Nissan - Altima :: 2000 - Check Engine Light Has Been On
I have a Nissan Altima 2000 with about 98,000 miles. The "check engine" light has been on. This happened once before and eventually the light went off, but now it is on again. I read the manual and it said that the gas cap isn't on tight enough. Checked that and it is fine - but the light never went off. Should I bring it in to a mechanic?
View 5 RepliesNissan - Altima :: 2003 - Check Engine Light Coming On And Staying Lit
My wife has a problem with the check engine light coming on and staying on. The dealer has replaced the fuel pump twice (which they say is the problem) but it keeps happening.
View 4 RepliesNissan - Altima :: 1999 - Check Engine Light Code P1447
My 1999 Nissan Altima. Has a check engine light code P 1447. Car stalled needed a jump to get started. Left it by the mechanic running and stalled again what could it be?
View 1 RepliesCamry :: Check Engine Light Is On For Bad Knock Sensor In Bank 1
Wife has a 08 solara 2.4 auto. Check engine light is on for bad knock sensor in bank 1. Now car is not pulling itself, it takes off fine then shifts and falls on its face, I think its missing 2nd and going to 3rd. It is also not shifting into 5th so its staying in 4th and using a lot of gas. I tried manually shifting but it still goes to 3rd and will not go to 5th. I have been told this knock sensor could be causing it all. Cant clear code, I hit clear but nothing happens. We don't have a lot of money to pay the Toyota dealer to fix it and I can do all the work but they wont even show me where the knock sensor is.
View 5 RepliesHyundai - Accent :: Check Engine Light Came On - Knock Sensor Code
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 RepliesAvalon 2005-12 :: Check Engine Light On And Code Is P0327 (Knock Sensor)
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
Lexus GS 2006-11 :: Check Engine / VSC Lights On - P0333 Knock Sensor Code
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesSubaru - Forester :: 2002 - Check Engine Code For Knock Sensor - Motor Mounts?
2002 Subaru Forester I took my car to the Auto Zone to read a check engine code. It came back as being a "knock sensor". Besides that I needed a battery, and when the guy was putting it in he said my engine was moving too much and that I probably needed motor mounts.
I was looking at a discussion back in 2010 and the Subaru specialist told the person needing motor mounts is rare for a Subaru, is that true? I'm taking it to a mechanic, what should I expect? how many motor mounts does a subaru have?
Nissan - Altima :: Service Engine Light Refuses To Stay Off
I have a 2005 Nissan Altima with a SERVICE ENGINE light that refuses to stay off. Initially, upon hooking the car up to my mechanics computer, the code indicated a faulty crankcase sensor. I purchased the sensor and it was installed. I was then told to drive 30 or 40 miles at various speeds, stop and go traffic without shutting off the engine to reset the computer. This was done twice without success. The light remains on . The inspection was due in December and this is becoming very frustrating not to mention illegal to drive these 40 mile circuits. I have even disconnected the battery, reconnected (light off!), and drove ANOTHER 40 miles. The light stayed off while driving but came back on after restarting. 3 times , 2 different mechanics reset the cars computer with theirs. 4 different computers still diagnose a faulty crankcase sensor. The sensor has been replaced twice. Everyone is stumped and I really don't want to take the car to a dealer.
View 18 RepliesNissan - Altima :: Misfiring Cylinder While Driving And Engine Light Came On
I have a 4 cylinder, 2002 Nissan Altima with about 170,000 miles on it. About 2 months ago, the car starting misfiring while driving and the engine light came on. I went to autozone, used their diagnostic tool and it said I needed to replace the fourth cylinder's ignition coil. I ended up just replacing the spark plugs at that point. After replacing the spark plugs, the misfiring seemed to stop, but the check engine light was still on although the car ran great in comparison.
Then, about 2 weeks ago, the car started smelling like gas and slightly misfiring again. I bought set of ignition coils and changed them out. I started it up, the car seemed to work great. I went to the store about an hour later and the car worked better all the way there with no problems. Then, as I was about to leave the store, I started the car up and it started sputtering and misfiring and you could visibly see the engine shaking like crazy when I popped the hood. It stopped shaking, evened itself out, after about a minute. Then, I felt the top each of the coils and the first three were fine, but the fourth had a rapid tapping coming from it that was obviously not right.
I gave it a couple of days, but the car didn't stop smelling like gas or misfiring when starting up, so I pulled out the ignition coils and the spark plugs. The fourth spark plug was brown and burnt from the bottom to the halfway point, unlike the other still-clean spark plugs. My first hopeful thought was, maybe it wasn't tight enough and that was letting gas or oil inside to burn. I tightened it up, put everything back and it seemed to be alright, even the tapping from the coil stopped.
However, within the last couple days, the car has been smelling like gas and feels like it sputters and misfires once I start it up. The misfiring seems to stop after I rev the engine a little bit, but sometimes when I'm idling, you can still smell the gas and sometimes audibly hear a sputtering.
So my question is: what the hell could be wrong? Faulty wires, a stuck valve, bad compression, what? Remember, the fourth cylinder's spark plug was only burnt on the bottom half if that's useful.
Nissan - Altima :: 1998 - Oxygen Sensor Goes Bad As Soon As It Is Repaired
I have a 1998 Nissan Altima (manual transmission). The "Check engine light" came on. The oxygen sensor went bad again. I have had this repaired twice (to pass inspection). Every time I get it repaired, I take the car back to the inspection station and then it passes inspection. But in a few weeks to a couple of months, the "check engine light" comes on again. Every time I get this repaired its almost $400-$500 expense. I should probably take the car to another mechanic this time.
View 1 RepliesNissan - Altima :: MIL Came On / Code P0335 Crankshaft Position Sensor Circuit
My wife's 2003 Altima has been stalling. The MIL came on P0335 Crankshaft Position Sensor Circuit. I did a little research and it seems that it is pretty common for that sensor to go bad, so I bought a new one. The problem is I can't get the wires off the old one. It is in such a ridiculous place. There is no line of sight anywhere. It has to be done completely by feel. Supposedly, I should be able to push the button until it clicks and then remove the connector. When I push the button, it definitely clicks - but it doesn't stay clicked. It clicks right back out before I can pull on the connector. How can I keep that button clicked in when I can't see anything and I can just barely get one hand down in there?
View 19 RepliesSonata NF (2006-10) :: Engine Knock And Check Engine Light Came On
I recently got a Sonata from my parents when they moved to Pennsylvania. It's a 2007 with the 2.7 liter engine. It has had low oil for some time, so when I got it (last week) I put more in, up to but not above the full line.
It has had now for just a couple of days a very bad rattle, which is barely audible (but still IS audible) at idle and gets very severe during and after acceleration. It remains for some time even after the gas is no longer being pressed, then subsides a bit. I diagnosed it as knocking, but just today the check engine light came on and the rattle got louder.
I don't have another car to drive and I have class in five hours. Should I drive it or call a cab?
Golf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesNissan - Altima :: 2003 - Won't Start When Engine Is Hot
2003 Nissan Altima 2.5 SL automatic - starts fine when the engine is cold but won't when the engine is hot. It acts flooded. I've changed the camshaft and crankshaft sensors, spark plugs, one spark plug coil, radiator, valve cover and the coolant temperature sensor. The car will turn over but will not start - sometimes it will after 5-10 minutes of trying.
View 1 RepliesNissan - Altima :: 2007 Won't Start / No Ready Light
It ran out of gas with the previous owner and they say the steering is new and the hybrid battery is new and the 12 volt is new but when I got it I had to get the 12volt battery trickle charge which it charge to 80 percent and it still didn't start only goings from lock, acc, then on never say ready no sound but when I pull the IGCT relay the fans come on but it don't start what is this relay?is this car just like Toyota primis. What could be the problem of this mechanism to get it running I have the only one in my town which no one knows how to work on It.
View 4 RepliesNissan Hybrids :: 2007 Altima Engine Won't Start ECM
My 2007 Nissan Altima Hybrid has had this recurring problem since I purchased it used and I learned the original owner had the same recurring issue and other owners on the internet also. Typically when I go to start my car in the morning, after my car has sat in the garage over night, I depress the brake and the ignition button and **ALL** the warning lights come on including the EV mode ready and Service Engine light but the car has no power steering and the gas engine won't start at all. The car is drivable for about 30 seconds in EV mode then dies. When the car is at the dealer the car starts fine and they can't replicate the issue but find the following DTC's: UOO73, UO100 ECM 211, UO100 ECM 530, UO123, UO124, U0126, U0129 BRAKE 220, UO293,UO131 EPS 433, UO121 EPS 434, U1020, U1022. Nissan replaced the hybrid battery, the hybrid harness and the main car harness and now they say there is nothing more they can do to fix the problem. The problem remains. Have you had the same or a similar issue?
View 8 RepliesNissan - Altima :: 2000 - Engine Dies After One Mile
Started my car the other morning to go to work (4:45 AM) with no problem and drove about one mile. Not wet weather. The engine dies, all lights that come on at start up (engine, alt, etc.) come on and I glided to the side. Tried starting it again - engine tried but did not catch. Tried a few more times and called AAA.
Towed it to a mechanic. Waited about 2 hours for them to open. They were able to drive it the rest of the day with no problem but they had the same thing happen the next morning (yesterday). Then it didn't happen to them today. One more try tomorrow and I hope they can identify it then.
2000 Nissan Altima w/150K miles, gas was less than 1/4 mark, no system lights on.
Nissan - Altima :: 2003 - Engine Won't Turn Over After A Brief Stop
My 2003 Nissan Altima recently started giving me trouble where I will drive for at least 20 minutes, stop to run an errand, come back, and the engine won't turn over. The first time this happened my check engine light came on. I brought it into the shop and had the cam sensors replaced. I'm still having the same problem. The engine cranks and the battery checked out okay. Car has 93,000 miles on it. I can usually get it to start after 5-10 minutes by cranking and pushing the gas to the floor. Could this be a fuel issue?
View 3 Replies