Corolla / Matrix 2009-13 :: 2010 Does Code P0037 Is For Bank 1 Sensor 2 Oxygen Sensor?
I have a 2010 Toyota Corolla 1.8L, the base model.
I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.
Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?
Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?
Mitsubishi - Mirage :: 1998 - CEL Codes For Fuel Trim Bank / Oxygen Sensor Bank 1 Sensor 2 And Cylinder 1 Misfire
I own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....
Ford 6.7L Power Stroke Diesel :: 2015 F550 - CEL Code Oxygen Sensor Performance Bank One Sensor One
The service truck threw a CEL, and i pulled oxygen sensor performance bank one sensor one code. That would be driver side sensor between the manifold and cat, rite? Don't want to change the wrong one...
View 11 RepliesFord Super Duty (1999-2016) :: 2008 F250 V10 - Bank 2 Sensor 2 Oxygen Sensor Is Faulty
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesCorolla / Matrix 2009-13 :: Oil Change Intervals?
I have a 2013 Corolla with full synthetic (0W-20). The dealer states this type of oil is only changed every 10k miles. I'm used to changing my oil every 3500-5000 mi. I'm not too keen on their recommendations but $70 for an oil change outside of the Toyota Care package is a little steep.
View 14 RepliesCorolla / Matrix 2009-13 :: Change Coolant In Toyota 1.8L
I am going to change the coolant in my 2009 corolla 1.8L. The service manual instructions tell me to open the "cylinder block drain cock plug" and I can't find it. The picture in the manual is not very clear, but it points to a spot on the engine just above the throttle body.
View 9 RepliesCorolla / Matrix 2009-13 :: Change / Clean PCV Valve?
I have an '09 with 138k miles on it, I was wondering where the PCV Valve is on the 10th gen, and how to remove it to either replace or clean it?
View 11 RepliesCorolla / Matrix 2009-13 :: How To Change Front Door Speaker
Speaker brackets and bracket preparation.
View 2 RepliesCorolla / Matrix 2009-13 :: Can Change Mileage Read Out To MPG Instead Of L/100km?
Is it possible on my new 2012 to change the mileage read out to mpg instead of L/100km?
View 5 RepliesCorolla / Matrix 2009-13 :: How To Change Drum Brakes To Disc
I bought a 2012 Corolla S and I feel that the rear brakes are a little cheap. Has swapping brakes but how?
View 3 RepliesCorolla / Matrix 2009-13 :: 2.4 Battery Change / Rough Idle
I changed the battery this morning in my 2009 Pontiac Vibe GT with the 2.4 and ended up with a rough idle. I was not having any of these issues before the change. How to adapt the throttle body?
View 2 RepliesCorolla / Matrix 2009-13 :: Oil Leaking At Or Near Pressure Sensor
I am looking at a 2013 S 1.8 with 38k miles... it seems to have oil leaking at or near what looks like the oil pressure sensor, but i have struck out finding a picture of one in place on the engine.
The oil stain is above and behind the harmonic balancer at a sensor that sticks straight out towards the firewall and looks like the oil pressure sensor.
The engine has not been washed and there are no other stains above it. I am more than capable of changing the sensor... if that is what it is. Is this a cause for concern?
Corolla / Matrix 2009-13 :: Maintenance Light Is Flashing After Start Up - Just Got Oil Change
I just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 RepliesCorolla / Matrix 2009-13 :: Airbag Removal To Change Steering Wheel Lights
I'm trying to remove the airbag so I can get to the steering wheel lights to change them. I took the covers off of each side of the steering wheel, expecting to find T30 torx screws to take off so that I can remove the airbag, but there seem to be no screws at all holding it in! Am I missing something here? Will have pictures in a couple minutes.
Not sure why my pictures aren't working, here are the links :
[URL] ....
[URL] ....
Corolla / Matrix 2009-13 :: Check Engine Light On (Code P0353) After Oil Change
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
Corolla / Matrix 2009-13 :: How To Attach Brake Line Or Abs Sensor It Rubs
i have Ksport kontrol pros and no mattter how i attach the brake line or abs sensor it rubs! how to rout them. i bought 3/8 heater hose for the brake line and spliced it to make a sleeve. sway bar endlinks used to pinch the ABS against the coilover but now it rubs the cv axle. 09 rolla s
View 2 RepliesCorolla / Matrix 2009-13 :: 2011 LE - Bolt Above Oil Filter And Near Sensor Is Leaking
I am having trouble figuring out what a nut on my 2011 Corolla LE is called, so I am having alot of trouble looking up a solution on my own. There is a bolt above the oil filter and near a sensor that is leaking. I marked it in red in the below picture. I am having trouble looking up what to do without knowing enough about it to search.
View 5 RepliesCorolla / Matrix 2009-13 :: Engine Light For Air Fuel Sensor Code
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
Corolla / Matrix 2009-13 :: Got P2195 / P0031 Obd Codes - Replace Both Sensor?
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?