Ford 6.7L Power Stroke Diesel :: Installed New Batteries - Door Lock Fuse Blown Again And Again?
I just bought the batteries I was asking about in this posting. Bought them at auto zone on my lunch hour today, they swapped them out right there in the lot, no problems. Watched carefully to make sure terminals were not crossed, etc. When I came out of work a few hours later, the #20 fuse for door locks was blown. I chalked it up to the battery change, and put a new fuse back when I got home. I come out an hour later to leave, and the fuse is blown again. I have not replaced it again, need to go get more of the proper amp rating.
No other changes to the truck other than the battery replacement. And that's the only anomaly. No other problems, nothing. Getting ready to head cross-country on a skiing trip, this Friday, so there really is no time to get to the dealer to get this looked at.
Ford 6.0L Power Stroke Diesel :: Tail / License Plate Lights Not Working
So my tail lights and license plate lights are not working. The head lights work also my gauge cluster lights are not working. Which fuse I should check. Or what it might be?
View 6 RepliesFord 6.7L Power Stroke Diesel :: Light Bar Installed Now Static On Radio Stations
Installed a 20'' light bar on my 2012 and when I turn on the Aux 1 uplifter switch my radio stations have static. This was not the case before the install. I have the hot wire tied into the Aux 1 (25amp) switch. Ground is run to drivers side battery ground. Do I need some kind of relay in line?
View 5 RepliesFord 6.7L Power Stroke Diesel :: Trailer Running Lights Fuse Location?
I've been looking for the fuse that runs the trailer running lights and couldnt find it and it got dark on me.. Does anyone know if its under the hood or inside the cab? I blew the running lights fuse hooking up the trailer while the lights was on...
View 13 RepliesFord 6.7L Power Stroke Diesel :: 2012 - Fuse Control Of Trailer Lights?
I have a 2012 ford 150 what fuse controlls the trailer lights.
View 2 RepliesFord 6.7L Power Stroke Diesel :: Tail Lights Go Out / Wire Harness In Front Left Wheel Well Rubbed
My fathers truck had the tail lights go out the other night so we checked the fuse and the bulbs both good. Took it to ford and they found that a wire harness in the front left wheel well had rubbed through and needed replacement. I went and checked mine and yup it was rubbing through the wire just not all the way yet. Might want to take a look. It is at the top of the well near the coil spring. I will get the camera out tomorrow in the daylight and take a picture of the location.
View 13 RepliesFord 6.7L Power Stroke Diesel :: Moisture In Driver Side Tail Light?
Today, I noticed some moisture in my drives side tail light lens. Of course I'm a few months past the bumper to bumper warranty.
View 12 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Right Brake Light Out - Fuse Diagram?
I was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 RepliesLexus IS 2014+ :: No Tail Lights On - Parking Light Fuse Under Steering Column Blown
Driving home from work around 10pm. Leo started explaining that i had no taillights on but the brakes worked. He was right. I came home and found out my parking light fuse under the steering column was blown. I replaced the mini 10-amp fuse with a spare and they started working again. Then later, they stopped working again. Only thing i have installed electronic upgrade wise is after market LED fog lights(which went out with the parking lights but both came back on with the new fuse) and Navi bypass. What could it be?????
View 12 RepliesFord 6.0L Power Stroke Diesel :: Got EGR - Installed Oil Cooler - Crank But Won't Start?
Long story short: Got EGR Cooler and Oil cooler installed last week. New headgaskets and bolts. New down pipe. New orings on injectors. HPOP was installed 3 months ago before any of the above work.
Truck drove great for about 100 miles. Then stalled at a stop light. Restarted it. Drove another 10 miles. Truck then dies on me at 25mph. Wouldn't restart immediately. 10 minutes later it started. I drove it back home (couple miles). When i hit the last stop light, the idle immediately changed to crap. Very rough. Got home and parked it and since then I have not been able to start it.
I changed the EGR Valve, tried to start it and it wouldn't. Changed IPR Valve. Put all back together. No start. Cranked beautifully. But doesn't sound like it's taking fuel. note - no buzz/clicking from injectors and no fuel pump noise.
Here are my readings. FICM Sync - 1. I am stumped. I did recommended KOEO, checked emergency fuel switch reset, batteries are at 13.5 avg, checked harness wires and found one connector that wasn't snapped in cause the retaining clips were broken. Getting this connector replaced. Found another wire below chaffed. It is on the intake manifold. what is it for and could this be my problem? Pic below? This is where it connects to intake chaffed. The top of the two wires where they go into the connector were twisted around each other. Maybe wire to wire, maybe not. Would this cause my injectors to not buzz or fuel pump to not come on???
Ford 6.0L Power Stroke Diesel :: 2005 - Used PMC Installed Now Tachometer Won't Work?
My mechanic put a used 2005 PMC in my 2004 powerstroke. Now tachometer does not work, trans and coolant temp guages don't work and drives as if it is stuck in 3rd. gear. Does it need flashed @ a ford dealer to sync the two together?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Installed SCT Tuner 3 Injector Not Working?
I installed a sct tuner on my truck and used the default street flash and my #3 injector promptly took a dump. Will a tuner kill injectors?
I just finished up oil cooler rebuild studs, blue spring and egr delete.
Now it looks like i have more injectors going bad.
I have 147,000 miles on the truck.
Ford 6.0L Power Stroke Diesel :: Running Rough After Installed Trans Tune?
I towed my 32 ft/ 600lb travel trailer 115 miles into arkansas today. When I arrived at the campground, the engine was running rough and shaking the vehicle. I saw highs of 175 (trans temp) 1150 (EGT), 214 (ECT), and 224 (EOT).
I recently installed the canned trans tune from my new SCT X4.
I pulled codes (none), checked cylinder misfire count on scangauge 2 (none). In fact, all gauges on the SG2 were within spec. I popped the hood and let it idle for 15 mins. Temps all dropped down to what I usually see after normal driving (not towing).
The engine did start to calm down as it cooled, but still sounded a rough
Ford 6.7L Power Stroke Diesel :: Roll X Installed Now One Corner Unlatched Occasionally?
I installed the Roll X on my truck on the 27th of June. On several occasions I have found one corner has come unlatched. I'm not sure if it is from the bed flexing when I go over a bump or what?
View 2 RepliesFord 6.7L Power Stroke Diesel :: Remote Access Installed - Error Code 00011000?
I've had the Ford Remote Access installed on my pickup for over a year now and it's worked great up until about a week ago when I changed cell phone providers from AT&T to Verizon. Now when trying to use the app I get the error code 00011000. I up-dated the app to reflect the new carrier but it still doesn't work. And yes, my subscription to the service is current. What I need to do to get this working again, with winter just around the corner I'd sure like to have this functional again. I figured I'd give the forum a shot before I resort going to the dealer.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Wrench Light Comes On Initially / Click Under Dash And Cab Lights Go Off
2006 F-250 6.0l,Auto, 175,xxx mi
When I turn the key to on, I hear the vacuum pump cycle (passenger side fender), but don't hear the glow plugs or injectors cycle. Glow plug light comes on and stays on for 30secs. Wrench light comes on initially, but goes off after 3 secs, but then comes back on after about 8-10 seconds. When the wrench light comes on, I hear a click under the dash and my cab lights go off.
When I turn the key to start, nothing happens. If I jump the starter, engine turns over, but doesn't start. I have check numerous fuses, disconnected the fan clutch, tried moving the shifting lever to neutral, wiggled wires around the FICM/PCM/GPCM with no success.
I tried checking for DTC codes, but my scanner (300 reader) doesn't get any power. I have checked my light, it has power.
Twice before, the truck failed to start like this, but after removing & inspecting fuses/relays (all were good), it started back up. Also, occasionally the truck would stall, (just like someone turned the key off), but would start right backup. But when it stalled, the glow plug light would illuminate for a second,then go off.
Own truck for 8 months, replaced the batteries & injectors 6 months ago. Very light puff of smoke when starting up otherwise ran well when shut off.
How to proceed? My first diesel so I may need some extra details.
Ford 6.0L Power Stroke Diesel :: No Crank / Start - 30 Amp Fuse PCM Power Relay Is Blown
Ihave a 2008 E 350 6.0 , while driving i hit a small pothole no big deal the van stops running and coasts to the side of the road. get her towed. The dash lights show the PATS is engaged so it is no start no crank.
The 30 amp fuse PCM power relay is blown. when i replace it it blows as soon as i turn the key. im checking for wire chafing but so far have found none.
Ford 6.7L Power Stroke Diesel :: Power Door Lock Fuse Blowing Occasionally?
I purchased 2011 F250 King Ranch Edition about 3 months ago. I'm loving the truck and not had any issues until 3 weeks ago. I locked the truck as usual using the key Fob, and upon returning to the truck, I noticed the doors weren't locked. After some brief trouble shooting, I discovered the the fuse was blown that according to the manual controls just the power door locks. I thought it was strange that a new truck would be popping a fuse so I replaced it...a couple of days later it blew again. This time I was locking the truck with the door key pad. I took it to the dealership and they checked it over and said they replaced the fuse and cycled it numerous times but could not reproduce the problem. The told me that they even put a call in to the Ford engineers and they said check the key pad for water intrusion. The dealership told me they disassembled the key pad and found nothing wrong....lock and unlocked the door some more and the fuse would not blow. I picked the truck up four days ago and the fuse blew again last night. Everything else works...alarm sets and goes off if any of the doors are opened. The only thing that I can find that doesn't work when the fuse is blown is the remote start.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Blown Fuse Causing Lack Of Power To OBD Port?
Blown fuse causing a lack of power to the OBD port?
I just got my Kiwi2 BT OBD2 adapter and was hoping to start diagnosing my truck, but the adapter won't power on while connected to the truck.
I pulled and visually inspected fuse #12, I also verified power to the cigarette lighter plug and the accessory 12v power outlet.
The adapter powered up with no problem when I connected to a co-worker's Tacoma.