Malibu - Chevrolet :: Grinding / Squealing After Brakes Applied?
Here's my issue, after a full break job my right front brake began to grind. Curiously it wouldn't grind initially after breaking soon after start up. I could go on and slow break for quite a distance, but soon after a hard brake or just slow breaking long enough the grinding begins. I've taken the car back to Firestone three times and even after a few adjustments or cleaning the problem persist... I've starting to feel bad for Firestone and embarrassed to be holding on to this 99 Chevy. I can't continue to drive this small car that sounds like a MTA bus while braking.
But I digress... I did notice, purely by accident (or it may be a mere coincidence), a few times the ABS light came on and during those periods the grinding was less abrasive. This leads me closer to believing the issue is with the caliper.
Malibu - Chevrolet :: Clunking Noise - Steering Failure
After a little less than a week of clunking noises the steering on my daughters 2004 Malibu completely failed. The steering wheel moves the steering column, but not the tires. NHTSA has done 2 investigations and issued 8 TSB's on the steering system, but no recall. My question is if there is a way to determine if it is the rack and pinion system or the power steering control module. It seems many people have replaced multiple components on their cars without resolving steering problems. I am hoping to avoid that...
View 2 RepliesChevrolet - Malibu :: Noise Always Coming From Brakes
I heard some noise which seems coming from the brakes. But the noise is always there even when I do not apply the brakes. I think if the noise relates to the brakes or the pads, there should be no noise until I apply the brakes, am I right? My car: Chevy Malibu, 1999. The brake light is not on.
View 1 RepliesHyundai - Sonata :: 2008 - Noise When Turning With Brakes Applied
I have 2008 Hyundai Sonata. I hear some noise from front wheels when i turn to right or left with breaks applied. There is no any noise when turning without break. the cv joint has been replaced but no any result. Still there is noise.
View 8 RepliesChevrolet - Malibu :: Front Brakes Began Squealing
2009 Malibu had normal brake replacements. Front brakes began squealing. Mechanic said there was a lot of dirt, cleaned. Still squealing. Claiming that the brakes were getting hot due to weather. Well now it is cool still squealing. He said brakes are in real good shape. Why are they squealing.......... never had this problem before. He said they don't make the brakes like they use to, ok to drive because brakes are in good shape......I don't understand.
View 6 RepliesSubaru - Brakes - Steering - Outback :: 2008 - Whining Noise In Engine / Clunking While Turning?
My outback has 57k miles on it and already needs the front struts and rack replaced (diagnosed today at the Subaru dealership). The car has been making a whining noise in the engine and has been clunking when making turns for the past week. I have also noticed it hasn't been taking bumps as smoothly. They told me that both ends of the rack are leaking and both front struts are leaking. My husband did admit to hitting the curb on the driver side front tire pretty hard while making a u-turn about a month ago, but all other driving is pretty standard. Yes, we drive on dirt roads in the mountains a few times a year for hiking, but don't drive in a manner that I consider wrong. Did the u-turn incident cause this? (hard to believe that would affect both sides of the rack and struts).
View 2 RepliesMalibu - Chevrolet :: 2007 - Shimmy And Shake When Step On Brakes
My 2007 4 cyl. Malibu does a shimmy and shake when I step on the brakes. It seems to be worse when traveling at a faster rate of speed then when driving around town.
View 7 RepliesPassat (B6) :: 2008 - Grinding Sound When Brakes Applied
2008 Passat Komfort Wagon with 34,500 miles. Started to get grinding sound when I applied brakes, which diminishes as I drive. Thought it was rust, but sound is very loud and sounds just like pads are gone and digging into rotors. The brake warning light is not on.
Dealer told me rear caliper was closing unevenly and recommended service---not covered by warranty of course. When I picked-up car same noise as before. The service manager told be that the car was just washed and the rust built up in the last hour---I could believe some built-up, but the sounds made my teeth ache. When we went for a test drive the noise got quiter, but was still apparent. The SM told me this is a "normal" noise. I have had many cars with disc brakes, dating back to a 1960 Jaguar; none have made this "normal" sound.
Chevrolet - Trailblazer :: 2008 - Braking Sounds Like When Stop On Ice And ABS Applied
Recently had my brakes/rotors replaced on my 2008 chevy trailblazer. the problem is when slowing down to almost stopping the brakes sound like when you stop on ice and the ABS applies..The vehicle stops..but concerned what that feeling and noise is..After applying the gas it sounds like something is stuck? Occasionally my traction control light goes on?
View 9 RepliesLexus GS 2006-11 :: 2008 E-Brake Loose - Car Not Stopping When Brakes Applied
My 2008 gs 350 E-brake or parking brake isn't as tight anymore on a hill it doesn't stop my car when applied when parked how to adjust this? I rather not go to the dealer if its a simple fix?
View 5 RepliesDodge :: 2008 - Rear Passenger Wheel Squealing When Brakes Applied
I have been doing my own brakes for years. I have had some that were not easy to keep from squealing but this one has me wanting to get rid of the car. We have a 2008 Dodge Magnum R/T package. Roughly 38K miles on the car. When the car reached around 10K miles the rear passenger wheel would squeal when you applied the brake. Rotor surface was smooth as glass. I took off the rear rotors only and had them turned. Problem went away for about 5K miles. Then the fronts started squealing.
I replaced the fronts because hte factory did not leave any material to be turned and noted that Dodge glued the pads to the calipers like they would never need to come off. Problem went away for a little while. Then it came back with a vengeance. I replaced the pad material on the fronts with ThermoQuiet pads from Raybestos. Problem is coming back again and now I cannot tell which end of the car it is even coming from because it it so loud. My wife drives this car very carefully. My thought is she is polishing the rotors too smooth and this is our source of noise.
We are at the point of squealing again and I am at my wits end with this. If I light foot it, no noise. If I stop like I think it should be stopped, not killing it, the noise is there. If I stop very quickly about 3 to 5 times in a row the noise is gone for a little while until the pads cool and then it is back even if I am on the same journey.
Chevrolet - Malibu :: 2008 - Service Traction Light Comes On Randomly
I have a 2008 Malibu LS and the service traction light comes on randomly, I suspect a sensor. The car operates fine and this light has been coming on for several months. My question is can I just ignore? Another question is that I had new tires put on and they said I needed new control arms and bushings. I'm always suspicious when I go in for one thing and told I need something else. What would be the symptoms that I need to replace these parts?
View 5 RepliesMalibu - Engines - Lights - Chevrolet :: 2008 - Check Engine Light Came On?
My 2008 Malibu service manual states that the check engine light should briefly come on when I start my engine. When the engine is cold this does not happen. Also, it happens infrequently when the engine is warm. My Chevrolet dealer says this is normal as the light checks out when tested. Chevrolet has not given me a difinitive answer on this. My concern is that if this is a problem it may surface at another time when the light should go on and cause damage if not attended to. If the manual says the check engine light should go on when the engine is started and it doesn't, doesn't this mean something is wrong?
View 14 RepliesMalibu - Chevrolet :: 2008 - Remote Won't Lock / Unlock Doors Or Open Trunk?
Remotes suddenly will not lock/unlock doors or open trunk.Background - guy left key in ignition in 'on' position overnight. Also thunderstorm with very near lightning strike during that time.Battery dead in am, though after jump start it was not necessary to reset radio, clock, etc.Neither remote works.Checked the door lock fuse - looks OK, but did not replace it as there were no spares in the spare slots.Where else to look for the problem?
View 2 RepliesPrius (Gen 1) :: Pulsing Raspy Noise When Brakes Are Applied?
Our gen 1 has developed a (currently minor) noise issue when braking. I'd like to sort it out before it becomes serious.
The brakes are still strong, and the regenerative system appears to be working. When the brakes are applied (even gently) there is a pulsing raspy sound, seems like it is coming from the front, driver's side. It is more rapid at higher speeds, and louder during rapid deceleration. I guess I'd call it 'grinding', although this is much less unpleasant than the classic 'grinding brakes' I've heard on other cars.
In any other car I would figure a warped rotor or worn out brake pad. But I had imagined that the regenerative system handled light braking, and conventional brakes took over beyond a certain threshold. Now I'm hoping they work in tandem, even on gentle braking and this is just a boring, simple pad issue.
Buick - Century :: Noise First Time When Brakes Are Applied Each Day
Does this mean I need to see a mechanic. My car is a 97 buick century, 94kmiles. Rear brakes were replaced at 83k and front brakes were replaced at 80k. A few months ago, the noise began and has persisted once a day when brakes are applied first time of the day.
View 5 RepliesGolf/GTI VI :: Grind Noise When Applied Brakes On The Freeway
So I drove 400 miles today and when I was just about home I heard a grind when I applied the brakes on the freeway. Well I did a walk around the car to check all the pads and noticed my rear pads are almost gone. I'm not used to having the rear brakes implemented in so much of my daily driving, with the TCS and all.
To make it easy I'd like to keep all four corners on the same brake setup, I'm just not sure what is ideal on this car. I know OEM is gonna be said, but I upgraded my front pads to Hawk HPS'.
Tiguan :: Brakes Making Grinding Noise When Applied
Is it just me or is this an ABS thing? during a snow storm i was going about 25mph and had applied the breaks and started making a grinding noise... if it is the abs how are you suppose to work with the response time for a quicker stop.
View 2 RepliesSonata I45 (YF - 2011+) :: Clicking Noise After Brakes Applied
Right this clicking noise is really annoying me now, every time AFTER i brake i hear this click, the faster i stop the louder the click is, also when I am in neutral and suddenly rev its clicks sometimes but rarely, I am thinking it could be a loose exhaust somewhere? Its definitely coming from under my foot area. When I brake cornering it clicks too. Checked my control arms and everything, that's not rattling at all? Need to get rid of this click sound!!
View 3 Replies