Ford 7.3L Power Stroke (1999-2003) :: Massive Oil Consumption And Exhaust Smell
I'm having an issue with massive oil consumption and no oil leaks on the ground! No clue where the oils going but I burned more than 2 gallons today in a few hours of driving exhaust smells awful but the truck is running fine.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Oil Leak From Exhaust Manifold
I own a e1999 Ford F350 7.3 4x4 with a Garrett GTP38R turbo. I have been having issues with very little power and pulled an CEL of P0221. I know it's for the APS and have been trying to trouble shoot it as a new APS has not fixed the problem. However, while working on that I just noticed an oil leak appear. I tracked it down and can visibly see it leaking out the top of the passenger side exhaust manifold in two places. It is seeping out the top. Is oil supposed to even be running through here like that?
I recently replaced my up pipes with the newer style bellowed ones. While I had the turbo off I replaced all the o-rings top and bottom and did the EBPV delete on the pedestal. I have been having very little power and cannot the truck over 5-10 MPH and stays at low RPM's so I originally thought it was the leaky up pipes. Those were fixed along with fuel pressure checks which came back good. I then pulled the P0221 code finally. While I had the turbo off I inspected it and it did spin freely and had no side to side play in it.
What was unusual to me was there was a small pooling of oil in the turbo when I took it off. I know the CCV goes through here so some oil is normal. Also, when I was diagnosing the up pipe leak I could see a small amount of oil spraying out the blown donut gasket along with the exhaust gases. I don't think that is normal.
Is there an internal seal in the turbo that can go bad causing oil to spill into my exhaust and possibly leak at the exhaust manifold? Or do I have an internal oil leak from somewhere else?
Ford 7.3L Power Stroke (1999-2003) :: Engine Ticking - Exhaust Leak?
As it says, I have a tick. It's not apparent at idle and increases with engine speed.
Just spent $570 having bellowed up-pipes installed and while a little quieter, the tick is still there. What else tends to go out on these things? Manifold(s) cracked, manifold gasket(s)? It's seen high EGT's quite a bit but not for longer than 20-25 seconds.
Ford 7.3L Power Stroke (1999-2003) :: Massive Amounts Of Water In Oil
E99 f250 almost 300k rebuilt motor and trans before I got the truck I put new hpop icp ipr single shot injectors with hydra chip run very modest towing tune put less than 500 miles On it before his happened. I pilfered through many forums and this seems closely related I have and e99 psd that went down on me pulling a load I have massive amounts of water in my oil can't find the leak I pulled oil cooler and resealed still leaks. To the point I can put a running water hose in reservoir and never fill it because it leaks into motor so fast. Pulled hpop and gear to look inside front cover and no leak there. The driver side valve cover is also off with no visible damage. So I guess my question is where can that much water go? Cracked head? Front cover? Injector cups? Ruled out oil cooler because water is in oil not oil in water pulled water pump last night with no visible cracks washed it down and let it sit so I can look again today.... Hoping I don't have to pull the motor....
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 F350 Burning Massive Amounts Of Oil
I'm new to diesels and I've got a 2002 F-350 w/7.3L 224K miles. I've had it for about a year and had no problems. Burned a little oil, about a quart every 1000 miles or so, but in the last two weeks it's gone through the roof. I have gone through roughly 12 quarts in 300 miles. I see a lot of blue smoke at start up, and it's being harder and harder to start in the cold. From what I've read it could be several different things, and I plan on doing the CCV delete and changing the orings on the injectors just for good measure. Is there anything else that I might check as well, or am I completely off base on what it might be?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Leak At Passenger Side Up-pipe To Manifold - P1211 And P1280
I just finished installing a new turbo (shaft play and lots of oil in the compressor side), RR up-pipes, and T500 (250k and once had a very long crank to get the ICP up to start).
Anyway, except for another exhaust leak at the pass side up-pipe to manifold, it seemed to run okay but with lots of white smoke. I only have about 50 miles after the install, when it suddenly starting surging and made a lot of loud knocking noises. This then went away and came back again rather quickly. I was close to home, so I made back under power. I also received the two codes listed. My IPR is original, but two summers ago I installed the IPR re-seal kit. Everything on the IPR looked good when it came off for the T500.
After reading around, I saw that low fuel pressure / air in fuel can cause problems. I connected a pressure gauge to the pre-filter port on the filter housing, and got 40psi at idle. I then took a diesel shower and blew out the fuel line into the tank. After re-connecting it, the fuel pressure stayed the same but the engines idles much better, but still has blue smoke. It's the original fuel pump (to me anyway) and original fuel line connections.
I have about 3/4 tank, and no place to put it, so I'd need to run it out for the Hutch mod, or least to get in there and inspect. Would eliminating the Ford connections at the pump be worthwhile for now, and is 40psi at idle adequate? Wondering if it's time for a fuel pump?
Ford 7.3L Power Stroke (1999-2003) :: Oil In Exhaust System
I just installed a new MBRP 5'' exhaust system in my 7.3. I have only put a few miles on the truck since it was installed and I now have a black thick oily residue in the tailpipe. The exhaust system had some sort of oil in it when it was shipped. I remember getting it on my hands when installing it. I think the oil in my tailpipe is just the oil burning out of the exhaust system which mixes with soot that turns it black. When I installed the new up-pipe, the exhaust side of the turbo was dry. Like I said, I haven't ran the truck many miles with the new system yet. A few friends of mine have looked at the exhaust and they think I have a bad turbo seal. I didn't have any oil in the exhaust with the old system. It was sry. My truck has 135,000 miles on the original turbo. I hope my turbo seals aren't bad.
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 - Oil Coming Out Of Exhaust
Recently I came across a guy parting out his F-250 with a 7.3 powerstroke. Said it had a blown engine, and didn't know what was wrong, but oil was coming out of the exhaust.
My question here is why that's happening. I don't have any experience with the powerstrokes, so I'd like to know what the culprit is before I even consider buying it.
Ford 7.3L Power Stroke (1999-2003) :: 2001 F450 - SES Light Came On Followed By Loss Of Power Under Load And White Smoke From Exhaust
I have a 2001 F450 7.3 chassis cab with just over 100k. I have a new problem... So far on two different occasions the service engine came on followed by a loss of power under a load and white smoke from the exhaust. Took it to the shop the first time, they determined it to be a dirty air filter, which seemed odd since it just happened all of a sudden. They changed air & fuel filter, problem gone- for two weeks..
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Up-gradation Of Turbo And Exhaust?
I've been mulling over the idea of doing a muffler job on my 2002 f350 7.3 cc short bed. I do tow on and off for work and dual material for work. I am thinking of upgrading the exhaust because I noticed a couple small leaks in the muffler and I'd like to lower the egt's for the truck so it breath a bit smoother. I'm not a fan of the really high pitched sounds I've heard on some I want it deep and heavy sounding. The turbo is fine for now but eventually I'll need to know what to upgrade to once it starts to wear out. I don't plan on doing dumb chips or tunes because it's not a toy truck but a work and daily driver.
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Manifold Bolts Broken?
Just bought a 03, the seller showed me a exhaust leak. I found a bolt broken off, flush with the head. Looked at the passenger side when I got home, that side leaks too, and found one broken off bolt there too. Question, are these easy to do? As in, I have extracted broken bolts before, but they where on my V10 and I could just weld nuts to them and they came right out.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Back Pressure Sensor
So I have a non ebpv pedestal I was going to clean my sensor on the front because my mileage has went down a bit. My question is is this even worth doing since the valve is not there anymore I have got mixed answers trying to look it up some say it still affects the mileage some say it won't. I cleaned it once about 10 years ago. I have an AE also how do I test it and what should it read if I do need to clean it or replace it?
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Broken Exhaust Manifold Bolt
So I received my International bellowed up pipes from Riffraff and I figure I will start soaking all of the bolts with some aerokroil before I get started on monday and I see the very last bolt head near the up pipe is gone. The bolt is there but the head is gone and you can definitely see soot buildup everywhere near it. I don't know if I should order a new manifold for the passenger side and new bolts, order a driver and passenger side manifold and new bolts, or just order one set of new bolts and try to get take the passenger side manifold off and replace the one broken bolt.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2003 F350 - Oil Leak When Parked After Running
I have a 03 F-350, 7.3L. There is a slow oil leak that only leaks after I've run the truck. In other words, it doesn't just sit and leak overnight. I'll park it after running, and the next morning I'll notice a small pool of oil, approximately 2" in diameter. The leak appears to be coming from the oil pan area. I degreased the entire oil pan area to get a better visual of where the leak is coming from. I can see oil trailing down the front of the oil pan and the rear of the oil pan. Does this sound like the gasket? Or, what else could it be? I'm praying its not as bad as I think and need to replace the gasket.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Manifold Removal - 1 Bolt Stuck?
I managed to get the drivers side exhaust manifold and all of its bolts off no problem. On the passenger side I had 1 bolt head that was already broken and I have only 1 other that is still holding on for dear life. I've been soaking it in aerokroil for awhile now and no luck. I tried some PB blaster today because I am willing to try anything. I also tried heating up the bolt with a torch and some map gas but not sure if I am heating it up enough or not. Anyways, everything else has been going great, got the uppipes off and the valley, turbo and pedestal all cleaned up good. Just need to get the last whole bolt and broken bolt out so I can install the new manifolds. What I should try to remove the last 2 bolts. How hot should I get the bolt when trying to remove it? Or should I be heating the engine block?
View 12 RepliesFord 7.3L Power Stroke (1999-2003) :: Broke Off Bolt In Exhaust Manifold To Head
Well i had an exhaust leak on this F250 and so I started torquing the bolts on the manifold to the head. (45 ft.lbs) A couple were very loose so I was thinking "Great, this may fix my problem!"
My first mistake was probably the Harbor Freight Tools torque wrench.
I am on the driver side, second from the rear and then bang! I see a gaping hole where the bolt used to be. Bolt on the floor. I cant see up in the hole to the head, I think it broke flush with the head.
Ford 7.3L Power Stroke (1999-2003) :: Exhaust Rubbing Trans Cooler Line - Fix?
So changing the oil in my truck the other day, I noticed the exhaust clamp at the union between my down pipe and first section of my exhaust has been rubbing the trans cooler line and there's a Nick in the granny pan. Lookin at the rubber grommet on the hanger, its stretched tight and looks like the exhaust has shifted over. What could have done this or possible fixes?right by now it's got a gob of high temp silicone acting as a stand off. Don't wanna put the new line in until I have the situation remedied.
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: F550 Backfire And Shot Flames Out Of Exhaust
I was driving my bosses f550 with a 7.3, and while towing a loaded 40' flatbed of hay, it started bloing white smoke and lost all power and had almost no pedal feel. It wouldnt even go past 2500 RPM. Then, all of a sudden, it started billowing black, and BOOM backfired and shot flames out the exhaust. Then, I pulled over at a parts store and replaced the fuel filter, which worked for a while, but then it started blowing white smoke again. Once I limped it home and unhooked it, I took it out and let her rev a bit and it seemed to stop blowing smoke, but it still has less than the normal power it used to have. It has 226000 miles and is completely stock.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 Turbo Exhaust Housing Gasket
So, I just got my turbo back from my pal Ruben at SoCal Porting (does good work fast and inexpensive) and, I have a question about the exhaust housing with the EBPV.
Is there a gasket that goes between the turbine housing and the adapter that the down pipe mounts to? And, if so, what is the part number for it? If it's steel to steel cool. If not, I'd prefer to put the OEM gasket in there versus permatex or something similar.
Pic of the compressor housing with a little port work....