Ford 7.3L Power Stroke (1999-2003) :: Serpentine Belt Coming Off AC
Leaving on a 200 mile trip in the morning and when checking the fluids, I found the serpentine belt trying to get off the AC pulley. I've put in on twice and it immediately jumps half way off when starting the engine. How long it's been doing this. Nothing is obviously loose or moved. What is likely causing this?
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Torque Value For 13 Mm Belt Tensioner Nut?
Thought I had these bookmarked but not. What is the torque value for the 13 mm bolt , replacing the tensioner.
View 4 RepliesFord 6.7L Power Stroke Diesel :: 2012 - Seat Belt Won't Retract On Its Own?
Dad's truck 2012 regular cab. Seat belt doesn't like to retract on it's own. The retracter(next to your left butt cheek) works fine, or so it seems. The belt seems to get caught in the swivel mount above your shoulder. I've tried a piece of sand paper in between the belt and the plastic but it doesn't work any better. Is there a way to adjust the retracter? Looking for a solution before we close the buckle in the door frame and have bigger issues...
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Serpentine Belt Started Shredding
About 2 weeks ago i noticed that the serpentine belt started shredding. I noticed it before it was all gone, so i parked it and started ordering parts before i did anything. Since i had to get the radiator hose off, i decided to flush the coolant, change the thermostat and the upper radiator hose to go around the belt. Once the parts arrived, I drained the coolant and did two flushes and tried to change the hoses and thermostat. the Gates hose ended up not being the right hose, in hindsight I should have used the old hose and put it back together.
But I returned the Gates hose and ordered a Motorcraft hose. not thinking, i left the system dry and possibly sitting with water from the previous flush. Three days ago, I got the correct Motorcraft part and did the work on Sunday. since it had been sitting, i decided to run another flush, i noticed a squeaking sound and that the water was coming out a little browner than when i left it. So I ran another two flushes and said to hell with it and put the whole thing back together and filled it with coolant and distilled water.
This morning, the squeaking sound was louder, but temps where fine and coolant level was fine. I drove to work ( about a 10 mile drive) and when i finally stopped, i got a whiff of coolant smell. I noticed coolant behind me and when i lifted the hood, i noticed the reservoir was half empty and coolant dripping down from the center of the block. I can still hear the squeaking, I figure the water pump is on its last leg and decide i need to go home. I walk in to work and let them know I'm gonna take the day off to situate this. Before i leave, i top off the reservoir with a gallon of distilled water and head out.
After a short distance I notice that the squeaking stops, now I'm terrified that the water pump just completely failed. (I've never had one fail on me so I'm not sure what happens when it does) As i drive home, I'm watching all my gauges. none of the temperature gauges spike, everything was normal for the drive home (another 10 miles) I park it and lift the hood and the reservoir is completely full. why is reservoir completely full? why would a leak like that stop? Should i just change the water pump? I don't want to just hope for the best, i do use my excursion to haul the kids from time to time.
Ford 7.3L Power Stroke (1999-2003) :: Belt Screech Sound Coming From 38R
The last week or so I have been having a screeching belt sound driving me insane in my 2003 F-250 7.3. After further investigating I have found out it is coming from my 11 month old GTP38R bearing. It has an aftermarket billet compressor wheel in it and I sold the factory wheel when I installed the Billet wheel. Where to locate a factory Garrett GTP38R wheel? All I can find online are Billet wheels or random off brands. At this point I would even trade my Billet wheel for a factory 38R wheel.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Lost Serpentine Belt - Overheated
I was cruising along yesterday and felt the steering pump go out on the highway. Nowhere to pull over and pulling a big horse trailer. Three miles later I finally get to a wide spot to dive into. I look down and the temp gauge is maxed and the oil light is on. Most of the antifreeze boils out when I got the engine shut down. I had no choice but to have a friend bring a new belt and some antifreeze to the rescue. Got it changed and filled back up. Started and drove home fine.
I've got this twisted gut feeling about the whole deal. What kind of damage did I likely do? Things to look for? Did I just kill the longevity of the motor? I've been trying to do things right and treat it well to ensure a reliable truck.
On a side note the belt came apart in ribbons and it was absolutely shredded. The belt appeared to be less than 3 months old. No cracks or tears and a bright white numbers sticker on the back
Ford 6.0L Power Stroke Diesel :: 2006 - Turn Off Seat Belt Chime?
So i did this with mine but friend just bought 06 6.0. How do u shut the chime off for the seatbelt again. I know parking brake on key to on position not run. How many time do u buckle and unbuckle again?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F350 - Heat Seat Power Wire Location
I have a 2001 F350 XLT with cloth seats. In 2003 I upgraded those seats to power seats.
- When I upgraded to power seats I did not run a new power wire. Since my 2001 was at least fused for power and heated seats I located the Power seat 30amp power wire.
- That wire is located on engine compartment fuse #15 (Circuit 5298 as I recall) and Dark Green. It comes through the firewall and runs down the drivers side kick panel along the floor and then intersects with the power and ground seat belt wires that ran under the seat.
- The ground wire was coiled and attached to a ground stud behind the drivers side kick panel.
About a month ago I had a mouse get in and chew my seat wiring to shreds. I built my own harness and am good to go there, however since I had these seats all apart I decided to replace the foam and add HEAT.
So that brings me to the specific question. In the engine compartment fuse box, there is a 30amp positive wire for Heated seats. My schematic says it is a 14 gauge wire RD/BK on circuit 1153.
Where in the heck is this wire? I have literally tore the dash apart looking for this wire.
- I have verified the following with my fluke continuity tester.
- It is not part of the four customer access wires that drop on the right side of the interior fuse panel.
- It is not part of the tow wire bundle.
- I have checked the bundle that the Dark Green Power seat wire is in and there are no RD/BK wires in that bundle. I also poked the other 2 14 gauge (Yellow/Blue) wires in that bundle and verified they are not them.
-I have checked the three wire bundles behind the passenger side glove box and was unable to locate.
- I have verified it is not stored behind the compartment below the cigarette lighter.
I am looking for info which wire I am talking about and knows where Ford stored them when not used by having the XLT Trim with cloth seats. Yes I am aware that I can run an additional wire with a 30 amp fuse to the batter, but I would prefer to use the system and fuse that was designed for this.
Ford 7.3L Power Stroke (1999-2003) :: Chirping Sound Coming From Serpentine Belt And Pulley Area
I have 1997 F250 LD since i bough it has been doing this chirping sound coming from the serpentine belt and the pulley area but when the truck has been working for 15 - 20 min it goes away
This is apart from the from the problem before I think the fan clutch is broken because when I start the truck I can hear the fan going at the same speed of the engine is that normal ? even when the truck is cold
Ford 7.3L Power Stroke (1999-2003) :: Serpentine Belt Started Squealing - Coolant Leak Behind / Below Thermostat Housing
My serp belt started squealing so I pulled the thermostat housing to inspect the rubber gasket. It looked OK, but I cleaned up both surfaces and replaced with a new gasket, and put it back together. The housing was replaced just a couple months ago along with new hoses. It was not corroded and OK to reuse.
Started the truck up and saw a slowish/steady drip of red Cat ELC dripping on the driveway. Opened the hood up again and carefully inspected around the thermostat housing - no coolant is leaking there.
I did notice the same slow/steady drip coming from just behind and beneath the thermostat housing. See in pic, this is where it is dripping. One other question, what is this plug for on the side of the water pump?
Ford 7.3L Power Stroke (1999-2003) :: Crew Cab Leak / Whenever It Rains The Carpet Under The Rear Seat Is Wet
2001 7.3L 4x4 328,000 miles.... I have the crew cab? (rear doors open opposite to the front) anyhow whenever it rains the carpet under the rear seat is wet. Just wondered if this is a known issue, with a fix or just something random I'm going to need to chase down....
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F250 - Belt Is Rubbing Front Edge And Making A Whipping Sound At 65 Mph
I have a 2002 f250 7.3 and the belt is rubbing front edge of the belt and making a whipping sound at 65 mph. Have replaced tensioner, idler, water pump and a/c bearing & pulley.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Code B1230 - Driver Safety Belt Retractor Low Or High Resistance On Squib
So I am trying to learn how to use the forscan program. I find that it detected an open circut for th deleted intake heater, which I expected. It also found :
===ECS DTC B1230===
Code: B1230 - Driver Safety belt Retractor Low or High Resistance on Squib
Module: Electronic Crash Sensor
Diagnostic Trouble Code details
Driver Safety belt Retractor Low or High Resistance on Squib
So that answers the the question about the intermittent airbag/ seat-belt lamp. How to solve this problem? BTW- This is a E350 SD Van ....
Ford 7.3L Power Stroke (1999-2003) :: F350 - Swap Seat Bottoms Side-to-side?
Can I swap my seat bottoms? I have '99 F350 with 40-20-40 seats. Drivers seat is getting tired. Would like to take just the seat bottom and flip-flop. Can it be done?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: F350 - Seat Bottoms Swap Side-to-side?
Can I swap my seat bottoms? I have '99F350 with 40-20-40 seats. Drivers seat is getting tired. Would like to take just the seat bottom and flip-flop. Can it be done?
View 14 RepliesTouareg :: Disconnecting Sensors To Replace Serpentine Belt
I've replaced the water pump on my Touareg 2009 TDI at 112,000 miles and am trying to fit a new serpentine belt at the same time. I'm stuck because two sensors and their wires are inside the circle of the belt and I seem to have to disconnect the sensors to remove the old belt and fit the new one - this isn't shown is any of the diagrams I have from website and I am wary of just pulling and twisting to disconnect them. I've posted two pics of the sensors - I think one of them is a crankshaft location sensor. How to disconnect them or with fitting the serpentine belt in general would be great. I love my Touareg TDI (bought from new in 2009) and have just started servicing it on my own - I'd like to drive it 300k miles.
View 1 RepliesFord Excursion :: 2003 - Replacing Seat Belt?
Puppy chewed them up. Puppy has grown so I know it's time to replace them however they are discontinued. Some grey ones are available but I'd like to stick with OE colors if possible. Any leads, prefer new if possible
View 9 RepliesFord F-150 - 1997-2003 :: Seat Belt Won't Retract Back Up
Driver side seatbelt wont retract back up i have to push it in and sometimes it will suck it up but most of the time it wont is there a way to take it apart and clean it maybe?
View 9 RepliesFord Ranger / B-Series :: 2003 - Unhooking Seat Belt Buzzer
I recently bought a 2003 Ford Ranger. What I want to do is unhook the seat belt chime. In the past with the other 3 Rangers I owned I unplugged it from under the seat. But when I unplugged this one the light for the air bag stayed on. I like the freedom to choose and I don't care for the chime.
View 14 Replies