Elantra MD (2010-15) :: 2011 - Automatic Transmission Slipped
My automatic transmission slipped today. Really worried now. 2011 elantra with 36k on it. It was raining and I was turning right out of a shopping center. I floored it to beat the incoming traffic and the tranny slipped. It hasn't slipped since then and has been perfect so I know the dealer will say they can't replicate the problem. Should I be worried about this?
View 15 RepliesSonata I45 (YF - 2011+) :: Transmission Will Jerk / Buck Fairly Hard When Put Into Drive
I have a 2011 Hyundai Sonata limited with 68,000 miles on it. Once the car has been warmed up for awhile and I shift into drive after a stop, the transmission will jerk/buck fairly hard. It only does it while being put into drive and I haven't had any other issues while driving.
View 7 RepliesElantra XD (2001-06) :: Hesitate To Accelerate / Shift Hard And At Higher RPMs
So my girlfriend has an 04 elantra 2.0... the car will be running fine but then after so long of driving(maybe 15, 20mins) itll start acting strange..
It will hesitate to accelerate and shift hard and at higher rpms. Then at cruising speed it will turn off instantly(no sputter, hesitation, almost as if you just turned the key off). Seconds later the engine will come back but the gauges die and the engine will remain on.
At that point i pulled over and as i was on the brakes the car died when I came to a complete stop. Once the car completely turned off it would not start back up. However jump starting it got it going. The car is not throwing any codes.
Elantra MD (2010-15) :: Transmission Slips From Cold Start / Shifting Hard From 1st To 2nd Gears
I've had 2 Elantra 2012 models 1 a gls the second a limited. As far as transmission issues both Elantra's from a cold start after allowing RPM's to idle down before taking off they both have started shifting hard going from 1st to second gear 1st car was around 8-9 k miles now 2nd started at 3 k miles. Since owning 2 cars same make same year same transmission and many times to dealer 1st car ended with Transmission replaced 2nd has now started doing the same thing they reset adaptive and next day did it again its now back at dealer waiting for them to diagnose again.
View 13 RepliesFord - Escape :: 2010 - Hard To Start On Chilly Days / Hesitate On Turning Over
I have a 2010 which lately has been having difficulty starting on chilly days. That's saying something considering i live in Memphis, where the cold days are relatively mild. Sometimes it will hesitate on turning over, start and then my gauges flutter and the car shakes a little. Other times it makes a high pitched cranking noise. I haven't taken it anywhere yet because it seems to exclusively happen in the morning after the car has been sitting for 10 hours.
View 4 RepliesLexus GX 2004-09 :: GX470 Does Not Want To Reverse When Slipped Into Gear
For some reason when GX470 is parked, it does not want to reverse when slipped into gear. I have to apply a some pressure on the gas pedal and than it moves with a loud thud like noise, I have noticed it when the GX is parked for 24-36 hours.
We leave here in N-CAL and weather cant be an issue. Besides it always parked in the garage.
Escort :: 95 Manual Transmission / Clutch Never Slipped
95 Ford Escort 1.9L, 330,000 miles. Never changed the clutch and i bought it with 80k on it. With that said the clutch never slipped and a lot of this is highway mileage so i never saw a reason to change the clutch just because.
Last week i pulled into the driveway i depressed the clutch pedal as i normally do and as i slowed, the car bucked like it was still in gear and didn't recognize the clutch was depressed. When it started bucking i tried to pull the gear shifter to neutral but it wouldn't move, the car finally died in it's parking spot. I quickly popped the hood and had my son press the clutch in and out and all components seemed to be moving fine, i was mainly looking at the slave cylinder assuming since it's a hydraulic clutch if it was a hydraulic issue that wouldn't move if i didn't have hydraulic pressure.
No obvious leaks were noted, i looked at the master cylinder and it seemed a little low but not empty maybe just above min. I filled it to max and still no change. So i assumed it was the clutch finally disintegrated and locked up. Yesterday i got in the car to attempt to move it to the garage to work on it. It started up fine, shifted through all gears with no issue's, drove it around for about 15minutes shifting a lot and pressing the clutch randomly and it worked fine.
I brought it back home and tried to kill it a few more times before i got it to the garage, it finally locked again but it was in neutral and i couldn't get into any gear. Turned the car off and then restarted and it shifted into gear, i pulled it into the garage and stopped with no other issue's.
Checked closer for leaks, between master and slave and couldn't find any. Pulled speedo cable and checked trans fluid, its brownish red (more brownish) and thin but didn't really smell burnt and it is at the correct level. Linkage has some slop in it but i don't see it binding anywhere, i layed under the car and was able to move linkage in/out of gear with my hand. It's easy enough to say the clutch is well over due for changing but since there were no signs of a failing clutch when i drove it i think i need to look elsewhere.
Could it be worn fluid? Could it be debris in the line? Or could it be that the fork just isn't engaging or disengaging properly due to wear?
Elantra XD (2001-06) :: 2004 - Hard Jolt When Putting Into Reverse
My 04 elantra starting acting up yesterday. It has started jumping/ rocking entire car when putting in to reverse. What might cause this problem. It is hard to describe what it is doing being I know nothing about cars. It is a large jolt when going into reverse.
View 4 RepliesElantra XD (2001-06) :: Hard Shift When Put It In Reverse / Hesitates Quite A Bit To Accelerate
I have an 01 Elantra Gls with perplexing issues. The car starts at 3000 rpms, and continues to bounce between 2k and 3.5k in both park and neutral. when I put it in reverse i get a very hard shift. It actually jerks the whole car. in drive and reverse, it idles around 1.5k it hesitates quite a bit to accelerate. All fluid levels are right and don't smell burnt. it takes me 10 mins to put 4 gallons of gas in. if i pump too fast it shoots back at me. i randomly smell gas while driving. Im hoping these problems are a couple of issue I can handle at home. i just wanted some input before i buy the manual. thinking vacuum lines maf sensor.
View 7 RepliesSanta FE SM (2001-06) :: Auto Transmission Slipped Into Neutral
While driving the other day the automatic transmission in my 2003 Santa Fe slipped into neutral. I pushed the car home wherre it currently sits. I checked for error codes and found none. There is a grinding noise when I shift from any gear into park.
View 1 RepliesGolf/GTI VI :: Hard Shifting Into Reverse When Transmission Is Cold
Noticed that the transmission is cold (ie. sits overnight) it is hard, sometimes impossible, to shift into reverse. Specs on my gti: 14k miles, pretty much stock, manual trans...
View 1 RepliesHyundai - Elantra :: 2005 - Rally Hard To Move Gear Shift When Put Car Into Reverse
I have a 2005 Hyundai Elantra with approx 155,000 miles on it(I don't know if that matters). The car started ok at first. When I put it into reverse, I noticed that it was really hard to move the gear shift(which it's normally really easy). I put it back in park and let it sit for a minute thinking it just had to warm up a bit more.
When I tried it again, it was still hard to shift, but this time when it got into gear I heard a loud clunk. This scared me, so I put it back in park and turned off the car. Now it won't start. All of my lights(headlights, dashboard lights, radio) come on, but the engine won't turn over.
I don't know if any of the following is relevant but I'm putting it out here anyway just in case it is: The battery is only a year old(and since all my lights came on, I don't think it's dead)I had an oil change on Saturday. The belts were replaced a few months ago. My check engine light is on because of an O2 sensor.
Ford Transmission :: 1992 E350 - Trans Slipped And Lost Drive
Quick question. I have a 1992 Ford E-350 Box Truck and during a recent highway trip the transmission slipped and I lost Drive (3rd). The van drives fine in 1st, 2nd, reverse, and overdrive. When it's in D, it wont move at all from a stop. I'm able to get it in to overdrive by starting in 2nd, accelerating to about 35mph, then shifting it in to D. If I accelerate enough after shifting to D, I can usually get it to shift in to OD. The fluid is full and clean.
View 1 RepliesGolf/GTI VII :: Hesitate When Going From Reverse To Drive?
After reversing the car and coming to a stop to change to drive the car seems to bog down like the engine is dying or hesitating but then will pick back up and then start moving forward.
View 2 RepliesFord Excursion :: Transmission Leak / Hard Time When Try To Reverse
I've seen this talked about before and it's happened to me before as well but now the tranny is leaking onto my Ypipe a couple times per week and it's giving me a hard time when I try to reverse. revs drop and it stalls if I don't give it enough gas.
So I know I have to change the seal but Ford is telling me the torque converter will need to be replaced but another transmission shop told me once the seal is changed and fluid level set appropriately I shouldn't have the reversing problem anymore?
Is this something I could attempt myself... looks almost like I'd have to move the exhaust to drop the tranny...
Ford Transmission :: Hard Shift And Clunk When Shifting To Reverse
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 RepliesFord F-150 - 1997-2003 :: Transmission Slipped On A Shift - Codes P0713 / P0712
I was out driving in my 2003 F150. The transmission Slipped on a shift. I noticed the OD light is blinking. Transmission went into OD and drove fine. Pulled codes P0713 and P0712 transmission fluid temperature sensor. Made it home. An hour later tried to back out and now sounds like a grinding or rubbing sound. But it sounds like the sound is coming from the rear end. I am lost.
2003 F150 4.6L SuperCab....
Volkswagen :: Transmission - Grinding Noises From Transfer / No Reverse And Hard To Shift
I have a 97 jetta trek that is having problems. Grinding noises from transfer , no reverse, hard to shift, loud winding noise. I think it's may be the trough out baring thing from what I'm reading.
View 6 RepliesToyota - Sequoia :: 2001 - Transmission Slipped When Accelerated From A Stop Off The Highway Exit Ramp
Yesterday my transmission slipped as I accelerated from a stop off the highway exit ramp. It grabbed almost immediately and no problems till I got to my destination about 2 miles down the road.......fluid was dripping from the underneath the engine......reddish/pink fluid. Engine was not over heated (according to the gauge). Pulled car off driveway and down the road a bit and transmission was really slipping when trying to accelerate quickly (no issue with slow acceleration). Checked transmission fluid and it was not covering the stick. I thought maybe I burst a transmission coolant line but upon inspection no fluid on that.
So I added 1 quart of transmission fluid this morning and started the car to hope to find the leak. No immediate leaking the transmission case, seals or lines. But I did notice that when I started the car the coolant reservoir was "bubbling". After about 5 minutes to allow the engine to warm and the coolant gauge to come to normal operating range I noticed coolant reservoir/overfill spewing out a pinkish foamy fluid and then checking the transmission fluid level it was drained again (no fluid on stick when running). One last fact....the fluid temp coming from the overflow was cold, so was the radiator fluid after I popped off the radiator cap.....but the dashboard temperature coolant gauge was at the mid point/normal operating temperature of the scale.
So my question is......where do I take the car to have it looked at......a transmission shop, or a typical full service mechanic? Is the transmission fluid co-mingling with the coolant fluid and if so how does that happen?