Dodge - Dakota :: 1991 - Slight Lack Of Acceleration
I have a 1991 DODGE Dakota V6 3.9L FI with a TorqueFlite TF-6 A-500 4 speed RWD Automatic Transmission. Now, this truck is amazing and so is this transmission. It's been going for 22 years and about 400,000 miles and the bands in the tranny have never been replaced...EVER. The fluid filter has been replaced, once. Anyway...it's amazing, I mean the thing is still going strong after all this time and such low maintenance.
Anyway, I noticed a slight lack of acceleration, so as usual for an old automatic, I figured the bands might be slipping a bit. So I dug up the torque specs for it and performed the adjustments. Now, this is the funny part and I was not at all surprised to discover this. In fact, I'd had the hunch the entire time. I discovered that the bands are so old that they no longer respond properly to the recommended torque specs, so I had to guess work them. I did a bit of careful fiddling as I know just about everything there is to know about automatics and I understand perfectly the damage that can be caused when under/overtightening bands.
Anyway, I did some fiddling and got some interesting results that actually made me laugh to be honest, but I knew at first I wasn't quite doing it right. First gear was all right, but second kicked in a little late, and I felt a slip when third came around. So, I decided it was time for a moment of truth. What I ultimately ended up doing was tightening the bands to the recommended torque (in this case 72 inch lbs) and then slowly backing them off until I felt them let go, Then I put the proper torque on the locknuts (in this case 30 ft lbs).
Now, this tranny has two bands and a clutch pack, it has the low-reverse (rear) band, and the Kickdown(forward) band, and I believe the clutch pack is used to engage 3rd gear, because the rear band gives you 1st and rev, and the kickdown band gives you 2nd. After my ultimate adjustments, the kickdown band DID drag just a little for about a minute, but she quickly worked herself into a state where she's shifting better and accelerating better than she ever has before.
I'm amazed by this thing. I'm wondering if the kickdown band lets off when you hit 3rd gear? I know that when I feel the first kick, it's the KD band grabbing the front drum, which gives me second, but I'm wondering if it pulls simultaneously as third gear kicks in, or whether it stays tight against the drum?
Dodge - Dakota - Transmissions :: 1991 Truck Will Go Into Reverse But Will Not Go Into Drive Or Any Of Other Gears
The truck will go into reverse, but will not go into drive or any of the other gears. When shifted into one of those gears, it just idles as though in neutral. This started as I was driving down the highway at approximate 70mph. The speedometer jumped up then fell to zero as the car slowed to a stop. There was no noise except the sound of rapid fuel intake and then it went to idling. I have been told it may be a speed sensor, but I was wondering if there was anyway to confirm that before I have the truck towed down to a mechanic and find out its more than I want to pay to fix it.
View 1 RepliesFord - Escape :: Secondary Air Relief Solenoid Circuit Malfunction
I have a 2010 Ford Escape. The engine light came on about 10 days ago. I ordered a OBD which arrived the day that the engine light went out (two days ago...) Anyway, the OBD showed a P1490, which, according to google means Secondary Air Relief Solenoid Circuit Malfunction.
View 3 RepliesCamry :: Engine Code P0741 - Torque Converter Clutch Circuit Solenoid
How can I fix the P0741 engine code? Vehicle has 100k mileage.
Some of the on and off symptoms: loss of power, doesn't go over 40mph on the bridge, rpm dramatically goes high at low speed, lower mpg.
I did a tune-up: [URL] .... 2Bplugs, engine, coolant, [URL] .... 2Bfluid, steering, ignition coils, short ram intake filter cleaned.
Eclipse - Mitsubishi :: 2000 - Fault Codes For Shift Solenoid And Sensor A Circuit
I found the fault codes, I need the steps to fix them.
P0760 - Shift Solenoid,
CP0755 - Shift Solenoid
BP0340 - Camshaft piston sensor "A" Circuit
P0335 - Crankshaft Position Sensor A Circuit
I'd like to think it's as easy as replacing the sensors, but it never is.
Ford Super Duty (1999-2016) :: P1747 Code - EPC Solenoid Short Circuit
I have a f350 2000 4x4 automatic 170.000 miles. Service light on and OD light flashing. I have code p1747 "EPC solenoid short circuit"
This code make that the engine runs slow without power and hard shifting. I change all the solenoid body and check all wiring.
Later using a voltmeter i separate EPC solenoid wiring and see that have 5 volt. If I don't accelerate more 2000rpm OD light is not flashing and truck works normal but slow.
When I accelerate more than 2000rpm OD light begin to flash and transmission fail more. I check that EPC wires mark about 0 volts when OD light is flashing. Transmission hydraulic system seems to be ok because oil is very red and clean. Maybe another sensor is making this failure....
Ford - Explorer :: 1999 - Code P1451 EVAP System Canister Vent Solenoid Circuit Malfunction
I have a 1999 Ford Explorer with the V-6 SOHC that is stuttering and stalling when I try to accelerate. A very slight acceleration will get the vehicle moving, but anything coming close to normal gas pedal pressure causes immediate stuttering and/or stalling. Check Engine light came on when problem started yesterday.
Where is the EVAP System Canister Vent Solenoid? I bought a code reader after beating my head against the truck all afternoon and got code "P1451 EVAP System Canister Vent Solenoid Circuit Malfunction". My Haynes book says on the left side frame rail... can't find anything along there that looks like it (based on picture from Rock Auto for replacement part) and found some people online talking about it being in the engine compartment on the passenger side...
Just crawled all over the truck and I think I found the charcoal canister, but couldn't trace it back to the vent solenoid... There was something right next to the canister, but again, it looked nothing like the replacement part listed on Rock Auto...
Ford Super Duty (1999-2016) :: 2000 F250 - Code P1746 - EPC Solenoid / Open Circuit
I have a 4r100 in my 2000 f250 7.3. I am getting a P1746-EPC Solenoid, open circuit. Does this mean this particular solenoid in the solenoid body has failed and should i replace the solenoid body?
View 3 RepliesFord Wiring/Electrical :: P1451 Code - EVAP Control System Canister Vent Solenoid Circuit Malfunction
I'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
Dodge Dakota :: V8 Turns Over But Won't Fire
97 Dodge Dakota Sport V8. Has spark, turns over, won't fire.
View 1 RepliesDodge - Dakota :: 2001 / 3.9L - Start And Run For A While And Will Die
My dad has a 2001 Dodge Dakota extended cab with a 3.9L v6 (standard transmission). It will start and run for a while and it will die, if you turn the key it will start up again but will eventually die. He has changed the spark plugs & wires, the distributor cap & rotor, the MAP sensor, and the throttle valve sensor. It still does the same thing.
View 1 RepliesDodge - Dakota :: Oil Light On After Start Up
So, my oil light comes on after startup like usual then shuts off. Anywhere from 2-5 minutes of the vehicle running light comes back on and does not shut off unless I restart the vehicle. Have changed oil pressure switch and oil pressure is reading in the normal range..
05 dakota with 175000 kilometres
Dakota :: No Air Coming Out Of Floor Vents When Switch To Heater
Would the control on dash cause there to be no air coming out heater vents on floor. I can hear the blower very loudly in dash about in the middle air comes out dash vents and out defroster ducts. When you switch to heater you get blower noise but very little air coming out floor vents.is it the control or possibly a vacuum mother on a vent somewhere
View 3 RepliesDakota :: 1999 Dodge Engine Idling At 2K RPM
1999 Dodge Dakota
3.6 liter w/air conditioning
I'm pretty sure I made a mess of things. My Serpentine belt was all cracked and making noises while idling and driving. It was time to replace it. It's a long story, but my auto mechanic told me to drive my truck for a week and then give him a call. Well.... I didn't do that. My battery went dead and I charged it up and it lasted a month. Yesterday, it wouldn't start so I bought a Serpentine belt and installed it. As far as I know, I didn't damage anything while I was working on it.
The battery was still dead and I charged it, however, the key was turned on while I was charging it. I don't know how I did that, but I did.
The problem I'm having is that the engine is now idling at 2000 RPM. I scanned it and there are no codes or pending codes.
Today, I went out and drew a diagram of how the belt is routed and it's the same as the diagram under the hood. I had a friend take a look at it and he agrees that I put it on correctly.
Dodge - Dakota :: 1996 3.9 - Stalling And Backfiring?
I have had this truck in 3 different shops and none of them could figure it out. The codes say misfire in cyl 2 and 5 bank 1 too lean and primary and secondary circuits malfunctioning for ignition coil. I've replaced the ign coil cap, plugs,plug wires, rotor, pcv, fuel pump, pick up coil, cat, o2 sensors and all sensors under the hood. Switched out all vacuum lines, cleaned the IAC and checked the pulse ring. The truck loses all power and either dies or backfires and regains power randomly. If I drive at night, it will stall and keep cranking when trying to restart. Usually have to let it sit for ten minutes for it to turn back over. Last night it backfired and stalled every 50 ft for over a mile. During the day, it revs up and down at idle by about 100 rpms.
View 6 RepliesDodge - Dakota :: 2002 - Stuck In Park
Have a 2002 Dodge Dakota automatic. This winter when temps. dropped into lows 10s and zero degree weather, the Dodge truck would start,but would not come out of park gear. Have replaced interlock solenoid and brake light switch. Still have same problem when Temperature drops into low 10s &below. Otherwise,everything ok. (not using ER brake).
View 5 RepliesDodge - Dakota :: 2003 - Radio Is Static - Won't Come On
I have a 2003 Dodge Dakota. A couple of years ago I was driving along and the radio just cut out, with no problems prior. I didn't go over train tracks or anything that would jar it, etc. It continued to not work for the next 6-8 months or so, but would occasionally cut in and out. After a period of time the radio suddenly began working again. The radio continued to work for a year or more. A month ago, I'm driving down the road and it again, cuts out. But now I can somewhat hear the radio amid the static. The best way to describe it is what happens to the reception when traveling under high voltage wires. Antenna is secure.
View 1 RepliesDodge - Dakota :: Will Not Start But Cranks / Turns
I have a 2002 Dakota 5.9l r/t. Always started and ran fine. It sat most of the winter approx 2 months. Now will not start but cranks/turns. Has new battery, newer full tune up and tried starting fluid.
View 2 RepliesDodge - Suspension - Dakota :: 2002 - Headlights Won't Come On
The parking lights come on, the turn signal lights work, the interior lights and high beams work. Could it just be a fuse or two? Dodge Dakota 4WD 2002 ...
View 3 Replies