Ford 6.0L Power Stroke Diesel :: Glow Plug Code And CEL Code P0675
Truck has been running very well while in the warmer North Carolina climate pulling trailers with no limp mode or wrench light. However, when daughter started the truck this morning, SGII showed one DTC and when she pulled it up it was P0675. OK, glow plug num 5 maybe or the module. No issues starting or rough cold idle. I told her to clear the code and we'll see if comes back.
She did ask if it is something she should have it repaired before the trip back to Vermont. So I thought I'd ping the group here since reading posts, they seem to be fairly easy to replace (and assuming it isn't a chafed wire) and I could probably save her some $. Just want to make sure there isn't any chance of real engine damage.
Ford 6.7L Power Stroke Diesel :: CEL Code P02E1 - Diesel Intake Air Flow Control Performance
My truck threw a CEL after the first start today. The CTS reports it twice. I noticed it about two minutes after start.
P02E1 - Diesel Intake Air Flow Control Performance
The air box gauge is green and it doesn't reset when I push it so that appears to be fine.
The one thing I can easily notice is the sound of the turbo. Typically when I stop and park, the turbo spools up, then down, then spools again and gives a sigh of relief and it's then silent. It's not doing that currently.
Now, I can hear it constantly when parked and it spools down after I turn off the engine, even two minutes later. That is not normal for my truck when I wait for the above to finish its routine. When I start the truck, the turbo immediately spools to where I can hear it which is also not normal, as if it's building 0.5 psi. I realize that's funny to say on a turbo diesel but I know the sounds of my truck. The EGT's are fine, EOT, ECT, TFT are fine and I can build boost when driving without issue. I took the drive to work easy this morning so the highest I noticed was 10 psi.
I restarted the truck after a 20 minute drive to the office and it didn't clear the CEL. The CTS squawked four times when it woke up the second time but it didn't show me which PID it was upset about.
I'm thinking this has nothing to do with the CAI and this is something downstream of there. EGR related? I haven't opened the air box yet, at work and in dress clothes so that'll need to wait. My past four or five regenerations all started between 1.94 and 1.97 soot gpl. That is also not normal and is something I have been keeping my eyes on. Currently the DPF is at 2.10 so it has made it further. Normal behavior (post emissions flash) is above 2.54 soot gpl for an AR.
Ford 6.7L Power Stroke Diesel :: P259F Code / Reduced Power Mode
It happened to me. I was 2 hours into my trip and towing the camper when I got the reduced power CEL. I have 28,000 miles on my truck and always tow in "tow/haul" mode with the exhaust brake on. I was lucky in that I has on a limited access highway and just happened to be approaching an exit to a fuel station with big rig access. I limped in there at about 20MPH checked the code with my Forscan lite and found the P259F code. I typed that into Google and found a thread on another Diesel forum! Some guys said it went away after 3 or 4 restarts. So, I tried a couple of restarts...no luck.
I was down to half a tank of fuel so I filled up and parked. As long as I was parked, I went into the camper and used the bathroom. When I got back in the truck, I thought about the WiFi scan adapter plugged into my OBDII connector and wondered if I should unplug it. I did and everything worked! So, I drove the next 4 hours in "tow/haul" mode, but I left the EB off. I also never plugged in the WiFi scan adapter because I didn't want to risk going into the reduced power mode again. Anyway, we made it home without incident. One of the reasons I traded my 2013 in on a 2015 was to get the engine improvements and the EB. I sure don't want to give up the EB. I'm going to take mine to the dealer, but after reading this post, I'm not expecting anything much.
Ford 6.7L Power Stroke Diesel :: Significant Reduction In Power - CEL And Code P208E
Got this nugget this morning after dropping my daughter off at school. I also noticed a significant reduction in power. Had to get fuel so while pumping, I checked the code with my WiFi reader and Engine Link app.
Got the code number which came up with this: 6.7L ? MIL on with DTCs P208E P218F P204F ? 2011-2016 Ford F-Super Duty
I decided to clear the code and see if it would instantly return which it didn't. Power came back as soon as it was cleared too. Will see if it comes back. Looks like the code is saying there might be crystals on my DEF injector. I did have a regen last night right before I parked for the evening and then this showed showed up first thing this morning. Would a DEF injector nozzle be covered under the emissions warranty if it comes back?
Ford 6.0L Power Stroke Diesel :: Code P2290 - Start But No Power
Long story behind it but finally got my scanner working right and checked the suggested systems for p2290.
IPR was 77+ on start up dropped to around 31 at idle
FMP is in the 46.5 to 47.5 range
SYC was at 1 and occasionally at 1.5
ICP was at 550-650 during startup and quickly ramped up to 1150 then settled into around 850 at idle.
The only thing that I'm not sure of is the IPR being 31 at idle, is that what it should be. The others I think are within normal operating parameters.
The truck starts but has no power. Can barely go up a slight hill on my street. Seems like it's going to be fine but as soon as I apply a little gas it just falls off.
Ford 6.0L Power Stroke Diesel :: Low Power Until Warms Up - P0234 Code
Local Volunteer Ambulance company has '09 -6.0 with very low power until warms up. Shows code P0234. FICM tests out 47.5- 48 volts.
Doing searce it looks like we have to pull turbo. Vehicle has 54K miles and never had EGR delete.
Ford 6.7L Power Stroke Diesel :: Getting Code PO088 / Power Reduced When Truck Flashed
I just pulled over when my truck flashed reduced power. Pulled code and it came up poo88. What to expect?
View 3 RepliesFord 6.7L Power Stroke Diesel :: Reduced Engine Power Message - Code P164A
So I just went on a vacation pulling my horse trailer (first time leaving the state with this truck) and at about 5 hrs into the trip I had a message Reduced Engine Power and went from 70 on the interstate to 10 miles an hour and slowing rather quickly. I ended up shutting it off and restarting and it came back just like normal. I found the nearest ford dealer and they put the computer on it and it showed absolutely nothing, no codes and nothing wrong. The mechanic reset some things and we went on our way.
Then I ended up getting a check engine light saturday. I found someone to read the code and it came up with P164A which is an O2 sensor, he was able to clear it and I put on probably 50 miles today and no check engine light. I have about a 10 hour drive back home. Still debating if I take it to ford near here if they will do anything now that it doesn't show a light?? I hate to chance getting broke down on the highway with a truck that will basically shut down like that?? It just doesn't make sense to me.
Ford 6.7L Power Stroke Diesel :: Got Code P0170 - Power Fuel Trim (Bank 1)
Drove the truck to the store tonight about 5 minutes away and everything seemed fine. Went to leave the parking lot and noticed the check engine light was on. Pulled out my tablet, dongle and fired up Torque Pro. Retrieved error code P0170. Truck has a little over 12,700 miles and is complete stock. I ran a search and didn't come up with much info on this code other than what Just Stroken posted in another post.
[URL]....
Looking for more information about this code?
Ford 6.7L Power Stroke Diesel :: Power Loss - Code P0401 - EGR Cooler Is Clogged
My 2011 has 62k miles and has been throwing P0401 codes, which results in losing power. I assume the EGR cooler is clogged. So I went to the dealership to see if it's covered, and was told there's no warranty coverage.
I would rather blockoff the EGR cooler than repair it. I would also like the extra performance from a tuner like the MiniMaxx. I do prefer the stock exhaust and not real excited about the drone/smell that comes with deleted DPF.
Will I have issues if it's tuned with the EGR blocked off, and stock exhaust? Or am I better off doing a full delete at this point?
Ford 6.7L Power Stroke Diesel :: 2011 F350 - Reduced Engine Power Code On Dashboard
I have a 2011 6.7 F-350 Diesel. I bought the truck new and I've never had any problems with it until now. I have a SCT Chip & Tuner. It needed an update so I returned the truck to stock and a code came up on my dashboard that said "reduced engine power" which obviously I thought was Normal because of the modifications done to my truck.
I updated my tuner and returned the truck to a performance tune but this dashboard code will not go away. My truck isn't reading any codes and there's no other indication lights on. The truck has Normal RPM readings but 0 throttle response. No power at all...
Ford 6.7L Power Stroke Diesel :: CEL With Code P00BC?
I recently put on my no limits intake and have started getting a check engine light for code P00BC which means P00BC - Mass or Volume Air Flow A Circuit Range/Performance - Air Flow Too Low. It comes at random times and I can not recreate it. Does not effect the driving of the truck. At first I thought it was the tunning but I got custom tunes and it happened again today. Is it possible that it just got dirty and needs to be cleaned?
View 14 RepliesFord 6.0L Power Stroke Diesel :: CEL On With Code PO299?
i had a very bad day yesterday after loading my families atvs on our trailer and heading 40 miles away the 6.0 let me down. the check engine light was on about a month ago but the truck was running perfectly so i unhooked the batteries and reset it and the cel had not been back on until the start of our journey yesterday. the cel came on and the turbo barked and then every time i hit the throttle i had no boost till about 2500 rpm then the boost would go up to 30-33 psi only going 60 mph. so after making it to the trails and making it home i took it to advanced auto to read the cel codes and they pulled the po299 underboost code. now i know that this has been brought up many times but i cant find any where the truck has been over boosting like mine was. and also i did check all the boots and they all seem to be fine.
I really don't want to take it to ford until i know some of the cause because the truck isn't under warranty ... Also only mods to the truck are mbrp 4 inch turbo back exhaust and afe stage 2 cai
Ford 6.0L Power Stroke Diesel :: Got Code P0276 With CEL?
I had a P0276 cel come up on Sunday. I had just changed my fuel filters so figured it had something to with that. I deleted and it just came back tonight.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Code P2201 For NOx Sensor
I have a little over 32k on my 2014. Left today for my first camping trip of 2017. 250 mile into the Eastern Sierras. Took a potty break after 125 miles or so and CEL came on. Used my CTS2 and got a P2201 code which is a NOx sensor. I decided to continue on to my destination and made it there safely.
My question is do you all think I will be ok driving 250 miles back home in a couple of days? Truck seems to run ok. MPG seems to be dropping.
Interestingly, the Soot % on my CTS2 dropped to 0% and stayed there the whole trip. Obviously it's going to the dealership come Monday, just wondering if I will make it home ok and not get stranded in the desert with the family.
Ford 6.0L Power Stroke Diesel :: 2007 - Got Code P0670?
]I have a 2007 F350 6.0, 75,000 miles
Have been having P0683 for many weeks with no starting issues. I replaced the GPCM and cleared the code. Now I have P0670. Still no issues with starting or running. Where to start troubleshooting? Batteries are good, wiring looks good (visually). Had to replace glow plug on #6 a couple of years ago, but I don't remember how I determined it was that cylinder.
Ford 6.0L Power Stroke Diesel :: FICM Code / Low Voltage
I replaced injector couple weeks ago. I hooked up to livelink thru sct because it was throwing a low voltage for ficm code. It is staying at 48 volts tho. I don't see any voltage from my glow plug relay, and I have a low voltage for my egr valve. Is it just bad luck that everything broke at once or is there a fuse or a connector that I forgot to plug in.
View 10 RepliesFord 6.0L Power Stroke Diesel :: Got Code P0683 When GPCM Off?
Had the GPCM off for the recent injector reseal job. Kid called me after school let out that it started like dog doo, has this code.
I am guessing something got chaffed or broke between the PCM and the controller.....I don't want to just throw a new controller at it.
How to test this? I am guessing there is a wire from the PCM to the controller that is not making the connection.
I noticed the code the other day, thought it was related to all the cranking perhaps. Reseated the two plugs, no joy.
Ford 6.0L Power Stroke Diesel :: CEL Is On - P1635 Error Code
My CEL is on and I pulled this code...I made the mistake of using a Hypertech programmer and the code came on soon after. I do have a stock code I saved from my SCT, would it fix it if I put it back in?
View 14 Replies