Corolla / Matrix 2009-13 :: Squealing And Screeching When Brake In Reverse
So I have a 2010 corolla s with 30k miles. I replaced my rotors and pads about 2 weeks ago to get rid of this problem. The problem was gone for a week and now it's back. I get tons of squealing and screeching when I brake in reverse.
View 5 RepliesCorolla / Matrix 2009-13 :: Uneven Brake Pad Wear About 50% More Than Passenger In Front
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 RepliesCorolla / Matrix 2009-13 :: Squealing At Startup - Timing Belt?
So I just traded my old car in for this one and I've had it maybe a little over a month. Anyways, when I go to start it now, even if I just turn on the main power and let the radio start up and the computer and then turn the engine. When it turns, majority of the time it will "squeal" like there something might be going wrong with a belt in there. I know that the timing belt should be changed once every so many miles, just not so sure on my vehicle. Also, if it could be anything else besides that.
View 1 RepliesCorolla / Matrix 2009-13 :: 06 LE Squealing Sound Whenever Brakes Applied
I bought my 06 Corolla LE last week and just started hearing a nasty squeaking sound whenever I applied the brakes. I took it to the dealer today and 4 hours later he calls me and tells me that he had to readjust my back brakes and lube them up and it should be fine..About a half hour into driving the car around town I start hearing this noise again. Now he's telling me to bring back in the morning to see what the issue is.
My question is besides the brake pads and rotors which were checked by another mechanic that said they were good what the hell could be the issue?
Corolla / Matrix 2009-13 :: Intermittent P0352 Code And Misfire
2009 1.8 Corolla . I'm chasing an intermittent P0352 code and misfire. Code points to coil pack #2 . Question is, which one is #2 ? I want to swap coils and see if the error follows the coil but I can figure out which cylinder is #2 and since all of the coil wires disappear into a loom, I'm not sure how else to tell.
View 2 RepliesCorolla / Matrix 2009-13 :: 2010 - Intermittent Low Idle When Warm After Rain
I have a 2010 corolla with 32k miles, automatic transmission. I have an intermittent low idle issue when it rained or when it is below freezing 32F. It happens when I am in drive and about to brake to a complete stop. The idle dips to around 500 rpm, the engine shudders and the car shakes then after a second or two, the engine idle goes back up to 800 rpm. There is no engine concerns at any other speed just at idle. I have no CEL codes. The engine never stalls. Low idle when braking.
View 1 RepliesCorolla / Matrix 2009-13 :: ABS And E-Brake Light Go On Randomly
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 RepliesCorolla / Matrix 2009-13 :: Brake Reservoir Cap Popped On
Our brake reservoir cap is rubber, and just pops on. There's a little top hat on top of that that plugs the tiny little breather in the actual cap. I lost mind down in the depths of the engine bay.
View 2 RepliesCorolla / Matrix 2009-13 :: Shakes When Brake On The Freeway
I have an 09 corolla S with 119000 miles.
My car shakes when i brake on the freeway and I just got new tires so Im sure it must be the rotors.
Is it better to just get new rotors or have a shop machine the old ones down.
Which way is more cost effective?? and how hard would it be to install them myself?
Corolla / Matrix 2009-13 :: Brake Pedal Working On Low Position
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 RepliesCorolla / Matrix 2009-13 :: Rear Brake Making Noise
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 RepliesCorolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Corolla / Matrix 2009-13 :: How Good Is Ceramic Brake Pads
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
Corolla / Matrix 2009-13 :: ABS / Traction Control / VSC Off Flashing - Brake Went On
My Abs traction control vsc off (keeps flashing) and brake light went on in my 2010 corolla....
View 2 RepliesCorolla / Matrix 2009-13 :: Front End Rumbling / Vibration Around 20 - 25 Mph
Recently purchased my first Toyota, a 2012 Corolla S with 76,000 miles on the ODO. I have a concern about a front end rumbling.
First, the problem...
This "rumble" (the best way I can describe it) starts becoming noticeable around 20-25 mph, depending on the condition of the road I'm on (it could be lower, but I'm in Michigan, all the roads are bad here). This rumble isn't a noise, but more of a low frequency sensation that can be felt in the car and through the steering wheel, and vibrates the rear view mirror. The rumble comes and goes, it isn't constant. Sort of like driving over a rumble strips put on roads before stop signs/intersections, it seems to have an oscillation to it. The rumble intensifies very little with speed. It doesn't seem to oscillate any faster or rumble much harder, it's just there.
Things I've ruled out...
Brakes. When I bought the car, the first thing I noticed was that the front brake rotors were slightly warped, so I installed new rotors and good pads. That didn't get rid of the problem, though I didn't really expect it to.
Tires. The previous owner had seriously over-inflated these tires. Once taken down to their proper pressure, they were noticeably cupped down the middle. These tires were also horribly noisy would not balance, so brand new tires went on (Michelins). The new tires greatly improved the ride, reduced noise, and got rid of a lot of other shakes and vibrations, but the "rumble" remains.
Wheel Bearings. I'm not 100% on this one, but as far as I can tell, it's not the wheel bearings. I've taken the car out on twisty roads and there is no change in the rumble through hard turns, nor any additional vibrations of any kind. Usually bad wheel bearings will exhibit some noise or vibration when being loaded in a turn, but not in this case, so I've ruled them out.
Things I'm not sure about...
CV Joints. I've never had a CV joint go bad or fail on me, so I am unfamiliar with the common signs and symptoms. I have inspected the boots, and they appear to be in good condition and crack free, though that doesn't mean a joint isn't failing. There's no clicking during slow sharp turns, but I think that would only present itself if an outer joint was failing. I'm going to get the car in the air this weekend to do a drain and fill on the tranny (the fluid is getting pretty dark, so I want to get some new in there).
I drove a Ford Focus for the past 10 years and a Ford Contour for 10 years before that, putting over 200,000 miles on both, and never experienced any sort of problem like this.
Corolla / Matrix 2009-13 :: Replacing Both Front CV Axles
My Axles started to make noises couple months ago While making Sharp turns. I bought some new axles for the front, but this will be my first time replacing CV Axles.
Any tips and or recommendations on what to do and not do, and tools to use? I watched a couple Youtube videos already. I plan on changing them out this weekend.
Corolla / Matrix 2009-13 :: Click In Front Wheel?
There Is a click in my front wheels that is audible as I slow down. What is going on. nothing else is wrong with the car. I have a 2013 corolla le....
View 3 RepliesCorolla / Matrix 2009-13 :: Rear Brake On Driver Side Squeaking
My 2009 Toyota Corolla LE is squeaking. The noise is coming from its rear break -- driver side. It happens only at a low speed when pressing the brake half way to slow down the car until it stops. Only 60-70% of the time though that it has the noise and only when going slow in the traffic and hit the brake. It doesn't seem to squeak on the highway.
The car has about 40k miles. I've heard that the rear brakes suppose to last ~100k miles. My questions and concerns are:
1. Is it too soon to replace rear drum breaks?
2. How to check the rear break pads to see if I really need to change them?
3. Are they just dirty? How to clean the rear breaks?
4. Finally, if I really need to replace them, how much does it cost in general?
I wish they were dish brakes -- so much easier to replace them.
Corolla / Matrix 2009-13 :: How To Attach Brake Line Or Abs Sensor It Rubs
i have Ksport kontrol pros and no mattter how i attach the brake line or abs sensor it rubs! how to rout them. i bought 3/8 heater hose for the brake line and spliced it to make a sleeve. sway bar endlinks used to pinch the ABS against the coilover but now it rubs the cv axle. 09 rolla s
View 2 Replies