Corolla / Matrix 2009-13 :: 2010 Does Code P0037 Is For Bank 1 Sensor 2 Oxygen Sensor?
I have a 2010 Toyota Corolla 1.8L, the base model.
I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.
Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?
Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?
Corolla / Matrix 2009-13 :: Drive Line Whine At Highway Speed
I have a 2009 Corolla (smaller 4 cyl) with auto trans. at 101K miles. I have a whine at hwy speed when the drive line is unloaded. What I mean unloaded is there is no acceleration or deceleration. The whine does not change pitch or level with speed.
View 1 RepliesCorolla / Matrix 2009-13 :: Oil Leaking At Or Near Pressure Sensor
I am looking at a 2013 S 1.8 with 38k miles... it seems to have oil leaking at or near what looks like the oil pressure sensor, but i have struck out finding a picture of one in place on the engine.
The oil stain is above and behind the harmonic balancer at a sensor that sticks straight out towards the firewall and looks like the oil pressure sensor.
The engine has not been washed and there are no other stains above it. I am more than capable of changing the sensor... if that is what it is. Is this a cause for concern?
Corolla / Matrix 2009-13 :: How To Change The Rear Bank Oxygen Sensor
My engine light just went on and the fault codes are:
P0138 -PowerTrain (O2 Sensor Circuit High Voltage Bank 1 Sensor 2)
P0607 - PowerTrain Control Module Performance
I have just bought Denso 234-4305 Rear Sensor but I was wondering if there are any guides to show where it's located?
The only guides I found is for the 9th Gen Corolla.
The Car has 88k miles on it so I guess it's outside the emissions warranty. Thus what is the price of a new ECU just in case that's the problem?
Corolla / Matrix 2009-13 :: 2011 LE - Bolt Above Oil Filter And Near Sensor Is Leaking
I am having trouble figuring out what a nut on my 2011 Corolla LE is called, so I am having alot of trouble looking up a solution on my own. There is a bolt above the oil filter and near a sensor that is leaking. I marked it in red in the below picture. I am having trouble looking up what to do without knowing enough about it to search.
View 5 RepliesCorolla / Matrix 2009-13 :: Engine Light For Air Fuel Sensor Code
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
Corolla / Matrix 2009-13 :: Got P2195 / P0031 Obd Codes - Replace Both Sensor?
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?
Corolla / Matrix 2009-13 :: Tire Pressure Sensor Part Number For 2011?
What is the part number to the TPMS sensors for a 2011 Corolla S. Or any stock toyota ones that will work?
View 2 RepliesCorolla / Matrix 2009-13 :: P0500 Code - Vehicle Speed Sensor Malfunction
My car is now 24/7 with this error which is Vehicle Speed Sensor malfunction an there seems to be no way of solving it, symptoms are:
*Speedometer not working, needle always in 0
*Power steering not working
*Car wont past 3rd gear
*Check engine light and power steering light on
I checked all 4 speed sensors and the wiring looks good and they look good. Also if i hit a bump, issue goes away for a couple of minutes, until i hit another, etc, so looks like a wire or short circuit, cant tell. Is there a speed sensor on the transmission as well? where is located?
Corolla / Matrix 2009-13 :: Toyota Vibe 2.4l 2AZ-FE - Coolant Leakage Around Temperature Sensor
My '09 2.4L Vibe has started to leak coolant around the coolant temperature sensor. It seems rather odd to me.
Who makes the OEM model? It shows as GM Part 88975489.
Corolla / Matrix 2009-13 :: ABS And E-Brake Light Go On Randomly
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 RepliesCorolla / Matrix 2009-13 :: Brake Reservoir Cap Popped On
Our brake reservoir cap is rubber, and just pops on. There's a little top hat on top of that that plugs the tiny little breather in the actual cap. I lost mind down in the depths of the engine bay.
View 2 RepliesCorolla / Matrix 2009-13 :: Shakes When Brake On The Freeway
I have an 09 corolla S with 119000 miles.
My car shakes when i brake on the freeway and I just got new tires so Im sure it must be the rotors.
Is it better to just get new rotors or have a shop machine the old ones down.
Which way is more cost effective?? and how hard would it be to install them myself?
Corolla / Matrix 2009-13 :: Brake Pedal Working On Low Position
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 RepliesCorolla / Matrix 2009-13 :: Rear Brake Making Noise
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 RepliesCorolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Corolla / Matrix 2009-13 :: How Good Is Ceramic Brake Pads
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
Corolla / Matrix 2009-13 :: Squealing And Screeching When Brake In Reverse
So I have a 2010 corolla s with 30k miles. I replaced my rotors and pads about 2 weeks ago to get rid of this problem. The problem was gone for a week and now it's back. I get tons of squealing and screeching when I brake in reverse.
View 5 RepliesCorolla / Matrix 2009-13 :: Intermittent Front Brake Squealing
Basically, whenever I brake, my front brakes squeal. But they only do this if I use about 25% to 33% force. If I press on the pedal harder, the squealing goes away and the same if I reduce the force.
I replaced my pads with Wagner ThermoQuiet pads in March 2015. The noise started a month or 2 after replacing my pads, and I've only put about 12k miles on them. I had my car in a couple weeks ago for an oil change, and the inspection showed that the pads still had plenty of life on them. I brought it up to the service advisor, and he suggested that my rotors might be warped and need to be machined. The problem with that is I feel absolutely no vibration in my brake pedal that would indicate warpage.
So the only other thing I can think of is the shims might be causing the noise. I was going to get some grease and apply that and see if it works. Also, when I was replacing the pads I bled out a little more brake fluid than I intended. But it hasn't seemed to affect my braking ability so I ruled that out.
Any guesses for what might cause this? Like I said, I have plenty of material left on the pads and I can stop without problems, so it's not a safety issue, just a tad annoying.