Ford Exhaust :: Exhaust Manifold Leak Due To Broken Rusted Bolts
I have a 97 Expedition with the 5.4 engine and 160k miles. Recently while having other work done I was told that I had an exhaust manifold leak due to broken rusted bolts.
View 3 RepliesFord F-150 - 1997-2003 :: Exhaust Leak On Passenger Side / Broken Exhaust Manifold Bolts
My wife's 97 f150 4x4 had an exhaust leak on the passenger side. 7 out of the 8 bolts holding the manifold on are snapped off. 4 of them are snapped off 1/8" below the top of the hole on the cylinder head . I am I unable to get a drill in to drill these out. The other 3 I've tried welding a nut on these but they won't budge and I wring the nuts off. If I have to pull the head(something I don't want to do)can I just pull that 1 head or do I have to tear the intake and everything off?
View 1 RepliesFord Exhaust :: 2005 F250 - Removing The Cat Converter Off The Pipe?
i've got an 05 f250 SD 5.4 v8. i had a bad manifold and decided to get headers. i figured i would get the most performance of of them if i did high flow cats too. oh and i also already have an exhaust on it. the only cats i can find for it are universal fit. my question is how would i be able to get the cats off of the factory pipes without damaging the pipes or original cats? plus the pipe with the flange end is a really small piece. would i be able to get it off just by heating it up?
View 1 RepliesSilverado :: 2010 - Drop The Pan Without Removing Exhaust Pipe To Change Filter?
I have a 2010 5.3 silverado, extended cab 2WD with 100K Miles on it. It's time to change the transmission fluid and Filter. It looks like there is an exaust pipe that runs about 3-4 inches under the transmission pan. Can I drop the pan without removing the exhaust pipe so i can change the filter?
View 2 RepliesFord Exhaust :: Crack And Subsequent Leak In Exhaust Pipe
Actually developed a crack and subsequent leak in a pipe running lengthwise, so assume the factory weld over the years went bad. Since it would be a weld overhead, wonder what method would be best? Would oxy acetylene work or mig? I don't have a tig so that not an option for me.
View 2 RepliesHonda - Accord :: Engine Oil Leak From Main Bearing Cap Side Bolts
I noticed oil on my garage floor from my 2002 Honda Accord V6 and thought the dealer hadn't tightened the oil pan bolt. The dealer charged me to diagnose that the dripping oil came from a main bearing cap side bolt. It seems the bolt threads, aren't sealed at the factory and to fix the problem the dealer will remove the bolt, clean it, then apply Hondabond HT Silicone Gasket to the threads and washer contact area. I have to leave the car for 24 hrs for the sealer to dry before staring the engine. Bolt to be removed, cleaned, sealed and replaced. Is this a recall item?
View 12 RepliesFord F-150 (2004-2008) :: Manifold Exhaust Leak - Rusted Bolts
Truck has 107 thousand miles; had to take it in for an manifold exhaust leak. Mechanic said bolts are so rusted they break.
1) was there ever a ALERT from ford about these bolt's?
2) Thought i read ford had stainless bolts for this problem...
I've had F150's only since the mid 70's and this 04 has cost me more in repairs than ANY previous F150..
Elantra XD (2001-06) :: Exhaust Leak Between Front Cat And Connecting Pipe
I changed my front catalytic converter yesterday. Everything was installed properly and the repair went smooth. Unfortunately when I started the car, I discovered the connection between the bottom of the cat and the connecting pipe was leaking out a ton of exhaust. The previous cat didn't leak like that. I put in a new gasket and tightened the bolts extra tight but the leak is still there. The worst part is that the leaking exhaust fumes are all traveling up into the hood, which makes it look like the engine is smoking. What should I do to stop the leak? I even tried using muffler tape but that only worked for an hour until it hardened and sounded like crap.
View 3 RepliesGolf VI R :: Exhaust Leak - Air / Water Condensation Is Coming Out Of Small Pipe?
I installed the non-resonated exhaust, but I noticed that some air/water condensation is coming out of the small pipe that join the cat and non resonated part of the exhaust.
I double checked the position of the small part and is very deep inside the other tubes, plus I checked the clamps too.
Ford 6.0L Power Stroke Diesel :: Installing Y Pipe - Bad Exhaust Leak
Over the weekend I replaced the passenger side up pipe with one that doesn't have a spot for the EGR cooler. After putting the turbo back in it has a pretty bad exhaust leak. Sounds like it is on the drivers side somewhere near the Y pipe. When replacing the passenger up pipe I didn't loosen any manifold bolts or anything and I am thinking that the Y pipe is out of alignment with the turbo. What is the proper procedure to loosen everything up and get it aligned on the turbo? My guess is remove turbo, loosen drivers side manifold, loosen passenger side manifold, loosen passenger up pipe and tighten it again now that everything isn't under tension, install turbo and clamp to Y pipe, tighten manifolds. Is that the right idea?
View 8 RepliesSubaru - Outback :: Potential Exhaust Leak - Smoke Coming From A Pipe Underneath
Recently, my car has been sounding louder than usual. It seems to be coming from under the vehicle, and when I checked, there was smoke coming from a pipe underneath. My best guess is that the exhaust is leaking. It kind of looks like there's a disconnect here....
View 3 RepliesGolf IV / Jetta IV :: 2002 - Exhaust Leak Coming From Either Manifold Or Flex Pipe
So I did the seafoam trick and I came to the conculsion that my exhaust leak is coming from either the manifold or the flex pipe. There was no smoke coming from under the car only a mist of smoking coming up from the back of the engine, probably by the manifold or the flex pipe. I do not see any visible cracking per say. I have attached a picture of the end of the flex pipe and it almost looks like someone may have tried to seal it before? I don't know if that is normal or not as seen in the picture.
2002 Volkswagen Golf 2.0 ...
Ford Super Duty (1999-2016) :: 2002 - Exhaust Noise - Leak / Bigger Pipe?
i have a 2002 250 with the 7.3. i put a mbrp aluminized 4in turbo back with a FTE 30in resonator. I'm getting a lot of noise in the cab sounds like its where the turbo goes into the 4in pipe. the muffler guy said its because of the bigger pipe and not a leak. is there anything i can do to get rid of the excess noise.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Exhaust Leak At Passenger Side Up-pipe To Manifold - P1211 And P1280
I just finished installing a new turbo (shaft play and lots of oil in the compressor side), RR up-pipes, and T500 (250k and once had a very long crank to get the ICP up to start).
Anyway, except for another exhaust leak at the pass side up-pipe to manifold, it seemed to run okay but with lots of white smoke. I only have about 50 miles after the install, when it suddenly starting surging and made a lot of loud knocking noises. This then went away and came back again rather quickly. I was close to home, so I made back under power. I also received the two codes listed. My IPR is original, but two summers ago I installed the IPR re-seal kit. Everything on the IPR looked good when it came off for the T500.
After reading around, I saw that low fuel pressure / air in fuel can cause problems. I connected a pressure gauge to the pre-filter port on the filter housing, and got 40psi at idle. I then took a diesel shower and blew out the fuel line into the tank. After re-connecting it, the fuel pressure stayed the same but the engines idles much better, but still has blue smoke. It's the original fuel pump (to me anyway) and original fuel line connections.
I have about 3/4 tank, and no place to put it, so I'd need to run it out for the Hutch mod, or least to get in there and inspect. Would eliminating the Ford connections at the pump be worthwhile for now, and is 40psi at idle adequate? Wondering if it's time for a fuel pump?
Ford Excursion :: 2000 - Leak At Fuel Filler Pipe
Just drove home a 2000 Limited from a used car dealer in NH to MA. Half way home, I stopped to gas up and noticed I was losing a small amount of fuel while pumping. It appears to be leaking from the filler pipe just before the tank, but there was too much splatter to tell for sure. No leak when not pumping, but the tank was only half full.
The dealer "guarantees" that the truck will pass MA state inspection. I'm sure a rusted out filler hose would result in a failure. The "guarantee" really means that he will buy the truck back should it fail, which is not really doing me any good b/c I'll have to start looking for a new truck all over again.
I'm unable to find a part # or pic of a filler neck for the Excursion. Is it the same as other Super Duty necks? Is this thing welded to the tank? That sounds like an involved, difficult fix.
Ford Super Duty (1999-2016) :: P0420 Code - Leak At The Joint Where Exhaust Manifold Meets Pipe Beside The Engine
I have a 2011 F350 CC long box 4x4, with a 6.2, 93,000 km on it. I periodically get a P0420. I clear it and sometimes it comes back in 10 or 20 KM and sometimes it comes back in a couple hundred km. Been doing this for about 800 KM.
Yesterday I got an exaust leak at the joint where the exaust manifold meets the pipe beside the engine. Checked close, bolts appear intact, leak is on the outboard side blowing towards the frame. Looks like a gasket or donut seal failed.
I am wondering if the catalytic converter was plugged or restrictive, would this cause the P0420 and could back pressure from a restricted catalyitic converter cause the gasket to blow?
Honda - Accord :: Reservoir Tank Losing Coolant - No Leak On The Ground
A few weeks ago my car over heated and stopped. I had it towed and the mechanic changed the water pump, timing belt, gasket cover and more. About two weeks ago I noticed antifreeze on my drive way. Took it back in and the mechanic changed a clamp on the radiator. it continued to leak antifreeze. I took it to Pep Boys for a pressurized test, they couldn't find a leak, but did say my radiator hoses needed changing and they suspect the radiator cap is the problem. That was a week ago. I just got back from vacation and the reservoir keeps getting low every day, but not at the minimum line since the first mechanic filled it to the top. There is not apparent leak under neath the car. No smell when I start. Oil is not milky. Called first mechanic he said sounds like a blown head gasket....
Car is Honda Accord 1999, 138K miles.
Ford Fuel System :: Small Leak Where Filler Neck Ties Into Rubber Hose That Runs Into Fuel Tank
I recently purchased a used 1999 F250 Super Duty with about 150k miles on it. The truck runs great and I have no complaints but there are a few things that need to be taken care of. It looks like there is a very small fuel leak where the filler neck ties into the rubber hose that runs into the fuel tank. There is a thin film of diesel along the side of the tank, on the leaf spring, the air bag and various other places. Nothing is dripping. I want to drop the tank and replace the hose. The Haynes manual says to depressurize the whole fuel system--is this really necessary if I don't plan on doing anything to the system aside from dropping the tank?
View 2 RepliesCaravan/Voyager :: 1993 Dodge Grand Van Not Properly Burning Fuel - White Smoke Coming From Exhaust Pipe
My van has quit me finally. It only has 98,000 original miles on it. Right now the car really smells like it is loading up and not properly burning fuel. Also a huge amount of white smoke is coming from the exhaust pipe. The oil pressure is good. could it be as simple as new plugs and plug wires, coil pack etc.
View 3 Replies