Prius C (Audio/Electronics) :: Multi USB Port Will Work If Plugged Into Single Port?
Plugging a multiple USB port into the single USB port? Does it work? For example a plugging a USB drive and an IPod?
View 4 RepliesFord F-150 - 1997-2003 :: OBD Port Not Working But Fuse Is Good?
Cigarette lighter works and shared fuse seems fine. OBD port even powers up my cheapo elm bluetooth reader. Unfortunately multiple different readers refuse to connect. I've tried disconnecting negative terminal for a half hour and trying again but no luck.
View 3 RepliesGen 3 Prius (Audio/Electronics) :: 2011 - Aux Port Only Working On Left Side
2011 Aux port only working on left side. Its not the cable. Plug port seams loose and wiggles. Use for Sat Radio hook up.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: OBDII Port Not Working- Fix?
I plugged in my basic OBDII scanner but I'm getting nothing back (the scanner works on my car so it's not the scanner). This is inline with the transmission shop where they said they couldn't connect either to my truck. But now the question is: now what? I don't think there is a fuse or such but how to troubleshoot the port.
Oh, and no, the CEL is not illuminated, just the ABS light remaining on from when my 4R100 was replaced a couple weeks ago. Can't connect to diagnose.
Camry :: AC Compressor - Poured Oil Into Port And It Back Out
Going to put on a new AC compressor on my 4cyl 02 Camry. I poured PAG oil into the port shown in the picture but have since poured it back out. Have I ruined this compressor? How much if any oil is supposed to be in there.
View 1 RepliesFord F-150 - 1997-2003 :: OBD2 Port Stopped Working - Fuse Not Blown
My 03 5.4 the obd2 port isnt working i have tried 4 bluetooth adapters and a snap on scanner and nothing will connect to the ecm. im having problems and trying to read codes my check engine light isnt on but that don't mean anything. my truck is running really rich and blows a little bit black smoke when i rev it up after its been idling a few min and getting horrible gas mileage again. yesterday i went to start it and i had to crank on it 4 time before it finally started and then when i reved it up it almost died on the way back down but it caught itself. then today i go out and it starts right up and runs fine but its still running rich but i still cant get an obd2 adapter to connect to the ecm. I checked the fuse and its not blown my cigarette plug and the power port both work. i really dont know where to start in trying to figure out this problem. Right now iI don't really want to take it to a shop right now.
View 4 RepliesGen 2 Prius (Audio/Electronics) :: Aux Port In Center Console Stopped Working Unless Jiggle The Cable
I have a 2009 Prius with the Aux port in the center console. It has stopped working unless you jiggle the cable. Need to get a replacement?
View 4 RepliesCamry 2012+ :: Changing Center Console 12v Charging Port To Hot
I would like to make one or both of the 12v charging ports in the center console supplied by constant power, instead of accessory fed.
I haven't torn too deep into this car yet, so is there an easier way to do this besides running a lead from the battery? An empty spot in the fuse block perhaps?
Lexus ES 2007-12 :: ES350 AC Giving Warm Air On Driver Side - Where Is Low Pressure Port
I have a ES350 and it is doing the issue of having warm air (or not cooled air) on the driver side, but has cold air on the passenger side. I looked around and saw it was a common problem. One of the solutions I read was to just refill the system with R134A. Not a problem for me, except I don't know where the low pressure port is located in my car. I was trying to find a online service repair manual on my car to locate where I need to connect to, to recharge the system.
View 12 RepliesCamry :: 2007 - AUX Input Not Working?
So I just got my 07 camry se v6 and was so excited and hooked my ipod into the aux input and go to push disc/aux and it wont go to aux?? so i took it to the dealership and they said oh its prob a bad cable so i bought a new 3.5 cable and tried it and still nothing. it plays cds fine. they tried saying that i might need some adapter from toyota directly to hook it up but i find this hard to believe... Could I have a bad aux input jack? i tried searching but came up empty handed. Aux input does not work. got new cable. still nothing. ?
View 14 RepliesCamry :: 2007 LE - Auto Headlights Not Always Working
2007 Camry LE. I keep my headlights in the AUTO position and have had two instances recently where they did not come on, and it was plenty dark enough that they should have. I was able to turn them ON, then back to auto, and some sequence of that finally got them to come on while on AUTO, but it was a little scary. I had other drivers flashing their lights at me so I would turn mine on. I guess I'll have to check every time from now on.
View 12 RepliesCamry :: 2007 - One Windshield Wiper Not Working?
I have a 2007 Toyota Camry. The wiper arm on the driver side is not moving while the one on the passenger side is working fine. I thought the wipers went bad and changed to new ones but the problem is still there. Is there something wrong with a motor?
View 3 RepliesCamry :: 2007 V6 XLE - Dashboard Gauges Working Intermittently
Got an 07 Camry V6 XLE - the dashboard is intermittent sometimes one gauge works, sometimes all gauges work, and every combination you can think of......
Car seems to run ok - battery has good voltage Alternator seems to work - discontented and clean the battery - checked all fuses....
Camry :: 2007 - All Lights Are Working Except High Beams
I've ran into an issue with my high beams on my 07 Camry SE. All lights are working except high beams. When you switch to high beams the lows only stay on. The dash light comes on and shows high beam indicator, but no brights! Fuses look good, and so do both bulbs. Going to go buy a bulb later today just to try. Like I noted they both just suddenly stopped. I'm leaning towards dimmer switch on column now.
View 11 RepliesCamry :: 2007 XLE - Central Brake Light Not Working
The 3rd central brake light is not working. I looked at the manual to find where the fuse is but could not find it.
View 13 RepliesCamry :: 2007 - DRL And High Beam Aren't Working
Where's the fuse for the DRL ...both my DRL and high beam isn't working ...I checked the bulb and is seem fine. I did check the fuse box on both locations ( under the hood and steering wheel) none of them says DRL fuse in there ...
View 14 RepliesCamry :: 2007 - Remote Engine Starter Not Working
My remote engine starter has stopped working. It still locks, unlocks, opens the trunk, and triggers the alarm. I have already replaced the battery, with no luck.
View 3 RepliesCamry :: 2007 - AC Only Half Working After Installing New Head-unit?
my 07 Camry has about 80k miles on her. I got fed up with the boring stock head unit and decided to get a new 8" headunit that would match the interior touch screen and all. Anyways I'm a fan of my AC as I normally use it. I took it to the audio shop to get my new headunit installed. I drive a couple hours enjoying it and decide to put on the ac. My problem is The air conditioning is only coming out of the passenger side now very cold and stale warm air is coming from the driver side vents. I can't figure it out. I got upset and went back to the shop to see if maybe they did something wrong and didn't hook something up correctly.
So they did everything they could and showed me that it wasn't any of there doing and that it's extremely "coincidental" that this happened immediately after they installed it. Anyways I'm also noticing that the light pointer above the dial on all 3 dials on the AC unit are not lighting up. And the light I am talking about is the pointer light that points and which measure of heat/cool comes out. The middle buttons still work and are lighting up as well as the off/on ac portions night back lights are working properly.
Also I have only the standard AC unit. Not dual climate. All my vents are set correctly as I never really mess with them. is there a possibility they could have damaged the Blend Door actuator. And know where the blend door actuator is located on a camry?
Camry :: 2007 XLE - Idling Too Low After Plug Change / AC Is Not Working At A Stop
I have a 4-cyl 2007 Camry XLE. I changed out the plugs, simple enough. but now the car seems to be idling too low, just a tick below 500 RPM. Its causing some minor vibrations as also the AC is not working at a stop, it just blow warm air. As soon as i push on the gas the RPM jerk up pretty sudden, the air pressure from the vents increases and its cooler. So it seems the AC issues is related to the RPM being too low so once i get the RPM's back up it should be good to go.
These are the stock Denzo SK20R11 plugs that were in the car : [URL] ....
And these are the equivalent NGK IFR6T11 plugs i put in [URL] .....
So, I thought maybe because the ECU got reset maybe some re-calibration, but I have driven a good 100 miles on it and no change so i doubt that's it.