Ford Wiring/Electrical :: Conversion Of Auto To Manual?
I am planning a swap in an Excursion from the automatic to the manual transmission.
How will I need to modify the wiring harness to make sure everything still works?
Things I can think of that will need addressed:
Harness for the brakes (Neutral Safety Switch?)
Harness for the clutch pedal
Cruise control harness differences?
Back up switch wiring?
Ford Wiring/Electrical :: 2001 - Dome Light And Door Chime Bell Stopped Working?
I'm having a problem with my interior dome light and my door chime bell not working in my '01 F-250. I found that the bulb was blown,so I replaced it thinking it might fix the door chime bell also, thinking they were wired together from the factory.
The new bulb didn't fix the problem. I recall that when I noticed the door bell didn't ding-ding anymore was about the time(when it got dark), that I noticed the dome light was out also.
What I may check? The fuses all work, the interior dome relay switch works and I see nothing else in the owners manual to look for as far as dome lighting and door bell chime.
Ford Wiring/Electrical :: 1993 F150 - Power Up Window And Locks Conversion
I have a 1993 F150 that I have been working on. I have a set of complete doors off of a 1989 with Power Windows and locks hung on the truck and need to figure out how to power them up. Looking for access to a wiring diagram that will identify the colors of the wires in the doors. I don't care about the auto down and all of that ... not going to try and convert the whole truck with comp and all ... just want to make these function.
View 14 RepliesDodge - Electrical-wiring - Ram50 :: 1995 - Intermittent Dash Panel Electrical Malfunction?
My beloved 1995 Dodge Ram Van has intermittent dash panel electrical issues. The gas gauge an speedometer are intermittent, coupled with lights and radio on off too. It It all started when I had the transition services years ago. It has less than 100k mileage.
View 1 RepliesFord Wiring/Electrical :: 1995 F150 - Headlights Not Turning On
Here's the breakdown. I have a '95 Ford F150 that I bought the previous year and it has been nothing but a problem. The most recent problem is the attempt to turn on the headlights. I will pull the plunger to turn on the headlights but I will only get the parking lights and when attempting to turn on the high beams I still get nothing. The only way that I get any sort of lighting is if I pull on the turning stick (almost like doing a manual override on a tripped wall plugin). Now here's the kicker. I still have parking lights, brake, tail, cab, and dash lights. Winter in quickly approaching and the nights are already getting dark, pretty soon the days will be just as dark.
View 3 RepliesFord Wiring/Electrical :: 1995 F150 Stalls When Headlights Turned On
After replacing my battery cables (Pos and Ground),My Truck stalls every time I turn on the headlights. The truck stays running with the parking lights on or if no lights on at all. Could I have mixed up the 2 positive accessory wires?
View 13 RepliesFord Wiring/Electrical :: 1995 - Fuel And Temperature Gauges Don't Work
After changing my radiator support, my fuel and temperature gauges don't work. I looked to see if everything was plugged in and I don't see anything unplugged. I do know the older trucks used the V-R regulators, but I don't know about this model.
View 2 RepliesFord Wiring/Electrical :: 1995 F250 Stalls And Won't Start At Operating Temp
95 ford f250 with 5.8l. I have currently replaced the battery, alternator, distributor, cap, rotor, icm, coil, plugs, wires, act sensor, ect sensor, fuel pump, fuel press regulator. I got it to start today by messing with timing at distributor it ran to operating temp and died. Would crank but not start.. So I replaced the act tensor today.. Now it still won't start... koeo test gives code 327... I am stumped and about to tow it away...
View 11 RepliesFord Wiring/Electrical :: 1995 F150 - Red Wire Coming From Firewall Into Engine Bay
The red wire coming from my fire wall is not connected to anything and I need to find what it is supposed to connect too it come out of my firewall near my steering column ... This is and 95 f150 with a 302 engine ...
View 1 RepliesFord Wiring/Electrical :: 1995 F150 - Door Jam Switch Broken On The Driver Side
I recently purchased a 95 F150 regular cab. The door jamb switch on the drivers side was broken. I removed the inside kick panel and found the switch badly burned and the wiring also burned. I purchased a new switch and found the socket with wires at LMC. The question is where do the wires go? Can I splice them in somewhere?
View 3 RepliesFord Wiring/Electrical :: 1995 - Speedometer Not Working / Transmission Shifting Hard And OD Light Blinking
I recently purchased a 1995 F150 4x4 with the 351 Windsor. Upon driving it I realized the speedo didn't work, transmission shifted hard,and OD light blinking. After googling my issue I found out it was the VSS. I climbed under the truck to find out the VSS isn't even plugged in. I searched for the wire but could not find it, only a spliced cable.....
View 4 RepliesFord Wiring/Electrical :: 1995 F350 - Function Of Small Yellow Running Lights On Rear Fenders
I have a '95 dually and it has small yellow running lights on the rear fenders. The only time those lights will come on is when the headlights are on (or parking lights) and I put it in reverse. Not sure, but I would have guessed they are supposed to on when the lights are on and go out when the truck is put in reverse.
View 5 RepliesFord Wiring/Electrical :: 1995 F150 - Chirp And Shudder At Low RPMs / Squeal And Vibrate At Higher RPMs
Ok, I have a 95 F150 5.0. It's sat for 6 months with the engine taken apart. I just finished putting everything back together with a new alternator. Well, I pulled a bone-head move and forgot to connect the harness when I fired the truck up. Other than not charging though, it ran fine. When I connected the harness, it began to chirp and shudder at low RPMs and squeal and vibrate at higher RPMs and it over heated VERY QUICKLY.
So hot the case was too hot to touch and the pulley smoked the belt. The engine didn't even have time to get up to operating temperature. I've had the alternator replaced twice, and this last one tested good putting out 14.5 volts. The work I did on the engine was to replace the valve springs, install a direct drive timing gear, replace a spun harmonic balancer, bypass the smog pump because it froze up, new distributor, a new ECU and O2 sensor.
Ford Wiring/Electrical :: 1967 F100 - Instrument Cluster Gauge Wiring
I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.
1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)
2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.
Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....
Ford Wiring/Electrical :: 2002 - Complete Headlight Switch Wiring Diagram?
Any COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 RepliesFord Wiring/Electrical :: Moving Engine And Ignition System - Wiring Harness For Further Use?
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
Ford Wiring/Electrical :: 1997 F250 - Rear Tail Lights Wiring
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesFord Wiring/Electrical :: 2004 - Instrument Cluster Wiring Diagram?
Looking for a source for a wiring diagram for the 2003/4 f350 instrument cluster, specifically the wiring/connectors to the gauges? A link to a PDF file would be nice. I would like to try and disconnect the PCM control to the transmission temperature and engine temperature and drive the gauges from my own sensors to bypass the non-linear behavior that ford decided was in our best interest. I am NOT interested in installing any more gauges, just want to control the ones already present with my own signals. It is possible that these gauges are all addressable devices on a common bus, instead of individual controls.
View 8 RepliesFord Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 Replies