Ford 6.7L Power Stroke Diesel :: Low Tire Pressure Light On - TMS Pressure Low?
I had new nitto snows put on my truck and low tire pressure light is on.....Checked tire pressure 65 front and 80 back.....Started truck and screen said tms pressure low.....Hit ok and drove around on and off for 2 days now and cant get the light to go out......Is there some way to get the light out or do I have to go to my dealer to have it reset???
View 14 RepliesFord 6.0L Power Stroke Diesel :: Oil Pressure Gauge Showing No Pressure
Last week I was driving on the highway and noticed the oil pressure gauge showed no pressure. Limped a half mile to the mother-in-laws and called for a tow. As my truck was pulled onto the flatbed I could see oil all over the bottom of the engine, tranny, rear end, etc. Turned out to be a bad oil pressure sender, which was leaking enough oil to blow the plug off the top of it.
I replaced the sensor, cleaned the engine and under-carriage, checked oil level (which showed no loss of oil) and drove around for a week without an oil pressure gauge while I waited for a new pigtail. Put the pigtail in yesterday and drove it today for the first time since. Gauge was working, got to the bank and it was reading zero pressure again. Limped home and watched the gauge go back up quickly and then back down. This happened twice and was showing pressure when I shut it off. Checked under hood, no oil leaks and plug is still secure.
Ford 6.0L Power Stroke Diesel :: Turbo Up To 30 Psi Normal?
My truck is all stock and I am running in performance tune? And my friend the former owner said I need to let her loose about 75 percent of the time I am driving it because it's my DD and I do not tow anything on a regular basis. I do not want to stretch my bolts by unnecessary pushing, I don't know if I'm even pushing it hard but I normally get the turbo up to about 30 psi is that to much?
View 8 RepliesFord 6.0L Power Stroke Diesel :: How To Get Oil Tube In Turbo
Still working on this E450. Now, I'm trying to get the turbo back on and I don't know how the heck to get the oil tube in.
There's so little room that I can't lift the turbo up. Just getting it in and out is a chore. I was able to pull the oil tube out with some difficulty when I was removing the turbo, but if it put it in first, the turbo won't go over it to get back in. If I leave it disconnected to get the turbo in, I have no way to reach under it to get the oil tube back in.
I only messed with it for a little while - it's physically difficult bending over inside the van to wrestle with it - and will go back at it first thing in the morning. I know there's gotta be a way, I've just never done this before.
Do I stick the tube in the turbo first, in the engine, or neither until I got the turbo in place?
Ford 6.7L Power Stroke Diesel :: Low Fuel Pressure And Reduced Pressure Limp Mode
My truck gave me low fuel pressure and reduced pressure limp mode at 21,000 miles. The fuel and air filters were changed at 16,000. The dealer said all they found was the fuel filters (at 21,000) were what needed to be changed. Also, why does my truck hum??
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - No Power At All / Turbo Was Not Kicking In
I have a 06 f350 superduty with a 6.0 I have had injector problems before with the motor even hydro locking no start this is the problem my truck started blowing white smoke with a strong diesel smell everyone said it was oil cooler but I took it to a ford garage the guy said I had 2 injectors hung open and wasn't hydro locking and suggested to put all 8 in so I did 3400.00 not I went to pick it up had no power at all turbo was not kicking in so I took it right back to them they checked it out said turbo was sticking had to clean it it would take 6 hrs. said the fuel In the motor caused it it was working fine when I took it to them now they say maybe a new turbo are they giving me the run around or is this possible....
View 9 RepliesFord 6.0L Power Stroke Diesel :: 2005 - Power Loss With CEL - Turbo?
2005 F250 SD, Crew Cab, Diesel 6.0L...
Hauling my jeep (close to 16,000 pounds all in F250+trailer+jeep) on a highway going a little over 70mph up a hill when I seemed to have lost some power and the check engine light came on. The turbo PSI was well over 20PSI (according to the gauge in the dash). I have a Scan Boss but I have not been monitoring turbo boost PSI.
I was only 10 miles from the final destination so I continued without stopping. It seemed that the turbo was limited for the rest of the trip. Later in the evening, no more check engine light but I haven't really driven the truck since then.
What do you think the problem was? What should the course of action be?
Ford 6.0L Power Stroke Diesel :: CAC / Boost Tube Keeps Coming Off Under Power At Turbo Connection
Having this problem, what to do to correct it? There is no hole in the boot and this just started about a year ago. Does not do it all the time.
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Turbo Won't Have Boost?
I have a 2004 Excursion with the 6.0. Lately it seems like the motor just doesn't have the boost it should. Funny thing is that the boost reading through the edge cts seems to be right. Under full acceleration it will pull 27 psi boost and 3900+ ICP pressure. No codes are being thrown. It just doesn't "feel" right (seat of the pants) and it also sounds louder but I don't known this for sure.
Where does the CTS get its boost reading from? The truck has new boots on the hot side from riffraff. Anything I can check?
Ford 6.0L Power Stroke Diesel :: F450 - Turbo Malfunctioning When Hot
I have an F450 with a 6.0 turbo diesel with 267000 miles std trans. 4wd and just bought it a few weeks ago. When the engine is cold, the truck runs fine but after driving for 15 minutes, I loose power in 3rd, 4th, and 5th gear. The gauge for the turbo drops from 20 down to 5 and the truck starts blowing black smoke. This starts at 1500 rpms and stops when I am past 2200 rpms.
Before 1600 rpms and after 2200 rpms, the truck has lots of power but withing those ranges, the truck has almost no power at all. When I first got the truck, the problem didn't start until I was up to 1800 rpms. No codes showing up either. I had the truck serviced by a diesel mechanic and the filters replaced using Ford parts. Problem persists and only exists when the engine is warm.
Ford 6.0L Power Stroke Diesel :: Turbo Keeps Blowing Hoses Off
I just recently repaired issues with my 6.0 and now new issues has begun. The turbo keeps blowing the pipes out of the rubber hoses. Not sure what is happening or why so a little insight would be useful.
Oh yeah out of all the work completed in my previous post..don't bother replacing the solenoid section of the injectors. I replaced two the bad ones, rebuilt the other 6 with new everything including a cleaning and now I am getting codes for 3 that are going bad. Oh well I tried right...
Ford 6.0L Power Stroke Diesel :: 2004 - Turbo Not Spooling At All
Ok so I just replaced the oil cooler, added 2 coolant filters, changed the oil/filter, and both fuel filters, and installed the updated turbo drain tube. I get it all back together, it takes a minute before it will fire but I figured that was normal for not having any oil in the sump under the cooler and changing both fuel filters. Everything seems fine, checking for leaks and I notice that I don't hear the whistle of the turbo so I go look at my edge CT and have zero boost and it stays at zero even if I rev it a bit. Obviously I didn't redline it or run it for very long maybe a total of 10 minutes over several times.
I will note that I did find a plug for the driver side injectors wasn't plugged in the first time I started it, but I shut it down pretty quick and plugged it in. So then after I noticed the turbo not spooling I used the chip to pull the codes and had a whole bunch related to the unplugged harness and one for turbo underboost. Figured it was because the harness was unplugged so I just cleared the codes and tried again, now I'm not getting any codes but I'm also not getting any turbo boost the only code that it is throwing is the P1000 "on-board diagnostic systems readiness test not complete" do I need to go drive it for the learning sequence because I had the batteries disconnected for a couple days?
Ford 6.0L Power Stroke Diesel :: Oil In Down Pipe Leaking On Turbo
Would there be much oil in the down pipe if the oil deal was leaking on the turbo? I broke it loose to look at it and not much there, one small area that looked like it has had on it..
View 13 RepliesFord 6.0L Power Stroke Diesel :: Burning Oil After Turbo Replacement
On Friday my turn shaft broke, 70 mph on the highway. As soon as it broke burned oil like a freight train, I know seal in the turbo. Bought brand new Garrett turbo installed last night. Let idle for 5 minuets and went and drove it and it burns oil once I get on it. Drove it for about 3 miles comes and goes? I did break a piece of the turbo vane off 1/4 inch by 1/4. The truck runs fine no knocks or misses. Could this just be oil left over or is there something else I should be looking for?
View 2 RepliesFord 6.0L Power Stroke Diesel :: Turbo Fluctuating While Accelerating
What could be causing my turbo to be fluctuating while accelerating? I can definitely hear the difference in the sound of the air and today while towing my camper I could even see the dash gauge bouncing around some.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Turbo Pulsing When Cruise On
I haven't been on for a while, but I'm trying to figure out if I have a slight turbo issue.
Turbo pulsing ? I am experiencing this, it just started about 3 months ago. First time it did it, I thought the truck was going into exhaust cleaning mode. Not the case. It doesn't do it with the cruise off, but with the cruise on it's like it can't decide if it needs boost or not.
Boost is pulsing between about 2-3 psi to 10 psi. No check engine light on to speak of. Now that I'm thinking about it. I think the turbo is falling flat with the motor cold too, or maybe it's a cold tranny..... gotta watch that closer.
Ford 6.0L Power Stroke Diesel :: Turbo Pedestal Sensor Function?
What's the purpose of the pedestal sensor
View 1 RepliesFord 6.0L Power Stroke Diesel :: Turbo Replaced - Oil Coming Out Of Exhaust?
Had a bad turbo on my 07 F550 with a 6.0. Replaced it today and took her for a ride. Started smoking and oil was spitting out of the weep hole in the muffler. A lot of smoke. The truck was smoking before I replaced the turbo too but I didn't have any oil coming out of the weep hole. I'm hoping it is just oil that had been passed into the exhaust by the bad turbo that is now being burnt off and pushed out by the new turbo. Does this sound plausible?
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2005 - Turbo Over Spooling Intermittently?
Having an issue with my 05 f350. Seems when I chomp on the the throttle I get tons of boost 30 lbs plus with no power. Seems most prevalent when starting on a hill , or hard on the throttle off the line . Also getting turbo "bark " when backing off throttle. It's less prevalent when feathering the throttle and usually more noticeable 1/2 throttle or more. I'm thinking could be the Vgt actuator or clogged/ dirty ebp sensor?
View 10 Replies