price range. I was curious if anybody has tried takin the knuckles and stub shafts off an older dana 60 and putting the knucke's on the front axle to get the older bearing style instead of the hub bearing and the actuall lock outs instead of the POS vaccum style.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 F250 - Electric Fuel Conversion?
So I'm not sure if I should post this here or in the 1994.5-97 section. The reason being I have a 2000 f250 with a 97 7.3. It currently has a mechanical fuel pump but they keep crapping out. We dont have the money to do a $600 diy conversion so were looking for a cheap solution.
So the 2000 has all the fuel lines and plugs to put a electric fuel pump in, but if I just threw a electric pump on then it would feed to the mechanical fuel pump which I'm guessing is a no no? Or possible?
If I put the electric fuel pump would I just have to remove the mechanical fuel pump and run lines from the pump to the bowl?
If the fuel bowl can't hold the pressure of an electric fuel pump then would I be able to swap the fuel bowl only and be good to go or is that impossible?
Let me know what you think were trying to do this as cheaply as possible.
2000 f250 auto 4x4, 97' 7.3 motor.
Passat (B6) :: Fog Conversion To HID
Converted fog lights to HID?? If so what color did you use to match the Color of the D1S bulb that shines through the projector??
View 12 Replies