Celica :: Headlights Adjustment - High And Low Beams
I just bought our 1st. Toyota 03 celica GT 5speed.113000 well cared for miles. My biggest concern is the headlight adjustment. The high beams are similar to aircraft landing lights but the low beams seem to cross with the left side too far to the center. I found the up-down adjuster (wish it had the cab operated feature) but can't find the left-right adjustment.
View 3 RepliesCelica :: 2001 GT - Head Beams Will Not Come On
I have a 2001 Toyota Celica gt and the high beams will not come on. No high beams no indicator light on gauge cluster either. I looked at all the fuses on interior and engine bay and they all are fine. Replaced the dimmer switch and still no high beams. If the headlight relay was not working would both high and low beams both not work?
View 1 RepliesPrius (2010-12) :: Headlights Low Beams Out?
I noticed tonight that my low beams are both out, and they were both working yesterday. Fuse #19, a 40A in a cluster of two 30A fuses appears fine when I look at it AND my horn and backup lights work just fine too. In the owner's manual it say that fuse position #19 controls the low beams and the horn (which is working) and the backup lights. SO, that says to me the fuse is ok because the other items are working.
FWIW, I can use the high beams, but recognize they're on a different fuse anyway. Also, I replaced BOTH headlamps with new Sylvania bulbs about 6 months ago when one of them went out. Could both low beam headlamps have burned out at the same time???? Is there some other fuse that controls them both other than the #19 fuse inside the engine compartment? Could this also be a problem in the control stalk switch on the steering console?
Touareg :: Headlights - How To Adjust Beams
How to adjust the Headlights on a 2006 Touareg. I am importing my US Reg Touareg to the UK and need to adjust the beams to UK Road Regs...
View 1 RepliesIS F (2008-2014) :: Water In Headlights / Low Beams Went Out
Recently got the car and after my first wash, there was alot of water inside the headlight then both my low beams went out. The next day, one of them came back on and i tested the other side with a new bulb but still no luck. What should i look in this situation? 2008 model
View 3 RepliesPrius (2004-09) :: High Beams Went Out - Replaced Relay But Situation Persists
My high beams went out a few months ago on my 2008 prius. They told me it was the relay. I just replaced it today with a relay from advanced auto parts. My highs work now. But as of 2 hours ago I noticed my lows are no longer coming on. A few days ago I picked up the car after having aftermarket hids put in. The lows were working then highs still no. A few weeks ago I had some other relays replaced and they told me the cap was off and water got in it.
So could it be that my low relays have gone bad now too. It seems weird right when I fix my highs my lows stop working. If its possible I want to try a new relay to see if that fixes it. But I need the part number and location in the relay box. I can post a picture of the inside of my relay box, can't point to which one it is. I am sure it even has the part number on it.
Lexus LS 2007+ :: High Beams Aiming Up In Trees After Replaced Bulbs
Prior to me switching out the high beam bulbs, they were both aiming correctly. After I switched out the bulbs, both high beams are aiming up in trees literally. They arent even close to lighting up the street/pavement. I was wondering if I may have installed them somewhat cockeyed but I thought it was odd that I would have done both of them the same since they are both equally up in trees/same overall height.
View 2 RepliesPrius (Gen 2) :: High Beams Go On When Headlights Turned On / Won't Turn Off
Anytime I turn the headlights on, the high beams go on too; I cannot switch off the high beams unless I turn off the headlights entirely (I have been driving with the low beams on during the day for the 5 years I have had the car)
I can find no reason for this; I'm inspecting the fuses (with little expectation). The only thing I can think of is the control switch or wiring. I have standard headlamps, not hid.
Nissan - 240sx :: Headlights - Only High Beams Work
I recently got this car from a friend, and when checking all the lights I noticed that only the high beams work, not the low beams. I replaced the lamps, and checked all the fuses, but the low beams still don't work.
View 3 RepliesSanta Fe (CM - 2007-12) :: Headlights Don't Work But High-beams Do
The normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 RepliesFord Ranger / B-Series :: 2011 - High Beams Not Working Even Replaced Fuse
I have a 2011 ford ranger XL and I get no high beams. My low beams work fine but when I try to either activate the high beams or pull for the flash to pass they do not illuminate and the indicator on the dash doesn't come up either. I have replaced the fuse with a fresh one, even though it didn't need to be replaced, and also replaced the headlights as well cause one was burnt out.
View 1 RepliesHeadlights - Chevrolet - Blazer :: 1997 Chevy - No High Beams
I have a 97 chevy blazer, that has no headlights. the daytime running lights, dash and marker lights all work but not the headlights or high beams?
View 4 RepliesElantra MD (2010-15) :: No Low Beams When Headlights On But Work When Running Lights On
My limited has lost it's low beams when the switch is set to head lights but not when set to marker lamps. They still shine at a reduced output then. I've read this may be an issue with the BCM?
View 1 RepliesOldsmobile :: When Hit Dimmer Switch To Select High Beams, Headlights Cut Out
I have a 1941 Oldsmobile and when I hit the headlight dimmer switch to select high beams my headlights cut out . My car has all original wiring and I suspect a short at one of the terminal blocks. I am unsure how to troubleshoot this problem. I cannot select my model number below I have a model 76 Dynamic Cruiser.
View 19 RepliesCamry 2012+ :: Headlights Horizontal Adjustment - Moving Beams Closer To Each Other
My headlights seem to be off. The beams are spread too far apart, leaving a dark spot right in the middle. It is a 2016 and I just noticed it tonight. I have been trying to find the horizontal adjustment. Is this it? I have tried to turn it but did not notice any difference. Which way am I suppose to turn the left and right one to have the beams move closer to each other?
View 7 RepliesGolf IV / Jetta IV :: 2001- Headlights Malfunction - Only High Beams Are Working
So I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
Sonata NF (2006-10) :: 2008 - Headlights Alignment / Low Beams Angled Almost To The Ground
I just ran into an issue with my 08 Sonata. Tonight while I was en-route to a emergency call, I came very close to hitting a dear. The low beams are angled almost to the ground and I don't know how to angle them up. I have to have my fog lights lit to see the road signs when my high beams are not on. Also need to know how to angle those as well.
View 8 RepliesCamry :: 2002 High Beams And Turn Signals Work But Headlights Not Working
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 RepliesPrius (2010-12) :: Headlights Surrounds Have Melted Sections In Front Of High And Low Beams
2010 Prius... Both of the outside clear poly carbonate headlight surrounds have melted sections in front of the high and low beams.
View 19 Replies