Ford 6.0L Power Stroke Diesel :: 2005 F350 - Turbo Is Spooling Up And Down Constantly
2005 f350 6.0 all stock except egr delete. My turbo is spooling up and down constantly. I can actually watch my VGT duty cycle fluctuate while sitting at an idle too. I've cleared the codes and p0299 always shows up first, but then I'll get p0069 BARO/MAP, and a p0470 exhaust pressure sensor eventually. Sometimes it takes an hour of driving before those show up. I can watch all these values on my torque pro, and nothing seems out of the ordinary other than the turbo opening and closing at will. What can cause this? I hate to just start throwing sensors at it.
View 11 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Turbo Not Spooling At All
Ok so I just replaced the oil cooler, added 2 coolant filters, changed the oil/filter, and both fuel filters, and installed the updated turbo drain tube. I get it all back together, it takes a minute before it will fire but I figured that was normal for not having any oil in the sump under the cooler and changing both fuel filters. Everything seems fine, checking for leaks and I notice that I don't hear the whistle of the turbo so I go look at my edge CT and have zero boost and it stays at zero even if I rev it a bit. Obviously I didn't redline it or run it for very long maybe a total of 10 minutes over several times.
I will note that I did find a plug for the driver side injectors wasn't plugged in the first time I started it, but I shut it down pretty quick and plugged it in. So then after I noticed the turbo not spooling I used the chip to pull the codes and had a whole bunch related to the unplugged harness and one for turbo underboost. Figured it was because the harness was unplugged so I just cleared the codes and tried again, now I'm not getting any codes but I'm also not getting any turbo boost the only code that it is throwing is the P1000 "on-board diagnostic systems readiness test not complete" do I need to go drive it for the learning sequence because I had the batteries disconnected for a couple days?
Ford 7.3L Power Stroke (1999-2003) :: Pop When Accelerating With Turbo Spooling Up And Lost Power - Code P0475
As I was getting ready to leave town with the tractor loaded up, I was accelerating with the turbo spooling up when I heard a bit of a pop and lost power (engine still running and all, just very low power like you get when the turbo fails). I wasn't far from the shop so I came back and started getting a lot of white smoke out of the exhaust, it doesn't smell like diesel, probably more like oil. Definitely smoke, not coolant. I pulled it around back and shut it down to go grab AE and scan it and it shows a P0475, starting it back up has light smoke at idle and it idles fine but as soon as you give it any throttle it starts smoking pretty badly.
Researching it looks like the most likely cause for this is the EBPV itself but before tearing it down that far. This is the only code it's showing.
Truck has 272k on it, turbo was rebuilt a couple of years ago but we didn't do anything with the pedestal at that time. I guess in retrospect, I probably should have done the EBPV delete and the resistor fix then but I didn't think about it at the time.
On another note, my AE is not showing any of the system test for some reason, the drop down is blank. I have version 7.0.1, so it's an old version but I'm working on an old truck, so... What that might be? I've got the truck pulled into the shop now to let it cool down. I'll probably let it sit overnight and take the turbo and EBPV out tomorrow unless someone has a better suggestion...
Ford 6.0L Power Stroke Diesel :: Can Interchange Turbo 2004 And 2005?
The 2004 and 2005 turbo is interchangeable and can you replace the bearing in it.
View 8 RepliesFord 6.0L Power Stroke Diesel :: 2005 - Power Loss With CEL - Turbo?
2005 F250 SD, Crew Cab, Diesel 6.0L...
Hauling my jeep (close to 16,000 pounds all in F250+trailer+jeep) on a highway going a little over 70mph up a hill when I seemed to have lost some power and the check engine light came on. The turbo PSI was well over 20PSI (according to the gauge in the dash). I have a Scan Boss but I have not been monitoring turbo boost PSI.
I was only 10 miles from the final destination so I continued without stopping. It seemed that the turbo was limited for the rest of the trip. Later in the evening, no more check engine light but I haven't really driven the truck since then.
What do you think the problem was? What should the course of action be?
Ford 6.0L Power Stroke Diesel :: 2005 Turbo And Pedestal On 2003 Swap?
Need to know if you can mount a 04+ turbo on a 03 engine without changing the intake with the cross in the back ? Or does the intake have to be changed. If the intake does need to be changed will the egr need to be change as well ?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2005 F350 - Bearing Get Loose In Turbo?
2005 f350 188000 on the clock had a bearing get loose in the turbo . Installed a new power-max but if the bearings are oil fed should i also change it? There are no signs of metal in the oil or the old turbo . The oil has 600 miles on it with archoil.
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2005 - Lack Of Turbo Boost At Startup
I've been having issue with my truck lacking boost over the past month or so. The psi levels are normal in the morning when I start it up cold, the problem almost always occurs at start-up when the truck is somewhat warm and has been sitting for an hour or more after use. I've had boost levels at idle from -0.14psi to -0.56psi and as low as -1.2psi when driving as the problem is occurring, but it eventually kicks on and goes to normal levels after several minutes of driving. After originally taking the truck to a local diesel mechanic I was told it had EGR codes and they recommended installing an SCT tuner and cleaning the EGR valve to solve the problem. I had them install an SCT 5015 tuner and clean the valve but I've still been having the problems with boost.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2005 - Hissing Noise When Accelerating - Lost Turbo?
I have a 2005 F250 with 186K miles. I do minor work on my vehicles but have little experience working on my diesel. I was accelerating when I heard a pop and a hiss similar to disconnecting an air hose from an air compressor. Total loss of turbo power. No turbo reading on the turbo gauge on dash. No loss of oil. No smoke. Oil and coolant look fine. Took off turbo and everything appeared to operate like it should (according to YouTube videos). Inspected lines and rubber boots.
Rubber has some cracks but not certain if they are holes. How small/large of a hole would cause total loss? Was originally scared to take it to a shop knowing they could name their price. Not opposed to taking it somewhere now knowing the turbo works but obviously would rather save the money. Any tips on troubleshooting? I'm not opposed to proactively replacing parts/sensors as the truck has given me 186k and I plan to keep it as long as possible.
Ford 6.0L Power Stroke Diesel :: White And Blue Smoke When Spooling Up In 1st / 2nd And 3rd Gear
Replaced stock turbo on my 04 f350 zf6 with a newer stock turbo from an 05 6.0 excursion with a wicked wheel. Truck never smoked before ever for any reason. Now with the new turbo the truck puffs out white and blue smoke when turbo is spooling up in 1st 2nd and 3rd gear but once turbo is spoiled up no smoke at all. 4th and 5th no smoke at all. What could be my issue? Truck runs great no sputtering or missing or anything. I rebuilt injectors about two months ago so those are good.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2005 F350 - Stuck Turbo Bolt On Driver Side
I am replacing the turbo on my 2005 f350 6.0. I have the passenger side mounting bolt and the rear mounting bolt out, but cannot get the driver side bolt to budge. I have sprayed it with WD40 and PB Blaster and tried a breaker bar. No luck breaking it loose. I am afraid I might round off the head even though I am using a 6 point socket.
View 12 RepliesFord 6.0L Power Stroke Diesel :: 2005 - High Pitch Squeal / Turbo Has Been Sticking After Hard Acceleration
For a month or two now my truck has been making a squeal and the turbo has been sticking after hard acceleration. The sticking was a woebegone unison ring and I was hoping the squeal would be resolved when I cleaned the turbo but it didn't, in fact, it got worse.
It used to be occasionally and go away after warming up, but now it's more constant than not. It goes away when the VGT does its idle cycle and once you get up to speed.
Here's the sound - YouTube.....
Ford 6.0L Power Stroke Diesel :: 2005 F250 Shifting Hard / Oil Leak Coming From Some Seals On The Turbo
This is is a truck I hardly know anything about. My wife bought it while I was deployed for herself and when it comes to vehicles she's an idiot. No, really she told me she bought it because at horse shows everyone else has one.
I noticed an oil leak and had a reputable shop look at it. They told me it was coming from some seals on the turbo. Long story short there is a brand new turbo on there, stock replacement. Now it seems very under powered and shifts hard. Pressing down anything more than 25% throttle will cause hard shifting or no shifting at all. It'll stay in second until I ease off the throttle.
I tried searching a few terms but I'm not sure what to look for. I don't know if someone has messed with the tuning. Broken clamp on the turbo. Replaced and everything is back to normal...
Ford 7.3L Power Stroke (1999-2003) :: 2002 - Turbo Noise From 5 To 15 PSI Intermittently?
I have an 02 crew cab SB 7.3L. The best way to I know to describe it is a sorta like a metal ringing noise. It just started this afternoon while pulling a 9k camper. It only does it under load. Boost stays the same and it happens in all ranges from 5psi to 15psi. It is intermittent. It sounds like it it coming from the turbo. I pulled off the boot and could not feel any play on the intake wheel.
After unhooking trailer and taking for a test drive I can not get it to do it again? The turbo was rebuilt about 4 years ago with a wicked wheel but has only seen about 18k miles since the rebuild. A quick look at the boots appear good but didn't get to take them off before going to work. I will try to post video.
Ford 6.7L Power Stroke Diesel :: No Turbo Pressure?
Weird thing happened today. Was out running errands, and upon pulling out into traffic I felt the truck lag a little. I figured it was the typical trans hiccup we all experience from time to time. As I continue driving, I notice I don't have any turbo boost.
I'm cruising around 55-60 and when I slowly give it gas......No boost. I stomp it and the turbo gauge slowly climbs to about 12 psi. At this point I waiting for the truck to throw a warning message and none came.
As I'm reaching my destination, the speed limit is 30 so I'm just putting along and any acceleration I did, the boost needle wouldn't move. I arrive at the store, and when I got back in 5 minutes later and drove off, My boost was back. Truck operated normal for the 25 minute trip home. I thought a similar thread was started but I couldn't find it.
Ford 6.0L Power Stroke Diesel :: Turbo Up To 30 Psi Normal?
My truck is all stock and I am running in performance tune? And my friend the former owner said I need to let her loose about 75 percent of the time I am driving it because it's my DD and I do not tow anything on a regular basis. I do not want to stretch my bolts by unnecessary pushing, I don't know if I'm even pushing it hard but I normally get the turbo up to about 30 psi is that to much?
View 8 RepliesFord 6.0L Power Stroke Diesel :: How To Get Oil Tube In Turbo
Still working on this E450. Now, I'm trying to get the turbo back on and I don't know how the heck to get the oil tube in.
There's so little room that I can't lift the turbo up. Just getting it in and out is a chore. I was able to pull the oil tube out with some difficulty when I was removing the turbo, but if it put it in first, the turbo won't go over it to get back in. If I leave it disconnected to get the turbo in, I have no way to reach under it to get the oil tube back in.
I only messed with it for a little while - it's physically difficult bending over inside the van to wrestle with it - and will go back at it first thing in the morning. I know there's gotta be a way, I've just never done this before.
Do I stick the tube in the turbo first, in the engine, or neither until I got the turbo in place?
Ford 6.0L Power Stroke Diesel :: 2006 F350 - No Power At All / Turbo Was Not Kicking In
I have a 06 f350 superduty with a 6.0 I have had injector problems before with the motor even hydro locking no start this is the problem my truck started blowing white smoke with a strong diesel smell everyone said it was oil cooler but I took it to a ford garage the guy said I had 2 injectors hung open and wasn't hydro locking and suggested to put all 8 in so I did 3400.00 not I went to pick it up had no power at all turbo was not kicking in so I took it right back to them they checked it out said turbo was sticking had to clean it it would take 6 hrs. said the fuel In the motor caused it it was working fine when I took it to them now they say maybe a new turbo are they giving me the run around or is this possible....
View 9 RepliesFord 6.0L Power Stroke Diesel :: CAC / Boost Tube Keeps Coming Off Under Power At Turbo Connection
Having this problem, what to do to correct it? There is no hole in the boot and this just started about a year ago. Does not do it all the time.
View 4 Replies