Honda - Cr-v :: How To Get Throttle Plate Open To Clean Throttle Body
2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 RepliesFord 6.0L Power Stroke Diesel :: P0488 Code After Intake Elbow Install
Anyways, I've been doing a lot of work on my 6.0 2004 Ford Excursion lately, and recently installed my Sinister Diesel intercooler pipes and intake elbow, and had to remove my throttle body completely to do so. I know that the 2004 models throw codes when removed, and that's what I'm here for. Mine isn't dogged down and actually runs even smoother with my new piping and intake, but I want to get rid of this code.
Is there any tune out there that can erase it? For some reason my Edge Insight CTS2 sees the code, but my SCT X4 flash tuner doesn't see the P0488 code. I know people have discussed this topic several times, but after hours of reading through posts I never found any solution to this. All I need is a way to delete the code because I don't like having my CTS2 with a trouble code for something I did on purpose!
Ford 6.0L Power Stroke Diesel :: Rough Idle And Loping Upon Cold Start - P0488 Code
My '05 Excursion recently started having rough idle and some loping when started cold. It seems to run good and idles pretty good when it warms up. I'm also getting a P0488 code (EGR Throttle Control Circuit A Range/Performance). I do have a BPD EGR and I don't recall if that would throw a code alone? I'm taking a trip next week and want to get it straightened out. Does it sound like an EGR valve issue?
I also thought about a battery issue, I know that can cause weird problems. I have Duralast batteries and they always seem to fail at about 2-3 years. I took it in and they say it tested good but I'm not always sure with them. Long story, but when cranking for longer than normal, the cranking power would drop quite a bit. Checked battery and had some corrosion. Cleaned and upon further inspection, the positive post is a bit eroded at the base and sunken in. The voltage was about 12.35 after sitting all night, a couple of the cells were reading lower than the others (about 50%, other 75%) when checked specific gravity. I tested voltage after batteries had been in the truck overnight, then unhooked from truck when testing.
I also thought about a glow plug/harness issue. The truck cranks for awhile before starting, 5-6 seconds sometimes, but not all the time. It starts up pretty quickly when warm. That's been going on for some time. Anyway, I will try to get a video of the rough start after cools down.
Ford F-150 (2004-2008) :: 2006 - Rough Idle / Throttle Plate Had Lot Of Carbon
I recently bought a 2006 that idles rough, not real bad, but bad enough for me (and my 9 year old kid!) to notice. I asked the dealer where I bought it and they put it on the computer and said everything checked out. He said "it's a characteristic of this motor." I've never heard of such a thing. The truck has 27,000 miles on it and the dealer flushed the fuel system. He said the throttle plate had a lot of carbon on it, but it still idles rough... 4.6 idle rough?
View 13 RepliesFord F-150 (2004-2008) :: 2005 - Codes P0325 And P1000 - No Power When Throttle Is Pushed Hard
I have a 2005 F150 5.4 FX4 and I had these two codes thrown over the past week/few days...P0325 and P1000 (pictures below of descriptions...I have an edge programmer and have been running it on the highest setting for a while now but always run premium fuel. I got these codes and reset them and they came right back. I then reset the cpu to the factory programming and they still keep coming back. I still have premium in it and it seems like when you hammer it that it falls flat on its face! It runs good and pretty smooth but seems like it has no power when throttle is pushed hard. It seems like it has a small vibration at about 3,000 RPM but only for a few seconds and then smooths right back out again. The truck has 88,000 miles and I just put new Motorcraft plugs in it about 6,000 miles ago. Not sure what I should do or what is the next step.
Photo hosting sites ...
Image ru ...
Sonata NF (2006-10) :: Intake Manifold Pressure Decreases With Throttle Plate Opening At Idle?
I am checking my car parameters at idle. I was comparing the values of intake manifold pressure and vacuum. When I press accelerator or give gas means throttle plate opening my manifold pressure decreases and vacuum increases, I hear when throttle plate open more air come inside so manifold pressure must be increases and vacuum decreases. Am I right? if so which part will be culprit of this action?
View 3 RepliesGolf/GTI VI :: Foot Well / License Plate LEDs Throwing Error Codes?
Any LED I can throw in the footwells / license plate area that won't throw a code? I'm using the ones from superbrightleds.
They worked everywhere except the license plate and the footwells. Everytime I get in my car I have to see (check license plate lights!) and a bulb out icon.
Ford Ranger / B-Series :: 2003 - No Power / Cannot Give Throttle Or Bogs Real Bad
I have an 03 Ranger 4.0 4x4 5 speed. It has no power, can't give throttle or it bogs real bad. Baro shows 18in vac with KOEO. When running it has 15in vac. Replaced MAF, fuel pump, and fuel filter.
View 4 RepliesFord Ranger / B-Series :: 5R55E - Gasket Blowing Out Of Separator Plate
My buddy has a '98 B4000 4.0 4x4 Auto, and just recently he lost 4th gear for whatever reason. Which is strange, considering 5th gear still works, and OD requires direct (4th) to work.
So we're thinking its a valvebody problem, and apparently the gasket blowing out of the separator plate is a very common problem. So we decided we're going to drop the valvebody and inspect/replace the gasket.
Now I see that the they now bond the gaskets to the separator plate: What is the part number for this bonded plate?
I've also seen mentions of a TSB, and other mentions of an updated EPC solenoid. Looking for more info on this?
Golf V R32 :: How To Mount Front Plate In Holeless Grill In A 2 Plate State
For those people who received a holeless grill in a 2 plate state how did you mount your front plate. I am supposed to have the holeless grill installed this Wednesday. I was thinking about using zip ties and mount it underneath it's original location but I am afraid that I will be blocking the radiator. I could do it by the side grill.
View 24 RepliesFord Ranger / B-Series :: 1987 - Transmission Leak / Fluid Puking Out Inspection Plate Area
Dad gave me an 87 Ford ranger a couple weeks ago. I love it. Everything works except I'm having transmission leak issues when I drive her more than 30 miles or so.the symptom is fluid puking out inspection plate area. I checked coolant lines today and unfortunately they are working great. I've had a couple suggestions recommending replacement of the front seal our front pump seal (is there a difference?)
View 7 RepliesSanta Fe (DM - 2013+) :: Limp Mode - Error Code P0488
I have a Korean spec 2014 Hyundai Santa Fe 2.2L R-eVGT 6AT 4WD. Around a year ago it started to go into limp mode i had it checked and the error code was p0488 (EGR) Throttle Control Circuit A Range / Performance.
It has gradually become more frequent to the extent it goes into limp mode within a a minute or so . so far the dealer has changed the EGR valve, TCM , the whole turbo assembly and it is no different. They have also stripped and cleaned the intake manifold and egr cooler.
Golf/GTI VI :: 2009 - Codes Came On / Throttle Malfunction
I have a 2009 gti and been having some problems with my throttle. Few codes came up for the longest time on and off. So one day after work I started my car and it started just didn't idle high then quit on me so I decided to take it to a local dealer to have the throttle body adpt and it was fine for about a week. Then same codes came back on witch was my angle sensor 2 throttle and position sensor too. So I got a new throttle body been a month I've had no problems until today. It stalled on me so I scanned it and codes for my valve was malfunctioning.
View 1 RepliesFord Ranger / B-Series :: Throttle With A/C On?
I have a weird issue. When I'm running AC on my 2.3l ranger sometimes the idle wont go down but rather hold its current RPMs till i either turn the AC off or place the truck back in gear. What that could be?
View 6 RepliesVolvo :: No Power To Plate Lights Or Rear Wiper
No power to plate lights or rear wiper. Fuses appear O.K., electrical contacts to bulbs appear O.K.
View 1 RepliesFord Ranger / B-Series :: 1986 - Bogs Down When Put Into Throttle
1986 Ranger 2.3 inline 4
I just recently bought an 86 Ranger from a friend. It had recently stopped working and had no desire to fix it. So here I am. The truck will sit in park and rev all day long, once its in drive it idols fine and moves its self down the street. The problem occurs when I apply throttle. It begins to bog down and I cannot get past 20mph. I have replaced the fuel regulator and also I took the tank down and replaced the fuel pump. The fuel filter is two months old, and the throttle response sensor is two weeks old.
Lexus SC430 :: 2002 - From Where License Plate Lights Get Power
Where the license plate lights get thir power from? I have a 2002 SC430 and the plug is just dangling. It goes behind the plate and then if I look under the car, it is just there by the bumper and I cannot find a connector that it can reach.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Bed Plate Leaking?
looking at a 2006 180,000 miles in super condition except for a bed plate leak that was identified by a dealer and quoted $4200 to fix it. Owner elected to not fix.
Doesn't drip much at all, couple drops over the coarse of a day perhaps. What happens if you let this leak go?
F Series :: Code P2135 - Electronic Throttle Body Replacement
Throttle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not working with diagnosis. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. How to change the throttle body and reset the pcm to learn the new idle trims. [URL] .....
View 2 Replies