Ford 6.0L Power Stroke Diesel :: 2005 E350 - No Hot Start / Just Cranks But Won't Fire Up
I have a 6 liter 2005 e350 diesel that starts great when cold and runs well all the time but after it warms up it just cranks but won't fire up. But if i shoot ether into the intake it will start. It doesn't show any failure codes.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2005 / E350 Van - Rough Idle Stalls / Hard To Start
Rough idle I have had for little bit.Would stall out at idle or a stop, but fire right up? No one could figure it out with the stalling, but now its bad, started yesterday. Have white/blueish smoke sometimes, ( white smoke smells fuel) on restart after warmed when it dies, first time it took 25 mins to restart, now only takes 5 to 15 mins, when I step on it INCREDIBLE full power, fuel mileage gone to hell also since yesterday. Had full tank, now 1/2 tank.
No problems on cold start at all, no check light, 325,000 and never had this before.
Bad fuel?
ICP?
FICM?
Recent work, new turbo, ( turbo was original turbo installed when built) cooling line to waterpump, oil change, new fuel filters, front brakes and 2 new batteries.
Ford 6.0L Power Stroke Diesel :: Crank But No Start - Check Engine Codes P0299 And P2262
I just got a new 2006 E-350 van about 4 months a go (my previous 2004 got scraped - found out the fuel line leaving the secondary filter into the engine with clogged with bits of paper (wtf?)... after I decided salvaged it for parts for my new van...).
New van drives beautifully in the last 4 months without problem, but shut down on me on the highway yesterday. No strange noise or anything when it went out. I managed to coast safely to the side of the highway. Unfortunately, I cannot seem to start the truck again and had it towed home. It cranks, but doesn't start.
I have a scan gauge ii this time and it shows the following:
KOEO:
FICM ~48.5V
ICP 0
IPR 14.8%
Sync 0
Cranking:
FICM ~48.5V
ICP ~8PSI
IPR 84.7%
Sync 1
I still have a P0299 and P2262 check engine code from 2 days previous to the above, but this doesn't seem to be related to the no-start conditioning (both turbo related)
So, pretty much, I'm looking at a very low ICP. Some research indicates this is is due to a bad HPOP, bad STC fitting, or a massive leak. Given the really low ICP, can I rule out the STC fitting and leak? Looks like only the LPOP is providing pressure. Is there anyway to tell if the HPOP is dead or not once I remove it?
Anything I should shot-gun replace first? I have a bunch of salvaged parts from my old van in my garage, which doesn't include the HPOP unfortunately.
Ford 6.0L Power Stroke Diesel :: How Tough To Access / Replace Windshield Washer Pump
getting weak spray/dribble (yea, it could be a "personal problem " on the drivers side squirter. Left side great. I have replaced both squirters and blew out the line where it T's over to the drivers side.
Still weak.. I'm thinking its most likely low pressure coming off the pump and maybe it's time to replace I haven't crawled under there to inspect placement of pump. Thought while there I would also replace the reservoir.
Ford 6.0L Power Stroke Diesel :: 2005 F250 - Engine Cranks Fine / No Cold Start
I'm TSing a no-start on my 2005 6.0L F250. Engine cranks fine. I've been working my way thru the TSing guide and using my new ScanGaugeII. No codes found. At glow plug warmup, (dash light goes off), I'm getting 40.5v FMP, 11.0v FLP, 14.8% ICP, and 0psi IPR. After cranking for 10-15 sec, get 35.5v, 10.0v, 84.7%, and 446psi. I've had a trickle charger on all night to keep the batteries charged. Have not seen FMP over 45 or IPR over 470.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2005 F250 - Engine Change Out Now The Truck Will Not Start On Hot Crank
So, we have a 2005 ford F 250 6.0 diesel and we had the engine changed out from a 2006. Now the truck will not start on hot crank. It will start up normal when cold. So dummy plugs and stand pipes were changed out as well as the oil pump and turbo from the 2005 engine because they were still perfect. What else could be causing the truck not to start up after truck is hot. Does the engine number have anything to do with it? Or anything electrical
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Tough To Start And A Lot Of White Smoke
For the past few days I noticed my truck would be really rough to start and a lot of white smoke. but once it ran for a minute or less it would be fine. Today when I got home I popped the hood and was looking for anything and noticed my degas bottle had this weird fluid inside on top of the coolant? So I popped the cap off and smelt it and its fuel. Of course this would happen to me. Now I'm not going to lie I have beat on it a few times this week but nothing so so serious.
Could this be contributing to it? Could it be a head gasket? now being a diesel mechanic I doubt its a head gasket simply because there is no oil mixing. I am praying its nothing too major. Once I have the narrowed down to what it could be ill see if its something I could tackle or if the stealership has to do it, which I am not looking forward to. I'd rather be down a truck for a little bit and save a boat load of cash.
Ford 6.0L Power Stroke Diesel :: E350 Dying When In Gear / Lack Of Power / Rough Idle
Having some problems with an e-350 dying when in gear and rough idle. Truck starts up after it dies. Vehicle acts like it is starving for fuel. I have check fuel pressure after fuel pump and getting 55psi. High oil pressure pump with in normal ranges. Cleaned and checked egr and it was in the closed position. Fuel filters have been changed. Injector buzz test ok.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2008 E350 - No Oil Pressure At Hot Idle
I just added 2 used 08 E350s to the fleet both about 180k on em and 1 has a little issue with oil temp and pressure. Driving ect is 222 and oil temp hits 240 then oil gauge drops to 0 and oil light comes on. I know the cooler is junk, but I am gonna pull the lp pump off and see what I find. I have a chance to fix this, or should I just order the 13k box with a reman in it.
View 13 RepliesFord 6.0L Power Stroke Diesel :: 2004 - How To Replace Thermostat In E350 Van
I bought a 2004 E350 van that has been driven 9000 miles in the past 6 years. Replacing a thermostat in an E350 6.0 Powerstroke van?
My van is running on the cold side ECT 176-180 when idling. It will reach 190 when I am driving. The EOT is 6-10 degrees higher.
I am flushing the system with Restore and plan to replace the T-stat soon when it arrives from Amazon. I have 3 gallons Cat ECT-1 full strength coolant and a lot of distilled and reverse osmosis water for the flush.
Is it a long procedure? There is not much room in a van to work with ease. If it's too involved, I will find some over time at work and pay my mechanic to do the install.
Ford 6.0L Power Stroke Diesel :: 2004 E350 - Bad Vacuum Pump - Replacement?
I have a 2004 E350 6.0 with a bad vacuum pump. I tried looking on Youtube for a video on replacing the pump but no luck. Looking for a video or instructions on replacing the pump? It looks fairly easy but you need to be a snake to gain access to the pump bolts.
View 9 RepliesFord 6.0L Power Stroke Diesel :: 2006 E350 Stalled While Driving Now Crank But Will Not Run
A friend brought to me this 06 E350 with a 6.0, which stalled on him while driving. The van will crank over good and strong, but won't run. It will how ever fire, and almost run until you let the key back (i would describe it as it does run with assistance from the starter). the FICM has 12V in and 47.5V out. And ICP is around 650 psi till it fires then it raises to 1215 psi. there are no codes either - I'm not familiar with these 6.0l...
View 13 RepliesFord 7.3L Power Stroke (1999-2003) :: E350 Diesel - 2nd Battery Won't Charging?
One of my batteries on my van is on the frame rail. The box rusted out so I routed the battery into the back of the van for now. The van wouldn't start because the batteries were low. I charged the battery in the front engine bay overnight but it did not charge the 2nd battery, does that mean there's a disconnect between the two batteries? I thought they were in parallel.
View 2 RepliesFord 6.0L Power Stroke Diesel :: How To Repair Broken Battery Cable For E350
When I dropped my 2 frame rail batteries I noticed the clamp on the positive battery cable was broke. How to splice in a new clamp?
Pick and pull is an option. I would rather repair my OEM cable and be done.
Ford 6.0L Power Stroke Diesel :: Oil Pressure Switch (Sending Unit) Location On E350
Will the oil pressure switch (sending unit) on my E series van be in the same location as on an F series truck even though the van's oil filter is under the engine instead of on top? I'm referring to the single wire sender for the dash gauge.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2006 E350 - Coolant Reservoir Has Crack / Leak
I bought a 2006 E350 with a 6.0L diesel. Has some issues I hope to work through, or failing that I'll ditch the thing and learn a lesson.
The pressurized coolant reservoir has a crack/leak in it. Is it wise to only replace it, or should I look for a root cause? The temp gauge does not go past 50% pulling hard up a mountain pass.
This was a fleet vehicle that was pretty much abandoned. There is a chance the reservoir was cannibalized for another rig and had the bad part thrown there but I'll never know.
Ford 6.0L Power Stroke Diesel :: 2005 - Won't Start When Hot
My 05 F350 will not start hot, occasionally stalls when hot as well. Starts immediately when cold and runs smooth as silk. Truck has 138k miles on it, I bought it studded and deleted, running 5w40 Rotella T6 with Archoil. Some history on the issue: Started out with a rough idle, found low FICM voltage along with a bad battery. Replaced both batteries and FICM, problem fixed. Soon after developed a misfire with a cyl 5 imbalance and injector code, replaced all 8 injectors which fixed that issue.
About 2 months ago I had a no start problem, turned out to be a bad ICP, replaced that and the harness and was all good for about 3 weeks. That's when it started becoming hard to start when the motor was warm, and then no start at all when hot and would stall occasionally at idle, wait an hour and it'll fire right up!
Ran the air leak test, found a leak on the right bank standpipe, replaced the dummy plugs and standpipes, no start still remained. Went on to replace the IPR and STC fitting which didn't work either. Now it throws a P2285 code, low ICP. Ran the air test again and I don't hear any leaks. HPOP seemed to have good compression turning by hand.
Ford 6.0L Power Stroke Diesel :: 2006 E350 Truck Started To Stall As RPMs Dropped
New here but long time lurker. I have a 2006 e350 with 6.0, bought it from a friend not long ago. The work that has been done to it the last 50,000 miles is as follows.. New hpop, all new injectors, egr delete, sct tuner, stand pipes and dummy plugs. I had it for a week and would get a no start hot once in a while. This issue had become worse and the truck started to stall as the RPMs dropped. Reading here i replaced crank sensor and the stalling stopped but the no start hot continued. I took it to a local diesel repair shop and they did the following..
Use a test ipr (no change), replaced ipr pigtail (was cracked) air test (leak under pass valve cover) replaced stand pipes and dummy plugs on this side. They said no leaks and I was good. Truck worked as its supposed to for 1 day and the no start hot issue reared its head again. Took it back and now they say the hpop is bad. The pump that was put in about 50,000 miles ago was a bostech? do these go out? Sangauge reads good ficm, but seams ipr doesn't climb that quick.
Ford 6.7L Power Stroke Diesel :: Low Fuel / Power Message Then Check Engine Light On
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.