Ford 7.3L Power Stroke (1999-2003) :: 2000 Turbo Exhaust Housing Gasket
So, I just got my turbo back from my pal Ruben at SoCal Porting (does good work fast and inexpensive) and, I have a question about the exhaust housing with the EBPV.
Is there a gasket that goes between the turbine housing and the adapter that the down pipe mounts to? And, if so, what is the part number for it? If it's steel to steel cool. If not, I'd prefer to put the OEM gasket in there versus permatex or something similar.
Pic of the compressor housing with a little port work....
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Turbo Noise From 5 To 15 PSI Intermittently?
I have an 02 crew cab SB 7.3L. The best way to I know to describe it is a sorta like a metal ringing noise. It just started this afternoon while pulling a 9k camper. It only does it under load. Boost stays the same and it happens in all ranges from 5psi to 15psi. It is intermittent. It sounds like it it coming from the turbo. I pulled off the boot and could not feel any play on the intake wheel.
After unhooking trailer and taking for a test drive I can not get it to do it again? The turbo was rebuilt about 4 years ago with a wicked wheel but has only seen about 18k miles since the rebuild. A quick look at the boots appear good but didn't get to take them off before going to work. I will try to post video.
Ford 7.3L Power Stroke (1999-2003) :: Rebuilt Turbo Still No Power And No Boost?
Well I am at a loss now. Rebuilt the turbo with a new wheel and kit from Riffraff. I still have no power, no boost and no codes. The new wheel whistles. I can hear it. It sounds way better than the old one. But still no power. I really don't know what to do now.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Pop When Accelerating With Turbo Spooling Up And Lost Power - Code P0475
As I was getting ready to leave town with the tractor loaded up, I was accelerating with the turbo spooling up when I heard a bit of a pop and lost power (engine still running and all, just very low power like you get when the turbo fails). I wasn't far from the shop so I came back and started getting a lot of white smoke out of the exhaust, it doesn't smell like diesel, probably more like oil. Definitely smoke, not coolant. I pulled it around back and shut it down to go grab AE and scan it and it shows a P0475, starting it back up has light smoke at idle and it idles fine but as soon as you give it any throttle it starts smoking pretty badly.
Researching it looks like the most likely cause for this is the EBPV itself but before tearing it down that far. This is the only code it's showing.
Truck has 272k on it, turbo was rebuilt a couple of years ago but we didn't do anything with the pedestal at that time. I guess in retrospect, I probably should have done the EBPV delete and the resistor fix then but I didn't think about it at the time.
On another note, my AE is not showing any of the system test for some reason, the drop down is blank. I have version 7.0.1, so it's an old version but I'm working on an old truck, so... What that might be? I've got the truck pulled into the shop now to let it cool down. I'll probably let it sit overnight and take the turbo and EBPV out tomorrow unless someone has a better suggestion...
Ford 7.3L Power Stroke (1999-2003) :: Oil Leaking From Turbo Area?
So my understanding is that if your turbo is leaking oil, you either need to rebuild it or get a new turbo cause the one you have is shot.
I have some oil leaking, but it's not a ton. One one of my buddies was telling me that it's possible that the amount that is leaking is normal due to the PCV (Pressure Control Valve) system, or something like that. Here are a few shots of the turbo, as well as the boots that are leading up to the turbo.
Ford 7.3L Power Stroke (1999-2003) :: Turbo Is Out - EBPV Delete
While my turbo is out I decided to delete the EBPV. I removed the butterfly and rod, & pounded in some 3/4 inch freeze plugs. Are there any mods that need to be done to the pedestal, or can I just leave it the EBPV plunger unhooked? It's not leaking, but will it leak if left unhooked? Or do I have to gut it and tig weld the oil gallery's
View 14 RepliesFord 6.0L Power Stroke Diesel :: Turbo Replaced - Oil Coming Out Of Exhaust?
Had a bad turbo on my 07 F550 with a 6.0. Replaced it today and took her for a ride. Started smoking and oil was spitting out of the weep hole in the muffler. A lot of smoke. The truck was smoking before I replaced the turbo too but I didn't have any oil coming out of the weep hole. I'm hoping it is just oil that had been passed into the exhaust by the bad turbo that is now being burnt off and pushed out by the new turbo. Does this sound plausible?
View 1 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Turbo Noise At Exhaust
I have a 2011 that does not currently have the complete factory exhaust system on it and no muffler. With the nice weather I have been driving around with the windows down and hear a noise out of the exhaust that sounds like tires spinning on wet pavement when I let off the throttle or at some shifts of the transmission. Boost seems normal, and don't hear any noise while under load. I think it is just the VGT closing and making the noise. With deleted sys heard this noise in exhaust?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: Removing Air Filter Intake At Turbo
Dumb question but how do I remove the air filter intake from the turbo Its a little oily there from a fuel or oil leak but I dont see a clamp holding it on the turbo?
Also what is the e clip? Is it the little thing holding the wastegate rod on the exhaust turbine? Can I just pull the rod up off the clip?
Ford 7.3L Power Stroke (1999-2003) :: Glow Plug Change / Oil In Turbo
I'm getting ready to change the glow plugs in my dad's e99, 196k on the clock. When I pulled the air intake tubes I found some oil in the turbo:
The inlet tube also had a bunch of gunk in it too:
Does this look like it is caused by the PCVor is it a bigger issue?
Ford 7.3L Power Stroke (1999-2003) :: Turbo Chatter Under Load - Boost Was Around 17 - 18 Psi
I have done some searching on this, seen a video on YouTube but haven't read anything that is firm on what it is. We pulled our 5er for the first time last weekend and the chatter was pretty pronounced in the Arbuckles here in OK. I was running around 65 mph when I hit the largest hill and as I was climbing my speed naturally dropped, boost was around 17 - 18 psi when the chatter started.
Is it something to be really concerned about? Is there anything to be done to prevent it? I'm pretty much still stock, only deletes have been airbox to 6637, and I deleted the heater by turbo for the boost gauge. Other than that everything on truck is still stock.
Ford 7.3L Power Stroke (1999-2003) :: Turbo Whistle Under Hard Pedal Before Shifting
I have a 01 7.3 F-350, 120000. I rarely get down hard on the go pedal but a while back I did and heard at pressure whistle just before it would shift. I thought a bad turbo hose so I replaced them all. 'While working on the hose mounts I cleaned up the castings for a better seal'. The hose replacement seemed to get the running but the whistle is still there. I am thinking a leak on the manifolds for the Y-Pipe connection OR does the turbo have a release valve that can make a whistle sound?
View 8 RepliesFord 6.0L Power Stroke Diesel :: 2007 F350 - Turbo Whine And Out Of Empty Exhaust
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Turbo To Pedestal Bolts Really Hard To Break Loose
Are we supposed to put anti sieze on the turbo to pedestal bolts. They were really hard to break loose when I pulled it Cheater bar tight. 18 ft. lbs sound right ?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Turbo Boost Loss And Engine Starting After 2 Attempts
I've got a 2002 Excursion which has been giving me a little trouble lately. I've got a DP tuner, 4" exhaust, afe stage 2, and gauges (boost, trans temp, EGT). I've been running these for about a year now without any truck problems until recently
So I noticed over the past couple weeks it has gradually been taking longer for the engine to start. Started off by just having to turn the engine over a few more times. Now it has turned into having to turning over the engine for a few seconds, then turning it to off, then trying again. It always starts on the second attempt to start my truck and sometimes really hard where it blows out a little black smoke.
Not sure if this is a correlation to the problem above or not, but I've also been losing boost pressure, and I'm not sure when this started since I haven't been on the highway for a while. I noticed this because this weekend I drove on the highway and saw that I was blowing some black smoke every time I accelerated which has never been the case.
So I check my boost gauge and see that I'm sitting at like 3-5psi when I used to be at around 10psi+. I also noticed when I accelerated the boost pressure would increase like normal but then quickly drop once I stopped accelerating which is unlike anything I've seen before in my truck. I don't seem to notice a huge difference power or throttle response, but then again 95% of the time I'm driving under 40 mph to get to work. So this problem could have started the same time as the starting problem, but I can't say definitively.
What this problem could be, what to check or test?
Ford 7.3L Power Stroke (1999-2003) :: Fuel Line Leads To Head Under Turbo Leaking?
The fuel line on the passenger side under the turbo that leads to the head is leaking looks like from rubbing on the pedestal, anyone ever just cut it and throw in some fuel line and hose clamps?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: High Pitched Turbo Whine Under Heavy Acceleration
I'm on the road and I pulled over for a pit stop so I don't have time for a search right now, but I noticed under heavy acceleration a turbo whine so high pitched it almost sounds like metal on metal. Is this normal and I just noticed it, a leak somewhere, or maybe indication of something worse? The truck seems to be running ok otherwise. It's an '02 w/7.3 and 220k miles.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 - Strange Turbo Sounds And Hard Shifting Into 3rd With TS6
I put a ts6 on my 2001 7.3. I love it shift points are better and truck has a lot more power. But I've noticed when I shift truck shifts into 3 (especially going uphill) I get a really weird turbo sound where it acts like its gasping for air (I have 6637 air filter) and then it shifts kinda rough into third. If I put chip on stock setting it doesn't do either of the things I described. Do I have loose turbo boots somewhere or possible bad turbo bearings?
View 4 RepliesFord 6.0L Power Stroke Diesel :: High Pitch Whistle Noise From Turbo / Exhaust Area
For a while now, I have been hearing a very high pitch whistle noise from the turbo/exhaust area. Everybody told me it was an exhaust leak, but I never could pin point the leak. While I was under the truck last weekend I found the flex joint on the passenger side up pipe was broken a leaking.
I ordered a Dorman replacement pipe that comes with a new gasket and hardware.
I will be the first to admit, I am not a fan of Dorman parts... BUT, this pipe is really nice. It looks identical to the pipe being sold on Dieselsite.com, it doesn't have the scoop inside to direct exhaust gas to the EGR cooler and it comes with all the mounting hardware.
[URL] ....
Once I got the turbo down pipe out of the way and soaked the bolts with penetrating oil, I had the broken up pipe off in 30 minutes.